• Electrical & Electronic Materials
• /
• v.11 no.10
• /
• pp.46-52
• /
• 1998

In this study, polarization switching characteristics of Pb(ZrxTil-x)O3 (PZT) thin films were investigated. Switching times(ts) were found to be decreased as the Zr mol% was increased. But, the switching peak currents(Imax) showed the largest value at 50 mol% Zr. As a result of this experiment, ts was found to be depended on the remanent polarization and coercive field and also Imax strongly depended on the dielectric constant of PZT thin films. In order to investigate the partial switching kinetics of PZT thin films, short and relatively small voltage pulses were applied to the MFM(metalferroelectric metal) PZT capacitors and polarization switching curves were measured with a variation of the total width of the applied pulses. Also, the switching curves were measured at different applied voltages(4, 8, 10, 12 and 14 volts). As the applied voltages increased, ts and Imax were found to be decreased and increased, respectively. In case of fatigued specimen which we applied $\pm$10 volts square pulse for 1010 cycles, ts and Imax were found to be shorter and smaller than those of virgin specimens. This is due to the decrease of the remanent polarization and the increase of the coercive field.

• Electrical & Electronic Materials
• /
• v.9 no.8
• /
• pp.836-850
• /
• 1996

In this study, we have analyzed structural analysis and measured ferroelectric characteristics of PZT thin films prepared by sol gel process with different sintering conditions and different Zr/Ti mot%. When the Zr mot% of PZT thin film was increased, it was found that the remanent. polarization and coercive field were decreased and increased, respectively. Also, the maxium dielectric constant of PZT(50/50) thin film was 786.8. We got double hysteresis(anti-fcrroelectric) curve from PbZrO$_{3}$ thin film. As heating rate goes up, pyrochlore phase of PZT thin film was decreased and dielectric and ferroelectric characteristics were improved. As a result of variation of sintering temperature and time 500.deg. C-800.deg. C and 5 sec.-8 hours, respectively, we got optimal sintering temperature and time. The optimium sintering temperature and time of conventional furnace method and rapid thermal processing method were 650.deg. C-700.deg. C for 30-60 minutes and 700.deg. C/20 seconds-2 minutes, respectively.

• Macromolecular Research
• /
• v.15 no.6
• /
• pp.553-559
• /
• 2007

Nanocomposite films were prepared by sol-gel synthesis from vanadium triisopropoxide with $poly((oxyethylene)_9$ methacrylate)-graft-poly(dimethyl siloxane), POEM-g-PDMS, producing in situ growth of vanadium oxide within the continuous ion-conducting POEM domains of micro phase-separated graft copolymer. The formation of vanadium oxide was confirmed by wide angle x-ray scattering (WAXS) and Fourier transform infrared (FT-IR) spectroscopy. Small angle x-ray scattering (SAXS) revealed the spatially-selective incorporation of vanadium oxide in the POEM domains. Upon the incorporation of vanadium oxide, the domain periodicity of the graft copolymer monotonously increased from 17.2 to 21.0 nm at a vanadium content 14 v%, above which it remained almost invariant. The selective interaction of vanadium oxide with POEM was further verified by differential scanning calorimetry (DSC) and FT-IR spectroscopy. The nanocomposite films exhibited excellent mechanical properties $(l0^{-5}-10^{-7}dyne/cm^2)$, mostly due to the confinement of vanadium oxide in the POEM chains as well as the interfaces created by the microphase separation of the graft copolymer.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.2
• /
• pp.343-349
• /
• 1998

The effect of pH on the dehydration reaction of $TiCL_4$ solution. KOH and HC1 were used as a accelerater and retarder in dehydration. Results are follow. Neutralization point is pH 7.4 in the system of $TiCL_4$- KOH and the production which is produced at acidic side is Ti -gel of poly metatitanic acid. The production which is produced at alkalic side is aligomer and crystalline potasium titanate is not detected.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.11 no.1
• /
• pp.27-32
• /
• 2001

The 0.9PMN-0.1PT powders was prepared by the sol-gel process, and the effect amounts of ${Mg(OC_{2}H_{5})}_2$ and ${Pb(CH_{3}COO)}_2.3H_{2}O$ as starting materials was studied. As a result the percent of perovskite phase of the calcined powders increased with increased calcination temperatures. Maximum of perovskite phase was at $850^{\circ}C$ for 4 hrs. 0.9PMN-0.1PT powder by addition of 5 wt% excess ${Mg(OC_{2}H_{5})}_2$ crystallized to perovskite phase with a ${\fallingdotseq}100%$ yield.

