• Bulletin of the Korean Chemical Society
• /
• v.32 no.7
• /
• pp.2237-2242
• /
• 2011

Anomalous scaling behaviors such as significantly large growth exponent (${\beta}$) and small reciprocal of dynamic exponent (1/z) values for many molecular crystalline thin films have been reported. In this study, the variation of scaling exponent values and consequent growth behaviors of molecular thin films were more quantitatively analysed using a (1+1)-dimensional surface lateral diffusion model. From these simulations, influence of step edge barriers and grain boundaries of molecular thin films on the various scaling exponent values were elucidated. The simulation results for the scaling exponents were also well consistent with the experimental data for previously reported molecular thin film systems.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 1999.03b
• /
• pp.180-183
• /
• 1999

It is well known that Fe3Al intermetallic compound shows an anomalous peak of the yield strength at about 50$0^{\circ}C$ and then decrease at higher temperatures The dislocation structure was examined by transmission electron microscopy and high temperatures. The dislocation structure was examined by transmission electron microscopy and high temperature mechanical properties were examined by tensile and load relaxation tests. The flow stress curves obtained from load relaxation tests were then analyzed in terms of internal variable deformation theory. it was found that the flow curves consisted of three micro-deformation mechanisms -i. e inelastic deformation mode plastic deformation mode and dislocation creep deformation mode depending on both dislocation structure and deformation temperature. The flow curves could be well described by the constitutive equations of these three micro-deformation mechanisms based on the internal variable deformation theory.

• 전기의세계
• /
• v.20 no.4
• /
• pp.23-30
• /
• 1971

The photovoltaic behaviors ahve been observed with a sandwich-type cell, consisting of a junction between .betha.-carotene and stannic oxide conducting layer to provide a junction electrode. In the stannic oxide and .betha.-carotene junction it was found that its electromotive forse decreased to a value smaller than the original one. This is due to a space charge formation. Photovoltage reached approximately 40mV with an irradiation energy of 250Kcal/M$^{2}$hr. It appeared that a magnitude of the photovoltaic response was proportional to the logarithm of irradiance. The time constant of the photovoltaic effect was shown to be approximately 0.7 sec. The wavelength dependence of the photovoltaic behavior was very anomalous. It is assumed that such an anomalous photoresponse depends on a internal capacitance due to some bubble during process to make a cell.

• Progress in Superconductivity and Cryogenics
• /
• v.25 no.4
• /
• pp.14-18
• /
• 2023

We have investigated the behavior induced by Ga substitution in B-1212 system and observed an anomalous superconductor-like resistivity drop with an onset near 260 K and an offset at 248 K in the nominal (B_0.65Ga_0.35)(Ba_1.25Sr_0.75)(Er_0.5Ca_0.5)Cu₂O_z compound. However, this property degraded with repeated cycling. Systematic studies of the superconducting properties of the (B_1-xGa_x)(Ba_1.25Sr_0.75)(Er_0.5Ca_0.5)Cu₂O_z compounds are reported and discussed in the context of the anomalous resistivity transition.

• Review of KIISC
• /
• v.5 no.2
• /
• pp.32-48
• /
• 1995

Our paper describes an Intrusion Detection Parallel System(IDPS) which detects an anomaly activity corresponding to the actions that interaction between near detection events. IDES uses parallel inductive approaches regarding the problem of real-time anomaly behavior detection on rule-based system. This approach uses sequential rule that describes user's behavior and characteristics dependent on time. and that audits user's activities by using rule base as data base to store user's behavior pattern. When user's activity deviates significantly from expected behavior described in rule base. anomaly behaviors are recorded. Observed behavior is flagged as a potential intrusion if it deviates significantly from the expected behavior or if it triggers a rule in the parallel inductive system.

• Journal of Information Processing Systems
• /
• v.20 no.2
• /
• pp.159-172
• /
• 2024

The number of healthcare products available for pets has increased in recent times, which has prompted active research into wearable devices for pets. However, the data collected through such devices are limited by outliers and missing values owing to the anomalous and irregular characteristics of pets. Hence, we propose pet behavior recognition based on a hybrid one-dimensional convolutional neural network (CNN) and long short- term memory (LSTM) model using pet wearable devices. An Arduino-based pet wearable device was first fabricated to collect data for behavior recognition, where gyroscope and accelerometer values were collected using the device. Then, data augmentation was performed after replacing any missing values and outliers via preprocessing. At this time, the behaviors were classified into five types. To prevent bias from specific actions in the data augmentation, the number of datasets was compared and balanced, and CNN-LSTM-based deep learning was performed. The five subdivided behaviors and overall performance were then evaluated, and the overall accuracy of behavior recognition was found to be about 88.76%.

