• 한국유체기계학회 논문집
• /
• 제6권3호
• /
• pp.28-35
• /
• 2003

This paper presents analysis results for the effect of power control strategies on the part load performance of gas turbine based power generation systems utilizing exhaust heat of the gas turbine such as combined cycle power plants and regenerative gas turbines. For the combined cycle, part load efficiency variations were compared among different single shaft gas turbines representing various technology levels. Power control strategies considered were fuel only control and IGV control. It has been observed that gas turbines with higher design performances exhibit superior part load performances. Improvement of part load efficiency of the combined cycle by adopting air flow modulation was analyzed and it was concluded that since the average combined cycle performance is affected by the range of IGV control as well as its temperature control principle, a control strategy appropriate for the load characteristics of the individual plant should be adopted. For the regenerative gas turbine, it is likewise concluded that maintaining exhaust temperature as high as possible by air flow rate modulation is required to increase part load efficiency.

• 제어로봇시스템학회논문지
• /
• 제10권2호
• /
• pp.192-196
• /
• 2004

A combined optimal design problem is discussed taking a 3-D truss structure as a design object. We use descriptor forms for a controlled object and a generalized plant because the structural parameters appear naturally in these forms. We consider not only the minimum weight design problem for the structure, but also the suppression problem of the effect of disturbances for the control system as the purpose of the design. A numerical example shows the validity of combined optimal design of the structure and control systems. We also consider the validity of the sensor-actuator collocation for the control system design in this paper.

• 동력기계공학회지
• /
• 제8권1호
• /
• pp.69-74
• /
• 2004

A structure-control combined optimal design problem is discussed taking a 3-D truss structure as a design object. We use descriptor forms for a controlled object and a generalized plant because the structural parameters appear naturally in these forms. We consider not only minimum weight design problem for structure system, but also suppression problem of the effect of disturbances for control system as the purpose of the design. A numerical example shows the validity of combined optimal design of structure and control systems. We also consider the validity of sensor-actuator collocation for control system design in this paper.

• 농업과학연구
• /
• 제42권2호
• /
• pp.111-116
• /
• 2015

Combined applications of rice bran with pine leaves were tested to examine the inhibitory effects to paddy weeds and increased yield of rice for developing techniques of environment-friendly weed management in paddy rice fields. Weed control efficacy at 60 days after treatment was improved to 88.8% by combined application of rice bran with pine leaves, while weed control efficacy by single application of rice bran showed 67.5%. The other weed control efficacy combined with chestnut leaves and barley straws were 76.3% and 69.9% respectively. Combined application of rice bran with pine leaves was more effective to broadleaf weeds such as Monochoria vaginalis. Weed control efficacy by combined application with pine leaves was 100% until 70 days after rice transplanting and maintained weed control effect up to 90 days after transplanting. Rice yield by combined application of rice bran with pine leaves was 526 kg/10 a, which was higher yield than by combined application with barley straws, single application of rice bran, natural snail application and hand weeding.

• 대한산업공학회지
• /
• 제19권1호
• /
• pp.61-71
• /
• 1993

We focus on a way of combining the Monte Calro methods of antithetic variates and control variates to reduce the variance of the estimator of the mean response in a simulation experiment. Combined Method applies antithetic variates (partially) for driving approiate stochastic model components to reduce the vaiance of estimator and utilizes the correlations between the response and control variates. We obtain the variance of the estimator for the response analytically and compare Combined Method with control variates method. We explore the efficiency of this method in reducing the variance of the estimator through the port operations model. Combined Method shows a better performance in reducing the variance of estimator than methods of antithetic variates and control variates in the range from 6% to 8%. The marginal efficiency gain of this method is modest for the example considered. When the effective set of control variates is small, the marginal efficiency gain may increase. Though these results are from the limited experiments, Combined Method could profitably be applied to large-scale simulation models.

• 한국지능시스템학회:학술대회논문집
• /
• 한국퍼지및지능시스템학회 1998년도 The Third Asian Fuzzy Systems Symposium
• /
• pp.465-468
• /
• 1998

In this paper, merits of both fuzzy and PID controllers are combined. The combined controller is designed such that the tuning of the PID controller is achieved by the basic fuzzy controller via its rule base. The proposed scheme avoids the tuning of PID parameters which is always a time consuming task, difficult to carry out and often poorly done. Computer simulations are made to demonstrate the satisfactory tracking performance of the combined fuzzy-PID controller.

