• 설비공학논문집
• /
• 제15권12호
• /
• pp.987-995
• /
• 2003

The performance of a residential heating and cooling system with $CO_2$ is predicted by using a cycle simulation model. The simulations are conducted by varying design parameters and operating conditions. The efficiency of the transcritical cycle can be improved by utilizing the advantages in heat transfer characteristics of $CO_2$ and developing microchannel indoor and outdoor heat exchangers. For the designed system of this study, the predicted COP of the heat pump system is approximately 3.5 in the heating mode and 3.0 in the cooling mode. The predicted optimal discharge pressure for the heat pump system is approximately 11 MPa in the heating mode and 9 MPa in the cooling mode.

• Journal of Power Electronics
• /
• 제17권1호
• /
• pp.1-10
• /
• 2017

This paper presents a novel predictive digital control method for boundary conduction mode PFC converters without the need for detecting the inductor current. In the proposed method, the inductor current is predicted by analytical equations instead of being detected by a sensing-resistor. The predicted zero-crossing point of the inductor current is determined by the values of the input voltage, output voltage and predicted inductor current. Importantly, the prediction of zero-crossing point is achieved in just a single switching cycle. Therefore, the errors in predictive calculation caused by parameter variations can be compensated. The prediction of the zero-crossing point with the proposed method has been shown to have good accuracy. The proposed method also shows high stability towards variations in both the inductance and output power. Experimental results demonstrate the effectiveness of the proposed predictive digital control method for PFC converters.

• 대한용접접합학회:학술대회논문집
• /
• 대한용접접합학회 2006년도 춘계 학술대회 개요집
• /
• pp.307-309
• /
• 2006

For efficient NDE of pipes, essential components of power plant facilities, ultrasonic guided waves were generated and received applying an air-coupled transducer and comb one as non-contact technology, Mode generation and selection were predicted based on theoretical dispersive curve and the element spaceof a comb transducer. In addition, a receiving angle of the air-coupled transducer was determined to acquire the predicted modes by theoretical phase velocity of each mode. Theoretical dispersive curve was compared with the results of the time-frequency spectroscopes based on the wavelet transform and 2D-FFT to identify the characteristics of the received mode. The received modes show a good agreement with the predicted ones.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2012년도 추계학술대회 논문집
• /
• pp.516-519
• /
• 2012

This study proposes a method of an equivalent bell model in order to tune the beat period of a Korean bell. In a Korean bell having a slight asymmetry, each circumferential mode splits into a mode pair which has a slight difference in frequency, and the interaction of the mode pair makes a beat in vibration and sound. An equivalent bell model which consists of an axi-symmetric bell and an equivalent point mass, has the same mode property as in a real bell. The equivalent bell model is constructed by the finite element analysis based upon the theory of a revolutionary shell Using the equivalent bell model, the beat period is predicted when the bell thickness is locally decreased to improve the beat property. The predicted result is verified by experiment on a test bell. The proposed method is useful to save the time required for tuning the beat period of a large bell.

• 환경영향평가
• /
• 제7권1호
• /
• pp.63-70
• /
• 1998

TCM has been used for many environmental impact assessments in Korea. But there was reported that an error was found in area source calculation of original TCM and modified. In this study, TUM(TCM-urban mode) and TRM(TCM-rural mode) were developed for urban and rural area by modification of original TCM. McElroy-Pooler dispersion parameter was used for area and point source in TUM, Pasquill-Gifford parameter was used for area and point source in TRM. And Irwin's vertical wind speed profile exponents were used for TUM and TRM. Then predicted value by TUM, TRM and a value from the same area and point data by CDM2, ISCLT3 were compared. And it was found that predicted value from point source by TUM, TRM was very similar to a value by CDM2, ISCLT3, and predicted value from area source by TRM was similar to a value by CDM2, ISCLT3. But predicted value from area: source by TUM was an half lower than a value by CDM2, ISCLT3.

• 한국근적외분광분석학회:학술대회논문집
• /
• 한국근적외분광분석학회 2001년도 NIR-2001
• /
• pp.1524-1524
• /
• 2001

A previous paper(Ito et al., 2000) has described the improvement of the standard error(SEC and SEP) of the predicted soluble solids(Brix) in a melon cultivar by non-contact mode with a fiber optic probe. Then we examined the immature and mature fruits. The objective of this study was to determine if non-contact mode could improve the standard error of the predicted Brix of matured melon fruits from cross progeny as well as the contact mode(usual method). The optical absorption spectrum was measured using a NIR Systems model 6500 spectrophotometer. A commercial spectral program(NSAS ver. 3.27) was used for multiple linear regression analysis. Absorbances of 902 and in the vicinity of 877 nm were included as the independent variables in both multiple regression equations. These wavelengths are key wavelengths for non-destructive Brix determination. When the results for the contact mode and non-contact mode are compared, the latter mode improved the former standard error(SEP and RMS).

