• Korean Journal of Environmental Agriculture
• /
• v.19 no.4
• /
• pp.324-327
• /
• 2000

Soybean (Glycine max L. cv. Hwangkeum) seeds were irradiated with the dose of $0{\sim}20$ Gy to investigate the effect of the low dose ${\gamma}-ray$ radiation on the early growth and resistance to subsequent high dose of radiation. Germination rate was not enhanced in the seeds irradiated with low dos ${\gamma}-ray$ but plant height and fresh weight increased in the low dose irradiation group. The optimal radiation dose for the growth increasing was 8 Gy in soybean plant. Growth inhibition of soybean plants by high dose radiation was noticeably reduced by pre-irradiation of low dose radiation, Resistance to subsequent high dose of radiation was effective in 8 Gy and 20 Gy irradiation group.

• Journal of Sericultural and Entomological Science
• /
• v.9
• /
• pp.43-47
• /
• 1969

This experiment was carried out to investigate the effect of gamma ray on the eggs of later stage in late fall rearing season. The results are summarized as follows: 1. The duration of larval stage was simmilar to that of control in any dose. The silkworm growth was uniform in does of 4,000 gamma ray, but in does of 8,000r 16000r was irregular. There were not malformed silkworms but many small silkworm. 2. Mortality of silkworms was very high 8,000r and over; virus diseases of 87.6 per cent, flacherie of 5.9 per cent and complication of 6.5 per cent. 3. The more the dose of gamma ray became, the lighter the weight full grown silkworm and matured silkworm became. 4. The uniformness of cocoons was registered in dose of 2,000r and the cocoons were irregular or small in dose of 16,000r

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.10
• /
• pp.2287-2292
• /
• 2012

In this study, $Co^{60}$ gamma-ray induced loss on Ge-doped single mode (SM) fiber has been measured. Gamma-ray is irradiated for 4 hours at the dose rate of 0.5 kGy/hr, 2 kGy/hr, 8 kGy/hr. Consequently, gamma-ray induced loss based on radiation effects in Ge-doped SM fiber occur significantly. Furthermore, dose rate effect was observed, that dose rate using the same total dose increased higher, then optical fiber loss increased more. Also annealing effect was observed, that the loss after irradiation, increased higher, then the recovery rate of loss was increased. This results are foreseen to be base data in the future radiation-hardened optical fiber study.

• Journal of Radiation Industry
• /
• v.5 no.3
• /
• pp.253-258
• /
• 2011

Acetylsalicylic acid (ASA) has been issued recently in contaminated water environments because of potential impacts on ecosystem and public health. This study was aimed at investigating the possibility of ASA degradation using gamma ray irradiation. In addition, the use of sodium persulfate, hydrogen peroxide, ferrous sulfate were tested in order to examine a synergistic effect with gamma ray. The absorbed dose was ranged from 0.2 to 10 kGy and the concentration of oxidants were from 0.1 to 10 mM in this study. The concentration of ASA was gradually decreased corresponding to the increase of the absorbed dose. When soudium persulfate was simultaneously applied, most of the parent compound was completely degraded even at a low dose of 0.8 kGy. The removal efficiency of total organic carbon was 90% even at the highest dose of 10 kGy without sodium persulfate. However, the efficiency was dramatically enhanced up to 98% at the same dose by adding 10 mM of oxidants. It was suggested that hydroxyl radical ($OH{\cdot}$) and sulfate radical ($SO{_4}^-{\cdot}$) were formed in the system and made roles in degrading ASA at the same time.

