• ETRI Journal
• /
• v.45 no.4
• /
• pp.690-703
• /
• 2023

Multistage amplifiers have become appropriate choices for high-speed electronics and data conversion. Because of the large number of high-impedance nodes, frequency compensation has become the biggest challenge in the design of multistage amplifiers. The new compensation technique in this study uses two differential stages to organize feedforward and feedback paths. Five Miller loops and a 500-pF load capacitor are driven by just two tiny compensating capacitors, each with a capacitance of less than 10 pF. The symbolic transfer function is calculated to estimate the circuit dynamics and HSPICE and TSMC 0.18 ㎛. CMOS technology is used to simulate the proposed five-stage amplifier. A straightforward iterative approach is also used to optimize the circuit parameters given a known cost function. According to simulation and mathematical results, the proposed structure has a DC gain of 190 dB, a gain bandwidth product of 15 MHz, a phase margin of 89°, and a power dissipation of 590 ㎼.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.12
• /
• pp.90-95
• /
• 2014

This paper presents a VHF/UHF-band variable gain low noise amplifier for multi-standard mobile TV tuners. A proposed VHF-band variable gain amplifier is composed of a resistive shunt-feedback low noise amplifier to remove external matching components, a single-to-differential amplifier with input PMOS transcoductors to improve low frequency noise performance, a variable shunt-feedback resistor and an attenuator to control variable gain range. A proposed UHF-band variable gain amplifier consists of a narrowband low noise amplifier with capacitive tuning to improve noise performance and interference rejection performance, a single-to-differential with gm gain control and an attenuator to adjust gain control range. The proposed VHF-band and UHF-band variable gain amplifier were designed in a $0.18{\mu}m$ RF CMOS technology and draws 22 mA and 17 mA from a 1.8 V supply voltage, respectively. The designed VHF-band and UHF-band variable gain amplifier show a voltage gain of 27 dB and 27 dB, a noise figure of 1.6-1.7 dB and 1.3-1.7 dB, OIP3 of 13.5 dBm and 16 dBm, respectively.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.1
• /
• pp.59-67
• /
• 2016

A novel instrumentation amplifier (IA) using fully-differential linear operational transconductance amplifier (FLOTA) for electronic measurement systems with low cost, wideband, and gain control with wide range is designed. The IA consists of a FLOTA, two resistor, and an operational amplifier(op-amp). The principal of the operating is that the difference of two input voltages applied into FLOTA converts into two same difference currents, and then these current drive resistor of (+) terminal and feedback resistor of op-amp to obtain output voltage. To verify operating principal of the IA, we designed the FLOTA and realized the IA used commercial op-amp LF356. Simulation results show that the FLOTA has linearity error of 0.1% and offset current of 2.1uA at input dynamic range ${\pm}3.0V$. The IA had wide gain range from -20dB to 60dB by variation of only one resistor and -3dB frequency for the 60dB was 10MHz. The proposed IA also has merits without matching of external resistor and controllable offset voltage using the other resistor. The power dissipation of the IA is 105mW at supply voltage of ${\pm}5V$.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.3
• /
• pp.15-20
• /
• 2012

This paper presents a 5-Gb/s optical receiver circuit realized in a $0.13-{\mu}m$ CMOS technologies for the applications of high-speed digital interface. Exploiting modified RGC input stage at the front-end transimpedance amplifier, interleaving active feedback and source degeneration techniques at the limiting amplifier, the proposed optical receiver chip demonstrates the measured results of $72-dB{\Omega}$ transimpedance gain, 4.7-GHz bandwidth, and $400-mV_{pp}$differential output voltage swings up to the data rate of 5-Gb/s. Also, the chip dissipates 66mW in total from a single 1.2-V supply, and occupies the area of $1.6{\times}0.8mm^2$.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.39 no.4
• /
• pp.25-35
• /
• 2002

This work describes an 8b 200MHz time-interleaved subranging analog-to-digital converter (ADC) based on a single-poly digital CMOS process. Two fine ADCs for lower digital bits of the proposed ADC employ a time-sharing double-channel architecture to increase system speed and a new reference voltage switching scheme to reduce settling time of the reference voltages and chip area. The proposed intermeshed resistor string, which generates reference voltages for fine ADCs, improves linearity and settling time of the reference voltages simultaneously. The proposed sample- and-hold amplifier(SHA) is based on a highly linear common-drain amplifier and passive differential circuits to minimize power consumption and chip area with 8b accuracy and employs input dynamic common mode feedback circuits for high dynamic performance at a 200MHz sampling rate. A new encoding circuit in a coarse ADC simplifies the signal processing between the coarse ADC and two successive fine ADCs.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.3
• /
• pp.384-390
• /
• 2008

Chaotic OOK modulation method can be used in LDR(Low Data Rate) UWB systems. In this paper, UWB chaotic-OOK transmitter system is designed and verified using TSMC 0.18 um CMOS process. A transmitter system is composed of Quasi-chaotic signal generator, OOK Modulator, and driving amplifier. The traditional chaotic signal generators using analog feedback method is weak to process variation. In order to solve this problem, a quasi-chaotic signal generator using digital feedback technique is get wide band signal and OOK Modulator using T-type switching structure is used to enhance the isolation characteristic. A driving amplifier has differential to single structure to avoid an external balun for low cost communication. The measured output power spectrum of the transmitter meet the FCC regulation and the result of the modulation test at data rate of 20 Kbps, 200 Kbps, 2 Mbps, and 10 Mbps is conformed to LDR UWB system. It is shown that the transmitter in this paper can be used for the UWB chaotic-OOK system.

