• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.1
• /
• pp.69-75
• /
• 2010

In this paper, with using the clapp type VCO(Voltage Controlled Osillator) configuration a wideband frequency synthesizer in UHF band is proposed. In order to design a wideband frequency synthesizer, the variation of phase in the negative resistance circuit as well as the load circuit was analyzed. Based on this result we propose a method to widen the operation range of the VCO. A frequency synthesizer using the proposed wideband VCO was designed and fabricated. It is shown that the synthesizer has the operating frequency range of 740~1,530 MHz by 0~5 V varactor tuning voltage, and it had the output power of 2~-6 dBm. Moreover, the phase noise measured as -77 dBc/Hz at 10 kHz offset, and as -108 dBc/Hz at 100 kHz offset from the oscillation frequency.

• Journal of Institute of Control, Robotics and Systems
• /
• v.6 no.8
• /
• pp.719-726
• /
• 2000

A real-time precise positioning is possible with GPS carrier phase measurements with efficient integer ambiguity resolution techniques. It is known that more reliable and fast integer ambiguity resolution is possi-ble as the number of measurements increases. Most precise positioning systems use dual frequency measurements and the wide-lnae technique to resolve integer ambiguity. The wide-lane technique magnifies the measurement noise while it reduces the number of candidates to be examined. In this paper a new integer ambiguity resolution method using dual frequency is proposed The proposed method utilizes the relationship between the wide-lane single frequency and the narrow-lane ambiguities to resolve narrow-lane integer ambiguity after fixing the wide-lane integer ambiguity. Experiments with real data show that the proposed method gives fast and reliable results.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.16 no.2
• /
• pp.145-151
• /
• 2011

In this paper, among the active islanding detection techniques, the modified active frequency drift method was analyzed, which is relatively easy to apply to the single-phase grid-connected PV PCS. The existing designs for turbulences in these applications were empirically conducted, and do not have sufficient reliability and performance. Therefore, three application forms of the modified active frequency drift technique were modeled, based on which the proper magnitude of turbulence, which is the frequency acceleration component, was calculated. Using the results, the magnitude of and injection method for turbulence for ensuring the islanding detection performance and improving the output power quality were proposed, and they were verified via simulations and experiment to prove that the reliable islanding detection technique can be developed merely by measuring the basic output power quality, without the need for expensive islanding simulation equipment.

• Journal of Power Electronics
• /
• v.10 no.3
• /
• pp.328-333
• /
• 2010

A photovoltaic power conditioning system (PV PCS) that contains single-phase dc/ac inverters tends to draw an ac ripple current at twice the output frequency. Such a ripple current perturbs the operating points of solar cells continuously and it may reduce the efficiency of the current based maximum power point tracking technique (CMPPT). In this paper, the ripple current generation in a dc link and boost inductor is analyzed using the ac equivalent circuit of a dc/dc boost converter. A new feed-forward ripple current compensation method to incorporate a current control loop into a dc/dc converter for ripple reduction is proposed. The proposed feed-forward compensation method is verified by simulation and experimental results. These results show a 41.8 % reduction in the peak-to peak ac ripple. In addition, the dc/ac inverter control system uses an automatic voltage regulation (AVR) function to mitigate the ac ripple voltage effect in the dc link. A 3kW PV PCS prototype has been built and its experimental results are given to verify the effectiveness of the proposed method.

• Journal of Power Electronics
• /
• v.11 no.5
• /
• pp.632-638
• /
• 2011

This paper presents a cascaded coil flux control based on a Current Source Parallel Resonant Push-Pull Inverter (CSPRPI) for Induction Heating (IH) applications. The most important problems associated with current source parallel resonant inverters are start-up problems and the variable response of IH systems under load variations. This paper proposes a simple cascaded control method to increase an IH system's robustness to load variations. The proposed IH has been analyzed in both the steady state and the transient state. Based on this method, the resonant frequency is tracked using Phase Locked Loop (PLL) circuits using a Multiplier Phase Detector (MPD) to achieve ZVS under the transient condition. A laboratory prototype was built with an operating frequency of 57-59 kHz and a rated power of 300 W. Simulation and experimental results verify the validity of the proposed power control method and the PLL dynamics.

