• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.03a
• /
• pp.352-361
• /
• 2006

The grouting method is widely used in construction to reduce permeability and reinforce the ground. If the cement and grout material are not mixed well in the injection tip equipment, an opposite flow and Interception state of the chemical grouting can occur. McG method installs a special grouting device to allow better mixing of the grouting material and prevent backward flow. The block of nozzle also diversify powder rate of cement. YSS that lowers $Na_2O$ and thereby increases durability is developed by gel-forming reaction material. In this study, the seepage state and unconfined compressive strength of the injection material using the special injection tip equipment is tested. The results of laboratory and field tests clearly demonstrate that the strength increases and permeability decreases using the McG method.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.1 no.3
• /
• pp.240-245
• /
• 2013

The optimum binder ratio of the low heat mass concrete for LNG tank was evaluated in the present study. Three types of binder such as OPC I, ground granulated blast-furnace slag powder were mixed and were used. Also fine particle cement and activator were used to raise an early age strength development and ground limestone was used to reduce the cost. As a result of the study, mix ratio II (30:30:40) was suitable for Bottom Center and mix ratio III(40:30:30) was suitable for Roof based on compressive strength and semi-adiabatic temperature.

• Proceedings of the KSR Conference
• /
• 2007.11a
• /
• pp.51-56
• /
• 2007

Pantograph of the electric train is the important part receiving current by adhereing contact wire. Wearing rate of pantograph or contact wire is changed by the type of pantograph and material of adhering part. In special, the weather influences the relative wearing rate and wearing type of pantograph Slider and Contact wire with steep wearing in arc and life cycle of pantograph slider. Presently, the weather causes side-wearing and over-wearing of pantograph slide installed in electric train. So it is difficult to manage and operate the electric train. Although the quality of slide using in line4 vehicle was finished the test in line 2 vehicle experimentally, it has to apply after pantograph is installed in some electric trains and check the influence in it and contact wire. It is because line4 section is very different from line2 section. Experimental application is the sequence to certify the safety and abrasion resistance importantly by enlarging experimental application with increase of the experimental electric train. The lenth of line4 in Seoul Metro is 71.5[km]. It is long section. The line is mixed DC 1,500[V] section and AC 25,000[V] section. It has underground section of 41.5[km] and ground section of 30[km]. Ground section is about 42% and receives much influence in the rain during the rainy season. After experimental application we found that this pantograph slide has twice as much abrasion resistance despite a little deviation and found the occurrence probability of arc and side-wearing is decreased considerably.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.40 no.2
• /
• pp.8-15
• /
• 2008

Wastewoods (logging residues) generated in Korea were used to make lignocellulosic fillers for papermaking. Lignocellulosic fillers could play great roles to increase retention efficiency and thus decrease turbidity of white water in papermaking process. In addition, lignocellulosic fillers could be used to improve physical properties of paper through their high affinity to cellulosic fibers, leading to the less use of chemical additives like retention aids. Wastewoods including Pinus densiflora and Quercus variabilis were chemically and mechanically treated for making fine particles passing through 100 mesh wire. The newly generated fillers showed larger particle size distribution than ground calcium carbonates but similar distribution to talc. In particular, pretreatment by hot water was more effective to generate smaller particle size than by alkali treatment. Lignocellulosic particles mixed with ground calcium carbonates under intense hybridizing condition greatly contributed to surface coverage of organic fillers in addition to filling to lumen and pits.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.7
• /
• pp.1054-1058
• /
• 2006

The purpose of this study was to use pig blood plasma transglutaminase (TGase) combined with thrombin and fibrinogen as a binder, which was applied to restructured meat, and to investigate its effect on the restructured meat quality. Pig meat was obtained 10 h post mortem from a traditional market was ground using a 10 mm aperture plate. A binder admixture was added (TGase:thrombin:fibrinogen mixed as 0.5:1:20 (v/v/v) to which was added 12% of its volume of 0.25 M calcium chloride) at 0, 5, 10, 15 and 20% of meat weight. Measurements included cooking loss, shrinkage rate, shear value, total plate count, pH value, TBA value, color difference, tension strength and sensory evaluation. The results showed that ground meat containing 20% w/w of binder admixture had higher cooking loss, shrinkage rate and shear value (p<0.05). Addition of different percentages of binder admixture did not affect total plate count, pH value, TBA value, and sensory evaluation of restructured meat (p>0.05). Tension strength was increased with increased level of binder admixture. Addition up to 15% binder admixture to restructured meat showed better scores of sensory texture, flavor and total acceptability (p<0.05).

