• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.437-440
• /
• 2006

In process of the mass concrete structure, the heat of hydration may cause serious thermal cracking. In order to eliminate hydration heat of mass concrete, this paper results of hydration heat control of mass concrete using the Oscillating Capillary tube Heat Pipe(OCHP). There were the several molds which shows a difference as compared with each other. One was not equipped with OCHP. Other were laid with OCHP, and the other were laid in 100cm, and exposed out 50cm. All of them were cooled with natural air convection. The OCHP was composed of copper pipe(outer diameter : 4mm, inner diameter : 2.8mm) and heat type was non-looped type. The working fluid was R-22 and its charging ratio was 40% by volume. The core of the concrete temperature was approximately $53^{\circ}C$ without OCHP. But the concrete temperature with OCHP was reduced its difference in temperature with the outdoor temperature to $12{\sim}15^{\circ}C$. Finally we saw the index figure of the thermal crack of the structures were varied from 0.6 to 1.6.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2005년도 춘계 학술기술논문발표대회 논문집
• /
• pp.9-12
• /
• 2005

This paper investigated the temperature history of mass concrete mock up structure considering different heat generation by varying with mixture proportion. Setting time difference between high early strength mixture (E-P) and retarding mixture (R-F30) was 14.5hours. Incorporation of $30\%$ of fly ash contributed to $10^{\circ}C$ of hydration heat reduction. In generally used C and D combination, bottom concrete shows earlier hydration, while E-J combination showed reverse tendency and thus, this method can reduce the crack occurrence. Therefore, heat generation difference method has beneficial effect on reducing crack induced by hydration heat resulting from heat generation difference between surface and center section.

• 한국세라믹학회지
• /
• 제47권5호
• /
• pp.394-400
• /
• 2010

This study examined the effects of particle size on characteristics of cement by controlling the particle size of commercial cement. Through a size adjustment, the cement has increasing more of particles that are less than $10{\mu}m$ in size so the initial reaction time has been shortened as a result of improvement in the early hydration reaction. Additionally, it showed a great characteristics of strength from the early age and the initial hydration heat has been increased as well. In the upper and middle parts cements, the initial hydration reaction rate contribution is high with the $10{\mu}m$ compared to original cement. So the initial hydration reaction rate is improved and as a result, it also showed relatively high hydration heat as well. Additionally, adiabatic temperature also showed an increase rate in the results.

• 한국건축시공학회지
• /
• 제21권6호
• /
• pp.551-562
• /
• 2021

본 연구에서는 IGCC에서 발생하는 부산물인 CGS를 콘크리트용 혼합 잔골재로써 효율적으로 활용하는 방안을 제시하기 위하여 플라이애시 치환 매스 콘크리트의 수화열 저감 효과를 확보하기 위한 방안으로 CGS 기반 혼합 잔골재와 플라이애시 치환에 따른 수화열 저감 특성 분석 및 해석을 실시 하고자 한다. 따라서, 매스 콘크리트의 수화열 저감을 위하여 활용되는 플라이애시 기반 저발열 결합재에 CGS를 잔골재로 치환하여 최적의 조합으로 FA 30% 및 CGS를 잔골재로 50% 치환할 경우 저발열 결합재 FA를 단일 치환한 경우보다 복합상승 효과에 따라 수화열 저감 성능이 더 크게 나타났다. 따라서 산업부산물인 CGS 골재 조합에 플라이애시를 복합 치환한 분체-골재조합 재료 시스템은 매스 콘크리트 수화열 저감 공법의 효율적인 대안으로서 활용이 기대된다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2012년도 추계 학술논문 발표대회
• /
• pp.101-102
• /
• 2012

In this study, it was evaluated about hydration heat reduction under hot weather condition. Placement temperature set 25℃ and 35℃, For hydration heat reduction was applied such as FA and BFS. As a results, mixture of BFS70% is the most effective hydration temperature reduction.

