• Membrane Journal
• /
• v.33 no.6
• /
• pp.369-376
• /
• 2023

In this study, the alternative to the energy-intensive conventional vacuum distillation process, an eco-friendly and energy-efficient pervaporation separation was employed in 1,2 hexane diol/water (HDO/water) mixture. The crosslinked PVA-glutaraldehyde was coated inside the alumina hollow fiber membrane (Al-HF). In the HDO/IPA pervaporation separation, optimization of the membrane concerning PVA/GA ratio, curing temperature, and pervaporation operating condition were performed. In the long-term stability test, the sustainable pervaporation separation performance giving flux in the range of 1.90~2.16 kg/m²h, and water content in permeate was higher than 99.5% (separation factor = 68) was obtained from the PVA/GA (molar ratio = 0.08, curing temperature = 80℃) coated Al-HF membrane from HDO/water (25/75, w/w, %) mixture at 40℃. Therefore, this work provides potential and inspiration for PVA-based membranes to mitigate excessive energy requirements in HDO/water separation by pervaporation.

• Applied Chemistry for Engineering
• /
• v.34 no.6
• /
• pp.649-659
• /
• 2023

This study was initiated to evaluate the phosphorus (P) removal and diesel oil degradation by bacteria isolated from industrial wastewater. The bacteria isolated were identified as Bacillus sp. The P removal efficiencies by Bacillus sp. were 99% at the initial 20 mg/L P concentration. The diesel degradation efficiencies by Bacillus sp. were 86.4% at an initial 1% diesel concentration. Lipophilicity by bacteria was the highest in the log phase, whereas it was the lowest in the death phase. As the diesel was used as a carbon source, P removal efficiencies by Bacillus sp. were 68%. When glucose, acetate, and a mixture of glucose and acetate as second carbon sources were added, the diesel degradation efficiencies were 69.22%, 65.46%, and 51.46%, respectively. The diesel degradation efficiency was higher in the individual additions of glucose or acetate than in the mixture of glucose and acetate. When P concentration increased from 20 mg/L to 30 mg/L, the diesel degradation efficiency was increased by 7% from 65% to 72%, whereas when P concentration was increased from 30 mg/L to 40 mg/L, there was no increase in diesel degradation. One of the five proteins identified by proteome analysis in the 0.5% diesel-treated samples may be involved in alkane degradation and is known as the cytochrome P450 system. Also, two of the sixteen proteins identified in the 1.5% diesel-treated samples may be implicated in the fatty acid transport system and alcohol dehydrogenation.

• Journal of the Microelectronics and Packaging Society
• /
• v.23 no.1
• /
• pp.11-15
• /
• 2016

The organic light emitting diodes (OLEDs) have been studied as large flexible displays, light source and hard wares of internet of things. However, OLEDs show some drawbacks in terms of external environments due to the low work function of the metals and the reactive organic materials. In particular, the operation functions of the OLEDs tend to deteriorate rapidly by exposing the oxygen and moisture. So as to prevent it, domestic and overseas studies underway in various method such as ALD, PVD, CVD. But it has complex process and high cost. Therefore In order to protect devices from the external environments, it is important to develop the passivation thin films of low-cost and simple process which can prevent the devices from the penetration of the oxygen and moistures. In this study, to improve the reliability, passivation thin films were coated onto the green OLEDs by spin coating method and investigated the changes of the optical properties of the prepared devices at various doping concentrations of sodium alginate (SA). The passivation solutions were synthesized by using polyvinyl alcohol (PVA) host material with a dopant of SA which were added with the amounts of 10, 20 and 40 wt% into the PVA. As a result, the best barrier properties of the OLEDs were obtained for the samples with 40 wt% SA. Finally, the passivation films can be optimized by using the mixture solution of PVA and SA materials.

