• Food Science and Preservation
• /
• v.9 no.3
• /
• pp.261-266
• /
• 2002

A transpiration model was selected and tested experimentally to predict transpiration into of Fuji apple stored in a normal air and controlled atmospheres (l∼3% O$_2$+ l∼3% CO$_2$) at 0$\^{C}$ and 98% RH for 6weeks. CA storage decreased the respiration rate of Fuji apple by 50% when compared with normal air storage. The transpiration rates of apple showed 50∼70% higher in normal air storage than those in CA storage and were decreased by increasing CO$_2$concentration under same concentration of O$_2$. The transpiration rates estimated by the selected model were in good agreement with experimental data for Fuji apples under controlled atmosphere conditions and normal air. When the respiratory heat generation rate u of Fuji apple increased with storage conditions, the evaporating surface temperature and transpiration rate also increased. But since some portion of respiratory heat was used as latent heat in the evaporating surface, the change of u value had a little effect on the determination of the evaporation temperature and the transpiration rate.

• Korean Journal of Materials Research
• /
• v.21 no.9
• /
• pp.520-524
• /
• 2011

Porous W with controlled pore characteristics was fabricated by a freeze-drying process. $WO_3$ powder and camphene were used as the source materials of W and sublimable vehicles, respectively. Camphene slurries with $WO_3$ contents of 10 and 15 vol% were prepared by milling at $50^{\circ}C$ with a small amount of oligomeric polyester dispersant. Freezing of a slurry was done in a Teflon cylinder attached to a copper bottom plate cooled at $-25^{\circ}C$ while the growth direction of the camphene was unidirectionally controlled. Pores were generated subsequently by sublimation of the camphene during drying in air for 48 h. The green body was hydrogen-reduced at $800^{\circ}C$ for 30 min and sintered in a furnace at $900^{\circ}C$ for 1 h under a hydrogen atmosphere. Microstructural observation revealed that all of the sintered samples were composed of only W phase and showed large pores which were aligned parallel to the camphene growth direction. The porosity and pore size increased with increasing camphene content. The difference in the pore characteristics depending on the slurry concentration may be explained by the degree of powder rearrangement in the slurry. The results strongly suggest that a porous metal with the required pore characteristics can be successfully fabricated by a freeze-drying process using metal oxide powders.

• Journal of the Korean Institute of Educational Facilities
• /
• v.20 no.2
• /
• pp.33-42
• /
• 2013

Due to the lack of available site in urban setting outdoor space in elementary schools are getting smaller and tend to be replaced by indoor spaces. Focusing on courtyard, piloti space and roof space, this study analyzed the current condition and usage of the outdoor spaces in the urban mini-schools based on the analysis of architectural drawing, interview, survey, and observation. Following issues are found for appropriate planning for outdoor spaces in the urban mini-schools. Firstly, roof space needs to be coordinated with the physical education and outdoor class curriculum and should be planned separately for quiet activities. Secondly, the piloti space should be planned as an independent space rather than a connection between classroom and outdoor space, with appropriate surveillance from teacher's space for the lower graders. Thirdly, courtyard space, typical space in urban mini school surrounded by densely arranged buildings, should be thermally controlled for outdoor class or resting with appropriate screen from noise to keep quiet atmosphere.

• Journal of Korean Academy of Nursing Administration
• /
• v.20 no.5
• /
• pp.525-534
• /
• 2014

Purpose: The purpose of this study was to identify moderating and mediating effects of social support in the relationship between work-family conflict, job satisfaction and turnover intention among married women nurses. Methods: The sample for this study consisted of 225 married female nurses from two hospitals located in Seoul. Data were collected through structured questionnaires and analyzed using descriptive statistics, t-test, ANOVA, Pearson correlation coefficients and hierarchical multiple regression with the SPSS 21.0 program. Results: (a) Social support of married female nurses had significant moderating and mediating effects between work-family conflict and job satisfaction. (b) Social support of married female nurses had significant moderating and mediating effects between work-family conflict and turnover intention. Conclusion: The results of the study indicate that social support is an important factor in work-family conflict, job satisfaction and turnover intention among married female nurses. Supervisor support is important to married nurses as social support as it is controlled by the organization. Therefore, supportive relationships based on mutual respect between supervisors and nurses are necessary for a creative organizational atmosphere and system.

• Journal of the Korean Ceramic Society
• /
• v.24 no.5
• /
• pp.453-460
• /
• 1987

β'-sialon(Z=2.7) specimens with <30%wt. graphite as a reducing agent were decomposed at 1350°up to 1,450℃ under the atmosphere of 90% N2-10%H2. The decomposition of β'-sialon was calculated from the change in Z-value, and the formation of new minerals was identified from X-ray diffraction patterns. The decomposition reactions of sialon were considered to yield a stable sialon close to β-silicon nitride and some aluminum compounds according to the following equations; β'-sialon(s)＋C(s)＋N2(g)→β2-sialon(metastable)＋β3-sialon(stalbe phase) β2-sialon(s)＋C(s)＋N2(g)→β3-sialon(s)＋AlN(s)＋α-Al2O3(s)＋15R(s)＋SiO(g)＋Al2O(g)＋CO(g) Z-value; β2( 3.5)>β'( 2.7)>β3( 0.5) The decomposition rate of sialon was controlled by two mechanisms ; One was characterized by the interface area of contact, corresponding to an apparent activation energy of 50.5Kcal/mol in the initial stage, and the other by the diffusion, corresponding to that of 104.3Kcal/mol in the final stage of the decomposition.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.415-417
• /
• 2005

