• 한국환경과학회지
• /
• 제22권4호
• /
• pp.425-433
• /
• 2013

A mass balance of process was calculated by using the analysis of basic unit and environmental assessment of all the processes of Busan fashion color industry cooperative that operates a combined heat and power plant and a bio treatment plant. The mass balance for the combined heat and power plant was done, based on boiler and water treatment processes while each unit reactor was used for the bio treatment plant. From the results above, a resource recycle network, a treatment flowchart for food waste water/wastewater treatment and a carbon reduction program were established.

• Journal of Power Electronics
• /
• 제16권5호
• /
• pp.1735-1742
• /
• 2016

This paper proposes an interleaved five-level boost converter based on a switched-capacitor network. The operating principle of the converter under the CCM mode is analyzed. A high voltage gain, low component stress, small input current ripple, and self-balancing function for the capacitor voltages in the switched-capacitor networks are achieved. In addition, a three-loop control strategy including an outer voltage loop, an inner current loop and a voltage-balance loop has been researched to achieve good performances and voltage-balance effect. An experimental study has been done to verify the correctness and feasibility of the proposed converter and control strategy.

• 대한기계학회논문집
• /
• 제19권9호
• /
• pp.2297-2307
• /
• 1995

An experimental study on the structure of a separated shear layer downstream of the backward-facing step has been performed by examining mean flow and turbulent quantities in terms of free stream turbulence. When free stream turbulence exists, the entrainment rate of the separated shear layer and the flow rate in the recirculation region are enhanced, resulting in shorter reattachment length. The production and diffusion terms in the turbulent kinetic energy balance are shown to increase more than the dissipation term does. Rapid decrease of the pressure-strain term in the shear stress balance implies the enhancement of the three-dimensional motion by free stream turbulence.

• Steel and Composite Structures
• /
• 제16권5호
• /
• pp.521-531
• /
• 2014

In this paper we consider a periodic solution for nonlinear free vibration of conservative systems for thick circular sector slabs. In Energy Balance Method (EBM) contrary to the conventional methods, only one iteration leads to high accuracy of the solutions. The excellent agreement of the approximate frequencies and periodic solutions with the exact ones could be established. Some patterns are given to illustrate the effectiveness and convenience of the methodology. Comparing with numerical solutions shows that the energy balance method can converge to the numerical solutions very rapidly which are valid for a wide range of vibration amplitudes as indicated in this paper.

• Journal of Advanced Marine Engineering and Technology
• /
• 제22권6호
• /
• pp.854-861
• /
• 1998

The demand of LNG as a cheap and clean energy which does not cause an environmental problem has sharply been increased in Korea. In general LNG is stored in a cargo tank specially designed as a liquid state below $-162^{\circ}C$. The main engine of a LNG carrier is generally a steam boiler because LNG is a highly flammable fluid with the possibility of explosion. The main engine of a cargo ship has to be capable of the propulsion load and various auxiliary loads for the safe navigation since it is the primary energy source. Therefore the evaluation of a main boiler's energy capacity is a key design point in the planning of LNG carrier's construction. This research is to develop the computational program for the analysis of steam boiler Heat balance for LNG carrier.

• 국제초고층학회논문집
• /
• 제1권2호
• /
• pp.73-80
• /
• 2012

In order to use sea breezes to counter the heat island phenomena, i.e. to promote urban ventilation, it is necessary to clarify the effect of building morphology and height on large-scale wind fields. In this study, the sea breeze in the vicinity of the Kanto Plain in Japan is simulated using a mesoscale meteorological model incorporating an urban canopy model, and the inland penetration of sea breezes is accurately reproduced. Additionally, a mean kinetic energy balance within a domain (Control Volume; CV) moving along the sea breeze is analysed. From the results, it is clarified that the sea breeze is interrupted by the resistance and turbulence caused by buildings at the centre of Tokyo. The interruption effect is increased in accordance with the height of these buildings. On the other hand, adverse pressure gradients interrupt in the internal region.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2003년도 Proceedings of ACRS 2003 ISRS
• /
• pp.292-294
• /
• 2003

