• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2003년도 추계학술대회 논문집
• /
• pp.85-89
• /
• 2003

Many single-stage PFC(power-facto.-correction) ACHC converters suffer from the high link voltage at high input voltage and light load condition. In this paper, to suppress the link voltage, a novel high power factor high efficiency PFC AC/DC converter is proposed using the single controller which generates two gate signals so that one of them is used far gate signal of the flyback DC/DC converter switch and the other is applied to the Boost PFC stage. A 130w prototype for LCD monitor adapter with universal input $(90-265V_{rms})$ and 19.5V 6.7A output is implemented to verify the operational principles and performances. The experimental results show that the maximum link voltage stress is about 450V at 270Vac input voltage. Moreover, efficiency and power factor are over $84\%$ and 0.95, respectively, under the full load condition.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.126-128
• /
• 2008

This paper presents an architecture for driving multiple paralleled cold cathode fluorescent lamps (CCFLs) for back lighting applications. Multi CCFL operation and increase of brightness, the key to the architecture is a proposed capacitive coupling approach for lamp ignition. This system is consist of a flyback converter, a single inverter to drive multiple lamps and conductive floating reflector. The topology is capable of driving a number of parallel lamps with independent accurate lamp, The capacitive coupling the leakage inductance and stray capacitance creation which it used, current regulation and improving cost effectiveness with significant reduction in size and weight, compared to typical high frequency ac ballast. Experimental demonstration results for ten of parallel CCFLs with simultaneous ignition.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2010년도 하계학술대회 논문집
• /
• pp.125-126
• /
• 2010

In this paper, a novel multiple output converter using quasi load is proposed. Conventional multiple output converters using multi-winding transformer has poor output voltage regulations. To solve this problem, there are many proposals like post regulation method, weighted control method, and etc. However, the post regulation method regulates output voltage tightly but its conduction loss and cost are increased. And the weighted control can achieve high efficiency and low cost but its regulation is not enough. To solve these problems, this paper proposes a novel multiple output converter using quasi load. The proposed method uses a quasi load which acts like an active dummy load for tight regulation but there is rarely increase of loss and cost. The proposed method is verified by hardware test by two output(24V and 15V) flyback type converter.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2010년도 하계학술대회 논문집
• /
• pp.133-134
• /
• 2010

전자전기 제품의 수요가 증가하면서 다양한 전원회로들이 개발되고 있다. 특히 높은 전력밀도와 제작 단가 절감을 위해서 다 출력 컨버터의 개발 연구가 진행되고 있다. 본 논문은 3.3V와 5V 두 가지 출력을 가지는 비대칭 하프브리지 플라이백 컨버터를 제안한다. 제어기 하나를 통해 추가적인 제이기술 없이 간단한 방법으로 출력 전압을 제어하였으며, 다 출력 컨버터에서 문제가 되는 cross regulation 성능을 향상 시켰다. 제안된 다 출력 컨버터는 3.3V/16A, 5V/12A 출력 용량의 시제품 제작을 통해 성능을 검증하였다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2010년도 하계학술대회 논문집
• /
• pp.226-227
• /
• 2010

최근 IT 산업의 $CO_2$ 배출량의 증가로 고효율 시스템의 개발이 중요시되고 있다. 이에 따라 많은 고효율 시스템에 대한 연구들이 큰 파워를 담당하는 PFC단과 DC/DC단을 중심으로 진행되어 왔고, 고효율의 시스템을 개발되었다. 하지만 스탠바이단에 대한 연구가 부족하였고 현재 낮은 효율에 머물러 있다. 그러므로 본 논문에서는 고효율 스탠바이컨버터를 통해, 전체효율의 향상시키는 연구하였다. 기존의 스탠바이 컨버터인 flyback 컨버터의 단점인 스위치의 높은 전압스트레스, 스너버 손실 그리고 Hard switching하는 단점을 DC/DC 컨버터와 통합된 구조를 가짐으로써, 추가적인 소자의 사용 없이 해결한다. 본 논문에서는 제안한 구조를 통해 경부하 효율이 향상되는 것을 결합원리, 동작원리 및 실험을 통해 검증하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 추계학술대회 논문집 학회본부 A
• /
• pp.406-408
• /
• 1999

In order to reduce the overall size and cost, researchers attempted to integrate the functions of power factor correction(PFC) and isolated dc-dc conversion into single power stage. However, single-stage isolated PFC converters have higher voltage stress and heavier loss when compared with a normal dc-dc converters. In this paper, we propose to add active clamping circuit to keep the switch voltage stress low and to achieve soft switching of electronic devices.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제50권3호
• /
• pp.122-129
• /
• 2001

Exact simulation of conducted EMI in switched mode power supplies is proposed. In order to achieve exact simulation, PSPICE active component ABM model and modified transformer model are proposed. Each model parameter is extracted from measurements and data-books. PSPICE simulation results with high frequency PCB pattern model are accordant with EMI measurements for a 50[W] isolated flyback converter. EMI relations of each component and EMI patterns are analyzed.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 F
• /
• pp.2163-2165
• /
• 1998

This paper presents an adaptive control scheme of a ballast for HID lamp for an automotive headlight. A flyback converter is used for the voltage step-up and for the control. A full bridge inverter is used as a ballast topology. The proposed control method is an adaptive output power control with a charge control. The developed ballast satisfies the requirement of a fast warm up characteristics and operating stability for an automotive application.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 춘계학술대회 논문집 초전도 자성체
• /
• pp.7-10
• /
• 2002

We designed the flyback planar transformer, which had 8W capacity, with 70V input voltage and 8.2V output voltage for the establishment of design method and the confirmation of application possibility. The numerical value of inductance measured under the switching frequency of 120 kHz was 1650 ${\mu}H$, which was the inductance efficiency of 85~87% against theoretical value. The A.C. resistance of primary and secondary coil was 4.2 ${\Omega}$ and 0.25 ${\Omega}$ respectively. On the other hand, the quality factor for each wound numbers showed quite a high value of 158 and 75 respectively. And the Coupling Factor was 0.96~0.97 under 120 kHz switching frequency. And the shape of the output wave of the planar transformer at 70V input voltage was a stable square wave.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 B
• /
• pp.986-987
• /
• 2006

준공진형 플라이백 컨버터를 사용하여 Full HD급 DLP 프로젝터용 컨버터 설계에 대해 고찰하였다. 소형 경량화 시키기 위한 방법으로 Full Mode Packaging 형태로 절연설계에 유리하게 하였고, Shidegn사의 MR4040을 사용하여 부분공진 스위칭 동작에 의해 고효율 저노이즈를 실현하였다. 중부하 시 스위칭 주파수는 35KHz, 경부하시 스위칭 주파수는 최대 200KHz이고 입력전압 AC $90{\sim}264$[v], 출력전력 66W급의 컨버터을 제작하였으며 측정된 효율은 최고 93% 이다.