• Annals of Clinical Neurophysiology
• /
• v.11 no.2
• /
• pp.71-73
• /
• 2009

Biclonal gammopathy is characterized by the presence of two different monoclonal immunoglobulins, and the clinical findings of biclonal gammopathy are similar to those of monoclonal gammopathy. An association between biclonal gammopathy and tsutsugamushi meningitis has not been reported previously. Here, we report a case of a 55-year-old man presented with fever and decreased mentality. A cerebrospinal fluid (CSF) test and an indirect immunofluorescent antibody test for Orientia tsutsugamushi revealed tsutsugamushi meningitis. CSF and serum immunofixation electrophoresis revealed biclonal gammopathy (IgG-${\kappa}$, IgG-${\lambda}$). His symptoms improved after antibiotics treatment, and serum biclonal gammopathy completely disappeared.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.29 no.5 s.236
• /
• pp.545-553
• /
• 2005

In the present study, The characteristics of developing steady laminar flows of a straight duct connected to a $180^{\circ}$ curved duct were examined In the entrance region through experimental measurement. Flow characteristics such as shear stress distributions, pressure distributions and friction coefficient experimentally in a square cross-sectional straight duct by using the PIV system. For the PIV measurement by particles produced from mosquito coils particles. The experimental data were obtained at 9 points dividing the test sections by 400mm. Experimental results can be summarized as follows. Critical Reynolds number, $Re_{cr}$ which indicates transition from laminar steady flow to transition steady flow was 2,150. Shear stress per unit length on the wall was stronger than that in the fully developed flow region. This was attributed to the fact that shear stress and pressure loss in the curvature of a duct were increased. Pressure distributions were gradually decreased irrespective of Reynolds number In the whole test section. This trends were in a good agreement with the reference results. Pipe friction coefficient in the steady state flow region was calculate from method of least squares. The co-relationship between fiction coefficient and Reynolds number was established as follow; ${\lambda}=56/Re$.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.09a
• /
• pp.81-85
• /
• 2002

The possibility of simultaneous analysis of 24 pesticides out of 30 residual pesticides which are subjected to test in the golf courses was examined. The utility of the simultaneous analysis of multi-residue pesticides was evaluated by recovery test through a standard addition method of pesticides in water, soil, and lawn grass. The experimental results of the recovery rates for individual pesticides are as follows : The number of pesticide of which average recovery was over 70% regardless of medium was 16 pesticides. These pesticides were composed of 8 organophosphorus pesticides(Chlorpyrifos, Chlorpyrifos-methyl, Diazinon, EPN, Fenitrothion, Phenthoate, Phosalone, and Toclofos-methyl). 4 organochlorinated pesticides(Daconil, Captan, Endosulfan, and Tetradifon), 2 pyrethroid pesticides(Fepropathrin, Lambda-cyhalothrin) and 2 other pesticides(Bromopropylate, Pendimethalin). On the other hand, in case of Dicofol, average recovery by medium was over 70% for water and lawn grass but was only 53.3% for soil. Therefore, the simultaneous analytical method applied in this experiment is not appropriate for analysis of Dicofol in soil. Furthermore, among 7 pesticides, 2 pesticides(Amitraz and Pyraclofos) showed that theirs average recovery rates deviated from criteria(70~130%) at almost all media, while 5 pesticides(Bensulide, Deltamethrin, Iprodione, Phosphamidon and Tralomethlin) were not detected from all media by selected GC detector(NPD or ECD).

• Proceedings of the KSME Conference
• /
• 2008.11b
• /
• pp.3102-3107
• /
• 2008

This paper was focused on the particulate matter (PM) on the gasoline and bio ethanol. Bio ethanol as a clean fuel is considered one of the alternative fuels that decreased the PM emission from the vehicle. Particle formation in SI engine was depended on the fuel and engine operating condition. In this paper, Particle number concentration behaviors were analyzed by DMS500 (Differential Mobility Spectrometer) and CPC (Condensation Particle Counter) instrument which was recommended by PMP (Particle Measurement Programme). Particle emissions were measured with various engine operating variables such as air excess ratio ($\lambda$), spark timing and intake valve opening (IVO) at part load condition. In vehicle test, the number of particulate matter was analyzed with golden particle measurement system, which was consist of CVS (Constant Volume Sampler), particle number counter and particle number diluter.

• Journal of the Society of Naval Architects of Korea
• /
• v.45 no.2
• /
• pp.109-123
• /
• 2008

The present paper presents the CFD result for a beam wave test case. An ONR tumblehome ship model with bilge keels is used. The beam wave test is for zero forward speed and roll and heave 2DOF with wave slope $a_k=0.156$ and wavelength ${\lambda}=1.12L_{PP}$, with $L_{PP}$ the ship length. The problems is solved numerically with an unsteady Reynolds averaged Navier-Stokes approach. The free surface flow is computed using a single-phase level-set method and the motions in each time step are integrated using a predictor-corrector iteration approach which uses dynamic overset grids moving with relative ship motion. The predicted CFD results for motions and forces are compared with experimental data, showing a reasonable agreement.