• Journal of Sericultural and Entomological Science
• /
• v.27 no.1
• /
• pp.24-30
• /
• 1985

The effect of some organic solvents on interrupting diapause of Bombyx mori eggs was examined to provide a clue to the mechanism of diapause initiation. Methyl alcohol and benzene proved to be efficient in developing the prospective diapause eggs upto the stage of hatching or body pigmentation of the embryos. On the other hand, most of the eggs soaked in chloroform and mixture solution of chloroform-methyl alcohol (2:1) died in the early embryonic developmental stage with yellow or red brown colours, and the egg weights decreased upto ca. 40% of the original weight 8 days after the treatments. Methyl alcohol treatment for 2, 5 and 10 min to the 5hr-old-eggs led to empergence of the larvae, with high incidence (70∼80%) in the race of Kumchu X Chonghwa and with low indidence (1∼4%) in Daezo. The effect of same treatment to 20hr old eggs decreased to ca. 10% in the emergence of larvae in Kumchn X Chonghwa and increased to 20∼30% in Daezo, while the effect disappeared shortly after the diapause initiation (48hr-old-eggs). Considering the high dependency upon the egg age of the sensitivity to solvents, it was supposed that initiation and termination of diapause may be controlled by different mechanism. It was also suspected that the solvents exert their effect on the permeability of the eggshell.

• Membrane Journal
• /
• v.17 no.1
• /
• pp.61-66
• /
• 2007

A zeolite membrane shows better thermal, mechanical and chemical stabilities than a polymer membrane. Water was separated from iso-propyl alcohol (IPA)/water mixtures by pervaporation using the NaY zeolite membrane synthesized in the laboratory. The effects of a mole fraction of IPA in the feed solution and an operating temperature were studied on the permeation flux behavior and the separation factor of water with respect to IPA. As a mole fraction of IPA increased, the water flux as well as the separation factor decreased. As the experimental temperature increased, the water permeation flux increased while the separation factor decreased. For IPA/water binary mixtures, the water flukes through the NaY zeolite membrane were observed to be $1.9{\times}10^2{\sim}3.5{\times}10^3\;g/m^2{\cdot}hr$ and the separation factors were found to be $7.0{\times}10^2{\sim}2.0{\times}10^4$.

• Journal of Korea Soil Environment Society
• /
• v.1 no.1
• /
• pp.67-79
• /
• 1996

Clay soils typically have low hydraulic conductivities in the presence of high polarity pore fluid, such as water. Low polarity fluids, such as hydrocarbon fuels and halogenated organic solvents, typically cannot migrate into clay pores because they cannot displace the pore water. Oxygenated additives in gasoline, such as alcohols and methyl-tert-butyl ether, are increasingly used to control air pollution emissions. These relatively polar and highly water-soluble compounds may facilitate displacement of pore water and enhance migration of fuels and solvents through clay-rich soil strata. In the reported research, the migration of gasoline-alcohol fuel mixtures (gasohol) through consolidated clay was examined. Prepared kaolinite clay samples were consolidated from slurry, and various combinations of gasoline, alcohol, and water were applied to the clays under 152 Pa gauge pressure. Movement of the fluids into the clay samples was monitored by measur ing displaced pore fluid and by magnetic resonance imaging of the samples. The structures of selected samples were examined using environmental scanning electron microscopy. Results of the research suggest that alcohol added to hydrocarbon fuels can enhance migration through some clays significantly. Gasoline did not migrate appreciably into water saturated clay, even after 14 days under pressure. The gasohol mixture migrated readily into the clay in only 20 minutes. Increased hydraulic conductivity of the clay in the presence of gasohol is hypothesized to be due to the collapse of the clays pore structure when ethanol is present, creating larger pores. Increasing pore diameter decreases the capillary pressure needed for the gasohol to replace water and allows gasohol to migrate through the clay.

• Polymer(Korea)
• /
• v.28 no.2
• /
• pp.135-142
• /
• 2004

Poly(vinyl acetate) (PVAc) prepared by emulsion polymerization has broad applications for additives such as paint binder, adhesive for wood and paper due to its low glass transition temperature which help to plasticize substrate resins. Since emulsion polymerization has a disadvantage that surfactant and ionic initiator degrade properties of the product polymer, poly(vinyl acetate-co-butyl acrylate) (VVc-BA) was synthesized using potassium persulfate as catalyst and poly(vinyl alcohol) (PVA) as protective colloid to prevent the degradation. The copolymer latex product was internally plasticized and has enhanced colloid stability, adhesion, tensile strength and elongation. During VAc-BA emulsion polymerization, no coagulation and complete conversion occur with the reactant mixture of 0.7wt% potassium persulfate, 15wt% poly(vinyl alcohol) (PVA-217), and the balanced monomer that the weight ratio of vinyl acetate to butyl acrylate is 19. As the concentrations of PVA increase, the copolymerization becomes faster and polymer particles are more stable, resulting in enhanced mechanical stability of the VAc-BA copolymer. However, the size of the polymer particles decreases with increasing PVA contents. Properties of the VAc-BA copolymer, such as minimum film formation temperature, glass transition temperature, surface morphology, molecular weight and molecular weight distribution, tensile strength and elongation, were characterized using differential scanning calorimeter, transmission electron microscope and other instruments.

