• Clean Technology
• /
• v.9 no.1
• /
• pp.43-48
• /
• 2003

As a result of study on factor affecting absorption efficiency using the structured packing, Mellapak N. 250Y for the chemical absorption of $CO_2$ that cause global warming due to development of industry, it is shown that Mellapak N. 250Y has lower pressure drop and superior efficiency of mass transfer than 25mm Pall ring. Also, in the absorption process, it produces high efficiency in the increase of load and concentration of absorption liquid and produces low efficiency in the increase of temperature. In the effect of overall mass transfer coefficient for 15% MEA on the temperature variation of absorbent, when absorbent temperature for 15% MEA varied as 25, 50, $80^{\circ}C$, overall mass transfer coefficients were shown as 0.83, 1.00, $0.90kmol/m^3-h-kPa$.

• Korea-Australia Rheology Journal
• /
• v.21 no.2
• /
• pp.109-117
• /
• 2009

Absorption rate of carbon dioxide was measured in the aqueous xanthan gum (XG) solution in the range of 0~0.15 wt% containing diisopropanolamine (DIPA) of $0{\sim}2\;kmol/m^3$ in a flat-stirred vessel with an impeller of 0.05 m and agitation speed of 50 rpm at $25^{\circ}C$ and 101.3 kPa. The volumetric liquid-side mass transfer coefficient ($k_La$) of $CO_2$, which was obtained by the measured physical absorption rate, was correlated with the viscosity and the elastic behavior of XG solution such as Deborah number as an empirical formula. The chemical absorption rate of $CO_2$ ($R_A$), which was estimated by the film theory using the measured $k_La$ and the known kinetics of reaction between $CO_2$ and DIPA, was compared with the measured rate. The aqueous XG solution with elastic property of non-Newtonian liquid made $k_La$ and $R_A$ increased compared with Newtonian liquid based on the same viscosity of the solution.

• Korea-Australia Rheology Journal
• /
• v.18 no.3
• /
• pp.133-141
• /
• 2006

Carbon dioxide was absorbed into the aqueous nanometer sized colloidal silica solution of 0-31 wt% and 2-amino-2-methyl-1-propanol of $0-2kmol/m^3$ in a flat-stirred vessel with the impeller of various sizes and speeds at $25^{\circ}C$ and 0.101 MPa to measure the absorption rate of $CO_2$. The volumetric liquid-side mass transfer coefficient$(k_La)\;of\;CO_2$ was used to obtain the empirical correlation formula containing the rheological behavior of the aqueous colloidal silica solution. Reduction of the measured $k_La$ was explained by the viscoelastic properties of the aqueous colloidal silica solution. The theoretical value of the absorption rate of $CO_2$ was estimated from the model based on the film theory accompanied by chemical reaction and compared with the measured value.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.8
• /
• pp.1396-1400
• /
• 2007

In this study, poly(iso-butyl methacrylate-co-ethylene glycol dimethacrylate) [poly(iso-BMA-co-EGDMA)] microgel was prepared and used as a face powder additive. The spreading, adhesiveness, and skin reactivity of poly(iso-BMA-co-EGDMA) microgel-containing face powder II were investigated and compared with the same properties of commercially available Silica bead 700-containing face powder I. In the results, the particle size of the poly(iso-BMA-co-EGDMA) microgel was significantly swelled as a result of sebum absorption. Face powder II showed a lower primary irritation index and a higher adhesiveness than did face powder I. Face powder I showed a low sebum absorption ratio and a relatively high rate of sebum absorption, whereas face powder II, contrastingly, exhibited a high sebum absorption ratio and a low rate of sebum absorption, which properties would reduce the phenomena of facial strain and sliminess. These results indicate that poly(iso- BMA-co-EGDMA) microgel has outstanding sebum absorption characteristic and adhesiveness, and thus that it is a good candidate for use as a face powder additive.

