• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.14 no.1
• /
• pp.10-15
• /
• 2003

Background and Objectives : Ankyloglossia, commonly known as tongue-tie, is the result of a short, fibrous lingual frenulum or highly attached geioglossus muscle. This condition may cause sucking and swallowing problems, articulation disorders, interference with the tongue's cleansing action, increased the potential for caries, and inability to lick the lips, play a wind instrument, and 'french kiss' Treatment is surgical procedure. In the most cases, horizontal sectioning and mucosal suture(the conventional procedure) is preferred, but in some cases, the Z-plastic procedure is effective. This study is aimed to compare the result of the two procedures. Materials and Methods : Twenty tongue-tie patients underwent operation. Ten patients were treated with the Z-plastic procedure and ten patients were treated with the conventional method randomly. We checked preoperative mobile tongue length, postoperative mobile tongue length, operation time and postoperative wound states. Results : Among the 20 cases of tongue-tie, 2 cases are excepted due to pre-operative state, thus we compared 18 cases of tongue-tie patients. There is no statistically significant difference between the two procedures except in operation time. The Z-plastic procedure apparently needs a little more operating time. Conclusion : Patients treated with the Z-plastic procedures appeared to have better outcomes, but the data shows no statistical significance except in operating time. Consequently, the Z-plastic procedure is indicated in a limited amount of cases.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.51 no.1
• /
• pp.86-93
• /
• 2015

Anchovy (Engraulis japonicus) is one of the most important species in the South Sea of South Korea. In order to estimate the biomass of anchovy, acoustic surveys, concurrently with trawling, were conducted in April, July, and September of 2013 and February of 2014 off the coast of Tongyeong and Yeosu. However, anchovies were found only during spring (April) and winter (February) surveys. To display only anchovy species confirmed by trawls on empty spaced echograms, virtual echograms were created. Three target strength (TS) values of anchovy were used: TS_z = 20 log L - (20/3) log (1+z/10) - 67.6 (Zhao et al.), TS_y =20 log L - 72.9 (Yoon et al.), TS_f = 20 log L - 71.9 (Foote). For anchovy schools combined with other species e.g., hairtail, squid, and Korean pomfret, their TS values were used to calculate an average TS. As a result, the anchovy biomass in the winter survey was approximately 75,000 tons (TS_z), 90,000 tons (TS_f), 114,000 tons (TS_y), respectively. The biomass in spring was 9,000 tons (TS_z), 9,200 tons (TS_f), 10,000 tons (TS_y). The sampling variance of spring was 70% and of winter was 30%. In order to manage anchovy resource sustainably, larvae and adult anchovy should be separately surveyed, the optimal area, date, and time for acoustic survey should be investigated, and the biomass survey should be done for relatively long and regular base.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.7
• /
• pp.2004-2008
• /
• 2014

This paper reports the facile synthesis methods of zinc oxide (ZnO) nanoparticles, Z1-Z10, using diethylene glycol (DEG) and polyethylene glycol (PEG400). The particle size and morphology were correlated with the PEG concentration and reaction time. With 0.75 mL of PEG400 in 150 mL of DEG and a 20 h reaction time, the ZnO nanoparticles began to disperse from a collective spherical grain shape. The ZnO nanoparticles were characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy and a $N_2$ adsorption-desorption studies. The Brunauer-Emmett-Teller (BET) surface areas of Z4, Z5 and Z10 were 157.083, 141.559 and 233.249 $m^2/g$, respectively. The observed pore diameters of Z4, Z5 and Z10 were 63.4, 42.0 and 134.0 ${\AA}$, respectively. The pore volumes of Z4, Z5 and Z10 were 0.249, 0.148 and 0.781 $cm^3/g$, respectively. The photocatalytic activity of the synthesized ZnO nanoparticles was evaluated by methylene blue (MB) degradation, and the activity showed a good correlation with the $N_2$ adsorption-desorption data.

