• 한국막학회:학술대회논문집
• /
• 한국막학회 2003년도 The 4th Korea-Italy Workshop
• /
• pp.77-80
• /
• 2003

Hydrocarbon-hydrocarbon separations are one of the most important processes in petroleum refining. Distillation process has been used for separating hydrocarbons, but this conventional process is very energy consuming. Pervaporation separation through polymeric membranes is an emerging process alternative to distillation because of energy savings, compact system installation, reduced capital investment, and other performance attributes. In hydrocarbon separations, polymeric membranes are easily swollen by hydrocarbons and can lose mechanical strength. Chemically robust membranes are needed for the separation of hydrocarbons. In this study, the blend membrane was applied to separate benzene and cyclohexane. This is a model system for aliphatic and aromatic separation. Cyclohexane is also physically very similar to benzene and as a result of the very closing boiling points (0.6$^{\circ}C$), benzene and cyclohexane form an azetrope. Thus the system provides a good model for azeotrope breaking by pervaporation. The semi-quantitative thermodynamic model predicts that the calculated selectivity increases with increasing Hydrin contents in the blend membranes. Pervaporation experiments utilizing various operating temperatures and feed concentrations with different blend membranes are compared with the result from semi-quantitative thermodynamic calculations.

• Korean Membrane Journal
• /
• 제3권1호
• /
• pp.1-8
• /
• 2001

A lab-scale submerged membrane bio-reactor (MBR) with intermittent aeration was carried out for investigating the behavior of soluble microbial products (SMP). The SMP concentration of mixed liquor at Run 1 accumulated immediately at the end of running and biodegradable SMP converted into non-biodegradable SMP, but it did not occurred at the Run 2 and 3. The SMP formation coefficient (k) at the anoxic phase was a little higher than oxic phase, and the lowest k was investigated at Run 3. The combination of biological denitrification with the MBR Process was advantageous in the prevention of membrane bio-fouling.

• Korean Chemical Engineering Research
• /
• 제60권1호
• /
• pp.51-61
• /
• 2022

Gas separation via hollow fibre membrane modules (HFMM) is deemed to be a promising technology for natural gas sweetening, particularly for lowering the level of carbon dioxide (CO₂) in natural gas, which can cause various problems during transportation and process operation. Separation performance via HFMM is affected by membrane properties, module specifications and operating conditions. In this study, a mathematical model for HFMM is developed, which can be used to assess the effects of the aforementioned variables on separation performance. Appropriate boundary conditions are imposed to resolve steady-state values of permeate variables and incorporated in the model equations via an iterative numerical procedure. The developed model is proven to be reliable via model validation against experimental data in the literature. Also, the model is capable of capturing axial variations of process variables as well as predicting key performance indicators. It can be extended to simulate a large-scale plant and identify an optimal process design and operating conditions for improved separation efficiency and reduced cost.

• 멤브레인
• /
• 제32권3호
• /
• pp.173-180
• /
• 2022

음용수 속 암모니아의 존재는 인간의 건강에 매우 해롭다. 농작물에서의 비료 사용, 산업 폐수, 화석 연료의 연소와 같은 활동으로 인해 가용성 암모니아는 지하수를 오염시킨다. 물에 존재하는 암모니아 농도가 낮더라도 해양생물 등의 수생환경을 훼손한다. 막 기술은 암모니아를 물로부터 효과적으로 제거하기 위한 매우 중요한 과정이다. 평평한 시트 막, 막 접촉기, 그리고 막 증류법은 암모니아를 제거하여 물을 정화하는 데 사용되는 방법들 중 하나이다. 막 접촉기는 막 증류법과는 달리 상변화 없이 액체와 가스 간의 또는 액체와 액체간의 질량 전달을 통해 암모니아를 제거하는 효율적인 공정이다. 다만 이 방법은 pH가 매우 높아 암모니아 제거에 비용이 많이 든다. 제올라이트는 우수한 이온 교환 능력을 가지고 있는데, 이는 암모니아와의 상호작용을 향상시켜 폐수로부터 흡착하는 능력을 향상시킨다. 제올라이트를 함유한 혼합 매트릭스 막은 암모니아 흡착 및 폐수로부터의 분리 효율을 향상시킨다. 이 리뷰에서는 위에서 소개된 내용이 자세히 논의될 것이다.

• 상하수도학회지
• /
• 제38권4호
• /
• pp.223-232
• /
• 2024

This study was conducted to simulate the lifetime of the membrane by analyzing the performance of the membrane degraded by chlorine. Chlorine exposure under several conditions caused the degradation of the membrane, resulting in the absence of any salts and an extreme increase in permeability. When the n value was calculated and compared through CⁿT analysis and CTⁿ analysis, the p values were all less than 0.005, but CTⁿ analysis, which had a higher R² value, was adopted to simulate the membrane lifetime. Power coefficients take on values higher than 1, indicating that the exposure time to chlorine has a greater influence on membrane deterioration than the chlorine exposure concentration at 20℃ and 30℃. In particular, the process should be operated at less than 0.5 ppm at 30℃, and the chlorine exposure time of 1 cycle should be set to within 15 hours. In addition, the sensitivity to chlorine increased by 10.5 to 12.2 times when the chlorine exposure temperature increased by 10℃ through the correlation between the chlorine exposure cycle and membrane lifetime. The membrane lifetime investigated in this study is only an estimated value, entirely because of chlorine membrane deterioration, excluding raw water characteristics and the type of detergent. Accordingly, it is considered that the membrane lifetime simulation can be applied by comparing the membrane performance with the actual process based on the filtration performance of membrane deterioration by chlorine.

