• Resources Recycling
• /
• v.13 no.3
• /
• pp.3-11
• /
• 2004

Basic studies have been conducted regarding the crystal formation of hydroxyapatite which was produced in the treatment process of phosphate-containing wastewater using calcium ions as the precipitating agent for its employment as the material for artificial bones. The precipitation of hydroxyapatite were conducted in the synthetic solution which simulating human body fluid for its increased applicability. Ca($NO_3$)$_2$$.$$4H_2$O and ($NH_4$)$_2$$HPO_4$ were employed for the precipitation of hydroxyapatite and its composition was analyzed after drying at 80oC. The thermal behavior of precipitate was investigated by examining the change in its crystalline structure according to the sintering temperature. DTA/TG analysis showed that the escape of moisture from the precipitate occurred at ca. $100^{\circ}C$ and the decomposition of ammonia and the evaporation of lattice water were brought about at around $250^{\circ}C$. X-ray diffraction analysis indicated that the thermally treated precipitate consisted mainly of hydroxyapatite. For dried precipitate, the bonds in the component materials which used for the precipitate formation were observed by FT-IR, and after thermal treatment the major bonds in the precipitate were shown to be $OH^{-}$, $PO_4^{3-}$ , and $CO_3^{ 2-}$ , which were main comprising bonds of hydroxyapatite.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.2
• /
• pp.165-172
• /
• 2014

Experiments were conducted to identify basic characteristics of $CO_2$ capture using a spray tower with a single nozzle. Results were evaluated in terms of $CO_2$ saturation which is the main determining factor of regeneration energy, and capture efficiency under various operating conditions. Changes in the capture efficiency under various conditions are well expressed as a monotone increasing function of the relative solvent $(NH_3):CO_2$ flow rate. Although changes in $CO_2$ saturation are also well described as a function of the $NH_3/CO_2$ flow rate ratio, these are expressed as a monotone decreasing function, in contrast with the increasing function of $CO_2$ efficiency. In recent research on the relationship between $CO_2$ saturation and capture efficiency, $CO_2$ saturation was found to decrease when capture efficiency increased. In conclusion, the results show that the amount of solvent used for achieving high capture efficiencies is excessive, as is the amount of regeneration energy needed.

• Korean Journal of Soil Science and Fertilizer
• /
• v.25 no.4
• /
• pp.334-341
• /
• 1992

The effects of the various pattern of paddy-upland switching system on rice yield and the nutrient absorption characteristics were examined in the paddy field of Seokcheon silty soil for three years from 1989 to 1991. The obtained results of the two years from 1990 to 1991 are as follows : 1. Rice grain yields were high in the order of potato-cabbage>soybean>continuous paddy plot for the second and third year. Among the rice yield components the numbers of grains per panicle and the rate of ripening grain exerted the yield increase. 2. The contents and absorption amounts of nutrient in harvested straw plant increased with the incease of rice yields during the second and third year(1990~1991). The amounts of all nutrient absorption increased with the increased level of nitrogen fertilization at the third year(1991). 3. The periodical change of leaf green color was responded well with the content of ammonia concentration of soil solution.

• Applied Biological Chemistry
• /
• v.22 no.1
• /
• pp.1-9
• /
• 1979

The physical and chemical properties of ${\gamma}-conglycinin$ of soybean (Glycine max) were investigated. The soybean protein extracted from soybean meal using 0.2M NaCl solution at pH 4.5 was passed through a Sephadex G-150 column to isolate 7S globulin. ${\gamma}$-Conglycinin was isolated and purified from the 7S globulin with a DEAE Sephadex A-50 column chromatography. The protein preparation was pure on immunoelectrophoresis, polyacrylamide gel electrophoresis and gel isoelectric fouling. It had an isoelectric point at pH 5.4 and contained 16.12% nitrogen, 4.18% mannose and 1.21% glucosamine. Amino acid composition, in general, shaved that ${\gamma}-conglycinin$ contained higher contents of lysine, dicarboxylic acids and ammonia nitrogen, and lower contents of sulfur-containing amino acids and tryptophan. The subunits of ${\gamma}-conglycinin$ were distributed in the range of pH 4.6-5.5. The subunits located in the pH region of 4.6-5.0 and 5.0-5.5 were glycopeptides (molecular weight of 38,000) and simple peptide (MW of 32,000), respectively.

