• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.04a
• /
• pp.116-119
• /
• 1997

We investigated new type non-robbing liquid crystal (LC) alignment techniques in the cell with slanted non-polarized ultraviolet (UV) irradiation on polyimide (Pl) film. It is shown that the uniform alignment for nematic (N) LC is obtained by using slanted non-polarized UV irradiation on Pl surface. We successfully obtained that the pretilt ang1e of NLC is generated about 3 degree in the LC cells by using slanted non-polarized UV irradiation with 70 degree on Pl surface. We consider that the pretilt angle generation for NLC is attributed to interaction between the LC molecular and the PI surface. We conclude that the uniform LC alignment is attributed to anisotropic dispersion force effect due to photo depolymerization of polymer on Pl surface.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.5 no.6
• /
• pp.563-567
• /
• 2010

In this paper, circularly polarized micro-strip GPS of 1.57 GHz and DMB of 2.63~2.65GHz antenna have been studied. In order to improve of frequency properties, parameters such as patch size, corner truncated type, and feed positions were simulated using HFSS program. GPS and DMB antenna were fabricated and characteristics were measured using network analyzer.

• Journal of electromagnetic engineering and science
• /
• v.7 no.3
• /
• pp.122-128
• /
• 2007

In this paper, we present the design and measurement of a side-fed circularly-polarized patch antenna with a dielectric loading. The antenna consists of a comer-truncated rectangular patch, an L-shaped ground plane, a dielectric loading material, and a coaxial probe. An antenna operating at the UHF band (910 MHz) for the RFID reader applications is optimized using a commercial software. The size of the patch is reduced by a factor of 1.73 by loading the patch with mono-cast(MC) nylon. Measurements of the fabricated antenna show performance characteristics comparable to those of much larger commercial RFID reader antennas.

• Journal of information and communication convergence engineering
• /
• v.16 no.3
• /
• pp.197-202
• /
• 2018

This paper reveals the impact of the insertion of electromagnetic band gap (EBG) structures on the performance of circularly polarized (CP) patch-slot antenna with offset slot. Several optimizations are necessary to precise physical parameters in the aim to fix the resonance frequency at 3.2 GHz. The proposed antenna possesses lightweight, simplicity, low cost, and circular polarization ensured by two feeding sources to permit right-hand and left-hand circular polarization process (RHCP and LHCP). The measured results compared with simulation results of the proposed circularly polarized EBG antenna with offset slot show good band operations with –10 dB impedance bandwidths of 9.1% and 36.2% centered at 3.2 GHz, which cover weather radar, surface ship radar, and some communications satellites bands. Our investigation will confirm the simulation and experimental results of the EBG antenna involving new EBG structures.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1607-1610
• /
• 2005

A new configuration of LCD projectors for polarized stereoscopic projection having no light loss in the polarization process is suggested. In the proposed system, two polarizing filters that are employed in the conventional LCD polarized stereoscopic projection system causing additional light loss and image distortion are excluded by taking into account of polarization property of the LCD projector and image processing techniques. From some experimental results by using the Type-1 LCD projectors, light loss of the proposed system occurring in the polarization process is found to be zero.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.8
• /
• pp.731-735
• /
• 2002

Electro-optical (EO) performances for the twisted-nematic (TN)-liquid crystal display (LCD) photoaligned with linearly polarized UV exposure on the poly［4- (fluorocinnamate) phenylmaleimide](PFCPMI) surfaces using a new photodimerization method were investigated. For a new UVLPH (UV linearly polarized during heating) photodimerization method, the photopolymer layers were exposed by linearly polarized UV dichroic polarizer without a specific UV filter during heating at $150^{\circ}C$. The Voltage-transmittance (V-T) curve without backflow bounce in the photoaligned TN-LCD with UV exposure on the PFCPMI surface for 10 min using the UVLPH photodimerization method was observed. For response time measurement, the transmittance characteristics of the photoaligned TN-LCD using the UVLPH photodimerization method on the photopolymer surface was better than that of the photoaligned TN-LCD using the UVLP photodimerization method under a room temperature.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.2
• /
• pp.139-144
• /
• 2001

In this study, we have investigated the photoinduced birefringence of Ag plarized-photodoping in double-layer of Ag doped chalcognide thin films and dependence of polarization states in chalcogenide thin films. Also, we have investigated the polarization dependence of photoinduced birefringence and the anisotropy of absorption in an amorphous As$\sub$40/Ge$\sub$10/Se$\sub$15/S$\sub$35/ chalcogenide thin films using two 632.8nm He-Ne lasers, which have a smaller energy than the optical energy gap (E$\sub$OP/) of the film, i.e., an exposure of sub-bandgap light (hν$\sub$op/). The photoinduced phenomena of Ag polarized-photodooping increasing the linear dichroism(d), about 84% and birefringence(Δn), about 23%. It will offer lots of information for the photodoping mechanism and analysis of chalcogenide thin films.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.7
• /
• pp.595-599
• /
• 2001

The mechanisms of pretilt angle generation for a nematic liquid cystal (NLC) using a photodimerization method with obliquely polarized UV exposure on the various new photo-crosslinkable polymer were studied. A good thermal stability of all the photo-crosslinkable polymers was obtained by thermogravimetric analysis (TGA) measurement until 450$\^{C}$. High pretilt angle of the NLC was observed by polarized UV exposure on the three kinds of the photo-crosslinkable polymers containing biphenyl(BP), decyl(de), and cholesteryl(chol) group, respectively. However, the low pretilt angle of the NLC was measured by obliquely polarized UV exposure on the two kinds of the photo-crosslinkable polymers containing fluorine and chalcone group. Consequently, the high NLC angle generated is attributable to the biphenyl and alkyl moieties, and photo-dimerized chalcone group of the photopolymer.

• Proceedings of the KIEE Conference
• /
• 1998.07d
• /
• pp.1395-1397
• /
• 1998

In this paper, we studied the liquid crystal(LC) alignment and generation of pretilt angle in nematic (N) LC with oblique p-wave polarized ultraviolet (UV) light irradiation on the two kinds of the polyimide (PI) surface. The monodomain alignment of NLC is obtained with oblique p-wave polarized UV light irradiated on PI surface at 5$\sim$60min. We obtained that the pretilt angles of the NLC is generated about $2.1^{\circ}$ with angle of incidence of $30^{\circ}$ at 20min. Also, the pretilt angle of NLC decreases with increasing the imidization temperature on PI surface.

• ETRI Journal
• /
• v.31 no.1
• /
• pp.77-79
• /
• 2009

The wave concept iterative procedure (WCIP) is used to analyze a quasi-square open metallic ring frequency selective surface (FSS). The quasi-square open metallic ring FSS is dual-polarized. When the incident plane wave is polarized in a direction parallel to the FSS' coupled parallel strips, it shows two rejecting bands. Moreover, another rejecting band can be obtained if the source plane wave is perpendicularly polarized with respect to the FSS' coupled parallel strips. The three resonant frequencies are inversely proportional to the length of the FSS' coupled strips to provide an easy fine tuning of the FSS structure. The simulated results obtained using WCIP are compared to the measured results, and a good agreement is reported.