• 산업경영시스템학회지
• /
• 제37권3호
• /
• pp.82-88
• /
• 2014

The government expands its investment on R&D programs for economic growth, thus there is growing attention on the result of R&D Programs. This study proposes more improved measuring method for efficiency when the number of R&D programs is not enough to be for measuring efficiency analysis. It provides more various application method of factors on efficiency analysis. This study analyzes the influence of each input factor on efficiency by using partial efficiency concept. And it also determines input factors in similar influence throughout Spearman correlation coefficient. Finally, it suggests new method to improve discriminatory power of efficiency analysis by determining representative factors. Also, the proposed method can be practiced not only for national R&D programs, but also for other fields of research.

• 한국화재소방학회논문지
• /
• 제33권3호
• /
• pp.56-62
• /
• 2019

본 논문은 규정 유량, 양정, 회전수 및 비속도가 각각 0.7 ㎥/min, 8 m, 1750 rpm, 182 m, ㎥/min, rpm인 원심펌프의 운전시 펌프의 회전수와 유량의 변화가 펌프의 운전특성에 미치는 영향을 고찰하였다. 실험에 사용된 펌프는 안내깃이 없고 외주에 바로 접하여 와류실이 있는 볼류트 펌프를 회전수 1350 rpm에서 1750 rpm까지 100 rpm씩의 회전수 변화 5단계에 따른 H-Q특성, L-Q특성, 𝜂-Q특성 등의 관계와 무차원 성능 특성인 양정계수, 동력계수, 효율 등의 특성을 실험을 통하여 다음과 같은 결론을 얻었다. 회전수의 증가에 따라 펌프 성능의 변화정도를 추정할 수 있고, 펌프의 최대효율은 1450 rpm일 때 유량 0.165 ㎥/min, 양정 4.73 m에서 약 52%, 최대 회전수인 1750 rpm일 때 유량 0.183 ㎥/min, 양정 6.72 m에서 약 50%의 효율이 나타난다. 또한 양정 대 유량의 성능 특성 곡선상에서 등효율 곡선은 펌프의 상사법칙에 따른 원점을 지나는 2차식의 곡선으로 나타나지 않고 타원형으로 변형되어 나타난다. 마지막으로 유량계수가 증가함에 따라 동력계수는 증가하고 양정계수는 감소하며, 유량계수가 0.08일 때 최대효율 52% 되는 것을 통해 유량변화가 운전특성에 미치는 영향을 알 수 있다.

• Nuclear Engineering and Technology
• /
• 제46권2호
• /
• pp.217-224
• /
• 2014

The present work used the efficiency transfer method used to calculate the full energy peak efficiency (FEPE) curves of the (2"*2" & 3"*3") NaI (Tl) detectors based on the effective solid angle subtended between the source and the detector. The study covered the effect of the self attenuation coefficient of the source matrix (with a radius greater than the detector's radius) on the detector efficiency. $^{152}$ An Eu aqueous radioactive source covering the energy range from 121.78 keV up to 1408.01 keV was used. In this study an empirical formula was deduced to calculate the difference between the measured and the calculated efficiencies [without self attenuation] at low and high energy regions. A proper balance between the measured and calculated efficiencies [with self attenuation] was achieved with discrepancies less than 3%, while reaching 39% for calculating values [without self attenuation] due to working with large sources, or for low photon energies.

• 복식문화연구
• /
• 제20권4호
• /
• pp.475-484
• /
• 2012

The purpose of this study is to help to prevent daily noises by measuring the noise absorption coefficient of the non-woven fabrics and wallpapers which are commonly used in lining and noise absorption coefficient of lining curtain. Seven types of fiber materials for the interior decoration, one non-woven fabric for the wallpaper linings, and two types of textiles for curtain linings are used as the experimental materials in this study. The noise absorption coefficient of the noise absorbents were measured by using impedance tube. And the thermal transmittance were measured by using thermal transmittance tester. The results of this study are as follows; Observing the noise absorption efficiency of each experimental materials, the combination of fiber materials and linings, the noise absorption efficiency of cotton, polyester and silk were similar and for the experimental materials of flax, rayon, acrylic and nylon were resulted the similar noise absorption efficiency. The result of combination of fiber material and black fabric was highest among the combined linings. For the combination of fiber material and non-woven fabric, double layers of non-woven fabric resulted slightly higher noise absorption coefficient result than single layer of non-woven fabric. The thermal transmittance and the sound absorbents of experimental materials were affected by the thickness, density and layer of air of the experimental materials.

