• 전자공학회논문지 IE
• /
• v.45 no.1
• /
• pp.24-30
• /
• 2008

In this paper, Digital MultiTone(DMT) is an emerging multi-carrier modulation scheme, which has been adopted for VDSL(Very high speed Digital Subscribe Line). A problem of DMT is its sensitivity to frequency offset between the transmitted and received carrier frequencies. This frequency offset introduces inter-carrier interference(ICI) in the DMT symbol. This paper is proposed an ICI cancelation scheme using Kalman Filtering. The performance of the proposed method is compared with conventional methods in terms of bit error rate performance, bandwidth efficiency, and computational complexity. Through simulations, it is shown that for high values of the frequency offset and for higher order modulation schemes, the EKF(Enhanced Kalman Filtering) method perform better than the others.

• Journal of electromagnetic engineering and science
• /
• v.4 no.2
• /
• pp.72-78
• /
• 2004

In this paper, we evaluate the performance of the digital modulation schemes described in the APCO Project 25 FDMA specifications which can be used for applying the ultra-narrowband technology to the current domestic simple two-way radio systems, and discuss difficulties in the DSP implementation of the systems. We analyze the effect on the systems' BER performance of receiver non-matched filter and frequency-offset between the transmitter and receiver oscillators. And we present a frequency offset compensation method for improving the system performance. The results of performance analysis showed that the CQPSK of APCO Project 25 using non-matched filter degraded the BER by 0.5～1.0 ㏈ comparing with PI/4 DQPSK using matched filter. In the event of 2 % frequency offset, about 1 ㏈ performance loss was produced at the BER of $$10^{-3}TEX>. With the frequency-offset compensation method implemented in the systems using phase recovery scheme of PSK synchronization detection, the performance degradation of about 1.0 ㏈ was occurred at the BER of $$10^{-3}TEX> for 10 % of frequency offset. The proposed method can be used for the improvement of system performance.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.1
• /
• pp.1-13
• /
• 1995

In this paper, a specification for wireless LAN MODEM using direct sequence spread spectrum (DS/SS) technique is presented. Some algorithms and hardware architectures for an efficient implementation of the DS/SS MODEM are suggested. In the method, all baseband signal processing are done digitally for single chip implementation. Schemes of DQPSK baseband modulation/demodulation, despreading with digital matched filter, digital timing recovery, and efficient carrier sensing are among the discussed algorithms. We also performed various kinds of simulations to evaluate the system performance and to extract parameters for hardware implementation. In addition, the pictorial view of ASIC of the SS MODEM is also shown.

• Journal of Advanced Navigation Technology
• /
• v.11 no.1
• /
• pp.9-16
• /
• 2007

In this paper, the Bit Error Ratio (BER) performances of the D8PSK modulation schemes for VDL Mode-2 are analyzed according to the matched and unmatched cases of the channel filters. The carrier frequency and phase offset effects are analyzed with unmatched case. Generally in digital transmission techniques, the Root Raised Cosine filters which are used as channel filters are applied to both sides at transmitter and receiver in order to achieve no ISI, but in VDL Mode-2, the Raised Cosine Filter is used only in transmission section and the receiver section uses general low pass filter, therefore we could not achieve ISI reduction effects but can have better spectrum quality. From the simulation results, the error probability is increased slightly (1~2dB) with use of un-matched channel filter, we got the conclusions that carrier phase offset do not effect to bit error ratio, but the frequency offset effect is so serious. Finally, narrow band D8PSK modulation signals are generated by the use of Digital Up-Converter and then its features are compared with analog modulator.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.1
• /
• pp.10-17
• /
• 2007

Hierarchical modulation technology which can make the advanced T-DMB(terrestrial-digital multimedia broadcasting) system backward compatible with the conventional T-DMB system and provide high-rate and high-quality services is introduced in this paper. As additional data streams are embedded within the conventional data streams by the hierarchical modulation, the advanced T-DMB system can provide high-quality video service and more broadcasting service channels. In order to guarantee the quality of both the conventional and additional services powerful error correcting scheme is required. The error performance of advanced T-DMB system with hierarchical modulation is investigated and analyzed according to the various error correcting schemes in this paper.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 1999.11b
• /
• pp.249-254
• /
• 1999

In this paper we analyze the bit error rate of an in-band DAB(Digital Audio Broadcasting) system which is based upon orthogonal frequency division multiplexing(OFDM) and uses M-PSK and M-QAM modulation schemes in the interference environment of an analog FM signal. Results are derived which take into account the influence of the frequency non- selective Rician fading channel, but they are valid for Rayleigh fading channel and AWGN channel as well. Theoretical bit error rates and simulation results are given for system parameters for DAB proposed by ETRI(Electronics and Telecommunications Research Institute).

