• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2002년도 학술대회지
• /
• pp.499-502
• /
• 2002

The present study has been carried out for understanding of flows over an evaporator in cooling system of water. Main emphasis is to decide the flow patterns in order to enhance the flow rate with low noise level. Two cases aye examined for comparison of flows; one is blowing system and the other is suction style with respect to Inn system. Present methodology for this work is PIV (Particle Image Velocimetry) techniques and Rot-wire anemometer for velocity measurements and wind tunnel for performance of the present fan. Consequently, it is found that flows passing evaporator and other components for cooling are more effective than the suction flows. Flow details with performance of fan system are also presented for proper explanation of the conclusion.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2005년도 전기학술대회논문집
• /
• pp.1096-1101
• /
• 2005

In this study, the experiment of thermal performance about closed-type hybrid cooling tower was conducted. A closed type cooling tower is a device similar to a general cooling tower, but with cooling tower replaced by a heat exchanger. The test section for this experiment has the process that the cooling water flows from top part of heat exchanger to bottom side in the inner side of tube, and spray water flows gravitational direction in the outer side of it. Air contacts of tube outer side are counterflow. The heat transfer pipe used in this experiment is a bare type tube having an outside diameter of 15.88mm. In this experiment, heat performances of the cooling tower are calculated such as overall heat transfer coefficient of between the process fluid and air, cooing capacity and pressure drop.

• 동력기계공학회지
• /
• 제9권2호
• /
• pp.88-92
• /
• 2005

The experiment of thermal performance about closed-wet cooling tower was conducted in this study. A closed cooling tower is a device similar to a general cooling tower, but with cooling tower replaced by a heat exchanger. The test section for this experiment has the process that the cooling water flows from the top of the heat exchanger to the bottom side in the inner part of the tube, and spray water flows in the gravitational direction in the outer side. Air comes in direct contact with the spray water at the outer side of the tube while passing from the lower the upper part having a counterflow to the spray water. The heat transfer pipe used in this experiment is a bare-type tube having an outer diameter of 15.88mm. The heat exchanger is consisted of seven rows and fifteen columns. In this experiment, thermal performance of the cooling tower is derived from overall heat transfer coefficients between the process fluid and sprayed water and volumetric overall mass transfer coefficient between sprayed water and air.

• 한국전산유체공학회지
• /
• 제14권1호
• /
• pp.62-69
• /
• 2009

The cooling system for electric devices of hybrid vehicles is examined. The present system is composed of coolant paths, inlet diffuser and heat sinks whose shapes are diamond and circular. In this work, inlet duct and fin arrays are combined in proposed models and examined by numerical calculations. Nusselt number and Reynolds number are considered for heat transfer performance. Main focus lies on the looking for optimal model for the cooling system adopted to compact driving module of a hybrid vehicle. The optimal model shows uniform flow patterns in the inlet diffuser and secondary flows after the fins attached to heat source. It is found that the vortical flows around the heat sinks are effective for heat removal mechanism.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제30회 춘계학술대회논문집
• /
• pp.315-320
• /
• 2008

본 연구에서는 화염 안정기 형상이 램제트 연소실에서의 단열 막냉각 효율에 미치는 영향에 대하여 실험을 수행하였다. 램제트 연소실 입구의 경사진 확장면의 끝에 화염안정기 형상을 설치하여 화염안정기에 의해 발생된 난류 유동이 다단 슬롯에 영향을 끼치도록 실험 장치를 구성하여, 화염안정기 형상을 탈부착 시키면서, 슬롯 출구 하류에서의 단열 막냉각 효율을 측정하였다. 화염 안정기를 설치하였을 경우 화염안정기에 의해 발생된 유동의 높은 전단력과 난류강도로 급격히 주유동과 혼합되어, 화염안정기가 설치되지 않은 경우에 비해 전체적으로 냉각 성능이 감소함을 결과를 통해 확인하였다.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2005년도 동계학술발표대회 논문집
• /
• pp.445-450
• /
• 2005

