• Journal of Powder Materials
• /
• v.19 no.4
• /
• pp.253-258
• /
• 2012

The characteristics of $Al_2TiO_5$ ceramics were influenced by the additives and the heat treatment that controls the microcrack behavior at grain boundaries. The effect of additives on $Al_2TiO_5$ ceramics were investigated in terms of mechanical properties and thermal expansion at high temperature. The $Al_2TiO_5$ were synthesized at $1500^{\circ}C$, $1550^{\circ}C$ and $1600^{\circ}C$ for 2h by reaction sintering. The formation of $Al_2TiO_5$ phase was increased by additives that enhanced the volume of the microcrack that can lead to low thermal expansion. The mechanical properties of the stabilized $Al_2TiO_5$ ceramics were increased remarkably at $1100^{\circ}C$, $1200^{\circ}C$ and $1300^{\circ}C$ due to the oneset of mechanical healing of grain-bondary microcracks at a high temperature. The amount of microcrack was decreased at lower sintering temperature that causes the increase of mechanical properties at high temperature.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.24 no.4
• /
• pp.247-256
• /
• 2012

The purpose of this study is to decide the permeability and the rate of flow in a way of both site investigation and backward analysis and the most reasonable numerical analysis by performing a seepage model test for measuring the deformation swept volume of the embankment body in order to review a stability of the sea dyke being composed of multi-layers depending on variation of infiltration. As a result of the review, it could be forecasted that sweeping loss would be taken place at the boundary between bed protection works and embankment materials of the sea dyke due to a permeability difference of the multi-layered bed foundation structures and the sea dyke deformation would be occurred as a result thereby. As result of a numerical analysis for the seepage model test, it could be observed that critical velocity method was found to be smaller than the numerical analysis value but its tendency was similar and therefore it was judged that this method could be applied for the actual cross section.

• School Mathematics
• /
• v.18 no.1
• /
• pp.85-103
• /
• 2016

This study was to find characteristics of argumentation derived from a discourse in a math-gifted 5 grade class, which was held for finding a Pick's formula using Geoboard function of TI-73 calculator. For the analysis, a video record of the class, transcript of its voice record, and activity paper were used as data and Toulmin's argument schemes were applied as analysis standard. As a result of the study, we found that the graphing calculator helped the students to create an experimental environment that graphing a grid-polygon and figuring out its area. Furthermore, it also provided a basic demonstration through 'data->claim' composition and reasoning activities which consisted of guarantee, warrant, backing, qualifier and refutal for justifying. The basic argumentation during the process of deriving the Pick's theorem by the numbers of boundary points and inner points was developed into a 'collective argumentation' while a teacher took a role of a conductor of the argumentation and an authorizer on the knowledge at the same time.

• Applied Chemistry for Engineering
• /
• v.7 no.3
• /
• pp.518-529
• /
• 1996

To develope chemical heat pump using available energy sources such as solar heat and many kinds of waste thermal energy we have studied the enhancement effect of inserted fins in cylindical packed bed reactor. Two dimensionnal(radial and circumferential) partial differential eqaetions, concerning heat and masstransfer in CaO packed bad, are solved numerically to describe the characteristics of the reaction of fins inserted reactor and heat transfer. The results obtained by numerical analysis about two dimensional profiles of temperature and conversion in the reactant in the packed bed and exothermic heat amount released from the reactor are follows; -. The insertion of fins in reactor can redue the reaction completion time by half. -. The rate of thermochemical reaction depends of the temperature and concentration and it is also governed by the boundary conditions and heat transfer rate in the particle packed bed.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.8 no.2
• /
• pp.9-16
• /
• 1990

This is a geodetic study on the the shoreline changes occurred by the facilities constructed in the beach. There are emperical, hydrological and numerical methods in predicting of the shorline changes. Numerical method is the most suitable method in the field of geodesy. There are many predicting models. This study adopted one-line model because it has a few hydrological factor and simplify the natural phenomena. This study established the ideal seawall boundary condition, applied the explicit model and the implicit model in the Dongsan harbour in East Sea, and could predict the optimum seawall position for protection of shore. The results are following ; Seawall protect shore of which input angle of wave is below 20$^\circ$, a ratio of wave height bleak/line does not effect in shoreline changes. The implicit model is accuracy but can not predict longtime change. But the explicit model is the opposite of the implicit model.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.16 no.3
• /
• pp.197-201
• /
• 1983

Underwater ambient noise level was measured at two points near the Youngil Bay. The environmental characteristics depend upon oceanographic conditions of sound propagation ana its implication on the source of ambient noise. Some noise sources were estimated, and the effect of the oceanographic conditions on the noise level variation had been considered. The results were as follows : 1) At the nearshore station of Youngil Bay, the ambient noise level in the near bottom(45m) was lower than that of the near surface(10m) by 15dB. This difference was due to spherical spreading from the upper to the lower layer. 2) At the open sea station which is located outside of the thermal front existing near the Youngil Bay, the ambient noise level of the upper layer(20m) was higher than that of the lower layer (100m) by $8{\sim}12dB$ below 50Hz and $15{\sim}23dB$ above 50Hz. 3) Above 60Hz the ambient noise level at the nearshore station was higher than that of the open sea station, while below 60Hz, the result was reverse. It appears that a boundary layer existed between the two stations.