• Journal of Mechanical Science and Technology
• /
• 제20권9호
• /
• pp.1502-1513
• /
• 2006

This study analyzes the design and part load performance of a power generation system combining a micro gas turbine (MGT) and an organic Rankine cycle (ORC). Design performances of cycles adopting several different organic fluids are analyzed and compared with performance of the steam based cycle. All of the organic fluids recover greater MGT exhaust heat than the steam cycle (much lower stack temperature), but their bottoming cycle efficiencies are lower. R123 provides higher combined cycle efficiency than steam does. The efficiencies of the combined cycle with organic fluids are maximized when the turbine exhaust heat of the MGT is fully recovered at the MGT recuperator, whereas the efficiency of the combined cycle with steam shows an almost reverse trend. Since organic fluids have much higher density than steam, they allow more compact systems. The efficiency of the combined cycle, based on a MGT with 30 percent efficiency, can reach almost 40 percent. hlso, the part load operation of the combined system is analyzed. Two representative power control methods are considered and their performances are compared. The variable speed control of the MGT exhibits far better combined cycle part load efficiency than the fuel only control despite slightly lower bottoming cycle performance.

• Communications for Statistical Applications and Methods
• /
• 제7권3호
• /
• pp.773-788
• /
• 2000

Statistical process control (SPC) and engineering process control (EPC) are based on different strategies for processes quality improvement. SPC reduces process variability by detecting and eliminating special causes of process variation. while EPC reduces process variability by adjusting compensatory variables to keep the quality variable close to target. Recently there has been needs for a process control proceduce which combines the tow strategies. This paper considers a combined scheme which simultaneously applies SPC and EPC techniques to reduce the variation of a process. The process model under consideration is an integrated moving average(IMA) process with a step shift. The EPC part of the scheme adjusts the process back to target at every fixed monitoring intervals, which is referred to a repeated adjustment scheme. The SPC part of the scheme uses an exponentially weighted moving average(EWMA) of observed deviation from target to detect special causes. A Markov chain model is developed to relate the scheme's expected cost per unit time to the design parameters of he combined control scheme. The expected cost per unit time is composed of off-target cost, adjustment cost, monitoring cost, and false alarm cost.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 춘계학술대회 논문집
• /
• pp.4-4
• /
• 2010

Multi Cultivation Remote-control System(MCRS) for crops through characteristics of multi-safe sensors was realized. It was carried out to investigate into the effect of LED Control with the physiological activity of crops(for examples, sprouts). We have also composed a Combined Automatic Control System possible for the control of temperature and humidity at the same time. And we producted the remote control as using Linux.

• 한국작물학회:학술대회논문집
• /
• 한국작물학회 2017년도 9th Asian Crop Science Association conference
• /
• pp.357-357
• /
• 2017

The combined application of oil cake and rice bran into the soil surface was found useful for weed control in our previous pot study. The present study was undertaken to evaluate the performance of white clover (Trifolium repens L.) while incorporated in the paddy field and effects of combined fertilizer on weed control and rice yield. A plot was divided into two parts i.e. white clover incorporated and not incorporated. The nitrogen content of the incorporated white clover was $12.5gm^{-2}$. Chemical fertilizer and combined fertilizer plots were compared with non-fertilizer conditions. The mixed ratio of combined fertilizer was oil cake 1.35 and rice bran 1.0. Combined fertilizer was applied to the soil surface, and chemical fertilizer was mixed in the soil. Nitrogen application rate was $8gm^{-2}$ for any fertilizer. The weed numbers were significantly reduced in the white clover plot irrespective of application condition both at heading and harvest time. Also, weed control ability was improved by the use of combined fertilizer. In the not incorporated plot, the number of weeds was suppressed about 90% by applying combined fertilizer. The rice yield was markedly increased by the incorporation with white clover under all fertilization conditions. Contribution rates of increased rice yield by white clover and combined fertilizer were about 55% and about 25%, respectively. The rice yield was increased by the incorporation with white clover, and the number of weeds remarkably decreased as well. Also, these effects were improved due to combined application of oil cake and rice bran.