• Journal of Electrical Engineering and Technology
• /
• v.13 no.2
• /
• pp.781-789
• /
• 2018

This paper proposes a new approach utilizing empirical mode decomposition (EMD) reconstruction to process vibration signals of a transformer under DC bias caused by high voltage direction transmission (HVDC), which is the potential cause of additional vibration and noise from transformer. Firstly, the Calculation Method is presented and a 3D model of transformer is simulated to analyze transformer deformation characteristic and the result indicate the main vibration is produced along axial direction of three core limbs. Vibration test system has been built and test points on the core and shell of transformer have been measured. Then, the signal reconstruction method for transformer vibration based on EMD is proposed. Through the EMD decomposition, the corrupted noise can be selectively reconstructed by the certain frequency IMFs and better vibration signals of transformer have been obtained. After EMD reconstruction, the vibrations are compared between transformer in normal work and with DC bias. When DC bias occurs, odd harmonics, vibration of core and shell, behave as a nonlinear increase and the even harmonics keep unchanged with DC current. Experiment results are provided to collaborate our theoretical analysis and to illustrate the effectiveness of the proposed EMD method.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.49 no.4
• /
• pp.161-167
• /
• 2000

This paper presents a new methodology that can evaluate transfer capability of composite power systems from the adequacy point of view in power system planning stages. First of all, to evaluate practical load supplying capability, nonlinear optimization problems of maximum load supplying capability(MLSC) and economic load supplying capability(ELSC) are formulated and solved by nonlinear primal-dual interior point method. Here, physical constraints considered in the optimization problems are the limits of bus voltage, line overloading, and real & reactive power generation. Also, an evaluation method of transfer capability is presented based on margins calculated by the MLSC and ELSC. Especially, to evaluate transfer capability flexibly, simple indices such as expected MLSC, transfer capability margin, and power not supplied are respectively proposed by considering (N-1) line outage probability. Numerical results on IEEE RTS 24, IEEE 118, and IEEE 300 bus system show that the proposed algorithm is effective and useful for power system planning stages.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.6
• /
• pp.965-974
• /
• 2009

The current study reviews the formula used to calculate the stability of an artificial reef in the breaking wave zone of coastal waters. A comparison was carried out between the existing formula and a new formula that takes into account the water particle velocity in the breaking wave zone. Water particle velocity was analyzed using the Fluent (CADMAS-SURF) software program. The new formula took into various factors, including the difference in the drag coefficient due to the direction of the current and the ratio of distance between two reefs. The drag coefficient of the artificial reef due to the direction of the current was 0.84 when the distance ratio was 0.5. When the artificial reef was placed at 45 degree angle to the current, the product of the drag coefficient and the project area were 40 to 46 % greater than when the reef was placed at 90 degree angle. Our results regarding the stability of an artificial reef indicate that the new formula provides the designers of artificial reefs with a more rational and economic design rationale rather than the existing formula.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.19 no.5
• /
• pp.30-38
• /
• 2005

This paper proposes a new method which can calculates nodal price as an economic signal at non-optimal operation. By using pseudo constraints in 11 cases, we calculate shadow price and nodal price based on non-optimal operation. By comparing shadow price and nodal prices based on optimal and non-optimal operation effectiveness of the method is verified.

• KIEAE Journal
• /
• v.17 no.5
• /
• pp.87-94
• /
• 2017

Purpose: Prefabricated modular space such as a container construction has recently been interested unlike the conventional construction method, and their scale have expanded from small buildings such as cafes, houses and pensions to shopping centers, complex cultural spaces where shows and exhibitions are possible doing. In this way, the container is in the spotlight as an advantage such as mobility, flexibility, correspondence, economic efficiency, recyclability and so on. However, there are no specific guidelines and standard design methods in aspects of structural calculation, functional insulation and environmental configuration. Therefore, as the first step to resolve these problems, this study has focused on the field of environmental performance of container construction, presented appropriate guidelines and searched ways to improve performances. Method: For this study, seven types of the modular building were chosen and compared, and their energy performances have been analyzed using a proven simulation tool. Essential methodology and terminology were examined to estimate and judge their efficiency. Result: In conclusion, energy performances depend on specific configuration of combined unit spaces, and design guidelines cold be set up for promoting their use in the practical field.