• Atmosphere
• /
• v.26 no.2
• /
• pp.243-256
• /
• 2016

Total number concentration of aerosols larger than 10 nm ($N_{CN10}$), 3 nm ($N_{CN3}$), and cloud condensation nuclei ($N_{CCN}$) were measured during four different ship cruises over the Yellow Sea. Average values of $N_{CN10}$ and $N_{CCN}$ at 0.6% supersaturation were 6914 and $3353cm^{-3}$, respectively, and the minimum value of $N_{CN10}$ was $2000cm^{-3}$, suggesting significant anthropogenic influence even at relatively clean marine environment. Although $N_{CN10}$ and $N_{CN3}$ increased near the coast due to anthropogenic influence, $N_{CCN}$ was relatively constant and therefore $N_{CCN}/N_{CN10}$ ratio tended to decrease, suggesting that coastal aerosols were relatively less hygroscopic. In general $N_{CN10}$, $N_{CN3}$, and $N_{CCN}$ during the cruises seemed to be significantly influenced by wet scavenging effects (e.g. fog) and boundary layer height variation. Only one new particle formation (NPF) event was observed during the measurement period. Interestingly, the NPF event occurred during a dust storm event and spatial scale of the NPF event was estimated to be larger than 100 km. These results demonstrate that aerosol and CCN concentration over the Yellow Sea can vary due to various different factors.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.12
• /
• pp.93-105
• /
• 2017

This study presents direct shear tests, model tests, and numerical simulations to assess the effect of reduction of soil strength because of saturation during formation of ground cave-in caused by damaged sewer pipe lines. The direct shear test results show that the saturation affects the cohesion of soil significantly although it does not influence the friction angle of soil. To experimentally reproduce ground cave-in, the model tests were performed. As ground cave-ins were accompanied with extreme deformation, conventional finite element method has difficulty in simulating them. The present study relies on generalized interpolation material point method, which is one of meshless methods. Although there are differences between the model test and numerical simulation caused by boundary conditions, incomplete saturation, and exclusion of groundwater flow, similar ground deformation characteristics are observed both in the model test and numerical simulation.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.3
• /
• pp.41-48
• /
• 2014

Experimental study of sedimentation and self-weight consolidation has been primary research area in dredged soil. However, good quality of the dredged soil and minimum water pollution caused by the pumping of reclaimed soil require intensive study of the flow characteristics of dredged material due to dumping. In this study, continuity and the equilibrium equations for mass flow assuming single phase was derived to simulate mass flow in dredged containment area. To optimize computation and modeling time for three dimensional geometry and boundary conditions, depth integration is applied to governing equations to consider three dimensional topography of the site. Petrov-Galerkin formulation is applied in spatial discretization of governing equations. Generalized trapezoidal rule is used for time integration, and Newton iteration process approximated the solution. DG and CDG technique were used for weighting matrix in discontinuous test function in dredged flow analysis, and numerical stability was evaluated by performed a square slump simulation. A comparative analysis for numerical methods showed that DG method applied to SU / PG formulation gives minimal pseudo oscillation and reliable numerical results.

• The Korean Journal of Ceramics
• /
• v.6 no.3
• /
• pp.258-261
• /
• 2000

Highly (h00)-oriented (Ba, Sr)TiO$_3$(BST) thin films were grown by pulsed laser deposition on the perovskite LaNiO$_3$(LNO) metallic oxide layer as a bottom electrode. The LNO films were deposited on SiO$_2$/Si substrates by rf-magnetron sputtering method. The crystalline phases of the BST film were characterized by x-ray $\theta$-2$\theta$, $\omega$-rocking curve and $\psi$-scan diffraction measurements. The surface microsturcture observed by scanning electron microscopy was very dense and smooth. The low-frequency dielectric responses of the BST films grown at various substrate temperatures were measured as a function of frequency in the frequency range from 0.1 Hz to 10 MHz. The BST films have the dielectric constant of 265 at 1 kHz and showed multiple dielectric relaxation at the low frequency region. The origin of these low-frequency dielectric relaxation are attributed to the ionized space charge carriers such as the oxygen vacancies and defects in BST film, the interfacial polarization in the grain boundary region and the electrode polarization. We studied also on the capacitance-voltage characteristics of BST films.