• Membrane Journal
• /
• v.10 no.3
• /
• pp.139-147
• /
• 2000

Non-Fickian (or anomalous) diffusion was observed in transient sorption of aromatic solvents(such as benzene, toluene, and chlorobenzene) in fluoropolymers (such as ETFE, ECTFE and PVDF). In this study, five other transient sorption models (Crank, Long ＆ Richman, Berens ＆ Hopfenberg, Neogi, Li) based on Fick's law were employed to fit the anomalous sorption data for aromatic solvents. The adjustable parameters were determined by least square analysis of the measured and predicted fractional uptake. For ETFE sorption data slightly deviating from Fickian behavior, all the models exhibited satisfactory results in fitting the anomalous sorption data. In particular, Neogj model predicted intrinsic diffusivity (0.4～0.8$\times$10$^{-5}$ $\textrm{cm}^2$/day) and equilibrium diffusivity (0.13～0.31$\times$10$^{-4}$ $\textrm{cm}^2$/day) as well as relaxation kinetics related to non-Fickain diffusion. For a typical sigmoidal sorption behavior in PVDF, only Crank's model could give the reasonable evaluation on transport properties. The ratio of intial diffusivity (D$_{i}$) to final equilibrium diffusivity (D$_{\infty}$) was ranged from 80 to 200. For the final stage of uptake In ECTFE with drastic acceleration, all the models exhibited significant deviations from the sorption data. New diffusion models based on thermodynamics and continuum mechanics should be employed to get valuable information on transport properties as well as relaxation kinetics coupled with non-Fickian diffusion.

• Polymer(Korea)
• /
• v.28 no.1
• /
• pp.24-34
• /
• 2004

Transient sorption experiments were conducted among several combinations of fluoropolymers and various organic solvents. Fully fluorinated polymer tended to exhibit ideal sorption behavior, while partially fluorinated polymers showed anomalous sorption behaviors with a drastic acceleration at the final stage of uptake. Minimization of least-squares of the measured and predicted fractional uptake, which indicated the increasing degree of deviation from Fickian diffusion, gave values of 3.0${\times}$10$\^$-4/, 1.75${\times}$10$\^$-3/, 8.68${\times}$10/sup-3/, 1.75${\times}$10$\^$-2/, respectively, for perfluoroalkoxy copolymer, poly(ethylene-co-tetrafluoroethylene), poly(vinylidene fluoride), poly(ethylene-co-chlorotrifluoroethylene). From stress-strain tests, it was confirmed that non-Fickian diffusion is closely related to the significant variation of mechanical properties (such as modulus and tensile strength) of swollen polymer. Anomalous sorption behavior stemmed from non-Fickian diffusion caused by nonlinear disruption of polar inter-segmental bonds due to solvent-induced plasticization. Thus, it is imperative to investigate the diffusion behavior of swelling solvents in partially fluorinated polymers, especially for the application to barrier materials or perm-selective membranes.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.1
• /
• pp.84-88
• /
• 1999

The behavior of oxygen precipitation was investigated in radial direction using Si wafers with different vacancy-related defects generation area. The behavior of oxygen precipitation in radial direction is strongly dependent on the size of vacancy rich area which is related with crystal growth condition. Oxygen precipitation rate is more enhanced in vacancy rich area than that of interstitial rich area. And anomalous oxygen precipitation is generated in the marginal bands of vacancy and interstial area. In V/I boundary, however, oxygen precipitation is suppressed to nearly perfect.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 1992.05a
• /
• pp.17-17
• /
• 1992

The ceramic high transition temperature superconducting materials present many interesting characteristics that will be analysed from two points of view: physical behavior, and chemical aspects. From the first point of view, these materials display an enormous variety of different physical properties. At low doping levels the normal state shows antiferromagnetism and insulating behavior. At intermediate doping levels, an anomalous metallic state appears and, the optimum Tc in the superconducting state is generated. With increasing doping a normal metallic state develops and superconductivity starts to disappear. Many of the physical phenomena that describe the overall behavior when doping levels are changed will be discussed. From the poing of view of the chemical aspects. we well discuss some of the problems involved in the methods of preparation with particular emphasis on defects, crystal structures, critical currrents, and applications in technology.