• Journal of Radiation Protection and Research
• /
• 제43권4호
• /
• pp.131-136
• /
• 2018

Background: We investigated the current characteristics of a thin-film Ag electrode on a chemical vapor deposition (CVD) diamond. The CVD diamond is widely recognized as a radiation detection material because of its high tolerance against high radiation, stable response to various dose rates, and good sensitivity. Additionally, thin-film Ag has been widely used as an electrode with high electrical conductivity. Materials and Methods: Considering these properties, the thin-film Ag electrode was deposited onto CVD diamonds with varied deposition thicknesses (${\fallingdotseq}50/98/152/257nm$); subsequently, the surface thickness, surface roughness, leakage current, and photo-current were characterized. Results and Discussion: The leakage current was found to be very low, and the photo-current output signal was observed as stable for a deposited film thickness of 98 nm; at this thickness, a uniform and constant surface roughness of the deposited thin-film Ag electrode were obtained. Conclusion: We found that a CVD diamond radiation detector with a thin-film Ag electrode deposition thickness close to 100 nm exhibited minimal leakage current and yielded a highly stable output signal.

• 척추신경추나의학회지
• /
• 제16권1호
• /
• pp.67-72
• /
• 2021

Objectives The purpose of this study was to analyze the current status of utilization of Korean medical institutions. Methods This study analyzed the Health Insurance Review and Assessment Service data (2016-2020). We included patients with one of the five most frequent diseases in Korea and examined the variation in healthcare utilization. Results This study analyzed the Health Insurance Review and Assessment Service data (2016-2020). We included patients with one of the five most frequent diseases in Korea and examined the variation in healthcare utilization. Conclusions As a result of this study, It was possible to understand the impact of Chuna treatment and COVID-19 on the use of Korean medical institutions. Further studies are needed to establish a definite conclusion regarding the relevance of COVID-19.

• Nuclear Engineering and Technology
• /
• 제54권2호
• /
• pp.501-506
• /
• 2022

Long turn-off time limits high frequency operation of Bipolar Junction Transistors (BJTs). Turn-off time decreases with increases in the recombination rate of minority carriers at switching transients. Fast neutron irradiation on a Si BJT incurs lattice damages owing to the displacement of silicon atoms. The lattice damages increase the recombination rate of injected holes with electrons, and decrease the hole lifetime in the base region of pnp Si BJT. Fast neutrons generated from a beryllium target with 30 MeV protons by an MC-50 cyclotron were irradiated onto pnp Si BJTs in experiment. The experimental results show that the turn-off time, including the storage time and fall time, decreases with increases in fast neutron fluence. Additionally, it is confirmed that the base current increases, and the collector current and base-to-collector current amplification ratio decrease due to fast neutron irradiation.

• 전력전자학회논문지
• /
• 제1권1호
• /
• pp.7-11
• /
• 1996

From the cost-effective point of view, it is very important to design a current with the highest utilization factor of current capacity of power devices. This can be accomplished by a current controller without overshoot irrespective of the varying bounds of control voltage in PWM converters and the dead time due to the time delay. This paper suggests a novel decoupled controller with Smith-Predictor which has the fast control response without overshoot and steady stats error and also deal with the design method of the controller for PWM converters. The extensive digital simulations done by SIMULINK/MATLAB show that the suggested controller guarantees the full utilization of current capacity of power devices and the decoupled current control behavior.

• 임상간호연구
• /
• 제18권1호
• /
• pp.159-170
• /
• 2012

Purpose: This study was designed to examine the validity of the evidence-based guideline on pain developed by Registered Nurses Association of Ontario(RNAO) translated into Korean based on the experts' opinions. Methods: The panel consisted of experts of 60 registered nurses in surgical units, medical doctors and nursing managers who were experts in pain assessment and management. The validity of translated RNAO guideline was evaluated in terms of appropriateness, applicability, and utilization in current practice. Appropriateness and applicability of each recommendation were measured with 9 point scale, whereas utilization was measured by yes/no question. Data were analyzed by mean, standard deviation, and percent. The experts' opinions were analyzed by content analysis method. Results: In general, most of the recommendations in the guideline received above 7 point in appropriateness and applicability. However, above 20% of recommendations showed less than 50% of utilization rates in current practice. Conclusion: The reasons for low utilization of recommendations in current practice are in need for investigation. This study can be used for the development of guideline more acceptable in Korean health care settings and improve the quality of care for the abdominal surgery patients suffering from pain in Korea.