• Membrane and Water Treatment
• /
• v.8 no.1
• /
• pp.35-50
• /
• 2017

The theoretical membrane gas absorption module treatments in a hollow fiber gas-liquid membrane contactor using Happel's free surface model were obtained under countercurrent-flow operations. The analytical solutions were obtained using the separated variable method with an orthogonal expansion technique extended in power series. The $CO_2$ concentration in the liquid absorbent, total absorption rate and absorption efficiency were calculated theoretically and experimentally with the liquid absorbent flow rate, gas feed flow rate and initial $CO_2$ concentration in the gas feed as parameters. The improvements in device performance under countercurrent-flow operations to increase the absorption efficiency in a carbon dioxide and nitrogen gas feed mixture using a pure water liquid absorbent were achieved and compared with those in the concurrent-flow operation. Both good qualitative and quantitative agreements were achieved between the experimental results and theoretical predictions for countercurrent flow in a hollow fiber gas-liquid membrane contactor with accuracy of $6.62{\times}10^{-2}{\leq}E{\leq}8.98{\times}10^{-2}$.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.9
• /
• pp.2702-2706
• /
• 2013

Silver nanoparticles (AgNPs) with spherical and prism morphologies were formed at room temperature depend on the amino acid attached with phenolic unit. Absorption studies showed 410-420 nm surface plasmon resonance absorption for spherical nanoparticles whereas prism morphology showed three absorption peaks (382, 452 and 523 nm). The formation of spherical and prism morphology was confirmed by scanning and high resolution transmission electron microscopy. Antibacterial studies of both the morphologies did not show any significant differences in the inhibition of bacterial growth.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.9
• /
• pp.1493-1498
• /
• 2007

In this work, alkyl methacrylate-based microgels were synthesized by an experimental design method, and their sebum absorption characteristics were investigated. The results of fractional factorial experimentation indicated that the cross-linking agent content, solvent content, and stirring speed were the main parameters in the synthesis of the microgels. The suitable synthesis conditions were determined by the response surface design method. Through a study of the monomer and solvent effects, it was confirmed that the microgel shows the highest sebum absorption ratio when t-butyl methacrylate is used as a monomer or when acetone is used as a solvent. The optimal microgel synthesis conditions for cosmetic application were determined, and the resulting microgel had a mean particle size of 4.7 μm and a sebum absorption ratio of 435%.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.4
• /
• pp.426-430
• /
• 2003

A range of methine dyes has been synthesized by condensation of highly electronegative active methylene compound dicyanomethylenecyclopentane derived from cyclopentanone with the formyl group of substituted benzaldehydes. The electronic absorption spectroscopic properties of the dyes were investigated. In general, substituents on the aromatic aldehyde moiety have a significant effect on the visible absorption maxima of the dyes; increasing the solvent polarity also showed a pronounced effect on the absorption maxima.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.10
• /
• pp.3015-3020
• /
• 2014

The behavior of benzo[a]pyrene-7,8-dione (BPQ) in aqueous solution and its interaction with native DNA was investigated using conventional absorption and linear dichroism (LD) spectroscopy. The appearance of a broad absorption maximum at long wavelengths and its proportional relationship to solvent polarizability suggested that BPQ adopts a aggregated state for all solutions examined. Disappearance of this absorption band at higher temperatures in aqueous solution also supported BPQ aggregation. When associated with DNA absorption spectral properties were essentially the same as that in aqueous solution. However, two isosbestic wavelengths were found in the concentration-dependent absorption spectrum of the BPQ-DNA complex, suggesting the presence of at least two or more DNA-bound BPQ species. Both species produced $LD^r$ spectra whose magnitude in BPQ absorption region is larger or comparable to that in the DNA absorption region, suggesting that the molecular BPQ plane is near perpendicular relative to the local DNA helical axis. Therefore, BPQ molecules are aligned along the DNA stem in both DNA-aggregated BPQ species.

• Clean Technology
• /
• v.7 no.4
• /
• pp.273-280
• /
• 2001

An absorber is a major component in the absorption refrigeration systems and its performance greatly affects the overall system performance. In this study, experimental analyses on heat transfer characteristics for removal of absorption heat in ammonia-water bubble mode absorber were performed. Heat transfer coefficients were estimated as the variations of input gas flow rate, solution flow rate, temperature, concentration, absorber diameter and height, and input flow direction. The increase of gas and solution flow rate affects positively in heat transfer. However, the increase of solution temperature and concentration affects negatively. Moreover, under the same Reynolds Numbers, countercurrent flow is superior to cocurrent flow in heat transfer performance. In addition, from these experimental data, empirical correlations which can explain easily the characteristics of heat transfer are derived.