• Journal of the Korean Wood Science and Technology
• /
• v.41 no.5
• /
• pp.440-446
• /
• 2013

To understand transition characteristics from wood to charcoal, Quercus variabilis wood was carbonized at 200, 250, 300, 340, 540 and $740^{\circ}C$, respectively. Heating value, pH and surface property by FT-IR spectroscopy of the carbonized charcoal were investigated. Heating value and pH increased with increasing carbonization temperature from 4500 cal/g and 4.3 of the control wood to 8,000 cal/g and 9 of the charcoal carbonized at $740^{\circ}C$, respectively. From FT-IR spectroscopy, the peaks from O-H, C-H and C-O stretching disappeared during carbonization at 540 and $740^{\circ}C$. Aromatic skeletal vibration at near $1,506{\sim}1,593cm^{-1}$ was repidly increased until $540^{\circ}C$. These results suggest that the chemical and physical characteristics of wood components in cell wall can be easily changed by increasing carbonization temperature and the carbonization seem to be incomplete at temperature below $540^{\circ}C$.

• Journal of Electrochemical Science and Technology
• /
• v.10 no.2
• /
• pp.131-138
• /
• 2019

To improve the performance of Si anodes in advanced Li-ion batteries, the design of the electrode plays a critical role, especially due to the large volumetric expansion in the Si anode during Li insertion. In our study, we used a simple fabrication method to prepare Si-based electrodes by grafting polyacrylic acid (PAA) to a carboxymethyl cellulose (CMC) binder (CMC-g-PAA). The procedure consists of first mixing nano-sized Si and the binders (CMC and PAA), and then coating the slurry on a Cu foil. The carbon network was formed via carbonization of the binders i.e., by a simple heat treatment of the electrode. The carbon network in the electrode is mechanically and electrically robust, which leads to higher electrical conductivity and better mechanical property. This explains its long cycle performance without the addition of a conducting agent (for example, carbon). Therefore, the partially carbonized CMC-g-PAA binder presented in this study represents a new feasible approach to produce Si anodes for use in advanced Li-ion batteries.

• Journal of the Korean Wood Science and Technology
• /
• v.30 no.1
• /
• pp.34-39
• /
• 2002

This study examined the effect of carbonized wastewoods on purification of waste water. The purification ability of charcoals(lump-shaped, approximately 3×3×3 cm) maded by wood-based material for waste water from a kitchen and septic tank was superior to those of thinned wood. For lump-shaped charcoal, gaps between particles in particleboard, and gaps between fibers in MDF were much more effective than micropore in purification of waste water. After purification test, color of waste water from wood-based material charcoals were much more lighter than thinned wood charcoals. In addition, odors of waste water from both charcoals tended to be decreased.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.4
• /
• pp.21-28
• /
• 2007

To analyze the changes in pH and elemental content ratio of wood charcoal and in FT-IR spectra of their surfaces, wood charcoals carbonized from Pinus koraiensis were used. pHs of wood charcoals carbonized from Pinus koraiensis at 300 and $400^{\circ}C$ were 5-27 and 6.80, respectively, whereas they were between 9.25~10.35 for the wood charcoals manufactured between $500{\sim}900^{\circ}C$ From the changes in the elemental ratios of Pinus koraiensis wood charcoal by increasing carbonization temperature, carbon (C) contents increased by elevating the carbonization temperature with the decreasing in content ratios of O and H. The largest changes in the ratio was found between the carbonization temperature 400 and $500^{\circ}C$. Ratios of C, O, H of the wood charcoal manufactured at 300 and $400^{\circ}C$ were 67.7, 28.9, 3.0% and 72.2, 24.9, 2.5%, respectively, while those at $500{\sim}900^{\circ}C$ were between 83.3~90.5, 13.6~9.0, 2.7~0.3%. The surface functional groups of Pinus koraiensis wood charcoals were determined by comparison of FT-IR spectra of the wood powder and the wood charcoal carbonized with the wood powder. The functional groups on the surface of wood charcoals carbonized at 300 and $400^{\circ}C$ were considered to be acidic groups like Lactone, Lactol, Carboxylic acid, Carboxylic anhydride, whereas Pyrone types could be the major functional groups for the wood charcoals carbonized between 500 and $900^{\circ}C$.

• Korean Journal of Environmental Agriculture
• /
• v.12 no.3
• /
• pp.247-254
• /
• 1993

The growth responses of Chinese Cabbage, lettuce, and spinach were evaluated to investigate the feasibility of carbonized rice-hulls as a sanitary cultivation media instead of soil. The carbonized rice-hulls were pretreated with several inorganic acid such as nitric, sulfuric, hydrochloric, and phosphoric acid for neutralization. The neutralization of the carbonated material using nitric, sulfuric, and phosphoric acid did not alter the growth responses of these vegetables compared to those of control plants grown on the normal cultivation soil. Especially, the nitric acid pretreatment resulted in the better growth of these plants than the mixture of soil and compost. This is probably due to the additional supply of the nitrate-nitrogens. However the growth responses of lettuce and spinach on the carbonated materials neutralized with hydrochloric acid were different and appeared to be having symptom which is analogous to the chloride toxicity during the late stage of growing. Although no difference was observed in chemical composition, the contents of protein-nitrogen were higher in the plants grown on the carbonated material compared to those of plant grown on the mixture of soil and compost. Based on our preliminary results, the carbonized and neutralized rice-hulls are very useful bed material for the sanitary cultivation under the controlled environmental condition.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.26 no.5
• /
• pp.188-192
• /
• 2016