• 전력전자학회논문지
• /
• 제11권5호
• /
• pp.426-430
• /
• 2006

본 논문에서는 제어 시지연을 갖는 고성능 PI 전류제어기에 대한 새로운 예측전류 적용방법을 모색한다. 먼저 선형 영구자석 동기전동기를 사용한 선형 서보 제어시스템에 존재하는 불가피한 전류예측 오차원인을 분석하고, 전류예측 오차와 제어 시지연을 고려한 전류제어 성능 개선 방법으로 수정된 동기좌표계 비간섭 PI 전류제어기를 제안한다. 그리고 시뮬레이션 및 실험 결과를 통하여 제안된 전류제어기가 서보 제어시스템에 존재하는 전류예측 오차와 제어 시지연이 있는 경우에도 개선된 전류제어응답을 보임을 검증하였다.

• Journal of Power Electronics
• /
• 제16권4호
• /
• pp.1367-1374
• /
• 2016

This paper presents a discrete-time version of voltage and current limited operation using an enhanced direct torque and flux control method for interior permanent magnet synchronous motor (IPMSM) drives. A command voltage vector for airgap torque and stator flux regulation can be uniquely determined by the finite-settling-step direct torque and flux control (FSS-DTFC) algorithm under physical constraints. The proposed command voltage vector trajectories can be developed to achieve the maximum inverter voltage utilization for the discrete-time current limit (DTCL)-based FSS-DTFC. The algorithm can produce adequate results over a number of the potential secondary upsets found in the steady-state current limit (SSCL)-based DTFC. The fast changes in the torque and stator flux linkage improve the dynamic responses significantly over a wide constant-power operating region. The control strategy was evaluated on a 900W IPMSM in both simulations and experiments.

• 한국수소및신에너지학회논문집
• /
• 제28권4호
• /
• pp.377-383
• /
• 2017

This paper presents the performance characteristics of a 1 kW solid oxide fuel cell (SOFC) stack under various internal reforming and fuel utilization conditions. The Research Institute of Industrial Science & Technology (RIST) developed the 9-cell stack using a $20{\times}20cm^2$ anode supported planar cell with an active area of $324cm^2$. In this work, current-voltage characteristic test, fuel utilization test, continuous operation, and internal reforming test were carried out sequentially for 765 hours at a furnace temperature of $700^{\circ}C$. The influence of fuel utilization and internal reforming on the stack performance was analyzed. When the 1 kW stack was tested at a current of 145.8 A with a corresponding fuel utilization of 50-70% (internal reforming of 50%) and air utilization of 27%, the stack power was approximately 1.062-1.079 kW. Under continuous operation conditions, performance degradation rate was 2.16%/kh for 664 hours. The internal reforming characteristics of the stack were measured at a current of 145.8. A with a corresponding fuel utilization of 60-75%(internal reforming of 50-80%) and air utilization of 27%. As fuel utilization and internal reforming ratio increased, the stack power was decreased. The stack power change due to the internal reforming ratio difference was decreased with increasing fuel utilization.

• Journal of Information Technology Applications and Management
• /
• 제15권3호
• /
• pp.127-152
• /
• 2008

This study sought to explore how SMEs are utilizing EC. Drawing on existing research on IT and EC related field, this study presented the framework of EC utilization level and analyzed its affecting factors in the point of organizational perspectives; strategy and competency. The impact of EC utilization on firm performance was also examined by employing BSC. Structural equation model was applied to test the relationships among the theoretical constructs with data from 171 SMEs. The results showed that the rate of EC utilization in SMEs is growing quite rapidly. However, manufacturing related firms still remain at a lower level compared to service related firms. As for the two affecting factors of EC utilization level, it was found that the level of EC utilization appeared to be driven not by strategy but by competency. This result implicates that EC utilization in SMEs doesn't reach to strategic purpose yet, while it is dependent on firm's competency. As far as the impact of EC utilization on firm performance, the study showed that the level of EC utilization has significant relationship with all perspectives performance indicators of BSC. This study can provide the managers with current EC utilization pattern and the guidelines as to where to put the efforts in the EC utilization and how to get an effective EC utilization strategy in the future.

• 가족자원경영과 정책
• /
• 제17권1호
• /
• pp.159-178
• /
• 2013

This study aims to evaluate the retirement income readiness of Korea, a country that-considering its high property asset ratio-is seeing an unprecedented rapid progression of graying. The result of analyzing 6,589 non-retired households in Statistics Korea's Survey of Household Finances (2011) is as follows. First, the Retirement Readiness Index, considering annual income and asset utilization income before including longevity risk, was 70.6. The index increased to 89.5 when utilizing real assets excluding houses and exceeded 100 when utilizing houses. Second, when designating 100 to be the life expectancy and taking into consideration longevity risk, there results were 52.5, 63.7, and 81.1, respectively. Third, since it is less likely for one to use all current financial assets as post-retirement income, the study reviewed the changes in the Retirement Readiness Index by applying three different levels of asset utilization ratios (50%, 75%, and 100%), which refer to the conversion ratios of current assets to retirement assets. This study is significant in that it considers longevity risk and applies asset utilization ratios in various ways, outside of the assumption that all current financial assets will be used as post-retirement income, to take a more realistic approach to retirement readiness.