• Journal of Biosystems Engineering
• /
• v.7 no.1
• /
• pp.17-32
• /
• 1982

The binders introduced in Korea were originally designed to be used for Japonica-type varieties which have relatively long stem and are highly resistant to shattering. In order to use it for Tongil varieties which are short and easy to be shattered, mechanical modifications are necessary to reduce a grain loss incurred during binder operation. This study was intended to investigate analytically and experimentally the major sources of grain losses caused by three kinds of binders now introduced in Korea. Actual modification for each of three binders was done and experimentally compared to see if any improvement on grain loss was achieved. The results obtained in this study are summarized as follows; 1. It was required that the power transmission of binder should have a shifting mechanism so that velocities of pick-up and traveling units could be changed independently as desired according to the Japonica-type and Tongil varieties. In other words, the desired velocity of traveling unit should be obtained by shifting the transmission and the velocity of pick-up unit should be selected by reaping clutch according to the variety independent of the velocity of traveling unit as shown in Fig. 6. 2. To reduce grain loss it was desired that the moving parts of the pick-up unit should have the lowest possible velocities in harvesting Tongil varieties, unless the reduction of the speed be hindered the conveyance of the material. Based on the study, it was concluded that the velocities of pick-up unit be reduced by about 35% of those of the existing units. 3. It was found that the lug at the upper rotating section of pick-up case gave a severe impact on the ears of rice to increase grain loss. The optimum design of pick-up case to protect the ears from the protruding part of the lug was recommended by the result of analysis of the trajectory of the end-point of lug at the position. 4. It was proved analytically and experimentally that pick-up unit at the lower-rotating part was the other important source of grain loss in pick-up and divider assembly. In order to reduce a grain loss incurred by lugs at their lower-rotating section, it was suggested to improve it by (1) widening the space between right and left lower-rotating section, (2) shortening the length of lugs, (3) enlargement of the angle between the pick-up case and ground-level, and (4) attaching guard to right and left dividers so that the rotating lug could not give a high impact to the paddy hill. 5. Pick-up and divider assembly of the original binder of three models studied was modified according to the suggestions that were given by the preliminary study. Field test showed that the modified binders were able to reduce grain losses by about 0.4-0.7 percentage points compared to those without modification.

• The Journal of the Korea Contents Association
• /
• v.21 no.3
• /
• pp.567-575
• /
• 2021

Residents in Dangjin, South Chungcheong Province, in which large-scale emissions facilities such as coal-fired power plants and steel mills are concentrated, are very much concerned about their health despite the local government's aggressive efforts to improve air quality and reduce greenhouse gases. To understand the impact of coal-fired power plants and external factors on local air pollution, the origins of local pollutants were investigated using stable carbon isotopes that are generally used as tracers of the provenance of fine or ultrafine dust. The origins of the pollutants were analyzed with the data library, built using the seasonally measured data for the two separate locations selected considering the distance from the coal-fired power plant and the analysis of previous studies, and with the back trajectory analysis. As a result of analyzing stable isotope ratios, the tendency of high concentration was found in the order of winter > spring > fall > summer. According to the data matching with the library, the mobile pollutants and open-air incineration had a relatively higher impact on the local air pollution. It is believed that this study, as a pilot study, should focus on securing the reliability of the study results through continuous monitoring and data accumulation.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.2 no.2
• /
• pp.14-23
• /
• 1998

The present study investigates numerically particle laden flow through compressor cascade. In general, a lot of turbine engines are affected by various particles which are suspending in the atmosphere. Especially in the case of aircraft aviating in volcanic, industrial and desert region including many particles, each components of engine system are damaged severely. That damage modes are erosion of compressor binding and rotor path components, partial or total blockage of cooling passage and engine control system degradation.. Initial damages can not be serious but cumulation of damages influences on safety of aircraft control and economical maintenance cost of engine system can be increased. When dust, materials and volcanic particles in the atmosphere flow in the compressor, it is necessary to predict damaged and deposited region of compressor blades. To the various flow inlet angle, predictions of particles trajectory in compressor cascade by Lagrangian method are presented and impulses by impaction of particles at blade surface are calculated. By the definition of particle deposition efficiency, characteristics of particles impact are considered quantitatively. With these prediction and experimental data, erosion rates are predicted for two materials - ceramic, soft metal - on compressor blade surface. Improvements like coating of blade surface could be found, by above prediction.