In this paper, the individual reentering rate of the cooling towers installed on a building roof is investigated considering the wind direction and louver wall installation. As the western wind with 5 m/s flows and the louver wall is not installed around the roof. the reentering rate of the cooling towers is predicted about 20%. However the reentering rate is simulated about 5% when the louver wall is installed around the roof. As the southern wind with 5 m/s flows and the louver wall is not installed, the reentering rate of the cooling tower is predicted about 30%.On the contrary, the reentering rate is simulated about 15% when the louver is installed. As a result, if there is no louver wall installed around the roof, the falloff of the cooling capacity would be serious by the reentering of the discharge air. The installation of the louver wall is strongly recommended to prevent the discharge air reentering.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제31회 추계학술대회논문집
• /
• pp.305-309
• /
• 2008

본 연구에서는 화염 안정기 형상이 램제트 연소실에서의 단열 막냉각 효율에 미치는 영향에 대하여 실험을 수행하였다. 램제트 연소실 입구의 경사진 확장면의 끝에 화염안정기 형상을 설치하여 세로축 화염안정기에 의해 발생된 난류 유동이 다단 슬롯에 영향을 끼치도록 실험 장치를 구성하였다. 화염 안정기를 설치하였을 경우 화염안정기에 의해 발생된 유동의 높은 전단력과 난류강도로 인해 급격히 주유동과 혼합되어 화염안정기가 설치되지 않은 경우에 비해 전체적으로 냉각 성능이 감소함을 결과를 통해 확인하였다. 또한 각각의 경우 분사율을 높여주면 좀 더 양호한 막냉각 효율을 기대할 수 있었다.

• 설비공학논문집
• /
• 제15권4호
• /
• pp.274-286
• /
• 2003

Numerical simulations are performed to investigate the turbulent convective heat transfer of the supercritical carbon dioxide flows in vertical and horizontal square ducts. The gas cooling process at the supercritical state experiences a sudden change in thermodynamic and transport properties. This results in the extraordinary variations of the heat transfer coefficients in the supercritical state, which are much different from those of single or two phase flows. Algebraic second moment closure which can include the effects of large thermophysical property variations of carbon dioxide and of buoyancy is employed to model the Reynolds stresses and turbulent heat fluxes in the governing equations. The previous correlations for the turbulent heat transfer coefficient for the supercritical carbon dioxide flows couldn't reflect the buoyancy effect. The present results are used to establish a new heat transfer coefficient correlation including the effects of large thermophysical property variation and buoyancy on in-duct cooling process of supercritical carbon dioxide.

• 한국추진공학회지
• /
• 제11권6호
• /
• pp.9-17
• /
• 2007

본 연구에서는 램제트 연소실에서의 재순환 유동이 슬롯 막냉각에 미치는 영향에 대하여 실험을 수행하였다. 램제트 연소실 입구의 경사진 확장면 돌출부에 의해 발생된 재순환 유동이 다단 슬롯 중 첫 번째 슬롯에 영향을 미치도록 실험 장치를 구성하여, 슬롯 출구 하류에서의 속도장, 온도장 및 단열 막냉각 효율을 측정하였다. 재순환 유동의 영향에 들어가는 슬롯에서 분사된 냉각유체는 재순환 유동의 높은 전단력과 난류강도로 인해 분사 직후 급격히 주유동과 혼합되어, 재순환 영역에 포함되지 않은 슬롯보다 냉각 성능이 감소함을 결과를 통해 확인하였다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2005년도 제25회 추계학술대회논문집
• /
• pp.59-63
• /
• 2005

본 연구는 재순환 유동이 램제트 연소실 슬롯 막냉각에 미치는 영향에 대하여 실험을 수행하였다. 경사진 확장면에 설치된 돌출부를 가진 냉각유로에 의해 발생된 재순환 유동이 다단 슬롯 중 첫 번째 슬롯에 영향을 미치도록 실험 장치를 구성하여, 슬롯 출구 하류에서 속도장, 온도장 및 단열 막 냉각 효율을 측정하였다 슬롯을 통해 분사된 냉각유체는 재순환 유동간의 높은 전단력과 난류강도로 인해 분사 직후 급격히 혼합되어, 냉각 성능이 감소함을 결과를 통해 확인하였다.