• 한국지능시스템학회:학술대회논문집
• /
• 한국퍼지및지능시스템학회 2004년도 추계학술대회 학술발표 논문집 제14권 제2호
• /
• pp.494-497
• /
• 2004

서로 다른 프로그램 언어로 작성된 소프트웨어 애플리케이션간의 통신을 가능하게 하는 ActiveX를 통하여 프로그램 개발자들은 코드의 재사용성, 소프트웨어의 통합측면에 있어서 이루 말할 수 없는 효과를 얻고 있다. ActiveX는 COM 기반의 분산 애플리케이션. 모델이 발전된 형태에 해당하는데 그동안 Visual C++, Visual Basic를 통하여 통신 애플리케이션에 이를 구현하는 것이 일반적이었다. 하지만 ActiveX 기술은 이러한 애플리케이션뿐만 아니라 제어 및 계측 분야에서도 널리 활용되고 있는데 이는 ActiveX 기술로 구현된 프로그램을 통하여 보다 신속하고 효율적인 작업 수행이 가능하기 때문이라 할 수 있다. 본 논문에서는 이러한 ActiveX 기술을 활용하여 원격.제어 및 모니터링 기능을 수행하는 애플리케이션을 구현하고자 한다. 이를 위한 개발 환경으로 LabVIEW를 활용하고자 하며 웹브라우져와 미디어 플레이어를 ActiveX 기술로 구현하여 애플리케이션 간 통신의 효율성을 검증하고자 한다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2009년도 춘계학술대회 논문집
• /
• pp.639-644
• /
• 2009

This research is concerned with the application of the active linear actuator to the active vibration control of structure. The active linear actuator will be mounted on the sub-frame so that it can cancel the excitation transferred from the engine. Accelerometer mounted on the sub-frame detects the vibration and its signal is fed into the DSP controller where the control algorithm is installed. The output of the DSP controller is connected to the driver which amplifies the DSP output. In general, the pulse width modulation power amplifier is used to drive the voice-coil type actuator. This study shows the dynamic characteristics of the active linear actuator and active vibration control experimental results.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2003년도 종합학술발표회 논문집 Vol.13 No.1
• /
• pp.638-648
• /
• 2003

An active capacitance circuit is analyzed in depth and its application to active RF BPF with low noise figure is discussed. The characteristics of the active capacitance circuit made of FET[1] exhibits negative resistance and conventional capacitance, which is easily controlled. However, it is difficult to make the negative resistance adequate in the designated frequency range due to the lack of detailed analysis, which could make an active circuit unstable as the frequency is going higher or lower. In this paper, we analyzed the negative resistance characteristics of active capacitance circuits and also presented the method that the flatness of passband can be controlled. Finally we have designed a 4-stage active BPE, which results in bandwidth of 100 MHz, 0,04 dB insertion loss, 0.2 dB ripple, and noise figure of 2.4 dB at 1.75 GHz band.

• 한국멀티미디어학회논문지
• /
• 제16권9호
• /
• pp.1018-1030
• /
• 2013

The corpus callosum is the largest connective structure in the brain, and its shape and size are correlated to sex, age, brain growth and degeneration, handedness, musical ability, and neurological diseases. Manually segmenting the corpus callosum from brain magnetic resonance (MR) image is time consuming, error prone, and operator dependent. In this paper, two semi-automatic segmentation methods are present: the active contour model-based approach and the active shape model-based approach. We tested these methods on an MR image of the human brain and found that the active contour approach had better segmentation accuracy but was slower than the active shape approach.

• 한국멀티미디어학회논문지
• /
• 제7권1호
• /
• pp.113-125
• /
• 2004

능동 네트워크는 능동 네트워크 애플리케이션의 통신 중 요구사항의 처리를 할 수 있게 하는 소프트웨어 프레임 워크를 제공한다. 능동보안을 위한 컴포넌트 아키텍쳐는 관련 컴포넌트들의 조합으로 재사용 시스템을 쉽게 구축할 수 있다. 이 아키텍쳐는 컴포넌트를 획득하고, 이해하며 조립하기 위한 표준 계층으로서 컴포넌트 식별, 탐색과 조정을 위한 지침을 제공해야 한다. 본 논문에서는 최근 연구되어지고 있는 능동네트워크의 보안에 대한 부분을 관리하기 위한 능동보안 컴포넌트 개발을 위한 아키텍쳐 설계 및 도메인 분석을 하였으며, 능동보안 도메인 아키텍쳐를 이용한 컴포넌트 개발을 위한 설계명세에 대하여 연구하였다.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2005년도 전기학술대회논문집
• /
• pp.406-411
• /
• 2005

