• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2000.11a
• /
• pp.143-144
• /
• 2000

급증하는 자동차 수요로 인해 발생되는 배출량 증가는 자동차 운행의 특성상 대도시 대기오염의 주원인으로 작용하고 있다. 자동차 배출오염물질의 배출량 추정에 있어 국내 차량의 배출계수 개발도 시급하지만 우리 나라 자동차 운행패턴에 관한 연구도 같이 병행되어야 한다. 본 연구에서는 Cold start emission과 Evaporative VOC emission의 산정에 있어서 국내 승용차의 1회 주행거리(Trip length)를 이용하여 승용차 부문 배출량 영향정도와 계절별 배출량 변화를 추정하여 보았다. (중략)

• Transactions of the Korean Society of Automotive Engineers
• /
• v.9 no.2
• /
• pp.67-74
• /
• 2001

A synchronized secondaty air injection method has been developed to hydrocarbon emission by injecting secondary air intermittently into exhaust port. The method has been tested in a single cylinder spark-ignition engine operating at cold-steady / cold-start conditions. Effects of air injection timing, intake pressure and engine air-fuel ratio have been investigated at cold-steady condition. Also, hydrocarbon emission and exhaust gas temperature with catalytic conberter are compared with a continuous SAI method and base condition at cold-start condition. Resules show that hydrocarbon reduction rate and exhaust gas temperature are sensitive to the timing of synchronized SAI. At cold-steady condition, HC emission is minimum at engine air-fuel ratio of 10. At cold-start condition, the accumulated hydrocarbon emission during the first 120 s decreases about 56% and 22% with the synchronized and continuous SAI, respectively, compared to that of base condition.

• Journal of ILASS-Korea
• /
• v.23 no.4
• /
• pp.244-253
• /
• 2018

Recently, The ministry of Environment in korea have introduced Euro-6d temp which was strengthened at the same time as Europe. Small Light-duty passenger vehicles need the SCR system of after-treatment to meet enhanced emission regulations. However, SCR system has a low conversion efficiency in a low temperature less than 200 degree. In this study, the NOx conversion efficiency of SCR system was analyzed by installing a NOx sensors and a temperature sensors in a diesel vehicle. Also, in order to analyze the effect of the cold-start, the test was performed on the same RDE route and compared with the test of hot-start. As a result, SCR system has characteristics of low conversion efficiency under cold-start conditions.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.18 no.6
• /
• pp.46-52
• /
• 2010

In this paper, emission analysis during cold start period of CVS-75 mode in LPG vehicle was performed to find out proper operating conditions of SAI(Secondary Air Injection) system. In order to meet SULEV target, the simulated emission system had a SAI system as well as a MCC(Manifold Catalytic Converter) and a UCC(Under body Catalytic Converter). Using commercial 1-D code AMESIM, in which 7 step global surface chemical reactions of Langmuir-Hinshelwood type were adopted, transient emission analysis in the exhaust system during cold start period of CVS-75 mode were carried out to figure out the effects of flow rate, duration of supply air on HC, CO, NO emission.

• Journal of Mechanical Science and Technology
• /
• v.14 no.10
• /
• pp.1168-1177
• /
• 2000

Hydrocarbon adsorber is considered as a promising technology to reduce cold start HCs in automotive exhaust gas. In this study, three in-line adsorber systems were tried to reduce the cold start emission. To check the basic characteristics of adsorber converters, surface areas, TPD and TP A were examined after a hydrothermal aging. Also idle engine bench was used to find the adsorption and desorption capabilities of the adsorber systems at cold start. Finally a practicability of the adsorber systems for the LEV achievement was checked with FTP test on a 2.0 D MIT vehicle. The results of this study indicate that hydrocarbon adsorber system is one of the promising passive technologies to meet the ULEV regulation.

• The Journal of Korea Robotics Society
• /
• v.10 no.2
• /
• pp.90-95
• /
• 2015

The main goal of e-learning systems is just-in-time knowledge acquisition. Rule-based e-learning systems, however, suffer from the mesa effect and the cold start problem, which both result in low user acceptance. E-learning systems suffer a further drawback in rendering the implementation of a natural interface in humanoids difficult. To address these concerns, even exceptional questions of the learner must be answerable. This paper aims to propose a method that can understand the learner's verbal cues and then intelligently explore additional domains of knowledge based on crowd data sources such as Wikipedia and social media, ultimately allowing for better answers in real-time. A prototype system was implemented using the NAO platform.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2023.11a
• /
• pp.89-92
• /
• 2023

