• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.2B
• /
• pp.151-159
• /
• 2002

Frequency synthesizer is an essential part for developing high speed frequency hopping radio. A high speed synthesizer using DDS driven PLL technique is designed and implemented for a X-band portable satellite terminal. It generates transmitter and receiver frequency ranging 6600∼7100MHz and 6140∼6640MHz, respectively by using 102.4MHz local oscillator, Its lock time is below 15 $\mu$sec and Its phase noise is below -754dBc at 1KHz offset Sequency.

• Journal of Advanced Navigation Technology
• /
• v.10 no.4
• /
• pp.348-355
• /
• 2006

In this paper, frequency multipliers used S-band transponder of the KOMPSAT 3 are designed and fabricated. In the transponder, 108 times multiplier which generate 1st LO signal(2008.8MHz) is comprised of the X9 frequency multiplier, 1st X2 multiplier, 2nd X2 multiplier and the last stage of the X3 frequency multiplier. As results, output power of 8.17 dBm at 2008.8MHz, the harmonic suppression of -56.67dBc, the bandwidth of 14MHz were measured.

• Journal of Navigation and Port Research
• /
• v.27 no.5
• /
• pp.513-517
• /
• 2003

In this paper, a VCDRO(Voltage Control Dielectric Resonator Oscillator} applied to X-band as stable source is implementea and constructed with a MESFET for low noise, a dielectric resonator of high frequency selectivity and high Q varactor diode to obtain a good phase noise performance and stable sweep characteristics. The designed circuits is simulated through the harmonic balance simulation technique to provide the optimum performance. The measured results of a fabricated VCDRO show that output is 2.22dBm at 12.05GHz. harmonic suppression -30dBc. phase noise -130dBc at 100kHz offset. and sweep range of varactor diode $\pm$18.7MHz. respectively. This oscillator will be available to X-band application.

• Journal of Advanced Marine Engineering and Technology
• /
• v.30 no.3
• /
• pp.444-448
• /
• 2006

In this paper, a frequency synthesizer for X-band FMCW radars is proposed. Some X-band FMCW radars have been used as a level sensor for tanker ship and the resolution of the level sensor may be mainly depend on linearity of frequency sweep. For a linear frequency sweep. the proposed synthesizer employs a phase-locked loop using prescalars and a high speed digital PLL chip. The measured results show that the linear frequency sweep range is from 10 GHz to 11 GHz and the output power of the synthesizer is minium 7 dBm. and the phase noise is about -80 dBc/Hz at 100 KHz offset from 11 GHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.5
• /
• pp.69-76
• /
• 2004

In this paper, a VCDRO (Voltage Control Dielectric Resonator Oscillator) with low phase noise for X-band application has been designed and fabricated. A low noise and low flicker noise MESFET and a high Q dielectric resonator were selected to obtain good phase noise Performance. Also, a varactor diode having high Q, qualify factor was used to reduce the loading effects and a big Gamma of diode was chosen for linearity of frequency over voltage tuning range. The fabricated circuits was simulated with circuit design tools, ADS to provide the optimum performances. As the measured results of fabricated oscillator, the output power was 5.8 ㏈m at center frequency 12.05㎓ and harmonic suppression -30㏈c, phase noise -114 ㏈c at 100 KHz offset frequency, respectively, and the frequency tuning range as the function of valtage applied to varactor diode was 15.2 MHz and its power variation with frequency was 0.2 ㏈. This oscillator could be available to a local oscillator in X-band.

• Journal of Advanced Navigation Technology
• /
• v.2 no.1
• /
• pp.22-33
• /
• 1998

In the coherent-on-receiver radar system using the magnetron source, frequency synthesizer is employed as a STALO(Stable Local Oscillator) to keep the intermediate frequency stable. In this paper, X-band(8.4GHz~9.7GHz) single loop frequency synthesizer is designed and implemented by an indirect frequency synthesis technique. Phase comparison is performed by a digital PLL(Phase-Locked Loop) chip and the loop filter is designed for the low phase noise. The effects of loop component characteristics on the output phase noise are analyzed for single loop structures, and the calculated results are compared with the measured data.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.6
• /
• pp.84-90
• /
• 2011

In this paper, a dual-band pseudo-combline narrow bandpass filter is proposed. The proposed bandpass filter adopts the open resonant stubs and the proposed bandpass filter can be used for ITS(Intelligent Transport System) and X-band satellite systems application. The proposed bandpass filter has the insertion and return losses of 1.72 dB and 15.5 dB at the bandwidth of 3.6 % and center frequency of 5.8 GHz, respectively. Also, the second operating frequency band for insertion and return losses are 1.92 dB and 16.3 dB at the bandwidth of 3% and center frequency of 8.5 GHz, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.5 s.120
• /
• pp.511-521
• /
• 2007

In this paper, we designed and fabricated a Ka-band synthesizer module. In addition, the systematic layout procedure and the test procedure were presented for the construction of compact synthesizer. To implement the Ka-band synthesizer, X-band VCO is employed as VCO and its frequency was multiplied by 3 with frequency tripler. The fabricated frequency synthesizer shows a frequency tuning range of 500 MHz, output power of about 14 dBm, and a phase noise of -96.17 dBc/Hz at the 100 kHz offset frequency.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.5
• /
• pp.715-722
• /
• 2000

In this paper, the PLDRO is designed and implemented for X-band. It is comprised of tunable high Q resonator with a varactor diode for frequency tuning, loop filter and a 1/8 prescaler which up to 10GHz. Also, it is implemented a TCXO and a VCO signal into the phase detector and achieved a highly stable signal source. From the measurement, the designed PLDRO has the output power of 2.5dBm at 8GHz and phase noise of -64.33dBc at 10KHz offset from carrier. Its characteristic is 26 dBc. This PLDRO has much better temperature stability.

• Journal of Satellite, Information and Communications
• /
• v.11 no.4
• /
• pp.107-113
• /
• 2016

In this paper, we suggest a design method of a wide-band Butler matrix working at 5.9 GHz for V2X communication antennas. Since V2X communication needs beam-forming and beam-steering antennas to make transportation systems, mobile comm platforms, saturated frequency-resources, and signal TX-and-RX smart, multi-functional, resolved, and efficient utmost, respectively, the proper Butler matrix and its radiating elements as a low-profile geometry are realized. The constitutive components of the basic Butler matrix of a narrow band are designed first. And then, it is extended to a wide-band version to make its frequency-shift less affected by the event of the antenna system being mounted on a car body. The beam-forming and beam-steering performance is presented as the common feature tagged along with the different bandwidths of the frequency responses as the comparison between the narrow- and wide-band cases.