• Journal of the Korean institute of surface engineering
• /
• v.29 no.5
• /
• pp.563-569
• /
• 1996

Degradation of $Zn_3N_2$ films is studied by using several analytical techniques. Polycrystalline $Zn_3N_2$ films prepared by reactie rf magnetron sputtering are kept in the air. Electrical and optical properties are measured by using van der Pauw technique and double-beam spectrometry. Structure and chemical bonding states are studied by X-ray diffraction(XRD), Fourier transfer infrared ray spectroscopy(FT-IR) and X-ray photoelectron specroscopy (XPS). Significant differences are observed in optical properties between the degraded film and the ZnO film. XRD analysis reveals that the degraded film contains very small ZnO grains because very weak and broad ZnO peaks are observed. XPS and FT-IR measurements reveal the formation of $Zn(OH)_2$ in the degraded film. The existence of N-H bonds in degraded films is exhibited from the N 1s spectra. $Zn_3N_2$ change into the mixture of ZnO, $Zn(OH)_2$ and an ammonium salt.

• Journal of the Korean Applied Science and Technology
• /
• v.29 no.1
• /
• pp.149-158
• /
• 2012

Magnesium hydroxide[$Mg(OH)_2$] was prepared by hydrothermal method using oleic acid as surface modifier. $Mg(OH)_2$ particles exhibit flake morphology with micrometer in size and the surface modification starts from the reaction of $C_{17}H_{33}COO^-$ group, derived from oleic acid molecule in alkaline environments. It is found that hydrothermal treatment conditions such as pH, temperature and reaction time are important for the control of the morphology and properties of surface modified magnesium hydroxide. The obtained magnesium hydroxide groups were characterized by FE-SEM, XRD, FT-IR, TGA. The dispersion in organic solution was determined by sedimentation test and compared with the result of raw $Mg(OH)_2$.

• Analytical Science and Technology
• /
• v.10 no.1
• /
• pp.18-30
• /
• 1997

Na, TPA-ZSM-5 with Si / Al mole ratio of about 130 was synthesized at low temperature and atmospheric pressure. These intermediate products were characterized by using XRD, XRF, FT-IR, NMR, and SEM. As a result, intermediate product were different from those that synthesized by autoclave method but spectroscopic characteristics of the final products showed to be in the typical ZSM-5 region. The defect sites were observed in the final product and removed by calcination at $540^{\circ}C$. Na, TPA-ZSM-5, aboveall, was synthesized at this condition within 48hr.

• Elastomers and Composites
• /
• v.49 no.1
• /
• pp.66-72
• /
• 2014

Carbon coating on silica particles is done by grafting expanded graphite on the silica aggregates. Successful coating of carbon is corroborated using FT-IR, TGA, XPS and TEM. Crystalline nature of coated graphite is corroborated using XRD. Influence of carbon coated silica particles on rheometric and mechanical properties of SBR composites are investigated. Carbon coated silica particles showed significant improvement in rheometric and mechanical properties, when compared to pristine silica filled system corroborating higher polymer-filler adhesion. This fact was further supported by bound rubber content and equilibrium swelling ratios of unvulcanized and vulcanized SBR composites.

• Applied Chemistry for Engineering
• /
• v.18 no.2
• /
• pp.111-115
• /
• 2007

Bimodally porous ${\gamma}$-alumina granules, including mesopores (2~50 nm) and macropores (>50 nm), were prepared by sol-gel and oil-drop method. Mesopores are made from the voids among the alumina crystallites, while macropores are from the space of the decomposed PS particles used as physical templates during the granulation process. The product ${\gamma}$-alumina granules with the average diameter of 2 mm were characterized by FE-SEM, XRD, FT-IR, $N_2$ porosimetry, and universal mechanical testing system.