• Journal of Power System Engineering
• /
• v.10 no.1
• /
• pp.34-40
• /
• 2006

The snow melting system by electric heating wires which is adopted in this study is a part of road facilities to keep surface temperature of the road higher than freezing point of water for melting the snow accumulated on it. The system is designed to increase traffic safety and capacity. The electric heating wires are buried under paved road at a certain depth and operated automatically and manually. Design theory, amount of heating, and installation standard vary according to economic situation, weather condition, and installation place where the system applies. It is tried to figure out that the appropriate range of required heat capacity and installation depth and intervals for solving snowdrifts and freezing problems with the minimum electric power consumption. The most important factors to design the system are calculation of heating capacity depending on weather condition and depth and interval of the electric heating wires depending on air condition respectively. The study were performed under the range of the air temperatures($-2^{\circ}C,\;-5^{\circ}C,\;-8^{\circ}C$), the intervals of the electric heating wires(70mm, 100mm, 125mm), and the installation depths(50mm, 70mm, 100mm). The ready made commercial program package was used to verify the experimental results.

• Journal of Korea Water Resources Association
• /
• v.35 no.6
• /
• pp.729-736
• /
• 2002

The computation of normal depth is one of the most important parts in the design of open channel flow, and the best section is in general the most economic section in the case of constructing artificial open channels. Thus the determination of the normal depth of the best section is the essential item in the design of most open channel flows. To estimate the frictional forces a power law is introduced, which is applicable to most situations in open channel flows. Explicit and consistent forms of equations are deduced for the calculation of normal depth of triangular, rectangular and trapezoidal best sections. Furthermore the equations of normal depth are found to have the same form as those of pipe diameter for the design of pipe flow.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.63 no.5
• /
• pp.73-81
• /
• 2021

The objective of this study was to analyze the waste nutrient generation loads from hydroponics for three major crops in Gyeongsangnam-do. Study hydroponic farms were selected for the three major crops such as paprika, strawberry, tomato based on the agricultural statistics data and field investigation. The flow amount and water quality for inflow and outflow of study hydroponic farms were monitored and analyzed on a monthly basis. Monitored samples were analyzed in terms of DO, BOD, T-N, T-P, SS, and EC. The generated load of BOD, T-N, and T-P were calculated from the monitored flow and water quality. The monitoring results showed that the drainage ratio for the circular hydroponic farm was lower than the non-circular hydroponic farm because the outflow from the circular hydroponics were much lower than that from the non-circular. The generated load calculation results showed that the BOD tended to have a smaller value than the TMDLs guideline for land, while T-N and T-P showed higher value than that from the TMDLs guideline. In order to effectively manage the pollutant load discharged from the hydroponics farming complex, it is necessary to manage the non-circulating hydroponics farm. To improve water quality, it is necessary to gradually expand the circulating hydroponics farm through policy and economic support.

• Geomechanics and Engineering
• /
• v.18 no.3
• /
• pp.277-289
• /
• 2019

In this study, an innovative anchoring approach has been developed dealing with all relevant aspects in consideration of previous works. An ultimate pulling force calculation of anchor is presented from a geotechnical point of view. The proposed umbrella anchor focuses not only on the friction resistance capacity, but also on the axial capacity of the composite end structure and the friction capacity occurring around the wedge. Even though the theoretical background is proposed, in-situ application requires high-level mechanical design. Hence, the required parts have been carefully improved and are composed of anchor body, anchor cap, connection brackets, cutter vanes, open-close ring, support elements and grouting system. Besides, stretcher element made of aramid fabric, interior grouting system, guide tube and cable-locking apparatus are the unique parts of this design. The production and placement steps of real sized anchors are explained in detail. Experimental results of 52 pullout tests on the weak dry soils and 12 in-situ tests inside natural soil indicate that the proposed approach is conservative and its peak pullout value is directly limited by a maximum strength of anchored soil layer if other failure possibilities are eliminated. Umbrella anchor is an alternative to conventional anchor applications used in all types of soils. It not only provides time and workmanship benefits, but also a high level of economic gain and safe design.

• Journal of Korea Trade
• /
• v.26 no.1
• /
• pp.99-112
• /
• 2022

Purpose - This paper empirically investigates via a spatial lag model from the perspective of space economy to find the influencing factors of South Korea's OFDI along with 60 countries. Design/methodology - In the study of regional economic phenomena, we must first test the corresponding spatial correlation, and on this basis, complete the construction of the spatial model. For the target research object, after testing the spatial correlation, if there is spatial correlation, a spatial measurement model is needed. This paper uses the global Moran's I index for calculation. Based on the characteristics and research needs of the research object, this paper selects the spatial lag model to verify the existence of the spatial effect and factors affecting OFDI. Findings - Our results show that export scale, infrastructure, technology level, political stability, resource endowment, market size, distance and labor cost have a certain impact on Korea's OFDI, but at present the distance and market size factors are the most important influencing factors for South Korea's OFDI, The technical level and political stability have little effect on South Korea's OFDI, and are not main factors determining South Korea's OFDI. Originality/value - Through spatial measurement verification, it was found that the spatial effect has a significant impact on OFDI, along with more than 60 countries. On this basis, relevant suggestions are put forward, which have strong practical significance for South Korea's OFDI to achieve healthy and sustainable development.