• Korean Journal of Food Science and Technology
• /
• v.4 no.4
• /
• pp.252-258
• /
• 1972

Methods of separating yeast cells from oil-water-cell emulsion and subsequent purification of the recovered yeast have been studied. In addition, the results of preliminary feeding experiments in which a yeast grown on gas oil was incorporated into chick rations are reported. According to the present study, it appears that the recovery of the yeasts would be easier at pH 9, since the emulsion is relatively more unstable. A class of surface active agent at a concentration of 0.3% was found to facilitate the separation of the yeast from the emulsion. The use of electrolytes such as NaCl and KCl were found to be most effective in breaking the emulsion. Solvent treatment using iso-propyl alcohol and its azeotropic mixture with hexane at $58^{\circ}C$ are particularly suitable for purification of the yeast. In the feeding experiment it was found that 5 percent of the fishmeal in the control ration could be replaced by the yeast with no adverse effect on performance. However, when 8 percent of the fish meal in the control ration was replaced by the yeast, some effect on live-weight gain of the chicks was observed.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.3
• /
• pp.286-291
• /
• 2006

We studied possibility of mixing treatment of livestock wastewater and sewage using Phanerochaete chrysosporium PSBL-1. Our study showed that 97.6% of SS and 95% of T-P removal efficiency was achieved when 2 mL BF02(a coagulant) and 100 mL C-210EL(a cationic polymer) were added to the mixture(2:1, v/v) of livestock wastewater and sewage. We studied treatment characteristic of Phanerochaete chrysosporium PSBL-1, after were mixed pretreated wastewater and sewage by dillution ten times about livestock wastewater. The removal efficiency of NBDCOD(non-biodegradable COD), $NH_3-N$ and T-N was increased according to increase of pH. That is, T-N concentration of effluent was satisfied 60 mg/L by drain water waterqulity standard of livestock wastewater public treatment facilities with 35 mg/L from a lapse of five days at pH 6.7, 51 mg/L from a lapse of three days at pH 8 and 33 mg/L from a lapse of one day at pH 10. Moreover $COD_{Mn}$ concentration of effluent was satisfied 40 mg/L by drain water waterqulity standard of livestock wastewater public treatment facilities after a laps of one day at all pH. Organics and nitrogen concentrations of effluent were higher case with addition of V.A.(veratryl alcohol) than case without addition of V.A.(veratryl alcohol). $COD_{Mn}$ concentration of effluent satisfied drain water qulity standard of livestock wastewater public treatment facilities from a lapse of one day, when C/N rate(3:1) of influent was not controled. T-N satisfied that from a lapse of two days, when C/N rate was controled with $4{\sim}6$.

• The Korean Journal of Mycology
• /
• v.41 no.3
• /
• pp.167-171
• /
• 2013

The goal of this study was to screen a useful alcohol fermentative yeast for Gugija leaf makgeolli (Gl makgeolli) brewing and establish its optimal fermentation condition. Gugija leaves with various alcohol fermentative yeasts were added into the mixture of cooked non-glutinous rice and koji, and then fermented at $25^{\circ}C$ for 7 days. Among several Gl makgeolli, ethanol contents was the highest in Gl makgeolli made by S. cerevisiae F-1. Therefore, we selected S. cerevisiae F-1 as suitable yeast for brewing of Gl makgeolli. Gl makgelli with the best total acceptability and high antihypertensive action was obtained when cooked non-glutinous rice (120 g), boiled D.W (100 mL) and JJ koji (60.5 g/300 sp) were mixed and fermented for 2 days at $30^{\circ}C$ with S. cerevisiae F-1 (5%), and added again cooked non-glutinous rice (150 g), glutinous rice (100 g), D.W (500 mL) and Gugija leave (0.1%/cooked rice) and further fermented for 5 days at $25^{\circ}C$.