• Journal of Korean Society of Steel Construction
• /
• v.10 no.2 s.35
• /
• pp.153-160
• /
• 1998

The sectional dimensions and initial crookedness of the RHS(rectangular hollow section, ${\boxe}-75{\times}75{\times}3.2,\;{\boxe}-100{\times}100{\times}4.2,\;{\boxe}-125{\times}125{\times}6.0$) were measured. The axial compressive strength tests for columns with slenderness $46{\sim}84$ were performed as well as stub tests and tensile tests. FEM analysis was also used. The measurement shows that the errors of sectional dimensions are negligible. For the column length corresponding to ${\lambda}=100$, the initial crookedness with the 2.5% probability estimated from the measured results is 1/490, 1/1121 1/1395 for each section respectively. The yield strengths obtained from tensile test are higher than the specified minimum value by more than 30%. The column test shows that the maximum axial resistances are almost same as, or a little higher than the FEM results and the specified strength curves of AISC Specification and Eurocode, when the maximum strengths from the stub tests are used as the yield strength of the steel. But the test results show much higher column strength than those specified in the Standard and Code, when the specified minimum yield strength of the steel is used.

• Journal of Power System Engineering
• /
• v.22 no.6
• /
• pp.67-73
• /
• 2018

Gasoline that meets the quality standards is distributed in Korea. However, consumers who use toluene or solvent mixed with gasoline have appeared due to rising crude oil prices and for the purpose of tax evasion. Gasoline quality standard is enacted by the domestic and international research reference. A wrong fuel can influence automobile performance or environmental issue. Thus, empirical data from this issue is necessary. Therefore, this research observed catalyst influence by gasoline property change and inspect influence of environment. In this study, fuel property evaluation, lean-burn evaluation, and real vehicle exhaust emission test were performed. In the result of fuel property, the fuel "A" was measured to be up to 27% less octane than the normal gasoline and the distillation property was measured 24% higher than normal gasoline. In the test result of single cylinder engine lean-burn test, the fuels "A" and "B" show torque value 20% less than the normal gasoline. As a result of vehicle test using the catalyst, the fuel "A" was increased more than the normal gasoline with 83% THC, 1,806% CO and 128% NOx, and the fuel "B" was increased more than normal gasoline with 1.6% THC, 391% CO and 142% NOx.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.32 no.1
• /
• pp.53-63
• /
• 2022

Objectives: This study was designed to evaluate the filtration efficiency, inhalation resistance, and liquid resistance of commercial reusable masks in comparison to the performance of KF-AD masks (reference masks). Methods: Thirty-six masks were purchased from an online market. Filtration efficiency and inhalation resistance were determined in the same manner as in MFDS certification testing, respectively using TIL/IL & Filter Test 1300S (SFP Services, UK) and Breathing Resistance Analyzer DA2001 (Lambda Ray, South Korea). Results: Most of the filtration efficiencies found for the 19 masks were far lower than the test standard for KF-certified masks. Four masks met KF94 and three masks even met KF80. Most inhalation resistances were also much lower than the standard, with many almost one-half of the standard. In addition, all the masks except KF-AD masks did not pass the liquid resistance test. Conclusions: Although most of the filtration efficiency performance results found in this study for the reusable masks, which emerged as an alternative, were lower than the standard for health masks, multi-use masks can be used with a replacement filter inserted.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.28 no.5
• /
• pp.314-319
• /
• 2015

In this research, we focused on the development of cy3 dye with high thermal stability and good solubility for LCD color filter. Cy3 dyes were prepared through the synthetic procedure of two steps. The synthesized cy3 dyes were characterized by using NMR, FT-IR, UV/Vis spectroscopy, and TGA. These cy3 dyes showed maximum absorption wave length (${\lambda}_{max}$) in the range of 549~555 nm in UV/Vis spectrum. And we confirmed that solubility characteristics and thermal stability of cy3 dyes were dependent on the structure of counter cation. Cy3 dyes with methyl counter cation and ethyl counter cation have good solubility in organic solvents such as chloroform, ethanol, and PGME. Moreover, Cy3 dye with ethyl counter cation gave excellent thermal stability in TGA thermograms. And Cy3 dye with ethyl counter cation showed good result in photoresist film test.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.10
• /
• pp.1822-1828
• /
• 2008

This paper presents design parameter calculation methodology and its realization to construction for the 10/350${\mu}s$ lightning impulse current generator(ICG) modelled as double exponential function waveform with characteristic parameters ${\alpha},{\beta}$. Matlab internal function, "fzero" was applied to find ${\lambda}={\alpha}/{\beta}$ which is solution of nonlinear equation linearly related with two wave parameter $T_1$ and $T_2$. The calculation results for 10/350${\mu}s$ lightning impulse current show very good accuracy with error less 0.03%. Two type of 10/350${\mu}s$ ICGs based on the calculated design circuit parameters were fabricated by considering the load variation. One is applicable to the MOV based Surge protective device(SPD) for less 15 kA and the other is to test small resistive devices such as spark gap arrester and bonding device with maximum current capability 30 kA. The tested waveforms show error within 10% in comparison with the designed estimation and the waveform tolerance recommended in the IEC 61643-1 and IEC 60060-1.