• Proceedings of the IEEK Conference
• /
• 1998.06a
• /
• pp.38-41
• /
• 1998

Due to the increasing demand to multimedia services over wireless communication network, LMDS(Local Multipoint Distribution Service) has been proposed as an alternate approach for broadband wireless access network. But LMDS, Which uses the mmwavelength radio spectrum, has been limited for unknown microwave frequency characteristics. In this paper, we analyze the parameters related to the system design on 28GHz frequency: Propagation path loss and rainfall attenuation. Based on these analytical results, the proper cell size in Korea is determined. We also analyze the bit error rate and frame loss rate for various kinds of digital modulation schemes(QAM 4, 16, 64, 256). Finally, we apply to ㅍ service to evaluate a call blocking rate, efficiency and channel capacity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.10A
• /
• pp.1147-1158
• /
• 2004

In this paper we design STBC-OFDM systems by applying several STBC schemes to the OFEM system and show their comparative analysis results obtained through computer simulations under Rayleigh fading environments, considering the effect of channel estimation error. We first consider the space-time coding algorithms of major STBC schemes, together with their demodulation algorithms. We then select the OFDMparameters considering mobile environments and design the STBC-OFDM systems by choosing one of digital modulation schemes such as QPSK, BPSK, 16QAM, 64QAM, and 256QAM according to the transmission rate, and describe the block diagrams of the demodulator and channel estimator. We finally compare and analyze the BER performances of the STBC-OFDM systems according to the transmission rate and the number of receive antennas.

• Transactions of the Society of Information Storage Systems
• /
• v.1 no.2
• /
• pp.155-160
• /
• 2005

In this paper, the channel decoder promising reliable data retrieving in noisy holographic channel has been developed for holographic WORM(write once read many) system. It covers various DSP(digital signal processing) blocks, such as align mark detector, adaptive channel equalizer, modulation decoder and ECC(error correction code) decoder. The specific schemes of DSP are designed to reduce the effect of noises in holographic WORM(H-WORM) system, particularly in prototype of DAEWOO electronics(DEPROTO). For real time data retrieving, the channel decoder is redesigned for FPGA(field programmable gate array) based hardware, where DSP blocks calculate in parallel sense with memory buffers between blocks and controllers for driving peripherals of FPGA. As an input source of the experiments, MPEG2 TS(transport stream) data was used and recorded to DEPROTO system. During retrieving, the CCD(charge coupled device), capturing device of DEPROTO, detects retrieved images and transmits signals of them to the FPGA of hardware channel decoder. Finally, the output data stream of the channel decoder was transferred to the MPEG decoding board for monitoring video signals. The experimental results showed the error corrected BER(bit error rate) of less than $10^{-9}$, from the raw BER of DEPROTO, about $10^{-3}$. With the developed hardware channel decoder, the real-time video demonstration was possible during the experiments. The operating clock of the FPGA was 60 MHz, of which speed was capable of decoding up to 120 mega channel bits per sec.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.10
• /
• pp.858-866
• /
• 2013

In the DVB-S2, which is the technical specification of the second generation digital video broadcasting via satellite, APSK modulation scheme along with LDPC coding schemes are defined. APSK is a multi-lelvel PSK modulation scheme and decoding of LDPC coded signal requires soft decision information. Therefore, the APSK demodulator at the receiver should have capability of estimating soft information. In this paper, we introduce a method to estimate soft information by using simple distance estimation, and show that this method overestimates the soft information. Subsequently, this overestimated soft information leads to performance degradation. In order to overcome this problem, we propose a scaling method to improve the performance at the receiver In addition, we show that the proposed scaling scheme enables us to estimate the soft information with linear order complexity and produce the performance close to the maximum likelihood detection.