• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.1-9
• /
• 2014

In this paper, a reconfigurable polarization patch antenna that uses a Y-shaped feed is proposed. The proposed antenna consists of a square patch, a Y-shaped feeding structure, a PIN diode, and a bias circuit for diode operation. The structural symmetry/asymmetry of the feeding structure is determined by the on/off operation of the PIN diode that inserted into the side of one of the lines of the Y-shaped feeding structure. For the proposed reconfigurable antenna, the two microstrip lines of the feeding structure have the same length when the PIN diode operates in the on state, and the antenna exhibits linear polarization(LP). On the other hand, when the PIN diode operates in the off state, the length of one side line of the feeding structure is relatively shorter than that of the other line. Therefore, the antenna exhibits circular polarization(CP). From the measurement results, it is found that the proposed antenna exhibits good impedance matching and axial ratio. In addition, polarization switching can be easily achieved in the same operating band.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.6
• /
• pp.562-568
• /
• 2013

This paper presents a design of a wireless power transfer system based on magnetic resonant coupling technology with in-band wireless communication. To increase the transmission distance and compensate for the change in the effective capacitance due to the varying distance, the proposed system used a loop antenna with a selectable capacitor array. Because the increased transmission distance enables multiple charging, we added a communication protocol operated at the same frequency band to manage a network and control power circuits. In order to achieve the efficient bandwidth in both power transfer mode and communication mode, the S-parameters of the loop antennas are adjusted by switching a series resistor. Our test results showed that the loop antenna achieved a high Q factor in power transfer mode and enough passband in communication mode.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.6
• /
• pp.689-697
• /
• 2016

In this paper, we design and implement SPA (Switched Parasitic Antenna) antenna which can control its beampattern using multiple parasitic elements. By applying SPA antenna to wireless communication system and implementing beamforming scheme, we show that SPA antenna can be used to improve the performance of wireless communication systems. SPA antenna consists of a single active antenna and multiple parasitic elements around the active one, and can control its beampattern by switching the parasitic elements. Using this characteristic of the SPA antenna, it is possible to impelemtent beamforming technique with single RF chain, which enables to design low cost, low complexity and low power wireless communication systems. In order to verify the beamforming gain, we measure and analyze the system level performance, such as SNR, PER, and throughput.

• Journal of Advanced Navigation Technology
• /
• v.22 no.4
• /
• pp.311-318
• /
• 2018

In this paper, test-bed for the evaluation of wireless communication system on a small launch vehicle is proposed. The proposed test-bed consists of antenna test-coupler, RF attenuators, and RF switch modules. The antenna test-coupler isolates antennas for each band and transmits / receives wireless signals. The RF attenuator and switch are used for path selection of testing signal path. In design and measurement result of the antenna test-coupler, the antenna test-coupler has shielding effect higher than 39.3, 47.1, 56.1 dB at UHF-, S-, X-band. Through testing on small launch vehicle wireless communication system, we were able to successfully transmit and receive data between each test system and launch vehicle with antenna path switching.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.2
• /
• pp.628-649
• /
• 2017

Security and resource-saving are both demands of the fifth generation (5G) wireless networks. In this paper, we study the secrecy spectrum efficiency (SSE) and secrecy energy efficiency (SEE) of a K-tier massive multiple-input multiple-output (MIMO) enabled heterogeneous cellular network (HetNet), in which artificial noise (AN) are employed for secrecy enhancement. Assuming (i) independent Poisson point process model for the locations of base stations (BSs) of each tier as well as that of eavesdroppers, (ii) zero-forcing precoding at the macrocell BSs (MBSs), and (iii) maximum average received power-based cell selection, the tractable lower bound expressions for SSE and SEE of massive MIMO enabled HetNets are derived. Then, the influences on secrecy oriented spectrum and energy efficiency performance caused by the power allocation for AN, transmit antenna number, number of users served by each MBS, and eavesdropper density are analyzed respectively. Moreover, the analysis accuracy is verified by Monte Carlo simulations.

• Journal of Korea Society of Industrial Information Systems
• /
• v.25 no.5
• /
• pp.13-21
• /
• 2020

This paper proposes a sign reversal channel switching method in space-frequency block code for orthogonal frequency division multiplexing system. In case of sending source data on other antenna, it is necessary for the receiver to change combining method according to the channel variation. If one does not know the predefined channel switching sequence, it is not possible to decode the received data precisely. In transmit data symbols' exchanges for a channel switching, data symbols are exchanged according to a format of space-frequency block code. In this paper, we proposes a simple sign reversal method except exchanging data symbols between transmit antennas. It is shown that this method occurs another combining method for a simple encryption in the receiver.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.803-805
• /
• 2015

MIMO receiver for multiplexing gain brings about antenna volume issue to which beam pattern switching scheme shall be one of the solutions. This scheme has been studied mainly in theory. This paper presents the test results and performance analysis of 2x2 MIMO receiver we implemented by using beam pattern switching.

• Journal of Satellite, Information and Communications
• /
• v.5 no.2
• /
• pp.75-81
• /
• 2010

COMS (Communication, Ocean and Meteorological Satellite) is the multi-purposed Korean geostationary satellite funded by four Korean government ministries, and is to supply communication services, ocean and weather observation for 7 years. As part of COMS, development of Ka band communication payload composed of microwave switching transponder and multi-horn antenna is sponsored by KCC (Korea Communications Commission) and developed by ETRI (Electronics and Telecommunications Research Institute). The purpose of Ka Payload development is to acquire space proven technology of Ka payload and to exploit advanced multimedia communication services. This paper aims to study development technology of Ka payload system through whole process of ETRI project. Also application of Ka payload will be dealt in this paper.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9A
• /
• pp.889-895
• /
• 2010

In this paper, we have studied the implementation and adaptation of a smart antenna system for mobile terminals. We have designed a smart antenna system with switching beam structure in order to reduce the hardware and computational complexity. Additionally we have analyzed the reduction of the effect of multipath fading due to beamforming using real measurement data from commercial CDMA cellular channel environments. After analyzing the measurement data, we found out that the effect of fading reduces by ~3dB due to the effect of $2{\times}2$ beamforming in mobile terminals with 6dB beamforming gain.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.1
• /
• pp.78-84
• /
• 2008

In this paper, the reconfigurable annular ring slot antenna with circular polarization diversity is proposed for SDMB(Satellite Digital Multimedia Broadcasting) system. The proposed antenna consists of a ring slot with four tuning stubs. Four PIN diodes are attached to switch circular polarization diversity. By switching the diodes ON or OFF, the proposed antenna can be operated either RHCP mode or LHCP mode. The experimental result shows that the proposed antenna has an impedance bandwidth(VSWR${\leq}$2) of 570MHz(2.47-3.04GHz) at LHCP mode, an impedance bandwidth (VSWR${\leq}$2) of 560MHz(2.45-3.01GHz) at RHCP mode, a maximum gai of 3.1dBi at RHCP mode, 4.76dBi at LHCP mode. The 3dB CP bandwidth of about 100MHz at both RHCP and LHCP mode is achieved at the center frequency 2.63GHz. The proposed antenna is suitable for application such as mobile satellite communications, WLAN(Wireless Local Area Networks), and broadband wireless communication systems.