• Journal of the Korean Chemical Society
• /
• v.62 no.1
• /
• pp.7-13
• /
• 2018

The potential of zinc fluorides with different molar ratios of Zn/F was applied as a solid catalyst in the simultaneous reaction of transesterification and esterification of crude palm oil (CPO) for biodiesel production. These materials were prepared by the fluorolytic sol-gel technique with different fluorine contents. The resulting samples were investigated using elemental analysis, XRD, FT-IR, TG/DTG, $N_2$ physisorption measurements and SEM. The results exhibited that the presence of fluorine strongly affected the catalytic activity in the biodiesel production. The catalysts with smaller fluorine contents (${\leq}1$) showed the best performance in all of the observed samples, yields from 92.94 to 89.95, 87.38 and 85.21% with increasing fluorine contents, respectively. The yield toward the formation of biodiesel depended on the phase and particle sizes of catalysts, but it was not influenced by surface area, pore size, and volume of the samples. The recovered catalyst showed a gradual decrease in activity over three cycles of same reactions.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.4
• /
• pp.1663-1666
• /
• 2012

Background and Objective: Protein expression in colon and rectal cancer (CRC) and paired normal tissues was examined by two-dimensional gel electrophoresis (2-DE) to identify differentially expressed proteins. Materials and Methods: Five fresh colorectal cancer and paired adjacent normal tissues were obtained and differentially expressed protein spots were determined using PDQuest software, with identification on the basis of MALDI-TOF mass spectra. Results: Compared with normal colorectal mucosa, protein abnormal expression of 65 spots varying more than 1.5 times were found in 2-DE gels from colorectal cancer samples (P<0.05); forty-two proteins were up-regulated and 23 were down-regulated; twelve protein spots were identified using mass spectrometry, of which 8 were up-regulated, includimng HSPB1and Annexin A4, while 4 were down-regulated, the results being consistent with Western blot findings. Conclusions: Two-dimensional electrophoresis reference maps for CRC tissues and adjacent normal mucosa (NMC) were established and 12 differentially expressed proteins were identified. Up-regulated HSPB1 and Annexin A4 may play many important roles in the pathogenesis of colorectal cancer.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.2
• /
• pp.183-188
• /
• 2003

The micro-patterning of multi-layered thin films containing CdS and $Ta_2O_5$ layers on ITO substrate with various structures was successfully obtained by combining three different techniques: chemical solution depositions, sol-gel, and microcontact printing (μCP) methods using octadecyltrichlorosilane (OTS) as the organic thin layer template. $Ta_2O_5$ layer was prepared by sol-gel casting and CdS one obtained by chemical solution deposition, respectively. Parallel and cross patterns of multi-layers with $Ta_2O_5$ and CdS films were fabricated additively by successive removal of OTS layer pre-formed. This study presents the designed architectures consisting of the two types of feature having horizontal dimensions of 170 ㎛ and 340 ㎛ with constant thickness ca. 150 nm of each deposited materials. The thin film lay-out of the cross-patterning is composed of four regions with chemically different layer compositions, which are confirmed by Auger electron microanalysis.

• Carbon letters
• /
• v.15 no.2
• /
• pp.136-141
• /
• 2014

Three dimensional self-assembled graphene hydrogels were easily fabricated by electron beam irradiation (EBI) using an aqueous solution of wool/poly(vinyl alcohol) and graphene oxide (GO). After exposure to various levels of EBI radiation, the highly porous, self-assembled, wool-based graphene hydrogels were characterized using scanning electron microscopy and Fourier-transform infrared spectroscopy; to determine the gel fraction, degree of swelling, gel strength, kinetics-of-swelling analyses and removal of hexavalent chromium (Cr(VI)) from the aqueous solution. X-ray diffraction results confirmed that EBI played a significantly important role in reducing GO to graphene. The adsorption equilibrium of Cr(VI) was reached within 80 min and the adsorption capacity was dramatically increased as the acidity of the initial solution was decreased from pH 5 to 2. Changes in ionic strength did not exert much effect on the adsorption behavior.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.350-354
• /
• 2009

In this work, polymer - inorganic composites have prepared using polymer such as polyethylene glycol (PEG)/poly (methyl methacrylate, PMMA) and inorganic nanofillers materials such as TiO2 nanotubes (TiNTs)/carbon nanotubes (CNTs). The extensive structural, morphological and ionic properties revealed that the high surface area and tubular feature of nanofillers improved the interaction and cross-linking to polymer matrix which is significantly enhanced the ionic conductivity and electrical properties of composite electrolytes. Comparably high conversion efficiency ~4.5% has been observed by using the newly prepared PEG-TiNTs composite solid electrolyte as compared with PMMA-CNTs electrolyte based DSSCs (~3%). The detailed comparative properties would be discussed in term of their structural, morphology, ionic and photovoltaic properties.