• Journal of Animal Science and Technology
• /
• v.58 no.1
• /
• pp.4.1-4.7
• /
• 2016

Background: This study was conducted to evaluate the effects of adding Korean rice wine residue (RWR) in total mixed ration (TMR) on in vitro ruminal fermentation and growth performance of growing Hanwoo steers. Methods: For in vitro fermentation, the experimental treatments were Control (Con: 0 % RWR + TMR), Treatment 1 (T1: 10 % RWR + TMR), and Treatment 2 (T2: 15 % RWR + TMR). The rumen fluid was collected from three Hanwoo steers and mixed with buffer solution, after which buffered rumen fluid was transferred into serum bottles containing 2 g dry matter (DM) of TMR added with or without RWR. The samples were then incubated for 0 h, 12 h, 24 h, or 48 h at $39^{\circ}C$ and 100 rpm. For the in vivo experiment, 27 Hanwoo steers (6 months old) with an average weight of $196{\pm}8.66kg$ were subjected to a 24-week feeding trial. The animals were randomly selected and equally distributed into three groups. After which the body weight, feed intake and blood characteristics of each group were investigated. Results: The pH of the treatments decreased significantly relative to the control during the 12 h of incubation. Total gas production and ammonia nitrogen ($NH_3-N$) was not affected by RWR addition. The total volatile fatty acid (VFA) was lower after 24 h of incubation but at other incubation times, the concentration was not affected by treatments. Feed cost was 8 % and 15 % lower in T1 and T2 compared to control. Blood alcohol was not detected and a significant increase in total weight gain and average daily gain were observed in Hanwoo steers fed with RWR. Conclusion: Overall, the results of this study suggest that TMR amended with 15 % RWR can be used as an alternative feed resource for ruminants to reduce feed cost.

• Journal of Food Hygiene and Safety
• /
• v.18 no.4
• /
• pp.195-201
• /
• 2003

An easily available, simultaneous identification/determination procedure for sildenafil, homosildenafil, tadalafil, vardenafil in adulterated health related foods was established by using a combination of three different analytical methods; thin layer chromatography(TLC), liquied chromatography-mass spectrometry (LC/MS) and high-performance liquied chromatography (HPLC)/photo-diode-array detector. The sample solution for TLC was applied to silica gel 60 $F_{254}$ plates with ethylacetate/acetonitrile/25%ammonia (90:10:5) as a developing solvent. Spots were located under UV radiation at 254 nm and dragendolfs reagent. Mass spectra of the compounds by LC/MS were investigated with electrospray ionization (ESI) interface, under positive ion mode. The HPLC analysis was performed on a column of capcell pack $C_{18}$ (UG120, 4.6${\times}$250mm I.D. 5 ${\mu}$m)with 0.1% sodium 1-hexansulfonate (in 0.1% phosphoric acid)/acetnitrile (73:27) as a mobile phase, and effluent was minitored with a photo-diode-applied to commercial foods, Sildenafil content was inthe range of 0.4mg/g~360.9 mg/g from 7 out of 35 samples. Homosildenafil content was in the range of 2.2 mg/g~336.0 mg/g from 7 out of 35 samples. Tadalafil content was 429.3 mg/g, 9.6 mg/500 mg from 2 out of 35 samples. The procedure described here is available for the screening of sildenafil, homosildenafil, tadalafil, vardenafil.

• Korean Chemical Engineering Research
• /
• v.46 no.2
• /
• pp.356-368
• /
• 2008

The effects of cosurfactant on silica nanoparticles were investigated in systems containing surfactant, oil and aqueous ammonia solution where nanoparticles were prepared using a single phase water-in-oil (W/O) microemulsion. For the same oil phase, a single phase region was dependent on the interaction between surfactant and oil. For the cyclohexane system, NP-5 surfactant showed a wider single phase region than NP-4. The addition of n-propanol as a cosurfactant resulted in an increase or a decrease of a single phase W/O microemulsion region depending on the continuous oil phase. For both cyclohexane and isooctane systems, the addition of n-propanol resulted in a decrease in the single phase region. On the other hand, for n-heptane system, the addition of n-propanol expanded a single phase W/O microemulsion region. Silica nanoparticles prepared within a single phase region showed that relatively large number of particles of irregular shape were obtained with the addition of n-propanol to NP surfactant system. The addition of n-propanol to LA-5 surfactant and n-heptane system produced a decrease in average particle size and an increase in the number of particles formed due to a decrease in the intermicellar exchange rate among microemulsion droplets.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.9
• /
• pp.895-900
• /
• 2012