In this work, the SiC powders were synthesized through the carbonized matter from the mixture of silica powder and rice husks. The SiC powders, obtained from the carbothermal reduction reaction of silica and carbonized rice husks, were investigated by XRD patterns, XPS, FE-SEM and FE-TEM. In the XRD patterns, the specimens showed clearly very high strong peak of (111) plane near $35^{\circ}$ as well as weak (220) and (311) peak respectively at approximately $60^{\circ}$ and $72^{\circ}$. Under Ar atmosphere, the power synthesized from the mixture (in case of mixing ratio, 6 : 4) of carbonized rice husks and silica showed mainly cubic SiC crystalline phase showing relatively lower ratio of hexagonal phase without residual carbon in XRD pattern. In the TEM analysis, the specimen, synthesized from carbonized rice husks and silica with mixing ratio of 6 : 4 under Ar atmosphere, showed relatively fine particles under $5{\mu}m$ and a crystalline SiC phase of (100) diffraction pattern.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.29 no.2
• /
• pp.45-49
• /
• 2019

Relatively fine silicon carbide (SiC) crystalline aggregates have been synthesized with the carbonized rice husks, paper sludge, coffee grounds as the carbon sources and the silica powder. The main reaction source to obtain silicon carbide (SiC) aggregates from the mixture of carbon sources and silica was inferred as the gaseous silicon monoxide (SiO) phase, being created from this mixture through the carbothermal reduction reaction. The silicon carbide (SiC) crystalline aggregates, fabricated from the carbonized rice husks and paper sludge, coffee grounds and silica ($SiO_2$) powder, were investigated by XRD patterns, FE-SEM and FE-TEM images. In these specimens, obtained from the carbonized rice husks, paper sludge and silica, XRD patterns showed rather high strong peak of (111) plane near $35^{\circ}$. The FE-TEM images and patterns of specimens, synthesized from carbonized rice husks, paper sludge, coffee grounds and silica under Ar atmosphere, showed relatively fine particles under $1{\mu}m$ and crystalline peak (110) of silicon carbide (SiC) diffraction pattern.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.30 no.2
• /
• pp.5-15
• /
• 2022

In this study, heated tobacco biomass was prepared as an active material for supercapacitor device. Retrieved tobacco leaf from the heated tobacco was carbonized at various temperature(800/850/950℃). Carbonized tobacco leaf material synthesized at 850℃ exhibited the highest C/O ratio, indicating the finest carbon quality. In addition, polypyrrole was coated onto the carbonized leaf material for increasing the electrochemical performance via low-temperature polymerization method. As-synthesized carbonized leaf material at 850℃(CTL-850)-based electrode and polypyrrole-coated carbonized leaf material(CTL-850/PPy)-based electrode displayed outstanding specific capacitances of 100.2 and 155.3F g^-1 at 1 A g^-1 with opertaing window of -1.0V and 1.0V. Asymmetric supercapacitor device, assembled with CTL-850 as the negative electrode and CTL-850/PPy as the positive electrode, manifested specific capacitance of 31.1F g^-1(@1 A g^-1) with widened operating voltage window of 2.0V. Moreover, as-prepared asymmetric supercapacitor device was able to lighten up the RED Led (1.8V), suggesting the high capacitance and extension of operating voltage window. The result of this research may help to pave the new possibility toward preparing the effective energy storage device material recycling the biomass.

• Clean Technology
• /
• v.28 no.3
• /
• pp.210-217
• /
• 2022

Boron(B) is a rare resource used for various purposes such as glass, semiconductor materials, gunpowder, rocket fuel, etc. However, Korea depends entirely on imports for boron. Considering the global boron reserves and its current production rate, boron will be depleted on earth in 50 years. Thus, a process including proper adsorbent materials recovering boron from seawater is demanded. This research proposed carbonized nanofibers prepared from electrospun PAN(polyacrylonitrile) mats as promising materials to adsorb boron in aqueous solution. First, the mechanism of boron adsorption on carbonized nanofibers was investigated by DFT(density functional method)-based molecular modeling and the calculated energetics demonstrated that the boron chemisorption on the nitrogen-doped graphene surface by a two-step dehydration is possible with viable activation energies. Then, the electrospun PAN mats were stabilized in air and then carbonized in an argon atmosphere before being immersed in the boric acid aqueous solution. Analytically, SEM(scanning electron microscopy) and Raman measurements were employed to confirm whether the electrospinning and carbonization of PAN mats proceeded successfully. Then, XPS(X-ray photoelectron spectroscopy) peak analysis showed whether the intended nitrogen-doped carbon nanofiber surface was formed and boron was properly adsorbed on nanofibers. Those results demonstrated that the carbonized nanofibers prepared from electrospun PAN mats could be feasible adsorbents for boron recovery in seawater.

• Korean Journal of Soil Science and Fertilizer
• /
• v.26 no.2
• /
• pp.93-102
• /
• 1993

Carbonized rice hull, neutralized by dilute nitric acid, was evaluated possibility as a bed matrial for sanitary cultivation. The growth response of Chinese Cabbage, lettuce, and spinach on the carbonized rice hull supplemented with different kinds and concentrations of available nutrition solution was accessed. The ideal nitrogen concentration of nutrition solution was 126 mg/l. Both solutions of compound fertilizer and nutrition containing microelements showed no difference in growth and chemical components of vegetables. Therefore, compound fertilizer was thought to be better than nutrition owing to the convenience of handling in practice. The gravel was also evaluated as supporting material of carbonized rice hull. Because of lasting latent heat in gravel, the mixing treatment of carbonized rice hull and gravel(7~10cm in diam.) was efficient to the growth resulting in the highest dry weight per plant, but the heavy weight of gravel made the handling very difficult. Light carbonized rice hull showed the better plant growth and ease handling, compared to the mixture of soil and compost, and had enough supporting capacity. Therefore, carbonized rice hull was thought to be a desirable bed material for environmentally controlled cultivation.