In this paper, we propose an active 90$^{\circ}$ phase divider for application to MMIC. Because of their very large size, conventional passive 90$^{\circ}$ dividers can't be integrated on MMIC. Therefore, highly miniaturized 90$^{\circ}$ dividers are required for a development of highly integrated MMIC. For this reason, active 90$^{\circ}$ divider is indispensable because active phase divider is much smaller than conventional passive dividers, and it can be integrated on MMIC. In this work, we developed active 90$^{\circ}$ divider with emitter inductor, and it was employed for the operation of the balanced mixer in order to verify the performance of the active 90$^{\circ}$ divider. According to the results, it was found that the active 90$^{\circ}$ divider exhibited good RF performances comparable to conventional passive power dividers.

• Journal of Power Electronics
• /
• 제18권3호
• /
• pp.871-878
• /
• 2018

In this paper, the conducted EMI reduction performances of active feed-forward current-sensing current-actuation (CSCA) and voltage-sensing current-actuation (VSCA) filters for a three-phase induction motor drive system are evaluated by experiments. For comparison purposes, the conducted EMI (CM emission, DM emission and total emission) of a three-phase induction motor drive with a conventional CM choke, a conventional CM choke in series with an active VSCA filter, and an active CSCA filter (where the CM choke was modified and used as a sensing current transformer) were compared to the case of a system without any filter inserted. Experimental results show that the active CSCA and VSCA filters can improve the CM reduction performance of the conventional CM choke by about 5 dB especially at low-frequencies. However, for DM comparisons, it shows that there is no different between cases with and without filters inserted.

• 대한기계학회논문집
• /
• 제18권5호
• /
• pp.1169-1181
• /
• 1994

Vibration isolation of mechanical systems, in general, is achieved through passive or active vibration isolators. Passive vibration isolator has an inherenrt performance limitation. Whereas, active vibration isolator provides significantly superior vibration-isolation performance at the cost of energy sources and sensors. Recently, in many cases, such as suspension system, precision machinery ... etc, active isolation system outweighs its limitation. Therefore, many studies, researches, and applications are carried out in this field. In this study, vibration-isolation characteristics of an active vibration control system using electromagnetic force actuator are investigated. Several control algorithms including optimal, feedforward are used for active vibration isolation. From the experimental results of each algorithm, effective control algorithms for this active vibration-isolation system are proposed.

• Smart Structures and Systems
• /
• 제16권1호
• /
• pp.27-46
• /
• 2015

Active surface adjustment of cable net structures is becoming significant when large-size cable net structures are widely applied in various fields, especially in satellite antennas. A general-duty adjustment method based on active cables is proposed to achieve active surface adjustment or surface profile reconfiguration of cable net structures. Piezoelectric actuators and voice coil actuators are selected for constructing active cable structures and their simplified mechanical models are proposed. A bilevel optimization model of active surface adjustment is proposed based on the nonlinear static model established by the direct stiffness method. A pattern search algorithm combined with the trust region method is developed to solve this optimization problem. Numerical examples of a parabolic cable net reflector are analyzed and different distribution types of active cables are compared.

• Journal of Power Electronics
• /
• 제19권5호
• /
• pp.1289-1302
• /
• 2019

In this paper, an optimal allocation method of a hybrid active power filter in an active distribution network is designed based on the differential evolution algorithm to resolve the harmonic generation problem when a distributed generation system is connected to the grid. A distributed generation system model in the calculation of power flow is established. An improved back/forward sweep algorithm and a decoupling algorithm are proposed for fundamental power flow and harmonic power flow. On this basis, a multi-objective optimization allocation model of the location and capacity of a hybrid filter in an active distribution network is built, and an optimal allocation scheme of the hybrid active power filter based on the differential evolution algorithm is proposed. To verify the effect of the harmonic suppression of the designed scheme, simulation analysis in an IEEE-33 nodes model and an experimental analysis on a test platform of a microgrid are adopted.