In order to retrieve the latent and sensible heat fluxes, high-resolution airborne imageries with visible, near infrared, and thermal infrared bands and ground-base meteorology measurements are utilized in this paper. The retrieval scheme is based on the balance of surface energy budget and momentum equations. There are three basic surface parameters including surface albedo $(\alpha)$, normalized difference vegetation index (NOVI) and surface kinetic temperature (TO). Lowtran 7 code is used to correct the atmosphere effect. The imageries were taken on 28 April and 5 May 2003. From the scattering plot of data set, we observed the extreme dry and wet pixels to derive the fitting of dry and wet controlled lines, respectively. Then the sensible heat and latent heat fluxes are derived from through a partitioning factor A. The retrieved latent and sensible heat fluxes are compared with in situ measurements, including eddy correlation and porometer measurements. It is shown that the retrieved fluxes from our scheme match with the measurements better than those derived from the S-SEBI model.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.3
• /
• pp.183-192
• /
• 2002

Concentrations of $\alpha$- and ${\gamma}$-hexachlorocyclohexane (HCH) were measured in ambient air samples at a two week intervals between July 1999 and February 2000 at Ansung, Kyonggi province. Their concentration levels averaged at 78 ($\alpha$-HCH) and 18 pg/m$^3$(${\gamma}$-HCH). Although the use of HCHs was ceased in South Korea since 1979, their residues are still present in air even after nearly 20 years. Given the composition of the two main HCH pesticide formulation (technical HCH antral lindane), the $\alpha$/${\gamma}$-HCH ratio in air is a useful indicator on the regional scale. The moderately low $\alpha$/${\gamma}$-HCH ration in this study indicates previous usage of both technical HCH and lindane. The relationship of temperature with gas-phase partial pressures was also examined using the Clausius-Clapeyron equation. Slopes generated by linear regression analysis between partial pressure (In P) and 1/T were considerably steep thor HCHs. It is thus suggested that their concentrations are controlled by re-volatilization processes from surfaces in the local surroundings of the sampling site.

• Journal of Powder Materials
• /
• v.26 no.6
• /
• pp.502-507
• /
• 2019

Macro-porous carbon foams are fabricated using cured spherical phenolic resin particles as a matrix and furfuryl alcohol as a binder through a simple casting molding. Different sizes of the phenolic resin particles from 100-450 ㎛ are used to control the pore size and structure. Ethylene glycol is additionally added as a pore-forming agent and oxalic acid is used as an initiator for polymerization of furfuryl alcohol. The polymerization is performed in two steps; at 80℃ and 200℃ in an ambient atmosphere. The carbonization of the cured body is performed under Nitrogen gas flow (0.8 L/min) at 800℃ for 1 h. Shrinkage rate and residual carbon content are measured by size and weight change after carbonization. The pore structures are observed by both electron and optical microscope and compared with the porosity results achieved by the Archimedes method. The porosity is similar regardless of the size of the phenolic resin particles. On the other hand, the pore size increases in proportion to the phenol resin size, which indicates that the pore structure can be controlled by changing the raw material particle size.

• Environmental Analysis Health and Toxicology
• /
• v.19 no.2
• /
• pp.161-167
• /
• 2004

Air quality monitoring is a primary activity for industrial and social environment. The government identifies the pollutants that each industry must monitor. Especially, the VOCs (Volatile Organic Compounds), which are very harmful to human body and environment atmosphere, should be controlled under the government policy. However, the VOCs, which have not been confirmed in emission sources are very difficult to monitor. It is needed to develop the monitoring system that allow the continuous and in situ measurement of VOCs mixture in different environmental matrices. Gas chromatography and mass spectrometry are the most prevalent current techniques among those available for the analysis of VOCs. But, they need a large size analytical instrument, which costs a great deal for purchase and operation. In addition, it has some limitations for realtime environmental monitoring such as location problems and slow processing time. Recently, several companies have commercialized a portable VOCs measurement systems, which cannot classify various kinds of VOCs but total quantities. We have developed a VOCs measurement system, which recognizes various kinds and quantities of VOCs, such as benzene, toluene, and xylene (BTX). Also, it can be used as a stand- alone type and/or fixed type in the vehicle with rack for real -time environmental monitoring.

• Journal of Korean Society for Atmospheric Environment
• /
• v.15 no.2
• /
• pp.79-87
• /
• 1999

$^{239+240}Pu$ concentrations in precipitation were determined for the period of May 1994 to August 1996 in oder to describe current $^{239+240}Pu$ deposition at the mid-western coat of Korea (Ansan, 37$^{\circ}$17'N, $126^{\circ}$50'E). $^{239+240}Pu$ concentration in daily precipitation varied from 0.05 to 131$\mu$Bq $kg^{-1}$ with a geometric mean of $1.26\mu$Bq $kg^{-1}$. The concentration was high in the period of Yellow Sand Storm in spring and low in wet summer monsoon. The specific $^{239+240}Pu$ concentration in daily precipitation appears to be controlled by the $^{239+240}Pu$ input to the atmosphere in spring and washout effects by precipitation in the wet summer monsoon. Wet depositional flux of $^{239+240}Pu$ varied from 4 to 123$\mu$Bq $m^{-2}d^{-1}$ with a geometric mean of $33.8\mu$Bq $m^{-2}d^{-1}$ and with a maximum in the period of Yellow Sand Storm and a minimum in the period of wet summer monsoon. $^{238}Pu$/$^{239+240}Pu$ activity raios(0.04~0.31) in precipitation for March-June period suggested that one of the major sources of Pu isotopes falling in Ansan area is the arid region of the Chinese continent.