• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1C
• /
• pp.120-130
• /
• 2009

In this paper, we propose a receiver structure for frequency synchronization in OFDMA (Orthogonal Frequency Division Multiple Access) system which is considered as 3GPP LTE(Long Term Evolution) downlink. In general, OFDMA frequency synchronization consists of two parts: coarse synchronization and fine synchronization. We consider P-SCH (Primary-Synchronization Channel) and CP (Cyclic Prefix) of OFDMA symbol for coarse synchronization and fine synchronization, respectively. The P-SCH signal has two remarkable disadvantages that it does not have sufficiently many sub-carriers and its differential correlation characteristic is not good due to ZC (Zadoff Chu) sequence-specific property. Hence, conventional frequency synchronization algorithms cannot obtain satisfactory performance gain. In this paper, we propose a modified differential correlation algorithm to improve performance of the coarse frequency synchronization. Also, we introduce an effective PLL (Phase Locked Loop) structure to guarantee stable performance of the fine frequency synchronization. Simulation results verify that the proposed algorithm has superior performance to the conventional algorithms and the 2nd-order PLL is effective to track the fine frequency offset even in high mobility.

• Economic and Environmental Geology
• /
• v.42 no.5
• /
• pp.495-500
• /
• 2009

Actinide sorption to the geological materials can reduce the mobility and bioavailability of radionuclides released to the environment through the development of nuclear weapons and nuclear energy. Under circumneutral pH conditions, actinide sorption can be enhanced by phosphate anions sorbed on oxide mineral surfaces as indicated by the sorption of trivalent lanthanide ions ($Ln^{3+}$), the chemical analog for trivalent actinide ions ($Ac^{3+}$). In this paper, we examined a ternary sorption system of trivalent europium ions ($Eu^{3+}$) sorbed onto boehmite (${\gamma}$-AlOOH) surfaces pre-sorbed with phosphate anions (${PO_4}^{3-}$), using extended X-ray absorption fine structure (EXAFS) spectroscopy. In the Eu-$PO_4$-boehmite ternary sorption system, $EuPO_4$ surface precipitates were formed as implicated by Eu $L_{III}$-edge EXAFS spectroscopy. Phosphorus K-edge EXAFS fingerprinting indicated a bidentate mononuclear surface complex formation of phosphate sorbed on boehmite surfaces as well as $EuPO_4$ surface precipitate formation.

• Journal of Technology Innovation
• /
• v.17 no.2
• /
• pp.187-206
• /
• 2009

Korea needs to create, diffuse, and exploit scientific and technological knowledge effectively through transforming its national innovation system from imitative system to creative one. For this purpose, it is necessary for Korea to nurture creative human capital (CHC), which are the main actor of generating S&T and innovation. This paper aims at discussing the strategies of nurturing creative human capital of government-sponsored research institutes (GRIs). In this paper, we argue that the management of creative human capital is particularly important for Korean GRIs because they deals directly with scientific and technological activities. For effective management of GRIs' creative human capital, we suggest a Model for Life Cycle Management of Creative Human Capital. This model is composed of four stages: inviting well-qualified researchers, strengthening mobility of researchers, providing special certificates to excellent researchers, and effectively exploiting retired researchers. We emphasize that each stage should form and reinforce a virtuous cycle. This paper argues that GRIs' creative human capital should be nurtured as 'Inverse T-Type Manpower', who have not only deep knowledge on their own special S&T areas but also broad knowledge on related areas, based on this Life Cycle Management Model.

• Korean Journal of Family Social Work
• /
• no.55
• /
• pp.265-297
• /
• 2017

This study aims to provide basic information about the policy and system improvements relevant to single elderly men, through an investigation concerning the use and needs of activity spaces near their housing environments. Eighteen single elderly men over 60-years-old living in Gunsan city of Jeonbuk province in Korea participated in in-depth interview, and the data were qualitatively analyzed. The results of the study are as follows: The social networks of the participants were focused on friends or colleagues, while mutual exchanges with their children were intermittently undertaken. Natural networks of the elderly were formed mainly in third places, such as parks, restaurants, or community facilities, and about a half of the elderly participants had no spatial needs, and the rest required spaces for meal services, the elderly living community, jobs, leisure/hobby activities, or facility improvements. The elements influencing use of activity spaces were access from the residence, health, social networks, and economic conditions. The results suggest the following: Exercise or leisure facilities supporting elderly mobility should be set up close to their residential environments. Senior facilities centered on systematic supports and shuttle buses circulating around the places that the elderly visit frequently should be considered. On the other hand, regular maintenance and education on residents' proper use of the facilities, and sufficient information and fee discounts for the general programs are needed so that the elderly could interact with the younger generation. From a public perspective, a rational system and policy based on understanding single elderly men's needs should be prepared for provision and management of the activity space.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.4
• /
• pp.423-430
• /
• 2019

The convergence of the automotive industry and the ICT technology can be broadly divided into the commercial service sector and the Cooperative-ITS (C-ITS) service sector. The C-ITS service sector is using V2X communication technology as a field that aims to provide safer transportation, more green and efficient transportation, and more predictable and productive mobility. The recent convergence of self-driving cars and connected cars requires high data rates, low transmission delays, and low transmission error rates. Interest in comparison of performance between WAVE and C-V2X (LTE-V2X, 5G-V2X) has been amplified and application services by communication technology are being studied. In this paper, we design the application performance evaluation method of Hybrid V2X communication system and confirm that the decrease of packet error rate (PER) performance is caused by the increase of communication distance, not the vehicle speed.

