• 한국신재생에너지학회:학술대회논문집
• /
• 2005.11a
• /
• pp.587-590
• /
• 2005

A detailed geothermal characteristics survey with numerical simulations of the heat transfer in a site for ground source heat pump system is necessary for deploying a shallow geothermal utilization system. Density, specific heat, thermal diffusivity, and thermal conductivity are measured on 91 core samples from a 300 m deep borehole in KIGAM(Korea Institute of Geoscience and Mineral Resources). The heat flow is estimated from the thermal gradient and average thermal conductivity and the correlation between fracture system and hydraulic conductivity is analyzed. From the obtained ground information of the study site the performance of the ground heat pump system can be analyzed with some detailed numerical simulations for seasonal heat pump operation skill and optimal system design techniques.

• ETRI Journal
• /
• v.20 no.2
• /
• pp.241-249
• /
• 1998

The structure and electrical characteristics of metal-ferroelectric-semiconductor FET(MFSFET) for a single transistor memory are presented. The MFSFET was comprised of polysilicon islands as source/drain electrodes and $BaMgF_4$ film as a gate dielectric. The polysilicon source and drain were built-up prior to the formation of the ferroelectric film to suppress a degradation of the film due to high thermal cycles. From the MFS capacitor, the remnant polarization and coercive field were measured to be about $0.6{\mu}C/cm^2$ and 100 kV/cm, respectively. The fabricated MFSFETs also showed good hysteretic I-V curves, while the current levels disperse probably due to film cracking or bad adhesion between the film and the Al electrode.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.4
• /
• pp.106-110
• /
• 1997

A new SOI NMOSFET with a 'LOCOS-like' shape self-aligned polysilicon gate formed on the recessed channel region has been fabricated by a mix-and-match technology. For the first time, a new scheme for implementing self-alignment in both source/drain and gate structure in recessed channel device fabrication was tried. Symmetric source/drain doping profile was obtained and highly symmetric electrical characteristics were observed. Drain current measured from 0.3${\mu}{\textrm}{m}$ SOI devices with V\ulcorner of 0.77V and Tox=7.6nm is 360$mutextrm{A}$/${\mu}{\textrm}{m}$ at V\ulcorner\ulcorner=3.5V and V\ulcorner=2.5V. Improved breakdown characteristics were obtained and the BV\ulcorner\ulcorner\ulcorner(the drain voltage for 1 nA/${\mu}{\textrm}{m}$ of I\ulcorner at V=\ulcorner\ulcorner=0V) of the device with L\ulcorner\ulcorner=0.3${\mu}{\textrm}{m}$ under the floating body condition was as high as 3.7 V. Problems for the new scheme are also addressed and more advanced device structure based on the proposed scheme is proposed to solve the problems.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.5
• /
• pp.1149-1154
• /
• 2014

To observe the tunneling phenomenon of oxide semiconductor transistor, The Indium-gallum-zinc-oxide thin film transistors deposited on SiOC as a gate insulator was prepared. The interface characteristics between a dielectric and channel were changed in according to the properties of SiOC dielectric materials. The transfer characteristics of a drain-source current ($I_{DS}$) and gate-source voltage ($V_{GS}$) showed the ambipolar or unipolar features according to the Schottky or Ohmic contacts. The ambipolar transfer characteristics was obtained at a transistor with Schottky contact in a range of ${\pm}1V$ bias voltage. However, the unipolar transfer characteristics was shown in a transistor with Ohmic contact by the electron trapping conduction. Moreover, it was improved the on/off switching in a ambipolar transistor by the tunneling phenomenon.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1986.04a
• /
• pp.138-141
• /
• 1986

After various oscillators have been reviewed, cesium beam frequency standards are recommended as the KRF(Korea Reference Frequency) source. We have investigated the characteristics of the SP-12M coaxial cable to find out whether it is usable for the network synchronization.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.17 no.6
• /
• pp.1620-1634
• /
• 2023

This paper studies the task of embedding nodes with multiple graphs representing multiple information channels, which is useful in a large volume of network clustering tasks. By learning a node using multiple graphs, various characteristics of the node can be represented and embedded stably. Existing studies using multi-channel networks have been conducted by integrating heterogeneous graphs or limiting common nodes appearing in multiple graphs to have similar embeddings. Although these methods effectively represent nodes, it also has limitations by assuming that all networks provide the same amount of information. This paper proposes a method to overcome these limitations; The proposed method gives different weights according to the source graph when embedding nodes; the characteristics of the graph with more important information can be reflected more in the node. To this end, a novel method incorporating a multi-channel gate layer is proposed to weigh more important channels and ignore unnecessary data to embed a node with multiple graphs. Empirical experiments demonstrate the effectiveness of the proposed multi-channel-based embedding methods.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.37 no.6
• /
• pp.76-82
• /
• 2000

To reduce the radiated noise of ships, the noises which are generated from onboard machinery, propulsion system and transfer characteristics of structure must be identified. While the ship is operating, however, we can not directly measure each signal of inputs and characteristics of transfer passage, because measured signals are superimposed by multi source and multi transfer passage. In this paper, the signal processing method for separating noise sources and transfer functions from the measured response signal by the cepstrum technique is proposed. The proposed method is verified by application of simulated signal and impact test and shows usefulness by application of real ship test.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.10a
• /
• pp.573-576
• /
• 2000

In this paper, analysis of operating characteristics of hybrid cascade multilevel PWM rectifier without bulky and heavy isolation transformers is presented. The multilevel PWM rectifier is analyzed by using the circuit DQ transformation whereby the static and dynamic characteristics and some useful design relationships are obtained. Then, the operating characteristics such as active/reactive power relationships with respect to control variables, DC voltages build up are presented. It will be shown that the DC voltages for the multilevel output generation may be directly built up from AC utility source. Finally, to confirm the validity of the analysis, MATLAB simulations are tarried out.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.48 no.11
• /
• pp.1388-1393
• /
• 1999

A more reliable algorithm for detecting a high impedance fault (HIF) requires fault currents at the relaying point containing information of load condition as well as HIF characteristics. This paper presents a modeling method of an HIF in a distribution system using EMTP. From the voltage and current waveforms of HIF experiment, the voltage-current characteristic is obtained and then piecewise linearized. The proposed method gets several points on the linearized voltage-current curve and then represents nonlinearity as piecewise linear resistances using Transient Analysis of Control Systems (TACS) in EMTP. Thus, an HIF is represented as a voltage source in the first and third quadrants of voltage-current plane. The method is implemented in EMTP and thus the voltage and current at the relaying point can be obtained when an HIF occurs. In this paper, an HIF was simulated on various load conditions and fault conditions in 22.9 [kV] distribution systems.

• Journal of the Korea Convergence Society
• /
• v.8 no.6
• /
• pp.97-107
• /
• 2017

The purpose of this study was to investigate information source of the choice of select dental medical institution and the relationship between socioeconomic characteristics and information searching pattern. This study was conducted for residents adults and teens living in Gwangju and rural communities of Jellanam-do province including. The study shows that 61.0 % of the information of selecting dental medical institutes had been introduced by the acquaintance and the rest of the information(37.0%) had been gotten from the internet. The purpose of this study is to develop an information search method that can influence the choice of medical consumers in dental clinics, and to establish a new dental clinic management strategy based on this research. Plus, we want to develop an information search source that can have a convergence effect on the selection of medical consumers in dental medical institutions.