• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.3
• /
• pp.93-98
• /
• 2017

This paper relates with the robustness performance improvement of QE-MMA (Quantized Error-MMA) adaptive equalization algorithm based on the dithering in order to reduce the intersymbol interference by nonlinear distortion occurs at channel. The QE-MMA was appeared for the easiness of H/W implementation in place of multiplication to shifting in the tap coefficient updates applying the power-of-two operation to the magnitude of error signal in currently SE-MMA, it's performance were degraded by this. For improving it's performance, the proposed DQE-MMA adds the dither signal which has constant statistical characteristics in the prestage of power-of-two operation. It was confirmed by simulation that the DQE-MMA gives better robustness performance than current QE-MMA in the same channel and signal to noise ratio.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.5
• /
• pp.1638-1653
• /
• 2014

A sequential optimization algorithm (SOA) for resource allocation in a cyclic-prefixed single-carrier cognitive relay system is proposed in this study. Both subcarrier pairing (SP) and power allocation are performed subject to a primary user interference constraint to minimize the mean squared error of frequency-domain equalization at the secondary destination receiver. Under uniform power allocation at the secondary source and optimal power allocation at the secondary relay, the ordered SP is proven to be asymptotically optimal in maximizing the matched filter bound on the signal-to-interference-plus-noise ratio. SOA implements the ordered SP before power allocation optimization by decoupling the ordered SP from the power allocation. Simulation results show that SOA can optimize resource allocation efficiently by significantly reducing complexity.

• Journal of Power Electronics
• /
• v.15 no.3
• /
• pp.796-805
• /
• 2015

New direct and indirect current control methods for a fault-tolerant active power filter topology are presented in this paper. Since a three-phase four-switch topology has a phase bridge current which cannot be directly controlled, a hysteresis control method in the α-β plane which controls the three-phase current in the two-phase stationary coordinate system is proposed. The improved SVPWM algorithm is able to eliminate the operation of the trigonometric functions in the traditional algorithm by rotating the α-β coordinates and alternating the sequence of the output vectors, which in turn simplifies the algorithm and reduces the switching frequency. The selection of the DC-side reference voltage and DC-side capacitor equalization strategy are also discussed. Simulation and experiments demonstrate that the proposed control method is correct and feasible.

• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.1350-1354
• /
• 2007

As the importance of low power design is emphasized, power consumption became one of the standards that represent the performance of the system. The purpose of this study is to decide design variable that minimize power consumption for the oxygen concentrator in two bed-one compressor 8 step PSA process that has above 90% purity at 3lpm by using given constants and selected parameters. Setting selected parameters as cycle time and equalization time, optimization for PSA process in the oxygen concentrator is progressed. For this, we need to know the features and basic principals of PSA process and to deduce objective function of performance analysis. Validations for objective function and lots of experiments are needed too. By using the characteristic curve of the compressor and the pressure curve of the process for 1 cycle, objective function was set. After theoretical 2 dimensional optimized paths was obtained. And then, by experiment, theoretical optimized path was verified.

• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.90-94
• /
• 1998

The parallel inverter is popularly used because of its fault-tolerance capability, high-current outputs at constant voltages and system modularity. The conventional parallel inverter usually employes active and reactive power control or frequency and voltage droop control. However, these approaches have the disadvantages that the response time of parallel inverter control is slow against load and system parameter variation to calculate active, reactive power, frequency and voltage. This paper describes a novel control scheme for power equalization in parallel connected inverter. The proposed scheme has a fast power balance control response, a simplicity of implementation, and inherent peak current limiting capability since it employes a instantaneous current/voltage control with output voltage and current balance and output voltage regulation. A design procedure for the proposed parallel inverter controller is presented. Futhermore, the proposed control scheme is verified through the simulation in various cases such as the system parameter variation, the control parameter variation and the nonlinear load condition.

