• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.10 no.1
• /
• pp.1-6
• /
• 2011

The Underground pipeline facility is a general but most important facility in modern world, but its maintainability has been left behind. An automated and intelligent management technology is needed to prevent the wast of social resource and security. In this paper, we introduce Pipeline Health Monitoring(PHM) with Ubiquitous Sensor Network(USN) for inexpensive structure safety monitoring system, and improve its utility by inventing the advanced impedance converter.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.10
• /
• pp.49-56
• /
• 2010

In this paper, a low-power frequency offset synchronization structure using CORDIC algorithm is proposed. Main blocks of frequency offset synchronization are estimation and compensation block. In the proposed frequency offset estimation block, implementation area is reduced by using sequential CORDIC, and throughput is accelerated by using 2 step CORDIC. In the proposed frequency offset compensation block, pipeline CORDIC is utilized for area reduction and high speed processing. Through MatLab simulation, function for proposed structure is verified. Proposed frequency offset synchronization structure is implemented by Verilog-HDL coding and implementation area is estimated by Synopsys logic synthesis tool.

• Journal of Ocean Engineering and Technology
• /
• v.30 no.4
• /
• pp.310-319
• /
• 2016

If a spoiler was attached to the pipeline investigated in a previous study, a strong flow and vortex at the lower part caused scouring and thus an asymmetric pressure distribution, which assisted in the analysis of the self-burial structure where a down force was applied to the pipe. However, only the fluid-pipe interaction was considered, excluding the medium (seabed), when practically burying the pipeline. Thus, this study applied a numerical model (LES-WASS-2D) to directly analyze the non-linear interactions among the fluid, pipe, and seabed in order to perform numerical simulations of a pipeline with a spoiler installed on the seabed. This allowed the self-burial mechanism of a pipeline with a spoiler to be analyzed in the same context as the previous study that considered only the fluid-pipe interaction. However, when a pipeline was installed on the seabed, a strong flow and vortex were found at the front of the bottom, and a spoiler accelerated the fluid resistances. This hydraulic phenomenon will reinforce the scouring and down force on the pipeline. In the general consideration of the numerical analysis results by the specifications and arrangements of the spoiler, a pipeline with a spoiler was found to be the most effective for the self-burial function.

• International conference on construction engineering and project management
• /
• 2015.10a
• /
• pp.744-745
• /
• 2015

Since the G20 summit in 2011, South Korea who was dependent on foreign energy needs of 97% receives natural gas from Russia from 2015 to 30 years, but South Korea is a situation of scarce experience and skills of pipeline project in permafrost area. In this study, we kept the target for analyzing the data and information flow of the pipeline projects in permafrost area, and the ultimate goal is set to developing the hierarchy structure of design and construction data for an efficient administration of the project. In order to develop that structure, Configuration Management was introduced and through this method, it is expected to be used to build the overall information management system in O&M phase.

• Journal of IKEEE
• /
• v.20 no.1
• /
• pp.75-81
• /
• 2016

This paper proposes a design of the tile based on graphic pipeline to improve the graphic application performance in SIMT based GP-GPU. The proposed Tile based on graphics pipeline avoids unnecessary graphic processing operation, and processes the rasterization step in parallel. The massive data processing in parallel through SIMT architecture improve the computational performance, thereby improving the 3D graphic pipeline performance. The more vertex data of 3D model, the higher performance. The proposed structure was confirmed to improve processing performance of up to 3 times from about 1.18 times as compared to 'RAMP' and previous studies.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 1991.04a
• /
• pp.29-33
• /
• 1991

This paper reports the application study of the ground reinforement under a buried pipeline subjected to differential settlement via a finite element modelling. The Soil-reinforrement interaction helps to mimimize the differential settlement between the adjoining pipe segments. The settlement pattern and deformation slope of a pipeline have been evaluated for a boundary condition at the joint between a rigid structure and apipeline. The analysis results are compared for both non-reinforied and reinforced cases to measure the effectiveness of the soil reinforcement for restraining the settlement of the pipeline.

• Journal of Advanced Research in Ocean Engineering
• /
• v.3 no.1
• /
• pp.1-14
• /
• 2017

The safety analysis of an earthquake is carried out during the operation of a subsea pipeline and an onshore pipeline. Several cases are proposed for consideration. In the case of a buried pipeline, permanent ground deformation by the earthquake and an increase of internal pressure by the acceleration of the earthquake should be considered. In the case of a subsea pipeline, a bending moment is caused by liquefaction of the backfill material on a trenched seabed, etc., which results in a high bending moment of the buried pipeline. The bending moment causes the collapse of the subsea pipeline or a leak of crude oil or gas, which results in economic loss due to enormous environmental contamination and social economic loss owing to operation functional failure. Thus, in order to prevent economic loss and operation loss, structurally sensitive design with regard to seismic characteristics must be performed in the buried pipeline in advance, and the negative impact on the buried pipeline must be minimized by conducting a thorough analysis on the seabed and backfilling material selection. Moreover, it is proposed to consider the selection of material properties for the buried pipeline. A more economical review is also required for detailed study.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.46 no.4
• /
• pp.157-164
• /
• 2009

An efficient pipeline MDC Radix-4 FFT structure is proposed in this paper. Every stages in pipeline FFT structure consists of delay' commutator and butterfly. Proposed butterflies in front and rear stages utilize CORDIC and Common Sub-expression Sharing(CSS) techniques, respectively. It is shown that proposed butterfly structure can reduce the number of adders through sharing common patterns of CSD type coefficients. The Verilog-HDL modeling and Synopsys logic synthesis results that the proposed structure show 48.2% cell area reduction in the complex multiplication part and 22.1% cell area reduction in overall 256-point FFT structure comparison with those of the conventional structures. Consequently, the proposed FFT structure can be efficiently used in various OFDM systems.

• Convergence Security Journal
• /
• v.16 no.7
• /
• pp.113-120
• /
• 2016

This paper presents a new high-speed SHA-1 pipeline architecture having a computation delay close to the maximum critical path delay of the original SHA-1. The typical SHA-1 pipelines are based on either a hash operation or unfolded hash operations. Their throughputs are greatly enhanced by the parallel processing in the pipeline, but the maximum critical path delay will be increased in comparison with the unfolding of all hash operations in each round. The pipeline stage logics in the proposed SHA-1 has the latency is similar with the result of dividing the maximum threshold delay of a round by the number of iterations. Experimental results show that the proposed SHA-1 pipeline structure is 0.99 and 1.62 at the operating speed ratio according to circuit size, which is superior to the conventional structure. The proposed pipeline architecture is expected to be applicable to various cryptographic and signal processing circuits with iterative operations.

• The Magazine of the IEIE
• /
• v.23 no.11
• /
• pp.89-100
• /
• 1996

A new stage-sliced pipiline structure is presented to design a high speed real time Global Positional Systems(GPS) applications. The CORDIC algorothm was revised to generate a pipeline structure, which will be used to produce a large amount of trigonometric computations rapidly. A stage-sliced approach was introduced to adjust the number of interative processes, and thereby to control the precision of computation results. Both the computation and the control circuits of the proposed architecture are included in a pipeline stage, which are intergrated into a stage slice. The circuit was prototyped using six FPGA chips : one is used for glue logics and five of the chips are used for pipeline slice implementation. A single FPGA chip comprising 7 pipeline stages provides one pipeline slice. To compensate and inter-slice time delay, dummy cycles are introduced in inter-slice signal exchanges.