Evapotranspiration estimations are essential for monitoring drought, wild land fire risk etc. In this study, a surface energy balance method, which combines meteorological observations with spectral data derived from remote sensing measurements, was used to estimate the regional evapotranspiration in the Mongolia, a large arid and semi-arid region with heterogeneous surface conditions. The Surface Energy Balance method has been applied to Landsat+ETM and NOAA-AVHRR sensors for the estimation of evapotranspiration in the grassland of Mongolia. As a result, a daily evapotranspiration map of Mongolia was produced.

• Steel and Composite Structures
• /
• 제42권4호
• /
• pp.477-487
• /
• 2022

The shear stiffness of headed-stud shear connectors has no unified definition due to the nonlinear characteristics of its load-slip relationship. A unified framework was firstly adopted to develop a general expression of shear load-slip equation for headed-stud shear connectors varying in a large parameter range based on both force and energy balance. The pre- and post-yield shear stiffness were then determined through bilinear idealization of proposed shear load-slip equation. An updated and carefully selected push-out test database of 157 stud shear connectors, conducting on studs 13~30mm in diameter and on concretes 30~180 MPa in cubic compressive strength, was used for model regression and sensitivity analysis of shear stiffness. An empirical calculation model was also established for the stud shear stiffness. Compared with the previous models through statistical analysis, the proposed model demonstrates a better performance to predict the shear load-slip response and stiffness of the stud shear connectors.

• 대기
• /
• 제23권3호
• /
• pp.307-320
• /
• 2013

We performed comprehensive quality control for eddy-covariance measurements from 3 farmland sites and 1 industrial site adjacent to Nakdong river. The quality control program is based on Foken and Wichura (1996) and Vicker and Mahrt (1997) and we added criteria for trend and standard deviation for scalar variables and modified criteria for non-stationarity condition of Foken and Wichura (1996) to consider random error of fluxes. The classification of data quality is designed for the raw data and the processed flux data, separately. Use of added criteria efficiently reduces the number of outlier for water vapor and $CO_2$ fluxes and use of modified criteria for non-stationarity reduces the number of outlier for scalar fluxes and increases the number of data with accepted quality for further work. Energy balance ratio is higher in farmlands than industrial site, which is due to neglect of heat storage term in industrial site. Among farmland sites, C4 site shows higher energy balance ratio than other sites. This is due to more homogeneous surface of C4 site than other farmland sites. However, energy balance ratio is very low or even negative at night. Mismatch between the flux footprint and the other energy component footprint over the heterogeneous surface is main cause for energy imbalance at night. Other possible causes are also discussed.

• 전기전자학회논문지
• /
• 제25권2호
• /
• pp.356-361
• /
• 2021

파워 소자의 트레이드오프 현상을 최소화하기 위해 제시된 구조가 Super Junction 구조이다. Super Junction은 기존의 많이 사용하던 기본 구조 대비 1/5 정도의 낮은 온 저항(Ron) 특성을 가질 수 있다. Super Junction 구조의 공정 방법으로 Multi-Epi 공정과 Deep-Trench 공정 방법이 있다. Deep-Trench 공정은 실리콘 기판 상면에 깊은 트렌치 공정을 통하여 그안에 불순물이 도핑 되어 있는 폴리실리콘을 매립하여 P-Pillar를 형성 시키는 공정 방법이라 매립하는 과정에서 결함이 형성되기 쉬워서 비교적 어려운 제조 방법으로 알려져 있다. 하지만 비교적 Deep-Trench 공정으로 만들어진 구조가 낮은 온저항과 높은 항복 전압을 형성하여 좋은 효율을 보인다. 본 논문에서는 공정상의 새로운 방법을 제시하고, Charge Balance 이론을 접목시킨 구조를 설계하였다.