• IEIE Transactions on Smart Processing and Computing
• /
• 제5권5호
• /
• pp.323-326
• /
• 2016

High Efficiency Video Coding (HEVC) adopts intra transform skip mode, in which a residual block is directly quantized in the pixel domain without transforming the block into the frequency domain. Intra transform skip mode provides a significant coding gain for screen content. However, when intra-prediction errors are not transformed, the errors are often correlated along the intra-prediction direction. This paper introduces a residual differential pulse code modulation (DPCM) method for the intra-predicted and transform-skipped blocks to remove redundancy. The proposed method performs pixel-by-pixel residual prediction along the intra-prediction direction to reduce the dynamic range of intra-prediction errors. Experimental results show that the transform skip mode's Bjøntegaard delta rate (BD-rate) is improved by 12.8% for vertically intra-predicted blocks. Overall, the proposed method shows an average 1.2% reduction in BD-rate, relative to HEVC, with negligible computational complexity.

• 한국음향학회지
• /
• 제27권7호
• /
• pp.365-371
• /
• 2008

본 연구에서는 미소 비대칭 링을 대상으로, 맥놀이의 주기를 조절하는 실용적 기법을 제시한다 미세한 비대칭성은 하나의 링 모드를 근접한 주파수를 갖는 모드 쌍으로 분리시키는데, 이 모드 쌍이 동시에 가진되면 근접한 주파수 성분이 간섭함으로써 진동과 음향의 맥놀이가 발생한다. 단순화된 종형상의 링 시편을 대상으로 모드 쌍 데이터를 정밀 측정하고, 측정된 모드 쌍 조건을 만족하는 등가 링 모델을 만든다. 등가 링에 대한 유한요소해석을 통하여, 질량을 부착시키거나 두께를 감소시킬 때, 모드 쌍의 조건 변화를 예측하고 맥놀이 주기를 조절하는 방법을 제시한다. 구조변경에 따른 맥놀이 주기 변화의 예측치와 측정치를 비교하여 제시된 맥놀이 조절기법의 타당성을 검증한다.

• 방송공학회논문지
• /
• 제19권2호
• /
• pp.158-165
• /
• 2014

최신 동영상 압축 표준 기술인 HEVC (High Efficiency Video Coding)는 기존의 AVC/H.264와 비교하여 동일 화질 대비 약 2배의 높은 압축률을 보여준다. 하지만 이러한 성능을 얻기 위하여 복잡한 연산이 필요한 기법들을 많이 도입한 결과, HEVC의 시간 복잡도는 AVC/H.264보다 더욱 증가하게 되었다. 이러한 문제를 해결하기 위하여 다양한 고속 알고리즘 연구가 진행되고 있다. 본 논문에서는 HEVC에 구현된 RMD (Rough Mode Decision)의 결과와 MPM (Most Probable Mode)을 활용하여 고속화된 최적 예측 모드 결정 방법을 제안한다. 제안한 방법은 RMD 과정에서 계산한 예측 방향과 MPM 도출 과정에서 계산한 예측 방향을 비교하여 최적 예측 방향을 선정한다. 이 방법을 All-Intra 환경에서 실험한 결과, 평균 0.8%의 BD-rate 손실이 발생하였고 전체 부호화 실행 시간은 평균 26% 감소하였다.

• 한국통신학회논문지
• /
• 제37권3A호
• /
• pp.157-162
• /
• 2012

본 논문에서는 후보 모드표를 이용한 새로운 화면내 모드 부호화 방법을 제안한다. 기존의 HEVC는 예측한 최고확률모드(most probable mode, MPM)가 현재 블록의 실제 모드와 동일하지 않을 경우 고정길이 부호(fixed length code, FLC)를 이용해 실제 모드 정보를 이진화한다. 하지만 HEVC는 화면내 블록은 많은 수의 모드를 사용하기 때문에 FLC를 이용해 이진화를 하면 코드워드의 길이가 길어진다. 본 논문에서는 예측한 MPM이 실제 모드와 동일하지 않은 경우 인접한 블록을 통해 생성한 후보 모드표를 이용해 부호화할 인덱스를 얻고, 이를 FLC 대신 통계적 특성을 고려한 Golomb-Rice 코드를 이용해 이진화하는 방법을 제안한다. 실험을 통해 제안한 방법이 기존의 HEVC 화면내 모드 부호화 방법에 비해 평균 약 0.5%의 비트 수를 감소시키는 것을 확인했다.