This paper aims to examine the effect of nanodroplets on pool-type absorption heat transfer enhancement and to find the relationship between the dispersion stability and the absorption performance. The concentrations of oil and surfactant are considered as the key parameters. $C_{12}E_4$ and Tween20 are used as the surfactants and N-decane oil is added to the $NH_3/H_2O$ solution to make the binary nanoemulsion fluids. Binary nanoemulsion fluids are dispersed by the ultrasonic vibrator and the stirrer under specific conditions. The dispersion stability of binary nanoemulsion fluids for each oil concentrations is evaluated from the droplet size and Tyndall effect analysis. The absorption performance of binary nanoemulsion fluids is compared with the result of dispersion stability. In addition, it is found that the binary nanoemulsion fluid is a strong candidate as a new working fluid for absorption applications.

• Korean Journal of Materials Research
• /
• v.20 no.12
• /
• pp.669-675
• /
• 2010

One of the greatest challenges for our society is providing powerful electrochemical energy conversion and storage devices. Rechargeable lithium-ion batteries and fuel cells are among the most promising candidates in terms of energy and power density. As the starting material, $TiCl_4{\cdot}YCl_3$ solution and dispersing agent (HCP) were mixed and synthesized using ammonia as the precipitation agent, in order to prepare the nano size Y doped spherical $TiO_2$ precursor. Then, the $Li_4Ti_5O_{12}$ was synthesized using solid state reaction method through the stoichiometric mixture of Y doped spherical $TiO_2$ precursor and LiOH. The Ti mole increased the concentration of the spherical particle size due to the addition of HPC with a similar particle size distribution in a well in which $Li_4Ti_5O_{12}$ spherical particles could be obtained. The optimal synthesis conditions and the molar ratio of the Ti 0.05 mol reaction at $50^{\circ}C$ for 30 minutes and at $850^{\circ}C$ for 6 hours heat treatment time were optimized. $Li_4Ti_5O_{12}$ was prepared by the above conditions as a working electrode after generating the Coin cell; then, electrochemical properties were evaluated when the voltage range of 1.5V was flat, the initial capacity was 141 mAh/g, and cycle retention rate was 86%; also, redox reactions between 1.5 and 1.7V, which arose from the insertion and deintercalation of 0.005 mole of Y doping is not a case of doping because the C-rate characteristics were significantly better.

• Polymer(Korea)
• /
• v.27 no.5
• /
• pp.470-476
• /
• 2003

In order to obtain high refractive plastic materials, 1,2 -ethylenedisulfanylbis(2-mercaptomethyl-1-ethanthiol) (ESTT) was newly prepared in good yield by the reaction of 1,2-ethylenedisulfanylbis(2-bromomethyl-1-ethanthiol) (ESTB) with thiourea followed by hydrolysis using an aqueous ammonia solution and characterized by $^1$H-NMR (-SH at 1.7 ppm), $\^$13/C-NMR(-CH$_2$SH at 28.4 ppm) and FT-IR (-SH at 2540 cm$\^$-1/) spectroscopy, etc. Polythiourethanes (PTU) were obtained from the combinations of ESTT with each of 4,4＇-methylenebis(phenylisocyanate) (MDI), tolyene 2,4-diisocyanate (TDI), isophorone diisocyanate (IPDI), mxylene diisocyanate (XDI), and 1,6-diisocyanatohexane (HMDI) in the presence of dibutyltin dilaurylate as a catalyst, in a casting mold, and characterized by FT-IR (existence of N=C=O) spectroscopy and elemental analyzer (sulfur content). Accordingly, their thermal, mechanical and optical properties were investigated by using DSC, TGA, hardness tester and refractometer: both the melting point on DSC and crystallinity on X -ray diffraction (XRD) for specimens of PTUs were not observed. PTUs with T$\_$g/s above 110 $^{\circ}C$ showed good hardness (Shore D) in the range of 86 to 89. Thermal stabilities of PTUs obtained by using ESTT and each of diisocyanates containing aromatic rings were especially good. Also, the optical transmittances of amorphous PTUs through UV-visible source in the range of 400 to 600 nm were good. PTUs showed refractive indexes above 1.60, and their refractive indexes gradually increased with increase of sulfur contents.