• Progress in Superconductivity and Cryogenics
• /
• v.20 no.3
• /
• pp.1-4
• /
• 2018

The effect of sulfate substitution on the formation of (Pb,S)-1201 type phase was investigated. Polycrystalline samples with nominal compositions of $(Pb_{0.5}B_{0.5-x}S_x)(Sr_{2-y}La_y)CuO_z$, (x = 0 - 0.5, y = 0.7 - 1.0) and $(Pb_{0.5}S_{0.5})(Sr_{2-y}La_y)CuO_z$ (y = 0.5 - 1.0) were prepared by using a solid-state reaction method. The samples were characterized by powder X-ray diffraction (XRD) and resistivity measurements. XRD data revealed that almost-single (Pb,S)-1201 phase samples could be obtained for x = 0.5 and y = 0.9-1.0, judging from the similar results of the XRD patterns between the (Pb,S)-1201 and (Pb,B)-1201 phases. Each of the samples has a crystal structure with tetragonal symmetry. The sample with x = 0.5 and y = 0.9 is found to show an onset of resistivity dropping at over 23 K and zero resistivity at 12 K.

• Journal of Astronomy and Space Sciences
• /
• v.30 no.1
• /
• pp.59-67
• /
• 2013

We present a spectroscopic study of 343 blue compact galaxies (BCGs) at 0.20 < z < 0.35 from the Sloan Digital Sky Survey (SDSS) DR7 data. We derive gas phase oxygen abundance using the empirical and direct method. Stellar masses of galaxies are derived from the STARLIGHT code. We also derive star formation rates of galaxies based on $H{\alpha}$ emission line from the SDSS as well as far-ultraviolet (FUV) flux from the Galaxy Evolution Explorer GR6 data. Evolution of the luminosity-metallicity and mass-metallicity (M-Z) relations with redshift is observed. At a given luminosity and mass, galaxies at higher redshifts appear to be biased to low metallicities relative to the lower redshift counterparts. Furthermore, low mass galaxies show higher specific star formation rates (SSFRs) than more massive ones and galaxies at higher redshifts are biased to higher SSFRs compared to the lower redshift sample. By visual inspection of the SDSS images, we classify galaxy morphology into disturbed or undisturbed. In the M-Z relation, we find a hint that morphologically disturbed BCGs appear to exhibit low metallicities and high SSFRs compared to undisturbed counterparts. We suggest that our results support downsizing galaxy formation scenario and star formation histories of BCGs are closely related with their morphologies.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.2
• /
• pp.199-208
• /
• 2012

This paper proposes a quasi Z-source DVR(Dynamic Voltage Restorer) system with a series connection of the output terminals, to compensate the voltage variations in the 6.6[kV]/60[Hz] power distribution system. The conventional DVR using one quasi Z-source AC-AC converter has the advantage which it can compensate the voltage variations without the need for the additional energy storage device such as a battery, but it is impossible to compensate for the 50[%] under voltage sags. To solve this problem, a DVR system using two quasi Z-source AC-AC converters with the series connection of the output terminals is proposed. By controlling the duty ratio D in the buck-boost mode, the proposed system can control the compensation voltage. For case verification of the proposed system, PSIM simulation is achieved. As a result, in case that the voltage sags-swells occur 10[%], 20[%], 60[%] in power distribution system, and, in case that the 50[%] under voltage sags-swells continuously occur, all case could compensate by the proposed system. Especially, the compensated voltage THD was examined under the condition of the 10[%]~50[%] voltage sags and the 20[${\Omega}$]~100[${\Omega}$] load changes. The compensated voltage THD was worse for the higher load resistances and more severe voltage sags. Finally, In case of the voltage swells compensation, the compensation factor has approached nearly 1 regardless of the load resistance changes, while the compensation factor of voltage sags was related to the load variations.

• Journal of Digital Convergence
• /
• v.11 no.12
• /
• pp.551-556
• /
• 2013

The Forearm and the lumbar spine bone mineral density bone mineral density values obtained through, T-score and Z-score correlation between numerical and calibration function obtained as a result of any one part to another part of the results is intended to infer. Groups of 66 patients, 11 patients by age 20-70 were composed of patients measured with the forearm and lumbar spine bone mineral density T-score and Z-score of the survey for each of the three factors that correlated to assess the correlation Find the correction factor to obtain the relationship. Bone mineral density of the correlation coefficient R = 0.769 correction factor is Y = 1.541X + 0.133. T-score of correlation coefficient R = 0.768 and the correction factor Y = 0.715X - 0.4 is Z-score of the correlation coefficient R = 0.635 correction factor Y = 0.751X - 0.162. It is regarded that there will be a clinical availability which can analogize the result of a part by using the result of the other part.

