• Korean Chemical Engineering Research
• /
• v.60 no.2
• /
• pp.260-266
• /
• 2022

Average aggregate size in particulate suspensions is estimated with scaling theories based on fractal concept and elasticity of colloidal gel. The scaling theories are used to determine structure parameters of the aggregates, i.e., fractal dimension and power-law exponent for aggregate size reduction with shear stress using scaling behavior of elastic modulus and shear yield stress as a function of particle concentration. The structure parameters are utilized to predict aggregate size which varies with shear stress through rheological modeling. Experimentally rheological measurement is conducted for aqueous suspension of zinc oxide particles with average diameter of 110 nm. The predicted aggregate size is about 1135 nm at 1 s^-1 and 739 nm at 1000 s^-1 on the average over the particle concentrations. It has been found that the predicted aggregate size near 0.1 s^-1 agrees with that the measured one by a dynamic light scattering analyzer operated un-sheared.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.14 no.1
• /
• pp.214-224
• /
• 1990

A "two-fluid" model using thermal eddy diffusivity concept and Lumley's drag reduction theory, is proposed to analyze heat transfer of the turbulent dilute gas-particle flow in a vertical pipe with constant wall heat flux. The thermal eddy diffusivity is derived to be a function of the ratio of the heat capacity-density products .rho. over bar $C_{p}$ of the gaseous phase and the particulate phase and also of the ratio of thermal relaxation time scale to that of turbulence. The Lumley's theory dictates the variation of the viscous sublayer thickness depending on the particle loading ratio Z and the relative particle size $d_{p}$/D. At low loading ratio, the size of viscous sublayer thickness is important for suspension heat transfer, while at higher loading, the effect of the ratio .rho. $_{p}$ over bar $C_{p}$$_{p}$/ .rho. $_{f}$ over bar $C_{p}$$_{f}$ is dominant. The major cause of decrease in the suspension Nusselt number at lower loading ratio is found to be due to the increase of the viscous sublayer thickness caused by the suppression of turbulence near the wall by the presence of solid particles. Predicted Nusselt numbers using the present model are in satisfactory agreements with available experimental data both in pipe entrance and the fully developed regions.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.6
• /
• pp.581-586
• /
• 2010

Generally, electrokinetic potential has been considered as an intensive property. In other words, electrokinetic potential is not affected by the amount of particulate matter. Montmorillonite, one of essential inorganic matter, was chosen to measure electrokinetic potential. The result of electrokinetic potential measuring experiment showed that the value observed to decrease as the amount of montmorillonite clay increased. This is due to the fact that total ions that adsorbed per unit mass were decreased as the amount of montmorillonite was increased. As a result, electrokinetic potential is considered as an extensive property. By using these results, total interaction energy of suspension was also checked, and revealed that total interaction energy was decreased as the amount of montmorillonite increased.

• Korea-Australia Rheology Journal
• /
• v.20 no.1
• /
• pp.27-34
• /
• 2008

Clay suspensions in liquid polymers exhibit a time-dependent behaviour that includes viscoelastic as well as thixotropic features. Because of the presence of interacting clay platelets, particulate networks can develop, which are broken down during flow and rebuild upon cessation of the flow. Here, the use of thixotropic techniques in probing flow-induced structures in nanocomposites is explored with data on a hectorite-poly(isobutylene) model system. By means of fast stress jump measurements the hydrodynamic contributions to the steady state stresses are determined as well as those caused by the stretching of the clay floes. Flow reversal measurements do not provide a clear indication of flow-induced anisotropy in the present case. The recovery of the clay microstructure upon cessation of flow is followed by means of overshoot and dynamic measurements. The development of a particulate network is detected by the appearance and growth of a low frequency plateau of the storage moduli. The modulus-frequency curves after various rest times collapse onto universal master curves, regardless of the pre-shear history or temperature. The scaling factors for this master curve are the crossover parameters. The crossover moduli are nearly a linear function of the crossover frequency, the relation being identical for recovery after shearing at different shear rates. This function depends, however, on temperature.

• Biomolecules & Therapeutics
• /
• v.25 no.4
• /
• pp.452-459
• /
• 2017

In this study, the effect of particle size of genistein-loaded solid lipid particulate systems on drug dissolution behavior and oral bioavailability was investigated. Genistein-loaded solid lipid microparticles and nanoparticles were prepared with glyceryl palmitostearate. Except for the particle size, other properties of genistein-loaded solid lipid microparticles and nanoparticles such as particle composition and drug loading efficiency and amount were similarly controlled to mainly evaluate the effect of different particle sizes of the solid lipid particulate systems on drug dissolution behavior and oral bioavailability. The results showed that genistein-loaded solid lipid microparticles and nanoparticles exhibited a considerably increased drug dissolution rate compared to that of genistein bulk powder and suspension. The microparticles gradually released genistein as a function of time while the nanoparticles exhibited a biphasic drug release pattern, showing an initial burst drug release, followed by a sustained release. The oral bioavailability of genistein loaded in solid lipid microparticles and nanoparticles in rats was also significantly enhanced compared to that in bulk powders and the suspension. However, the bioavailability from the microparticles increased more than that from the nanoparticles mainly because the rapid drug dissolution rate and rapid absorption of genistein because of the large surface area of the genistein-solid lipid nanoparticles cleared the drug to a greater extent than the genistein-solid lipid microparticles did. Therefore, the findings of this study suggest that controlling the particle size of solid-lipid particulate systems at a micro-scale would be a promising strategy to increase the oral bioavailability of genistein.