• Journal of Environmental Science International
• /
• v.18 no.6
• /
• pp.655-665
• /
• 2009

This study aims to identify the impacts of air quality in the Korean Peninsula according to the China's environmental policies in preparation of the Beijing 2008 Olympic Games. The measurement of emission variations in China, aircraft measurement, and modelling were carried out. The reduction measures in Beijing, China and its emission changes resulted in $30{\sim}65%$ in decrease out of the total emissions within the Beijing region, whereas when it comes to the whole nation of China, the reduction rate was about $4{\sim}9%$. Comparing the concentration of the air pollutants in Seoul and Ganghwa in August 2008 during around the period of Beijing Olympic Games with one in $2004{\sim}2007$ showed that the $SO_2$ concentrations in the past was above 5ppb, while the concentration in the 2008 olympic period was 4ppb and below. The NOx at the Seokmori site in Ganghwa tended to be lower in concentration in 2008 than in between $2004{\sim}2007$. As for $O_3$ and $PM_{2.5}$, the concentration tended to be rather low since August 11. The air current track that showed during the period of aircraft measurement presented to be flowed into Korea through the Northeast part of China and the coast of Bohai Bay, while the concentrations of $SO_2$. NOx, and $O_3$ over the west sea on August 20 and 24 were 0.54 (0.28ppb), 0.86 (1.84ppb), and 54.0 (41.5ppb) respectively, similar or lower than the ones measured in the past in the similar current patterns. The modelling result showed similar patterns to the data of aircraft measurement, in particular in $SO_2$. Overall, the reduction measures in Beijing, China affected directly and indirectly the air quality in the Korean peninsular, but the impact was not significant as it was momentary and limited to the intended area.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.5
• /
• pp.382-391
• /
• 2009

Atmospheric speciated mercury concentrations including total gaseous mercury (TGM) and reactive gaseous mercury (RGM) were measured in Chuncheon from March 2006 to November 2008. Average concentrations were 2.10 ${\pm}$ 1.50 ng/$m^3$ and 3.00 ${\pm}$ 3.14 pg/$m^3$ for TGM and RGM, respectively. RGM concentrations were higher during daytime than nighttime probably because of high photochemical activities. We found that RGM concentration considerably increased as ozone increased when fog occurred, indicating that ozone was the important oxidant for $Hg^0$ in aqueous phase. TGM concentration showed positive correlations with CO and $PM_{10}$ which can transport in long-range, but there was no correlation with $NO_2$. Considering that major source of mercury is combustion process, this result showed that local sources did not significantly impact on TGM concentration in Chuncheon. Five-day backward trajectories were calculated for the samples representing high and low concentrations of TGM, and determined that industrialized area of China including Shenyang and Beijing influenced TGM concentrations in Chuncheon.

• Journal of the Economic Geographical Society of Korea
• /
• v.22 no.4
• /
• pp.405-421
• /
• 2019

International aid to North Korea remains far below the humanitarian needs of vulnerable people. This paper examines the trajectory of international humanitarian assistance to North Korea over the last two decades with the focus on its decline in the context of the country's nuclear standoff and corresponding stringent sanctions. In so doing, the paper addresses major problems associated with North Korea's reception of foreign aid and operational constraints placed on humanitarian activities in the country. It shows that humanitarian assistance to North Korea has been largely shaped by geopolitical dynamics. A survey of UN reports and statistics also suggests a shifting trend in recent international aid to North Korea. The decline of aid and multiple operational obstacles faced by humanitarian organizations, for instance, have led to a fall in agricultural support and a proportional rise in health and related services. While UN Security Council resolutions include an exemption provision, humanitarian assistance to North Korea has been constrained by stringent sanctions, which have led to adverse consequences for the civilian population. In this regard, the paper suggests some policy directions for international aid to North Korea amidst negotiations over denuclearization, while stressing an urgent need to address the negative impact of sanctions on vulnerable groups in the country.