• 상하수도학회지
• /
• 제30권3호
• /
• pp.279-284
• /
• 2016

Membrane distillation (MD) is the thermally driven water separation process based on the vapor pressure difference across the membrane. In order to increase the water recovery of the conventional RO process, the additional MD-PRO pocess was suggested. In this study, the syntheric RO brine was used as a feed solution of the MD process. Due to the high salinity of the RO brine, the MD membrane could be fouled by the scalants. In order to mitigate the scaling on the MD membrane surface, the pre-treatment process using the column filled by natural zeolite was applied. The roughing filter was installed between the pre-treatment process and MD system in order to prevent possible particulate fouling by the debries of the natural zeolite. Moreover, in order to enhance the CEC of the natural zeolite, the NaCl soaking was conducted. The flux and electronic conductivity were monitored under given experimental conditions. And the membrane morphology and the chemical compositions were analyzed by using the SEM-EDX.

• 공업화학
• /
• 제23권5호
• /
• pp.445-449
• /
• 2012

고분자 전해질막 연료전지의 대량 생산을 위하여 막-전극 접합체(MEA) 활성화 방법의 개발이 중요한 현안이다. 현재 개발된 MEA활성화 방법은 시간이 많이 소요됨으로 인해 수소의 사용량 또한 증가하여 연료전지의 상용화에 큰 걸림돌이 되고 있다. 통상적인 활성화 방법은 활성화 원리를 주로 전해질 수화 관점에서 이해하였다. 반면, 본 논문에서 제안된 순환전압전류(cyclic voltammetry, CV) 활성화 방법은 전해질 및 촉매적 관점에서 별도로 분리하여 이해하였다. 따라서 전해질 관점에서는 상대 습도 100%인 가습된 질소를 공급하여 전극 및 막의 전해질을 수화시키는 과정으로 구성되고, 촉매적 관점에서는 CV 사이클을 수행하여 백금 촉매에 흡착되어 있는 불필요한 오염물질, 또는 산화피막을 제거하는 과정으로 수행된다. CV 활성화법은 2.5 h 내에 활성화가 종료되어 활성화 시간을 크게 단축시킬 수 있을 뿐만 아니라, 수소 사용량도 기존 활성화 방법에 비하여 1/4 이하로 감소시킬 수 있어서 효과적인 연료전지 활성화 방법으로 제안하고자 한다.

• 한국산업융합학회 논문집
• /
• 제26권6_2호
• /
• pp.1171-1181
• /
• 2023

In this study, a sweep gas - vacuum hybrid type membrane degassing process was proposed for ammonia wastewater treatment. In addition, the ammonia selective recovery of the hybrid type membrane degassing process was also investigated. As a result, the hybrid type membrane degassing process showed better degassing performance (54.9 mg NH₃/m²min for 360 min) than the sweep gas type (32.3 mg NH₃/m²min) or vacuum type (22 mg NH₃/m²min). Additionally, the hybrid type membrane degassing process showed an excellent ammonia selectivity (103 times compared to Na+ Na⁺, 133 times compared to Ca²⁺). The ammonia selectivity was appeared to be due to the conversion characteristics of ammonium ion / dissolved ammonia depending on pH. The results in this study are expected to be used in the development of ammonia wastewater treatment and ammonia recovery in the future.

• 멤브레인
• /
• 제17권3호
• /
• pp.244-253
• /
• 2007

광촉매 반응이 자연유기물에 의한 나노여과막의 오염에 미치는 영향을 살펴보았다. 광촉매 분해공정은 자연유기물의 분해와 변형에 효율적이었으며 이산화티타늄과 고정화 비드를 광촉매로 사용하였다. 광촉매적 특성을 비교하기 위하여 칼슘 이온 존재 시의 휴민산의 광분해를 모델 반응으로 설정하였다. 광분해 전에는 치밀한 막오염층이 형성되어 막오염을 가속화시킨 반면, 광분해 후에는 막오염이 크게 감소하였다.

• 한국농공학회논문집
• /
• 제55권2호
• /
• pp.21-27
• /
• 2013

The present study explored the way to desalinate seawater for agricultural irrigation using forward osmosis (FO) process using liquid fertilizer as draw solution. FO experiments were performed in a cross flow mode using flat sheet FO membrane. The effect of membrane orientation, flow rate, and draw solution concentration on the performance of forward osmosis was investigated by measuring water flux of forward osmosis membrane. The water flux when the draw solution was placed against the membrane active layer was lower than the water flux when the feed solution was placed against the membrane active layer. This results indicated that the decrease of effective osmotic pressure by dilutive internal concentration polarization was less than that by concentrative internal concentration polarization. Increasing flow rate from 66.7 to 133.1 $cm^3$/min resulted in increase of the water flux when the membrane active layer orient to draw solution and feed solution, respectively. The reduction of resistance to water flow increased water flux at higher flow rate. The water flux of FO membrane increased with increasing draw solution concentration from 10000 to 30000 mg/L. The water flux for $KH_2PO_4$ draw solution was similar to that for commercial fertilizer. Optimization of FO process would contribute to economically desalinate brackish water for agricultural use.