• 한국콘텐츠학회논문지
• /
• 제8권10호
• /
• pp.158-171
• /
• 2008

최근 지식기반경제로의 진입과 함께 지적자본의 효율성 측정에 관한 문제는 미시적 측면은 물론 거시적 관점에서도 중요한 관심의 대상이 되고 있다. 본 연구는 2000년-2005년 기간 동안 한국, 미국, 일본, 중국을 중심으로 각 국가별 지식기반경제에 있어서 국가경제 성취도를 측정할 수 있는 새로운 지표 즉, 국민지적자본의 효율성계수와 부가가치지적계수를 측정하여 상호 비교분석 하였다. 분석 결과 미국의 경우 국민지적자본의 효율성계수와 부가가치지적계수가 각각 1.480과 6.585로 4개국 중 가장 높게 나타났다. 이는 4개국 중 가장 높은 1인당 GDP 41,541 달러와 연결됨으로서 가장 효율적으로 국민지적자본을 활용하고 있는 것 으로 나타났다. 한편, 한국 경우는 국민적자본의 효율성 계수는 1.321인 반면 이에 상응하는 부가가치지적 계수는 4.733으로서 지식기반경제의 이행정도와 국가 경제규모에 걸맞게 국민지적자본을 활용을 하고 있는 것으로 나타났다. 그러나 일본의 경우 가장 낮은 국민적자본의 효율성(1.271)에 비해 매우 높은 부가가치지적계수(5.695)를 보인 반면, 중국의 경우는 비교적 높은 국민지적자본의 효율성(1.438)에 가장 낮은 부가가치지적계수(3.815)를 보임으로서 여타 국가들과 대조를 보였다.

• 한국물환경학회지
• /
• 제23권5호
• /
• pp.577-580
• /
• 2007

The influence of flow rate has been investigated on the treatment efficiency of continuous cycling electrolytic process employing artificial and actual photographic wastewater which containing silver ion. For artificial wastewater, the treatment efficiency of process was found to rise ca. three times when the flow rate of wastewater was increased from 3 mL/min to 15 mL/min. The process efficiency was doubled under the same condition regarding actual wastewater. The effect of flow rate on the treatment efficiency was observed to be altered according to the metal ionic form and solution composition. The coefficient of mass transfer was estimated using model equation, which verified that the raised treatment efficiency at higher flow rate was due to the increased mobility of ionic species.

• 설비공학논문집
• /
• 제6권2호
• /
• pp.140-154
• /
• 1994

Experimental studies were performed to determine the characteristics of flow structure and pressure drop in 15 : 1 scale models of multi-louvered fin heat exchanger in a wide range of variables($L_P/F_P=0.5{\sim}1.23$, ${\theta}=27^{\circ}{\sim}37^{\circ}$, $Re_{LP}=50{\sim}2000$). Flow structure inside the louvered fin was analyzed by smoketube method and new correlations on flow efficiency and drag coefficient were suggested. The new definition for flow efficiency, which modifies the existing flow efficiency, can predict the flow efficiency in the range above mentioned and is represented as a function of Reynolds number, louver pitch to fin pitch ratio, louver angle at low Reynolds number. Drag coefficient which is defined here is a function of Reynolds number, louver pitch to fin pitch ratio, louver angle below critical Reynolds number, and can be represented by a function of louver pitch to fin pitch ratio only above the critical Reynolds number.

• International Journal of Fluid Machinery and Systems
• /
• 제4권1호
• /
• pp.150-160
• /
• 2011

This study focuses on the Achard turbine, a vertical axis, cross-flow, marine current turbine module. Similar modules can be superposed to form towers. A marine or river hydropower farm consists of a cluster of barges, each gathering several parallel rows of towers, running in stabilized current. Two-dimensional numerical modelling is performed in a horizontal cross-section of all towers, using FLUENT and COMSOL Multiphysics. Numerical models validation with experimental results is performed through the velocity distribution, depicted by Acoustic Doppler Velocimetry, in the wake of the middle turbine within a farm model. As long as the numerical flow in the wake fits the experiments, the numerical results for the power coefficient (turbine efficiency) are trustworthy. The overall farm efficiency, with respect to the spatial arrangement of the towers, was depicted by 2D modelling of the unsteady flow inside the farm, using COMSOL Multiphysics. Rows of overlapping parallel towers ensure the increase of global efficiency of the farm.

• ETRI Journal
• /
• 제40권3호
• /
• pp.303-308
• /
• 2018

This paper proposes a simple yet accurate method for estimating the antenna correlation coefficient (ACC) of a high-order multiple-input multiple-output (MIMO) antenna. The conventional method employed to obtain the ACC from three-dimensional radiation patterns is costly and difficult to measure. An alternate method is to use the S-parameters, which can be easily measured using a network analyzer. However, this method assumes that the antennas are highly efficient, and it is therefore not suitable for lossy MIMO antenna arrays. To overcome this limitation, we define and utilize the non-coupled radiation efficiency in the S-parameter-based ACC formula. The accuracy of the proposed method is verified by the simulation results of a 4-port highly coupled lossy MIMO array. Further, the proposed method can be applied to N-port arrays by expanding the calculation matrix.

• Journal of Advanced Marine Engineering and Technology
• /
• 제33권1호
• /
• pp.52-61
• /
• 2009

This experiment was conducted in attempt of improving hydrodynamic efficiency of the propulsion mechanism by installing a spring to the wing so that the opening angle of the wing in one stroke can be changed automatically, compared to the existing method of fixed maximum opening angle in Weis-Fogh type ship propulsion mechanism. Average thrust coefficient was almost fixed with all velocity ratio with the prototype, but with the spring type, thrust coefficient increased sharply as velocity ratio increased. Average propulsive efficiency was larger with bigger opening angle in the prototype, but in the spring type, the one with smaller spring coefficient had larger value. In the range over 1.0 in velocity ratio where big thrust can be generated, spring type had more than twice of propulsive efficiency increase compared to the prototype.