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.246-247
• /
• 2010

This paper deals with the water treatment of the leachate from sewage filled ground by a pulsed power technology. Leachate from sewage filled ground should be treated below regulation level of COD in order to prevent environmental pollution and usually treated by a chemical method. Among the pollutants mixed in the leachate, chemical compounds of benzene series are known to be difficult to break down, and need to use high cost treat methods. The treatment of the benzene compounds by high power pulsed power supply was studied. For the high-rate, cost-effective treatment of leachate, pulsed power supply should have high repetition rates and require switching devices of long lifetime. In order to meet the demands of the above condition, pulsed power generator based on semiconductor switches using IGBTs as primary switches were developed. The experimental results verified that benzene compounds can be treated effectively by high voltage electric pulses, and this fact indicates that the treatment method by pulsed power source is a promising substitute.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.896-901
• /
• 2009

A Soil Nail is a structural element which provides load-transfer to the ground in excavation reinforcement applications. The nail may simply consist of a steel tendon, but most commonly the tendon is encapsulated in a cement grouted body to provide corrosion protection and improved load- transfer to the ground. For temporary excavation support in a congested urban area, the steel bar of Soil Nails should be removed to get permission of the private land to install Soil Nails. Several removable nail systems were developed and evaluated by pull-out load tests. The Soil Nail pull-out tests were performed on five nails installed in soft and hard rock at a 00 housing-redevelopment area in seoul. Two nails are plastic socket type and two are complex socket type mixed steel and plastic. The nail was 0.1mm in diameter, 4m long. In this study verification tests, and steel bar removing tests of plastic socket type nails and complex socket type nails were performed and presented.

• Geotechnical Engineering
• /
• v.14 no.1
• /
• pp.49-58
• /
• 1998

It was investigated whether the scrap tire can be recycled as a construction material for controlling the frost heave of the ground. Some frost heave tests and a frost penetration depth test in the laboratory were performed on the weathered granite soil mitred with variable amount of scrap tire powder under the atmospheric temperature at -$17^{\circ}$ to find the basic effects of the scrap tire on the control of frost. The frost heave control layer of the crushed stone mixed with scrap tire chips directly below thin subbass in the bituminous pavement was found to be effective for practical use. And the equation for the required thickness of this frost heave control layer with freezing index was suggested.

• Journal of Ecology and Environment
• /
• v.46 no.3
• /
• pp.243-249
• /
• 2022

Background: Mixed breeding herb Viola collina Besser, which produces both chasmogamous and cleistogamous flower, has limited habitats under closed canopy and short and early flowering timing, making it relatively more vulnerable to climate change. To better understand the effect of light and nutrient on the flower formation and vegetative growth of V. collina, a mesocosm experiment was conducted. Two-by-two factorial treatments of two light conditions (100% and 60% of natural light) and two fertilizer treatment conditions (fertilized and not fertilized) were applied in the mesocosm experiment. Results: The number of flowers, including chamogamous and cleistogamous flowers, was highest (5.65/pot) under 60% light and fertilized condition and lowest (1.41/pot) under 100% light and not-fertilized condition. However, above ground vegetative growth was highest (2.89 g/pot) under 100% light and fertilized condition and lowest (2.38 g/pot) under 60% light and not-fertilized condition. Above ground biomass to belowground biomass ratio was highest (1.50) under 60% light and fertilized condition and lowest (1.26) under 100% light and fertilized condition. Conclusions: This study showed that high light and nutrient are responsible for the vegetative growth, though the effect of fertilizer was reduced due to allocation and retainment of nutrients. In addition, the low light is necessary to make flowers, especially chasmogamous flowers.

• Conservation Science in Museum
• /
• v.4
• /
• pp.79-88
• /
• 2003

The lacquer ware objects of Nangnang were treated for conservation and seven of them were studied on the manufacturing technic. When we examined them using microscopes and an SEM-EDS analysis, the lacquer layer was proved to consist of two parts: the ground and the upper lacquer. The ground coating was made of several mixed materials such as powdered bone and minerals. Many forms of powdered bone were observed. We could find out that HgS, PbO and AgS were used as pigments. We could also find out a specific process and materials were used for those objects, although we could not say definitely what they were because the number of the sample was not big enough.