• Proceedings of the KIEE Conference
• /
• 2007.04b
• /
• pp.35-36
• /
• 2007

We investigated the characteristics of three phase flux-lock type SFCL. Three phase flux-lock type consists of three reactor wound on an iron core in each single phase and the secondary coil is connected to the superconducting elements in series. the superconducting elements with serial connection were quenched simultangously in the single line-to-ground fault.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.05a
• /
• pp.46-48
• /
• 2006

We investigated the analysis of operation mode of three-phase flux-lake type superconducting fault current limiter(SFCL). The structure of the integrated three-phase flux-lock type SFCL consisted of three-phase flux-lock reactor wound on an iron core with the same turn between coil 1 and coil 2 in each phase. When the SFCL is operated under the normal condition, the flux generated in the iron core is zero because the flux generated between two coils of each single phase is canceled out. Therefore, the SFCL's impedance is zero and the SFCL has negligible influence on the power system, However, if a fault occurs in any single-phase among three phases, the flux generated in the iron core is not zero any more. The flux makes elements of all phase-quench irrespective of the fault type, which reduces the current of fault phase as well as the current of sound phase.

• Journal of Electrical Engineering and Technology
• /
• v.7 no.1
• /
• pp.69-74
• /
• 2012

This paper presents a distributed winding type axial flux permanent magnet synchronous generator (AFPMSG) with reduced the total harmonic distortion (THD), suitable for wind turbine generation systems. Although the THD of the proposed distributed winding type is more reduced than the concentrated winding type, the unbalance of the phase back EMF occurs. To improve the unbalance of the phase back EMF and the output power of the distributed winding type AFPMSG, the Kriging based on the latin hypercube sampling (LHS) is utilized. Finally, these optimization results are confirmed by experimental results. As a result, the unbalance of the phase back EMF and the output power of the distributed winding type AFPMSG were improved while maintaining the total harmonic distortion (THD) and the average phase back EMF.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.3
• /
• pp.308-315
• /
• 2002

In this paper, the 5-bit digital phase shiftier with 10 InGaAs HEMTs is designed and fabricated for U.S. mobile DBS receiving active phased array antenna system in 12 GHz band. 11.25 $^{\circ}$, 22.5$^{\circ}$ and 45$^{\circ}$ phase bits are designed in leaded-line type. 90$^{\circ}$ and 180$^{\circ}$ phase bits are designed in reflection type combined with ring hybrid. The return loss more than 17.5 ㏈, insertion louts less than 7.8 ㏈, and maximum phase error of $\pm$6$^{\circ}$for 32 phase responses are measured in 12.2 GHz~ 12.7 GHz band.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.39-40
• /
• 2007

The analysis of fault current limiting characteristics according to variation of fault current level in the integrated three-phase flux-lock type superconducting fault current limiter (SFCL), which consisted of three-phase flux-lock reactor wound on an iron core with the same turn's ratio between coil 1 and coil 2 for each single phase, was performed. To analyze the current limiting characteristics of this integrated three-phase flux-lock type SFCL, the short circuit experiments was carried out the various three-phase faults such as the single line-to-ground fault, the double line-to-ground fault, the triple line-to-ground fault. From the experimental results, the fault current limiting characteristic was improved according to increase of fault current level.

• Proceedings of the KIEE Conference
• /
• 2005.07b
• /
• pp.960-962
• /
• 2005

In this paper, we investigated the quench characteristics of high-Tc superconducting(HTSC) elements in the integrated three-phase flux-lock type superconducting fault current limiter(SFCL) according to fault types such as the single-line-to-ground fault, the double-line-to-ground fault, the line-to-line fault and the triple-line-to-ground fault. The integrated three-phase flux-lock type SFCL is an upgrade version of single-phase flux-lock type SFCL. The structure of the integrated three-phase flux-lock type SFCL consisted of a three-phase flux-lock reactor wound on an iron core with the ratio of the same turn between coil 1 and coil 2 in each phase. When the SFCL is under the normal condition, the flux generated in the iron core is zero because the flux generated between two coils of each single phase is canceled out. Therefore, the SFCL's impedance is zero, and the SFCL has negligible influence on the power system. However, if a fault occurs in any single one of three phases, the flux generated in the iron core is not zero any more. The flux makes HTSC elements of all phases to quench irrespective of the fault type, which reduces the current in fault phase as well as the current of sound phase. It was obtained that the fault current limiting characteristics of the suggested SFCL were dependent on the quench characteristics of HTSC elements in all three phases.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.8
• /
• pp.1581-1586
• /
• 2012

