• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2005.06a
• /
• pp.1005-1010
• /
• 2005

In this paper, it is presented a frequency modulated continuous wave radar (FMCW) for distance measurement. The frequency range is $10{\sim}11$ GHz and the sweep time of the signal is 100 ms. The test target is 0.8 m2 of metal plate. The experiment is performed in open ground and the pyramidal horn antenna of about 22 dBi gain is used. The beat frequency according to the target moving to 40 m is measured. There is a good agreement between measured and calculated results. But the resolution of the FMCW radar is not good such as about 10 cm. It is result from the nonlinear signal of voltage controlled oscillator (VCO). To improve the nonlinear characteristic of VCO, a high pass filter and phase locked loop (PLL) frequency synthesizer are included in the radar system.

• Korean Journal of Remote Sensing
• /
• v.27 no.4
• /
• pp.403-410
• /
• 2011

Consistent observation with high temporal and spatial resolution is required for an efficient monitoring of coastal environments. Remote monitoring system installed on the ground is capable of simultaneous observation of wide coastal area and consistent observation with high frequency, which a small number of in-situ measurements cannot manage. This paper studies two typical ground based coastal monitoring system, marine radar and camera system. Marine radar can produce time series of frequency spectrum by integrating wave number spectrum calculated from spatial and temporal variation of waves in the radar image. The time averaged radar images of waves can analyze wave breaking zone, rip currents and location of littoral bars. Camera system can observe temporal variation of foam generation originated from coastal contamination as well as shoreline changes. By extracting the part of foams from rectified images, quantitative analysis of temporal foam variation can be done. By using the two above systems of different characteristics, synergetic benefit can be achieved.

• Journal of Navigation and Port Research
• /
• v.30 no.5 s.111
• /
• pp.357-362
• /
• 2006

This paper describes two kinds of personal hand-held electronic devices to enhance marine leisure safety. The one is Radar response-type safety device triggering by the pulse signal from a commercial 9GHz-band Radar to provide quick search and rescue with combined civilian-government-military fleets. The other one is M-RFID (Marine Radio Frequency IDentification) based safety electronic device using 900MHz Tx/Rx with spread spectrum frequency hopping and GPS. Through the field tests at sea using Korea Coast Guard's warship the operating performances are verified. Further plan for practical use of each device was also discussed.

• Journal of Ocean Engineering and Technology
• /
• v.20 no.1 s.68
• /
• pp.37-42
• /
• 2006

In the ocean engineering field, information about the ocean environment is important for planning, design, and operation, especially the wave information. High precision wave data is also important for considering environmental problems, like efficient operation of ships. For this purpose, many methods were considered in the past. However, an on-board directing wave measurement system has not been incorporated. The use of conventional marine radar Plane Position Indicator (PPI) images allows the estimation of wave information on a real-time basis, using both space and time information, regarding the evolution of ocean surface waves. In order to achieve data acquisition, the Radar Scan Converter (RSC) has been developed. Three-dimensional analysis was performed. The comparison of wave information derived from this system, and that of wave buoy, shows that this wave field detecting system can be a useful tool.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.21 no.6
• /
• pp.737-743
• /
• 2015

This paper are mainly focusing on the facts influencing on RCS reductions, appling radar absorbing materials by using RCS contributions of elements and appling a metamaterials which is high-tech radar absorbing materials. RCS analysis results are given for a simplified ship model, with radar absorbing materials and metamaterials cause RCS reduction in terms of mean values.

• Journal of Navigation and Port Research
• /
• v.44 no.2
• /
• pp.110-118
• /
• 2020

With the expansion of the shipping and port logistics industry in the 21st century, the traffic density is continuously increased because of the increase in volumes of world sea freight and fleets, as well as the increase in the causes of potential marine accidents, such as ship collisions and stranding. Accordingly, the International Maritime Organization (IMO) has requested that the installation and operation of VTS should be applied in areas with high risk of marine traffic, and the request should be included as one of the Safety of Life at Sea (SOLAS) regulations. In this paper, the fundamental requirements of the radar system for vessel traffic services were analyzed and the analyzing factors were based on the IALA guideline.s This paper also includes results for the requirement and recommendation analysis on detection distance, target separation, and the target position accuracy of X-band radar. Also, to check if it satisfies the requirement of detection distance, range and azimuth separation of small point targets, and target position accuracy from the IALA guidelines, the test was conducted through the radar image acquired at the VTS center, and hence, the validity of the technical performance requirements was confirmed.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2023.05a
• /
• pp.40-41
• /
• 2023

This paper introduces the design of detection, recognition, and tracking algorithms for VTS radar image-based objects. The detection of objects in radar images utilizes artificial intelligence technology to determine the presence or absence of objects, and can classify the type of object using AI technology. Tracking involves the continuous tracking of detected objects over time, including technology to prevent confusion in the movement path. In particular, for land-based radar, there are unnecessary areas for detection depending on the terrain, so the function of detecting and recognizing vessels within the region of interest (ROI) set in the radar image is included. In addition, the extracted coordinate information is designed to enable various applications and interpretations by calculating speed, direction, etc.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.21 no.5
• /
• pp.571-576
• /
• 2015

This paper presents a comparative study of wave height estimation method that was used for signal to noise ratio and shadowing ratio based on X-band marine radar. If the signal to noise ratio, and is widely used as a method for estimating an wave height, a new method is presented for shadowing ratio. In the case of radar images used in this study it is measuring the data from the coast of Ulsan Jujeon, compared with marine meteorological information from the Meteorological Agency measured a light beacon. We compared the measured data for about 34 days, the typhoon was measured, incluidng a period in the East Sea, and verify the results for various distribution of wave height. For estimate wave height using a shadowing ratio analysis, it does not require calibration and real-time advantages of this part, coming confirmed the possibility of the measurement, the cause detection error for radar image was caused due to determine.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2019.05a
• /
• pp.119-120
• /
• 2019

In order to verify the accuracy of wave measurement of the wave instrumentation system using X-band navigation radar, The validity of the results was obtained by analyzing the significant wave height around Ulleungdo. Especially, The correlations between the radar, wave height buoy and marine buoy for wave measurements were analyzed in season.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.6
• /
• pp.771-780
• /
• 2014

We installed HF Radar of Array type in Site A and Site B, observing the real-time wave and current in the central East coast of Korea. WERA(WavE RAdar) in this research uses HF Radar of Array Type with frequency range of 24.525 MHz, developed by Helzel, Germany. Each site is a 8-Channel system consisting of four transmitters and eight receivers, generating wave and current data, being observed every thirty minutes at the present time. HF Radar has grid resolution of an interval of 1.5 km using bandwidth of 150 kHz; The wave data covers an observation range of about 25 km, and the current data covers the maximum observation range of about 50 km. The Wave data observed by HF Radar was compared and verified with the AWAC data observed in the research sites. MIT also compared the Current data observed by HF Radar with Monthly the East sea average surface current and current flow pattern provided by KOHA(Korea Hydrographic and oceanographic Administration). The regression line and deviation of the comparison data of Wave was calculated by Principal Component Analysis, which showed correlation coefficient 0.86 and RMSD 0.186. Besides, data analysis of long-term changes of the current in the East coast showed that, during August and September, the North Korean Cold Current flow into the southward direction and the East Korean Warm Current flow into the northward direction in the coast.