• Applied Chemistry for Engineering
• /
• v.22 no.4
• /
• pp.376-383
• /
• 2011

The CMCs of LA and LA3 nonionic surfactants obtained from the reaction between glycidol and lauryl alcohol were found to be $0.97{\times}10^{-3}mol/L$ and $1.02{\times}10^{-3}mol/L$ respectively and the surface tensions for 1 wt% surfactant were 26.99 and 27.48 mN/m respectively. Dynamic surface tension measurements using a maximum bubble pressure tensiometer showed that the adsorption rate of surfactant molecules at the interface between the air and the surfactant solution was found to be relatively fast in both surfactant systems, presumably due to the high mobility of surfactant molecules. The contact angles of LA and LA3 nonionic surfactants were 27.8 and $20.9^{\circ}$ respectively and the dynamic interfacial tension measurement by a spinning drop tensiometer showed that interfacial tensions at equilibrium condition in both systems were almost the same. Also both surfactant systems reached equilibrium in 2~3 min. Both surfactant solutions showed high stability when evaluated by conductometric method and the LA nonionic surfactant system provided the higher foam stability than the LA3 nonionic surfactant system. The phase behavior experiments showed a lower phase or oil in water (O/W) microemulsion in equilibrium with an excess oil phase at all temperatures studied. No three-phase region was observed including a middle-phase microemulsion or a lamellar liquid crystalline phase.

• Korean Journal of Remote Sensing
• /
• v.38 no.5_2
• /
• pp.725-735
• /
• 2022

Currently, disasters occurring in Korea are characterized by unpredictability and complexity. Due to these features, property damage and human casualties are increasing. Since the initial response process of these disasters is directly related to the scale and the spread of damage, optimal decision-making is essential, and information of the site must be obtained through timely applicable sensors. However, it is difficult to make appropriate decisions because indiscriminate information is collected rather than necessary information in the currently operated Disaster and Safety Situation Office. In order to improve the current situation, this study proposed a framework that quickly collects various disaster image information, extracts information required to support decision-making, and utilizes it. To this end, a web-based display system and a smartphone application were proposed. Data were collected close to real time, and various analysis results were shared. Moreover, the capability of supporting decision-making was reviewed based on images of actual disaster sites acquired through CCTV, smartphones, and UAVs. In addition to the reviewed capability, it is expected that effective disaster management can be contributed if institutional mitigation of the acquisition and sharing of disaster-related data can be achieved together.

• Journal of Cadastre & Land InformatiX
• /
• v.52 no.1
• /
• pp.105-118
• /
• 2022

The demand for information related to 3D spatial objects model in metaverse, smart cities, digital twins, autonomous vehicles, urban air mobility will be increased. 3D model construction for spatial objects is possible with various equipments such as satellite-, aerial-, ground platforms and technologies such as modeling, artificial intelligence, image matching. However, it is not easy to quickly detect and convert spatial objects that need updating. In this study, based on spatial information (features) and attributes, using matching elements such as address code, number of floors, building name, and area, the converged building DB and the detected building DB are constructed. Both to support above and to verify the suitability of object selection that needs to be updated, one system prototype was developed. When constructing the converged building DB, the convergence of spatial information and attributes was impossible or failed in some buildings, and the matching rate was low at about 80%. It is believed that this is due to omitting of attributes about many building objects, especially in the pilot test area. This system prototype will support the establishment of an efficient drone shooting plan for the rapid update of 3D spatial objects, thereby preventing duplication and unnecessary construction of spatial objects, thereby greatly contributing to object improvement and cost reduction.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.50 no.12
• /
• pp.899-907
• /
• 2022

According to the Unmanned aircraft system Traffic Management (UTM), drones are permitted to fly up to 150m above ground, which is located in the atmospheric boundary layer where there is considerable wind fluctuation due to turbulence. Although it is difficult to predict when turbulence will occur drone aviation safety could be enhanced by having a better understanding of the characteristics of vertical profile of wind in the flight area. We used wind lidar (WIndMast 350M) to observe vertical profiles of wind at the test site for aviation meteorological observation equipment located near Incheon International Airport in July and September, 2022. In this study, we utilized the observed wind profile data to propose a technique for obtaining information that could help improve the drone aviation safety. The Fourier transform analysis is used to evaluate the temporal characteristics of the horizontal wind speed at various vertical levels up to 350m. We also examined the relative contribution of the variance of wind having scales of less than an hour, a crucial scale for drone flight, to the variance of wind having all scales at each vertical altitude for days with and without precipitation.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.5
• /
• pp.197-217
• /
• 2022

As automated vehicle(AV) accidents continue to occur, the importance of safety verification to ensure the safety and reliability of automated driving system(ADS) is being emphasized. In order to encure safety and reliability, it is necessary to define an operational design domain(ODD) of the ADS and verify the safety of the ADS while evaluating its ability to respond in situations outside of the ODD. To this, international associations such as SAE, BSI, NHTSA, ISO, etc. stipulate ODD standards. However, in Korea, there is no standard for the ODD, so automated vehicles's ODD expression method and safety verification and evaluation are not properly conducted. Therefore, this study analyzed overseas ODD standards and selected suitable ODD for safety verification and evaluation, and presented evaluation elements for ADS safety verification and evaluation. In particular, evaluation elements were selected by analyzing the evaluation environment of the automated driving experimental city (K-City) that supports the development of ADS technology.