• Journal of Mechanical Science and Technology
• /
• v.16 no.10
• /
• pp.1303-1313
• /
• 2002

Effects of the reduced frequency of upstream wake on downstream unsteady boundary layer flow were simulated by using a Wavier-Stokes code. The Wavier-Stokes code is based on an unstructured finite volume method and uses a low Reynolds number turbulence model to close the momentum equations. The geometry used in this paper is the MIT flapping foil experimental set-up and the reduced frequency of the upstream wake is varied in the range of 0.91 to 10.86 to study its effect on the unsteady boundary layer flow. Numerical solutions show that they can be divided into two categories. One is so called the low frequency solution, and behaves quite similar to a Stokes layer. Its characteristics is found to be quite similar to those due to either a temporal or spatial wave. The low frequency solutions are observed clearly when the reduced frequency is smaller than 3.26. The other one is the high frequency solution. It is observed for the reduced frequency larger than 7.24. It shows a sudden shift of the phase angle of the unsteady velocity around the edge of the boundary layer. The shift of phase angle is about 180 degree, and leads to separation of the boundary layer flow from corresponding outer flow. The high frequency solution shows the characteristics of a temporal wave whose wave length is half of the upstream frequency. This characteristics of the high frequency solution is found to be caused by the strong interaction between unsteady vortices. This strong interaction also leads to destroy of the upstream wake strips inside the viscous sublayer as well as the buffer layer.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.3
• /
• pp.276-282
• /
• 2003

OFDM is effective for the high speed data transmission. However, the nonlinear distortion is a serious problem because of the high PAPR due to many subcarriers. The conventional SLM selects the OFDM signal with the lowest PAPR. In this method, OFDM data can be correctly recovered only if the side information about the phase sequence is transmitted to receiver. This paper proposes a new method of side information insertion into the conventional SLM and reduces the computational complexity by adaptive method. Performances are compared in case that three kinds of phase sequences are used for phase rotation factor. The adaptive SLM method has the same PAPR reduction as the conventional SLM method. The required BER can be guaranteed by the proposed method. When subcarrier number N=32, computational complexity is reduced to 48 %, 72 % and 51 % for the branch number U=4, 8 and 16, respectively.

• Journal of electromagnetic engineering and science
• /
• v.4 no.2
• /
• pp.72-78
• /
• 2004

In this paper, we evaluate the performance of the digital modulation schemes described in the APCO Project 25 FDMA specifications which can be used for applying the ultra-narrowband technology to the current domestic simple two-way radio systems, and discuss difficulties in the DSP implementation of the systems. We analyze the effect on the systems' BER performance of receiver non-matched filter and frequency-offset between the transmitter and receiver oscillators. And we present a frequency offset compensation method for improving the system performance. The results of performance analysis showed that the CQPSK of APCO Project 25 using non-matched filter degraded the BER by 0.5～1.0 ㏈ comparing with PI/4 DQPSK using matched filter. In the event of 2 % frequency offset, about 1 ㏈ performance loss was produced at the BER of $$10^{-3}TEX>. With the frequency-offset compensation method implemented in the systems using phase recovery scheme of PSK synchronization detection, the performance degradation of about 1.0 ㏈ was occurred at the BER of $$10^{-3}TEX> for 10 % of frequency offset. The proposed method can be used for the improvement of system performance.

• The Journal of the Acoustical Society of Korea
• /
• v.26 no.6
• /
• pp.227-234
• /
• 2007

This paper describes a transmission method based on a single carrier with frequency domain equalization (SC-FDE) scheme with cyclic prefix(CP). The SC-FDE has similar features with orthogonal frequency division multiplexing(OFDM). Similar to OFDM, a SC-FDE system is computationally efficient since equalization is reformed on a block of data in the frequency domain. Especially, it has the advantage of low sensitivity to nonlinear distortion compared to OFDM. In this paper, we design a SC-FDE receiver using decision-directed method, and present simulation results.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.23 no.3
• /
• pp.213-220
• /
• 2020

This paper proposes a method on the performance analysis of pulse repetition frequency jitter compensation for generating Doppler profile. Exact phase compensation of each pulse is required to obtain Doppler profiles under pulse repetition frequency jitter. Three parameters such as velocity, pulse repetition frequency, and carrier frequency are examined to cause errors when conducting the pulse repetition frequency jitter compensation, then assuming well-focused Doppler profiles reflect well-conducted pulse repetition frequency jitter compensation, the proposed method in this paper utilizes the contrast to measure how well Doppler profile is generated. These are validated by electromagnetic computation data and computer simulation. Then, it is concluded which parameter is important on the performance analysis of pulse repetition frequency jitter compensation by using the contrast.