• Korean Journal of Remote Sensing
• /
• v.14 no.4
• /
• pp.366-375
• /
• 1998

Optical characteristics of the yellow sand and their influences on the ocean color remote sensing has been studied using ocean color sensor SeaWiFS measurements. Two cases of April 18 and April 25, 1998, representing yellow sand and background aerosol, are selected for emphasizing the impact of high aerosol concentration on the ocean color remote sensing. It was shown that NASA's standard atmospheric correction algorithm treats yellow sand area as either too high radiance or cloud area, in which ocean color information is not generated. Optical thickness of yellow sand arrived over the East Asian sea waters in April 18 indicates that there are two groups loaded with relatively homogeneous yellow sand, i.e.: heavy yellow sand area with optical thickness peak around 0.8 and mild area with about 0.4, which are consistent with ground observations. The movement of the yellow sand area obtained from surface weather maps and backward trajectory analysis manifest the notion that the weak yellow sand area was originated from the outer region of the dust storm. It is also noted that high optical thickness associated with the yellow sand is significantly different from what we may observe from background aerosol, which is about 0.2. These characteristics allow us to determine the yellow sand area with an aid of atmospheric correction parameter. Results indicate that the yellow sand area can be determined by applying the features revealed in scattergrams of atmospheric correction parameter and optical thickness.

• The Journal of the Korea Contents Association
• /
• v.22 no.4
• /
• pp.433-444
• /
• 2022

This study aimed to identify the change trajectories and clusters of Korean women's family values and depression levels, and the factors affecting depression, to use balanced panel data from the 1st to 7th rounds of the Korea Longitudinal Survey of Women and Families(KLSWF). The subjects of this study were 5,048 female panelists who participated in the KLSWF, and LSTM analysis was conducted using Python to divide the clusters of Korean women suffering from depression. In addition, descriptive statistical analysis, ANOVA, multinomial logistic regression analysis, and hierarchical regression analysis were analyzed using SPSS 23.0. Results, It was confirmed that women's depression increased with age, and family values had a significant impact on depression. It was found that the more open the marriage values of women in the married group, the higher the level of depression. The family values trajectory and depression level of the analyzed subjects were not a single pattern, but included four clusters. To prevent depression among Korean women and provide more concrete interventions, a humanities and sociological system that can identify depression groups should be prepared.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.2
• /
• pp.183-200
• /
• 2022

A variety of simulation approaches based on automated driving technologies have been proposed to develop traffic operations strategies to prevent traffic crashes and alleviate congestion. The maneuver of simulated autonomous vehicles (AVs) needs to be realistic and be effectively differentiated from the behavior of manually driven vehicles (MVs). However, the verification of simulated AV maneuvers is limited due to the difficulty in collecting actual AVs trajectory and interaction data with MVs. The purpose of this study is to develop a methodology to evaluate the suitability of AV maneuvers based on both driving and traffic simulation experiments. The proposed evaluation framework includes the requirements for the behavior of individual AVs and the traffic stream performance resulting from the interactions with surrounding vehicles. A driving simulation approach is adopted to evaluate the feasibility of maneuvering of individual AVs. Meanwhile, traffic simulations are used to evaluate whether the impact of AVs on the performance of traffic stream is reasonable. The outcome of this study is expected to be used as a fundamental for the design and evaluation of transportation systems using automated driving technologies.

• Korean Journal of Materials Research
• /
• v.33 no.1
• /
• pp.15-20
• /
• 2023

'Tracers' are bullets that emit light at the backside so that the shooter can see the trajectory of their flight. These light-emitting bullets allow snipers to hit targets faster and more accurately. Conventional tracers are all combustion type which use the heat generated upon ignition. However, the conventional tracer has a fire risk at the impact site due to the residual flame and has a by-product that can contaminate the inside of the gun and lead to firearm failure. To resolve these problems, it is necessary to develop non-combustion-type tracers that can convert heat to luminance, so-called 'thermoluminescence (TL)'. Here, we highly improve the thermoluminescence properties of MgB₄O₇ through co-doping of Dy³⁺+Ce³⁺ and Dy³⁺+Na⁺. The presence of doping materials (Dy³⁺, Ce³⁺, Na⁺) was confirmed by XPS (X-ray photoelectron spectroscopy). The as-synthesized co-doped MgB₄O₇ was irradiated with a specific radiation dose and heated to 500 ℃under dark conditions. Different thermoluminescence characteristics were exhibited depending on the type or amounts of doping elements, and the highest luminance of 370 cd/m² was obtained when Dy 10 % and Na 5 % were co-doped.