• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2006년도 전기학술대회논문집
• /
• pp.255-256
• /
• 2006

A wind power plant is one of the competitive and effective energy among the regulated 13 renewable energies, especially for the seashore and island. This study is focused on the possibility of wind power plant as a on-site electric power supply system for the common residential building in Youngdo, Busan. The following show the results of this study. 26 apartments' monthly electric power consumptions are surveyed and monthly variations are stable comparing to the metropolitan. With the wind speed measured in Youngdo island and wind power plant efficiency data, the simulation is conducted and the result shows that 35 wind power units are satisfied with full electric power load for all the common residential buildings in Youngdo island.

• 생약학회지
• /
• 제40권3호
• /
• pp.251-256
• /
• 2009

Cordyceps bassiana is a parasitic fungus and used as a Chinese traditional medicine. It has been called as DongChungHaCho(summer-plant, winter-worm) in China. Acute oral toxicity was examined in male and female ICR mice. Butanol fraction from Cordyceps bassiana(BuCb) was administered orally at a dose of 2,500 mg/kg, 5,000 mg/kg, 10,000 mg/kg. No death and abnormal clinical signs were observed throughout the administration period. The acute toxicity test on mouse did not show any oversign in net body weight gain, food and water consumptions, organ weights, gross pathological findings by different doses of BuCb. Also, biochemical examination revealed no evidence of specific toxicity. These findings show that BuCb has wide margin of safety on acute toxicity with single exposure.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(2)
• /
• pp.125-128
• /
• 2001

In this paper, we propose a low power Scan-based Built-ln Self Test based on circuit partitioning and pattern suppression using modified test control unit. To partition a CUT(Circuit Under Testing), the MHPA(Multilevel Hypergraph Partition Algorithm) is used. As a result of circuit partition, we can reduce the total length of test pattern, so that power consumptions are decreased in test mode. Also, proposed Scan-based BIST architecture suppresses a redundant test pattern by inserting an additional decoder in BIST control unit. A decoder detects test pattern with high fault coverage, and applies it to partitioned circuits. Experimental result on the ISCAS benchmark circuits shows the efficiency of proposed low power BIST architecture.

• 센서학회지
• /
• 제25권2호
• /
• pp.103-109
• /
• 2016

Recent light-enhanced metal oxide gas sensors are reviewed in this article. The basic mechanisms of a light-enhanced metal oxide gas sensor are discussed. Many literatures reveal that the standalone sensitivity and the response/recovery time enhancements enabled by the exposing light are not as high as the performance enhancement provided by external heating. Therefore, both optimal amount of external heating and exposed light intensity are necessary to increase the performance of these light-enhanced gas sensors. The development of highly light sensitive materials and structures is important to lower the overall power consumptions of the sensors.

• 한국치위생학회지
• /
• 제18권5호
• /
• pp.785-795
• /
• 2018

Objectives: This study aimed to: 1) investigate the beverage consumption pattern among Korean adults, and 2) analyze the relationship between the frequency of beverage consumption and oral health status. Methods: We used data from the 6th Korean National Health and Nutrition Examination Survey. A general linear model was employed to assess the associations between demographic factors and frequency of beverage consumption; and oral health status and the frequency of beverage consumption. Results: The beverage with the highest frequency of intake was coffee (11.5 times per week). More frequent consumptions of fruit juices and carbonated drinks were associated with higher numbers of decayed teeth. Conclusions: To improve oral health, frequent intake of acidic and sweetened beverages should be reduced, and the consumption of milk should be encouraged.

• Journal of Astronomy and Space Sciences
• /
• 제17권2호
• /
• pp.267-276
• /
• 2000

PSS(Pyramidal type 2-axes Analog Sun Sensor) which will be used for KAISTSAT-4 is designed to be small, light, low in power consumptions, and adequate for small satellite attitude sensor. The PSS for the KAISTSAT-4 consists of the pyramidal structure, solar cells and amplifier. The pyramidal structure is suitable for the 2-axes sensing, Solar cells are made up of a rectangular shape of crystal silicon. The PSS measures the angle of incident light and initial satellite attitude measurement, and provides an alarm for the sunlight-sensitive payloads. This paper explains the PSS structure and the characteristic test result about the PSS with $\pm$$50^{\circ}$in FOV, less than $\pm$$3^{\circ}$in accuracy.

• Progress in Superconductivity
• /
• 제9권2호
• /
• pp.157-161
• /
• 2008

Due to high speed operations and ultra low power consumptions RSFQ logic circuit is a very good candidate for future electronic device. The focus of the RSFQ circuit development has been on the advancement of analog-to-digital converters and microprocessors. Recent works on RSFQ ALU development showed the successful operation of an 1-bit block of ALU at 40 GHz. Recently, the study of an RSFQ analog-to-digital converter has been extended to the development of a single chip RF digital receiver. Compared to the voltage logic circuits, RSFQ circuits operate based on the pulse logic. This naturally leads the circuit structure of RSFQ circuit to be pipelined. Delay time on each pipelined stage determines the ultimate operating speed of the circuit. In simulations, a two junction Josephson transmission line's delay time was about 10 ps, a splitter's 14.5 ps, a switch's 13 ps, a half adder's 67 ps. Optimization of the 4-bit ALU circuit has been made with delay time consideration to operate comfortably at 10 GHz or above.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2004년도 학술발표회
• /
• pp.709-712
• /
• 2004

The development of a basin-wide runoff analysis model is to analysis monthly and daily hydrologic runoff components including surface runoff, subsurface runoff, return flow, etc. at key operation station in the targeted basin. h short-term water demand forecasting technology will be developed fatting into account the patterns of municipal, industrial and agricultural water uses. For the development and utilization of runoff analysis model, relevant basin information including historical precipitation and river water stage data, geophysical basin characteristics, and water intake and consumptions needs to be collected and stored into the hydrologic database of Integrated Real-time Water Information System. The well-known SSARR model was selected for the basis of continuous daily runoff model for forecasting short and long-term natural flows.

• Journal of Biosystems Engineering
• /
• 제18권1호
• /
• pp.71-77
• /
• 1993

This study was conducted in order to figure out the energy consumption pattern in rice production system of Korea, with literature investigation focused on energy requirement in rice production system in worldwide. The investigation reveals that 24,994 MJ/ha was needed to produce 4,500kg of rice production or 5.55 MJ/kg was consumed. The major enegry consumptions are resulted from the application of nitrogen fertilizer, fuel for farm machinery, and farm machinery embodied energy, which showed somewhat different energy consumption pattern than that of the developed country, like, U.S.A. Based on the machinery chosen in this investigation, it was found that 32.7% of the fuel energy, 2,431.8MJ, was consumed in drying operation, 32.2%, 2.402MJ, in tillage and land preparation. 25.8%, 1.923.6MJ in harvest. A linear relationship was found in pre harvest energy input and output of rice production.

• 한국미생물·생명공학회지
• /
• 제21권2호
• /
• pp.157-162
• /
• 1993

Raw starch can be effectively saccharified in an enzyme reaction system containing sttrition-milling media. In order to develop an effcient attrition-coupled bioreactor(bioattritor), a rotating drum type bioattitor was construced, and its optimal operation conditions and power consumptions were evaluated. The optimal conditions for 3l bioattritor were 4 baffled, baffle size of 1:0.05 (the ratio of drum diameter to baffle), drum rotation speed of 100 rpm, and 1.33g of 3 mm glass bead/g of raw corn starch.