• Korean Chemical Engineering Research
• /
• v.43 no.1
• /
• pp.71-75
• /
• 2005

$La_{0.5}Ca_{0.5}MnO_3$ colossal magnetoresistance (CMR) powders and pellets were synthesized by sol-gel process. The structural changes were investigated by FT-IR, CP/MAS $^{13}C$ solid state NMR spectroscopy and XRD. The particle characterization, microstructure of sintered samples, and cation composition of gel powders were studied by FE-SEM/EDS, TEM and ICP-AES. The structure refinement reveals that $La_{0.5}Ca_{0.5}MnO_3$ has orthorhombic, perovskite type unit cell. The magnetic characterizations were identified through measurement of magnetic moment by VSM.

• Korean Chemical Engineering Research
• /
• v.46 no.6
• /
• pp.1107-1112
• /
• 2008

Crystallization of calcium carbonate was performed by using aqueous calcium chloride and sodium carbonate for operational simplicity. Reaction time, solute concentrations, pH, and organic additive were varied to get calcium carbonate crystals. Silk fibroin was used as the additive to understand the change of morphology of calcium carbonate crystal. The crystals were analyzed by FE-SEM, XRD, and FT-IR. Reaction time, and pH mainly affected the morphology of crystals. Besides, it was found that silk fibroin inhibited the formation of vaterite and promoted the calcite forms.

• Proceedings of the KIEE Conference
• /
• 1995.07c
• /
• pp.1190-1192
• /
• 1995

Poly(vinylidene fluoride)(PVDF) is one of the most studied polymers in the latest date. The interest in PVDF lies in its remarkable piezoelectric and pyroelectric properties. Also, PVDF has at least four known crystalline structures(; they are referred to as the ${\alpha},\;{\beta},\;{\gamma}\;and\;{\alpha}_p$ phase or forms II, I, III and $IV_p$). In this study, the manufactured PVDF thin film through vapor deposition method had form II(; the glass at $70^{\circ}C$). This thin film was investigated by x-ray diffraction(XRD), Fourier Transform Infrared(FT-IR) spectroscopy and Differential Thermal Analysis(DTA). XRD and FT-IR indicate crystallization forms from the glass at $70^{\circ}C$ into form II.

• Korean Journal of Materials Research
• /
• v.30 no.5
• /
• pp.252-261
• /
• 2020

We prepare ZnO nanoparticles by environmentally friendly synthesis using Cyathea nilgiriensis leaf extract. Various phytochemical constituents are identified through the assessment of ethanolic extract of plant Cyathea nilgiriensis holttum by GC-MS analysis. The formation of ZnO nanoparticles is confirmed by FT-IR, XRD, SEM-EDX, TEM, SAED and PSA analysis. TEM observation reveals that the biosynthesized ZnO nanopowder has a hexagonal structure. The calculated average crystallite size from the high intense plane of (1 0 1) is 29.11 nm. The particle size, determined by TEM analysis, is in good agreement with that obtained by XRD analysis. We confirm the formation of biomolecules in plant extract by FT-IR analysis and propose a possible formation mechanism of ZnO nanoparticles. Disc diffusion method is used for the analyses of antimicrobial activity of ZnO nanoparticles. The synthesized ZnO nanoparticles exhibit antimicrobial effect in disc diffusion experiments. The biosynthesized ZnO nanoparticles display good antibacterial performance against B. subtilis (Gram-positive bacteria) and K. pneumonia (Gram-negative bacteria). Bio-synthesized nanoparticles using green method are found to possess good antimicrobial performance.

• Applied Chemistry for Engineering
• /
• v.7 no.1
• /
• pp.43-50
• /
• 1996

A series of domestic natural zeolites were investigated to identify the phase and to study the capability of $NH_4{^+}$-ion removal from solution system. It was proved that the natural zeolite from Young-II bay area was thermally unstable zeolite, heulandite by XRD and FT-IR analyses. In addition, the heulandite exchanged by $K^+$ ion showed the highest thermal stability upon heat-treatments. However, the best capability of removing $NH_4{^+}$-ion from the solution system was the non-exchanged zeolite.