In this paper, a novel resonator using ring type DGS is proposed for improvement of phase noise characteristics that is weak point of oscillator using planar type microstrip line resonator, and oscillator for 5.8GHz band is designed using proposed DGS resonator. The ring type DGS resonator is composed of DGS cell etched on ground plane under $50{\Omega}$ microstrip line. At the fundamental frequency of 5.8GHz, 7.6dBm output power and -82.7 dBc@100kHz phase noise have been measured for oscillator with ring type DGS resonator. The phase noise characteristics of oscillator is improved about 9.5dB compared to one using the general ${\lambda}/4$ microstrip resonator. Because it is possible that varactor diode or lumped capacitor is placed on the gaps of ring type DGS, resonant frequency can be controlled by bias voltage. We can design voltage controlled oscillator using proposed ring type DGS resonator. Thus, due to its simple fabrication process and planar type, it is expected that the technique in this paper can be widely used for low phase noise oscillators for both MIC and MMIC applications.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.1
• /
• pp.131-137
• /
• 2009

In this paper, we have manufactured hole type PRAM unit cell using phase change material $Ge_2Sb_2Te_5$. The phase change material $Ge_2Sb_2Te_5$ was deposited on hole of 500 nm size using sputtering method. Reset current of PRAM unit cell was confirmed by measuring R-V characteristic curve. Reset current of manufactured hole type PRAM unit cell is 15 mA, 100 ns. And electro and thermal characteristics of hole type PRAM unit cell were analyzed by 3-D finite element analysis. From simulation temperature of PRAM unit cell was $705^{\circ}C$.

• Economic and Environmental Geology
• /
• v.38 no.6 s.175
• /
• pp.699-705
• /
• 2005

In order to identify the speciation of As and trace elements which are contained weathered waste rocks on the abandoned Jangpoong Cu mine area, five fraction sequential extraction was carried out. Concentrations of the extraction solutions which were acquaired each fraction were mesured by ICP-AES. Mineral characters of weathered waste rocks were determinated by XRD. The weathered waste rocks could divide into two types (Type I and type II). Type land type II weathered waste rocks are mainly composed of a quartz and a calcite, respectively. The most dominant speciation of As, Co and Fe is residual phase. Most of the speciation of Cd, Mn and Zn is residual phase for type I and Fe-Mn oxide phase for type II. In case of Cu, residual phase is predominant in type I and sulfide is predominet in type II. The most dominant speciation of Pb for type I and type II is associated with the residual phase and Fe-Mn oxide phase, respectively. At pH 4-7 range, the order of relative mobility considers Zn>Cu>Cd>Pb>Co>AS in type I, and Cd>Cu>Zn>Pb>As>Co in type II.

• Korean Journal of Applied Biomechanics
• /
• v.16 no.2
• /
• pp.45-53
• /
• 2006

The purpose of this study was to analyze exercise related mechanical variables according to performance levels and Kumi-kata types in elite judo players (G1) and non-elite judo players, namely university players (G2). To achieve this purpose, three players in G1 whose main special skill was Morote-Seoinage and three university judo players(G2) was selected as comparative group. Then they were examined for distinguishing A and B types of Kumi-kata. Analyzed variables were the time required to show skills, knee degree, elbow degree. After analysing this study, conclusions were derived as follows. 1. In total necessary time of showing skills according to group of Kumi-kata type, G2 was longer than G1 in both A type (20.9%) and B type (23.7%). In necessary time of phase, in only 3P, G1 was shorter than G2 in A type (50%) and B type (75%). There was no difference in time required of 1P and 2P according to Kumi-kata type of group and in only 3P, B type was shorter than A type in both B type (75%) of G1 and B type (50%) of G2 2 There was no difference in elbow degree of offensive arm according to group of Kumi-kata type, however in A and B types, G1 could use skills by extending in kake phase, but G2 could use skills by bending. Elbow degree of offensive arm according to Kumi-kata type of group showed difference in E1. and F2 of G1. A and B types of G1 extended elbow degree in Kake phase, but G2 bent elbow degree so exercise program which could movable range extensively in Kake phase is needed.