• Textile Coloration and Finishing
• /
• v.8 no.1
• /
• pp.83-89
• /
• 1996

Carbon black has been used as a particulate soil to prepare artificial soiled fabrics for detergent study but it has two major defects. The one is the difficulty of quantitative analysis of carbon black for evaluate the detergency, the other is that there is no reliable correlation between the removal of carbon black and oily soil which is the major component of natural soil. In this study ferric oxinate was used as a particulate soil since it is in black color and can be soiled on fabric by suspension in water or by solution in chloroform and it is easily analysed quantitatively by extracting it from soiled fabric with chloroform to get correct value of soil removal. The characteristics of soil removal of ferric oxinate were compared with that of carbon black and Sudan black, an oil soluble dye, which had been proved that it's detergency correlated with that of oily soil The soil removal of ferric oxinate and Sudan black estimated from quantitative analysis and from K/S value were in good agreement whereas the result calculated by simple reflectance was consistently low. The soil removal of ferric oxinate was exceeded from that of carbon black without regard to surfactants, Triton and Las, but the effect of washing conditions such as temperature and washing time on soil removal of both soils with different suffactants showed no considerable difference. Though the soil removal of Sudan black was little effected by the conditions, the soil removal in Triton exceeded considerably that of in Las, which is the characteristic of oily soil. Thus the soil removal of Sudan black was in good agreement with ferric oxinate in Triton, a non-ionic surfactant, and with carbon black in Las, an artionic surfactant. We concluded that ferric oxinate is a more realistic model particulate soil for artificial soiled cotton fabric washed with non-ionic surfactant than carbon black.

• The Korean Journal of Rheology
• /
• v.9 no.2
• /
• pp.73-80
• /
• 1997

분말 입자 형태가 다른 2가지 스테인레스 강(SUS 316L)분말과 조성이 다른 2가지의 결합제를 이용하여 분말충전율의 변화를 가지도록 제조된 5가지 분말사출재에 대한 Bagley 보정 실험을 실시하여 Bagley 보정값에 대한 온도, 분말충전율, 분말 입자 형태 그리고 결 합제의 영향을 조사하였다. Bagley 보정값을 구하기 위한 자료 처리를 하는 과정에서 길이 가 긴 모세관(L/D=60) 의 압력손실이 Thixotropy에 의해서 감소한 현상을 발견하였다. 이는 모세관 점성측정기를 이용한 분말사출제의 점도 측정시 길이가 긴모세관의 사용이 바람직하 지 못하다는 것을 나타낸다. 분말사출재의 Bagley 보정값에 대한 온도와 결합제의 영향은 매우 미약하게 나타났는데 특히 결합제의 영향은 거의 나타나지 않는 것을 발견하였다. 분 말충전율과 분말 입자 형태의 Bagley 보정값에 대한 영향은 매우 크게 나타났으며 분말충 전율이 증가할수록 Bagley 보정값이 증가하고 분말 입자의 형태가 불규칙한 분말을 사용한 분말사출재의 보정값이 구형의 분말에 비해 높은 보정값을 나타냈다. 실험결과에 대한 고찰 결과, 분말사출재의 모세관 입출구에서 압력손실의 주 원인은 분말 이자간 마찰과 충돌이라 고 판단되었다.

• Journal of computational fluids engineering
• /
• v.6 no.4
• /
• pp.8-14
• /
• 2001

The phenomena of two-phase suspension flows appear widely in nature and industrial processes. Hence, it is of great importance to understand the mechanism of the gas-solid two-phase flows. In the present study, the numerical simulation has been approached by utilizing the Eulerian-Lagrangian methodology for describing the characteristics of the fluid and particulate phases in a vertical pipe and a 90°square-sectioned bend. The continuous phase(gas phase) is described by the Eulerian formulation and a κ-ε turbulence model is employed to find mean and turbulent properties of the gas phase. The particle properties(velocity and trajectory) are then described by a Lagrangian approach and computed using the mean velocity and turbulent fluctuating velocity of the gas phase. The predictions are compared with measurements by laser-Doppler velocimeter for the validation. As a result, the calculated results show good agreements.

• Journal of Korean Society on Water Environment
• /
• v.26 no.3
• /
• pp.525-531
• /
• 2010

To figure out the importance of temperature on electrochemical properties in water environment, calcium carbonate, one of important substances in water chemistry, was chosen to make suspensions. The result of electrokinetic potential of calcium carbonate suspensions revealed that it tended to increase as temperature increased. In addition, electrokinetic potential was negatively increased as suspensions became more basic. Its isoelectric point was ca. 7 regardless of temperature. The adsorption of hydrogen ions on calcium carbonate particles followed endothermic reaction. This result was verified by continuously measuring pH as adding HCl solution in calcium carbonate suspension. It explained that suspensions' potential was determined by DLVO theory which calculated total interaction energy between particles. Suspensions' total interaction energy was proportional to the value of electrokinetic potential. Furthermore, total interaction energy between particles increased as suspensions' temperature was increased.

• Journal of Aquaculture
• /
• v.14 no.1
• /
• pp.43-50
• /
• 2001

To study the effect of paddle wheel on water circulation, velocity components were measured in shrimp ponds both along the longitudinal direction from a single paddle wheel and at 25 grid points of two ponds, which have mean water depth of 1.2m and aspect ratio (length/width) 1.05 and 0.68, respectively. An analysis of factors related to water quality and circulation showed that I) a single paddle wheel has an effective distance of 33m for de-stratification, 16m for particulate suspension and 25m for removal of organic material, dispersion of DO and prevention of bed sediment disturbance and ii) with doubling the number of paddle wheels at the pond corners, the flow speed increased by 13% over the ponds, while it reduced by 8.5% around the pond centres. Contrary to expectation, increasing the number of paddle wheel did not generate strong circulation around the pond centre and improve water quality.