• Molecules and Cells
• /
• v.28 no.4
• /
• pp.331-339
• /
• 2009

Capsaicin is a very important secondary metabolite that is unique to Capsicum. Capsaicin biosynthesis is regulated developmentally and environmentally in the placenta of hot pepper. To investigate regulation of capsaicin biosynthesis, the promoter (1,537 bp) of pepper capsaicin synthase (CS) was fused to GUS and introduced into Arabidopsis thaliana (Col-0) via Agrobacterium tumefaciens to produce CSPRO::GUS transgenic plants. The CS was specifically expressed in the placenta tissue of immature green fruit. However, the transgenic Arabidopsis showed ectopic GUS expressions in the leaves, flowers and roots, but not in the stems. The CSPRO activity was relatively high under light conditions and was induced by both heat shock and wounding, as CS transcripts were increased by wounding. Exogenous capsaicin caused strong suppression of the CSPRO activity in transgenic Arabidopsis, as demonstrated by suppression of CS expression in the placenta after capsaicin treatment. Furthermore, the differential expression levels of Kas, Pal and pAmt, which are associated with the capsaicinoid biosynthetic pathway, were also suppressed in the placenta by capsaicin treatment. These results support that capsaicin, a feedback inhibitor, plays a pivotal role in regulating gene expression which is involved in the biosynthesis of capsaicinoids.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.14 no.1
• /
• pp.62-71
• /
• 2009

In this paper, an improved drive method of piezoelectric PZT stack actuator for micro-positioning system is proposed and the performances are evaluated. This type of amplifier is based on switching technology efficiently handling the arbitrary regenerative energy from the piezoelectric actuator. The conventional voltage-feedback control method has the THD of -32dB (${\approx}2.5%$) with 100mHz sinusoidal reference, which means that the positioning performance in linearity degrades due to the hysteretic relationship between actuator voltage and the displacement. This paper proposed an improved charge-controlling method, which utilizes differential information of charge reference instead of integrating the actuator's current. The current waveform has THD under -40dBV (=1%) and the displacement waveform nearly -52dB (${\approx}0.25%$), which means that the positioning performance is very excellent. Finally, another method of the displacement feedback control has better performance than the voltage method, however there exists a limitation in performance of the system.

• Animal cells and systems
• /
• v.3 no.3
• /
• pp.319-329
• /
• 1999

Onset of female puberty follows a series of prepubertal cellular and molecular events including changes of synaptic plasticity, synthetic and releasing activity and gene expression. Dramatic increase of gonadal steroid level is one of the most prominent changes before the onset of puberty. Based on the importance of steroid feedback upon the hypothalamus, we adopted an estrogen sterilized rat (ESR) model where 100 ng of 17$\eta$-estradiol were administered into neonatal pubs for 7 days after birth. To identify genes involved in the onset of female puberty, we applied PCR differential display using RNA samples derived from ESR and control rat hypothalami. About 100 out of more than 1000 RNA species examined displayed differential expression patterns between a 60-day old control rat and ESR. Sequence analysis of differentially amplified PCR products showed homology with genes such as mouse kinesin superfamily-associated protein 3 (KAP3) and several cDNAs previously described by others in mouse and human tissues. Several gene products such as 2-1 and 8-1 corresponded to novel DNA sequences. We analyzed mRNA levels of KAP3, 2-1 and 8-1 genes in the hypothalami derived from neonatal, 6-, 28-, 31-, and 40-day old rats. Northern blot analysis showed that mRNAs of KAP3, 2-1 and 8-1 genes were markedly increased before the initiation of puberty. Neonatal treatment of estrogen clearly inhibited prepubertal increases in KAP3, 2-1 and 8-1 mRNA levels. Therefore, these genes may play important roles in the initiation of hypothalamic puberty. In addition, intracerebroventricular (icv) injection of antisense KAP3 oligodeoxynucleotide (ODN) clearly delayed puberty initiation determined by vaginal opening, which further confirmed that KAP3 plays an important role in the regulation of puberty initiation.

• Journal of Convergence Society for SMB
• /
• v.6 no.3
• /
• pp.49-55
• /
• 2016

This paper proposes an adaptive video signal transmission scheme in order to ensure the QoS (Quality of Service) of user requirements. SVC (Scalable Video Coding) is an effective transmission scheme, because that can transmit video signal according to the video layer's weight. However, in previous works, those adaptive transmission systems which are considered about the various channel environments and user requirements have not been insufficiently studied. So, we propose the SVC signal transmission using inter-layer differential OVSF code allocation scheme in MC-CDMA. The proposed scheme is able to obtain each layer signal's protection order and control the sub-block of MC-CDMA by feedback information from receiver. Therefore, our proposed scheme is possible to provide the video quality for each users according to variable channel environments. The simulation results demonstrate the enhancement of proposed system in terms of BER performance.