최근에 Serverless 컴퓨팅은 많은 관심을 받는 기술로, 서버 프로비저닝 없이 코드를 배포하고 실행할 수 있으며 요청량에 따라 동적으로 컴퓨팅 리소스를 확장하여 애플리케이션을 안정적으로 운영할 수 있는 환경을 제공한다. Serverless 컴퓨팅의 주요 이슈 중 하나인 cold start 는 함수를 실행하기 위한 컨테이너 초기화 및 구동하는 단계이며, 해당 과정에서는 이미지 풀링이 수행될 수 있다. 이미지 풀링은 cold start 지연의 대부분을 차지하고 함수의 응답시간을 증가 시켜서 사용자 경험에 부정적인 영향을 줄 수 있다. 따라서, 본 논문에서는 cold start 지연을 줄이기 위해 도커를 활용해서 이미지 레이어 동시 풀링 개수를 조절함으로써 이미지 풀링 속도를 개선시킬 수 있는지 분석하였다. 이와 같은 분석을 통해 풀링 개수가 풀링 속도에 영향을 줄 수 있음을 확인하였다.

• International Journal of Automotive Technology
• /
• v.6 no.5
• /
• pp.445-451
• /
• 2005

Most of the pollutants from passenger cars are emitted during the cold-transient phase of the FTP-75 test. In order to reduce the exhaust emissions during the cold-transient period, it is essential to warm up the catalyst as fast as possible after the engine starts, and the Unburned Exhaust Gas Ignition (UEGI) technology was developed through our previous studies to help close-coupled catalytic converters (CCC) reach the light-off temperature within a few seconds after cold-start. The UEGI system operates by igniting the unburned exhaust mixture by glow plugs installed upstream of the catalyst. The flame generates a high amount of heat, and if the heat is concentrated on a specific area of monolith surface, then thermal crack or failure of the monolith could occur. Therefore, it is very important to monitor the temperature distribution in the CCC during the UEGI operation, so the local temperatures in the monolith were measured using thermocouples. Experimental results showed that the temperature of CCC rises faster with the UEGI technology, and the CCC reaches the light-off temperature earlier than the baseline case. Under the conditions tested, the light-off time of the baseline case was 62 seconds, compared with 33 seconds for the UEGI case. The peak temperature is well under the thermal melting condition, and temperature distribution is not so severe as to consider thermal stress. It is noted that the UEGI technology is an effective method to warm up the catalyst with a small amount of thermal stress during the cold start period.

• Transactions of the Korean hydrogen and new energy society
• /
• v.22 no.6
• /
• pp.859-867
• /
• 2011

The cold start problem is one of major obstacles to overcome for the commercialization of fuel cell vehicles. However, the cold start characteristics of fuel cell systems are very complicated since various phenomena, i.e. ice-blocking, electro-chemical reactions, heat transfer, and defrosting of BOP components, are involved in them. This paper presents a framework to approach the problem at a full stack scale using Axiomatic Design (AD). It was characterized in terms of Functional Requirements (FRs) and Design Parameters (DPs) while their relations were established in a design matrix. Considering the design matrix, the endplates should have low thermal conductivity and capacity without increase in weight or decrease in structural stiffness. Consequently, composite sandwich endplates were proposed and examined both through finite element analyses and experiments simulating cold start conditions. From the examinations, it was found that the composite sandwich endplates significantly contributed to improving the cold start characteristics of PEMFC.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.30 no.12 s.255
• /
• pp.1181-1187
• /
• 2006

Stringent regulations of exhaust emission from vehicles become a major issue in automotive industries. In SI engines, it is one of the crucial factor to reduce exhaust emissions during cold start in order to meet stringent regulations such as SULEV or EURO-4, because SI engines emit a large portion of total harmful exhaust compounds when they are cold. At early stages of cold start in gasoline engines, exhaust gas temperature plays a key role to improve three way catalyst by virtue of fast warmup. Therefore, this study focused on the increase of exhaust gas temperature under controls of engine operating parameters such as spark ignition timing, valve overlap by virtue of intake VVT and catalyst heating function. Furthermore, effects on harmful emission due to these parameters are also investigated. Experiments showed that retarded spark ignition timings and increased valve overlap may be helpful to increase exhaust gas temperature. It was also found that $NO_x$ was decreased with increased valve overlap. This study also showed that sudden changes in ISA and amount of fuel due to the deactivation of catalyst heating function cause temporal increase of harmful emissions.