• Macromolecular Research
• /
• v.10 no.6
• /
• pp.332-338
• /
• 2002

The effect of an electron beam and ${\gamma}$-ray irradiation on the curing of epoxy resins was investigated. Diglycidyl ether of bisphenol A (DGEBA) and diglycidyl ether of bisphenol F (DGEBF) as epoxy resin were used. The epoxy resins containing 1.0-3.() wt% of triarylsulphonium hexafluoroantimonate(TASHFA) and triarylsulphonium hexafluorophosphate(TASHFP) as initiator were irradiated under nitrogen at room temperature with different dosage of EB and ${\gamma}$-rays from a Co$^{60}$ u source. The chemical and mechanical characteristics of irradiated epoxy resins were compared after curing of EB and ${\gamma}$-ray irradiation. The thermal properties of cured epoxy were investigated using dynamic mechanical thermal analysis. The chemical structures of cured epoxy were characterized using near infrared spectroscopy. Mechanical properties such as flexural strength, modulus were measured. The gel fraction of DGEBA with ${\gamma}$-ray was higher than that of the epoxy with EB at the same dose. Young's modulus of the sample irradiated by ${\gamma}$-ray is higher than that of sample cured by EB. From the result of strain at yield, it was found that the epoxy cured by ${\gamma}$-ray had a higher stiff property compared with the irradiated by EB.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.9
• /
• pp.1611-1614
• /
• 2010

The explosion of a nuclear weapon radiates a gamma-ray in the form of a transient pulse. If the gamma-ray introduces to semiconductor devices, much Electron-Hole Pairs(EHPs) are generated in depletion region of the devices[7]. as a consequence of that, high photocurrent is created and causes upset, latchup and burnout of semiconductor devices[8]. This phenomenon is known for Transient Radiation Effects on Electronics(TREE), also called dose-rate effects. In this paper 3D structure of inverter and NAND gate device was designed and transient pulse gamma-ray was modeled. So simulation for transient radiation effect on inverter and NAND gate was accomplished and mechanism for upset and latchup was analyzed.

• Korean Journal of Environmental Agriculture
• /
• v.17 no.4
• /
• pp.368-370
• /
• 1998

In order to determine the optimal radiation dose for the sterilization of biowastes, the bioburden, frequencies and radiosensitivities of bacteria, mold and fungi in rice straw, chaff, corn stover and sawdust was observed before and after ${\gamma}-ray$ irradiation. Radiation sterilization dose of rice straw, chaff, com stover and sawdust was calculated as 17.7, 17.6, 15.6 and 20.0kGy, respectively, from the mutual compensation of screening dose and derived dose on the basis of $10^{-3}$ SAL. This method could be acceptable for the sterilization of various biowastes including food, pharmaceuticals, etc.

• Journal of Radiation Industry
• /
• v.4 no.1
• /
• pp.73-77
• /
• 2010

In recent day, there is much interest in the biocidal activity of silver since silver is known to be safe and effective as disinifectant and biocidal material against coliforms and viruses. In this study, hydrogels containing silver acetate as antibacterial agent have been prepared using gamma rays irradiation. The hydrogels are composed of poly(vinyl pyrrolidone) (PVP), poly(ethylene glycol) (PEG), carrageenan and silver acetate. The concentration of solution was 9 wt%. The ratio of PVP : PEG : carrageenan was 6 : 1 : 2. The concentration of the silver acetate were 0, 0.01, 0.03, 0.05 and 0.07% and Gamma irradiation dose was 25 kGy. The Gamma irradiation dose in hydrogels with 0.01% silver acetate were 20 kGy, 35 kGy, 50 kGy, 65 kGy, and 80 kGy. The results showed that 0.01% silver acetate concentration of hydrogels by 25 kGy irradiation dose showed the highest antibacterial activity against E. coli and Staphylococcus aureus. Moreover, antibacterial activity of various Gamma irradiation dose in hydrogels treated 0.01% silver acetate showed highest 35 kGy irradiation dose against Staphylococcus aureus.

• Journal of Radiation Industry
• /
• v.6 no.3
• /
• pp.211-215
• /
• 2012

In this study, crosslinked polyethylene (PE) foam sheets were prepared through gamma-ray irradiation. PE foam sheets were prepared through a foaming process using sodium bicarbonate as a blowing and foaming agent. The prepared PE foam sheets were then crosslinked through gamma-ray irradiation. The crosslinking degree was increased to 86.0% with an increase in the absorption dose. The tensile strength of the crosslinked PE foam sheets was increased with an increase in the absorption dose. However, the elongation-at-break of the crosslinked PE foam sheets was decreased. The thermal decomposition temperature of the crosslinked PE foam sheets was increased to $421.2^{\circ}C$ with an increase in the absorption dose. The SEM analysis revealed that the morphology was not changed significantly after the crosslinking through gamma-ray irradiation.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2009.06a
• /
• pp.533-534
• /
• 2009