• 한국세라믹학회지
• /
• 제37권1호
• /
• pp.70-76
• /
• 2000

In order to investigate the properties of the blended cement using coarsely ground blasturnace slag blended coements which were substituted from 10 to 70 wt% low Blaine slag powder (2,000 and 3,000 cm2/g) for porland cement clinker were prepared and Cal(OH)2 contents in hydrates hydration heat the fluidity and the compressive strength were measured. As the content of slag was increased the hydration heat and the early strength was decreased and the fluidity of the cement paste was improved. The heat evolution of the cement with 2,000cm2/g slag was lower than that of 3,000 cm2/g slag blended cement. Especially the heat evolution of 60wt% or above slag blended cement was similar to that of belite rich cement.

• 설비공학논문집
• /
• 제19권2호
• /
• pp.169-174
• /
• 2007

In process of reinforced concrete (RC) box structure, the heat of hydration may cause serious thermal cracking. This paper reports results of hydration heat control in mass concrete using the oscillating heat pipe. There were three RC box molds ($1.2m{\times}1.8m{\times}2.4m$) which were different from each other. One was not equipped with pulsating heat pipe. The others were equipped with pulsating heat pipe. All of them were cooled with natural air convection. The pulsating heat pipe was composed of 10 turns of serpentine type copper pipe whose outer and inner diameters were 4 and 2.8 mm respectively. The working fluid was R-22 and charging ratio was 40% by volume. The temperature of the concrete core was approximately $55^{\circ}C$ in the winter without pulsating heat pipe. For a concrete with pulsating heat pipe, however, the temperature difference with the outdoor one reduced up to $12^{\circ}C$. The index figure of crack was varied from 0.75 to 1.38.

• 한국구조물진단유지관리공학회 논문집
• /
• 제15권5호
• /
• pp.218-226
• /
• 2011

본 연구에서는 스트론튬계 잠열재를 사용한 저발열 콘크리트를 레미콘 배처플랜트에서 시험생산한 후 생산된 콘크리트의 기초성능 및 모의부재에 의한 수화온도 특성을 평가하였으며, 그 결과 스트론튬계 잠열재를 사용한 저발열 콘크리트의 현장적용 가능성을 확인하였다. 이후 스트론튬계 잠열재를 사용한 콘크리트를 실제 교각 건설현장에 적용하였으며, 적용부재에 대한 수화열 해석 및 타설 콘크리트의 성능평가 결과 수화열 및 온도균열 저감효과가 우수한 것으로 나타나, 향후 대형 매스콘크리트의 수화열 및 온도균열 저감대책으로서 활용이 기대된다.

• 토지주택연구
• /
• 제3권1호
• /
• pp.83-88
• /
• 2012

In this study, physical characteristics of cement and/or concrete materials that are typically used for energy-foundation (EF) structures have been studied. The thermal conductivity and structural integrity of the cement-based materials were examined, which are commonly encountered in backfilling a vertical ground heat exchangers, cast-in-place concrete piles and concrete lining in tunnel. For this purpose the thermal conductivity and unconfined compression strength of cement-based materials with various curing conditions were experimentally estimated and compared. Hydration heat generated from massive concrete in the cast-in-place concrete energy pile was observed for 4 weeks to estimate its dissipation time in the underground. The hydration heat may mask the in-situ thermal response test (TRT) result performed in the cast-in-place concrete energy pile. It is concluded that at least two weeks are needed to dissipate the hydration heat in this case. In addition, a series of numerical analysis was performed to compare the effect of thermal property of the concrete material on the cast-in-place pile.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1999년도 학회창립 10주년 기념 1999년도 가을 학술발표회 논문집
• /
• pp.289-292
• /
• 1999

The charateristic of hydration reaction was studied in CaO-Al2O3-SiO2 system glass. As a result, the rate of heat liberation curves of synthestized glass becomes fixed after having increased by degrees. And it is decreasing after having increased suddenly. It was found that the total heat liberation with hydration for synthesized glass has a close relationship with the formation amount of ettringite.