• Proceedings of the KIPE Conference
• /
• 1998.10a
• /
• pp.176-181
• /
• 1998

The parallel inverter is popularly used because of its fault-tolerance capability, high-current outputs at constant voltages and system modularity. The conventional parallel inverter usually employs active and reactive power control of frequency and voltage droop control. However, these approaches have the disadvantages that the response time of parallel inverter control is slow against load and system parameter variation to calculate active, reactive power, frequency and voltage. This paper describes a novel control scheme for power equalization in parallel-connected inverter. The proposed scheme has a fast power balance control response, a simplicity of implementation, and inherent peak current limiting capability since it employees an instantaneous current/voltage control with output voltage and current balance and output voltage regulation. A design procedure for the proposed parallel inverter controller is presented. Furthermore, the proposed control scheme is verified through the experiment in various cases such as the system parameter variation, the control parameter variation and the nonlinear load condition.

• Journal of electromagnetic engineering and science
• /
• v.4 no.1
• /
• pp.23-29
• /
• 2004

In this paper we analyze convergence constraints and time constant of IT-LMS algorithm and derive a method of making it's time constant independent of signal power by using input variance estimation. The method for estimating the input variance is to use a single-pole low-pass filter(LPF) with common smoothing parameter value, θ. The estimator is with narrow bandwidth for large θ but with wide bandwidth for small θ. This small θ gives long term average estimation(low frequency) of the fluctuating input variance well as short term variations (high frequency) of the input power. In our simulations of multipath communication channel equalization environments, the method with large θ has shown not as much improved convergence speed as the speed of the original IT-LMS algorithm. The proposed method with small θ=0.01 reach its minimum MSE in 100 samples whereas the IT-LMS converges in 200 samples. This shows the proposed, tap-power normalized IT-LMS algorithm can be applied more effectively to digital wireless communication systems.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.2
• /
• pp.97-102
• /
• 2020

This paper relates with the Hybrid-SE-MMA (Signed-Error MMA) that is possible to improving the equalization performance by using the adaptive modulus and adaptive step size in SE-MMA adaptive equalizer for the minimizing the intersymbol interference. The equalizer tap coefficient is updatted use the error signal in MMA algorithm for adaptive equalizer. But the sign of error signal is used for the simplification of arithmetic operation in SE-MMA algorithm in order to updating the coefficient. By this simplification, we get the fast convergence speed and the reduce the algorithm processing speed, but not in the equalization performance. In this paper, it is possible to improve the equalization performance by computer simulation applying the adaptive modulus to the SE-MMA which is proposional to the power of equalizer output signal. In order to compare the improved equalization performance compared to the present SE-MMA, the recovered signal constellation that is the output of the equalizer, residual isi, MD(maximum distortion), MSE and the SER perfomance that means the robustness to the external noise were used. As a result of computer simulation, the Hybrid-SE-MMA improve equalization performance in the residual isi and MD, MSE, SER than the SE-MMA.

• Journal of Power Electronics
• /
• v.18 no.4
• /
• pp.1211-1222
• /
• 2018

This study presents a power distribution control scheme for a three-phase interleaved parallel DC/DC converter in a battery energy storage system. To extend battery life and increase the power equalization rate, a control method based on the nth order of the state of charge (SoC) is proposed for the charging and discharging processes. In the discharging process, the battery sets with high SoC deliver more power, whereas those with low SoC deliver less power. Therefore, the SoC between each battery set gradually decreases. However, in the two-stage charging process, the battery sets with high SoC absorb less power, and thus, a power correction algorithm is proposed to prevent the power of each particular battery set from exceeding its rated power. In the simulation performed with MATLAB/Simulink, results show that the proposed scheme can rapidly and effectively control the power distribution of the battery sets in the charging and discharging processes.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.2
• /
• pp.67-72
• /
• 2021

This paper compare the adative equalization performance of the DSE-MMA (Dithered Signed-Error MMA) and QE-MMA (Quantized-Error MMA) which has a simplifies the computational operation of currently used MMA algorithm. The DSE-MMA possible to improve the rubustness to noise by using the dithered signal consider the polarity of error signal in the multiplication part. In QE-MMA, it use the polarity of error signal after performing the nonlinear power-of-two quantizing operation for easiness of H/W implementation. The same channel environment was applied, and it's performance of the output signal constellation, the residual isi and maximum distortion and MSE that means the convergence characteristics, the SER that means the robustness of external noise of algorithm were compared and evaluated. As a result of computer simulation, the QE-MMA has more good in constellation, residual isi, maximum distortion, MSE performanc than DSE-MMA. In SER, the DSE-MMA has more robust due to dither signal than QE-MMA.