• Korean Journal of Crystallography
• /
• v.5 no.2
• /
• pp.108-112
• /
• 1994

C19H20O5, Mr=314.337, triclinic,PI, a=10.291(2)A, b=11.218(3)A, c=3.059(1)A, α=74.54(2)°, β=1148.84(1)°, r=109.84(2)°, V=883.283(2)A3, λ(Mo Kα)=0.71069A, μ=0.47 mm-1, F(000)=324, 296K, Z=2, Dx=1.18Mgm-3. Final R=0.0580 for 1637[F>3σ(F)]unique refledtions. α,β-diphenylsuccinic acid, C16H14O4, are connedted with the solvent actone by hydrogen bond O(4)-H˙˙˙O(5), forming a dimer related by related by centrosymmentry thorough intermolecualr carboxylic hydrogen bond O(1)-H˙˙˙O(2)(-x,-y,-z). The nearest distance 3.288A[O(2)˙˙˙O(2)(-x,-y,-z)] between the dimers shows that the packing of the dimer is govermed by van der Waals'force.

• ALGAE
• /
• v.20 no.4
• /
• pp.379-388
• /
• 2005

Seagrass bed is an important component in coastal and estuarine ecosystems, providing food and shelter to a wide variety of fauna. Recently, seagrass coverage has declined significantly due to anthropogenic influences such as reclamation, dredging, and eutrophication and consequently, necessity of seagrass habitat restoration is rising. Transplantation experiments with Zostera marina using TERFS, staple method, and shell method have been conducted at Dadae Bay, Kosung Bay and Jindong Bay on the south coast of Korea to select an optimal transplanting method for restoration of Z. marina habitat. Three experimental sites located at the vicinity of natural Z. marina beds with an average water depth of about 4m. Z. marina plants, which were collected from donor bed in Koje Bay were also transplanted at 7 different time from October 2003 to July 2004 to find appropriate transplanting time. Density of Z. marina was monitored monthly at both transplanted areas and natural beds. Transplantation using the staple method showed the highest survival rate of transplant. Shell method was also an effective transplanting method at muddy areas in Kosung Bay and Jindong Bay, but not suitable at sandy areas in Dadae Bay. These results suggest that sediment composition of transplanting areas should be considered for the selection of the optimal transplanting method. Z. marina transplanted during fall usually showed the highest survival rate, while most Z. marina plants transplanted in summer died due to high lethal temperature during this period.

• Journal of Technologic Dentistry
• /
• v.35 no.2
• /
• pp.137-142
• /
• 2013

Purpose: This study was to observe the surface and interfacial characteristic of Zirconia by surface treatment. And it was observed the roughness and contact angle according to processing, and the interfacial properties by surface treatment on zirconia. Methods: The oxide formation and ion diffusion between core and veneer ceramic were determined by the X-ray Dot Mapping of EPMA(Electron probe micro analyzer). The roughness was measured by 3D Digital microscope and the contact angle according to processing of zirconia was observed using distilled water on the surface. Results: The surface roughness of the specimens Z04, Z12, Z15 was measured $0.67({\pm}0.03){\mu}m$, $0.50({\pm}0.12){\mu}m$, $0.35({\pm}0.09){\mu}m$, respectively. As results of contact angle test, Z04, Z12, Z15 of specimen group without binder treatment was measured $46.79({\pm}3.17)^{\circ}$, $57.47({\pm}4.83)^{\circ}$, $56.19({\pm}2.66)^{\circ}$, respectively. but, L04, L12, L15 of specimen group without binder treatment was measured $63.84({\pm}2.20)^{\circ}$, $66.08({\pm}0.16)^{\circ}$, $65.10({\pm}1.01)^{\circ}$, respectively. Average contact angle of L15 was measured $65.10({\pm}1.01)^{\circ}$. In X-ray Dot Mapping results, thickness of binder including Al element was measured that each of L04, L12, L15 were $20{\mu}m$, $15{\mu}m$, $10{\mu}m$. Conclusion: The more rough surface increases the wettability, but the sintered exclusive binder decreases the wettability.