• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.657-658
• /
• 2015

In an wireless sensor network, energy efficient routing protocol is important for multi-hop transmission because senor nodes are powered by battery. In multi-hop transmission, specifice nodes are used and the battery power becomes low, it induce the asymetric remaining power among the nodes and makes the network lifetime reduced. In this paper, we propose a power-aware routing protocol which determines the routing path considering the remaining power of the nodes. Simulation results shows that the proposed routing scheme minimize the transmission delay and increase the network lifetime.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.2
• /
• pp.111-116
• /
• 2016

This paper proposes a high-frequency (MHz) LLC resonant converter for a capacitor coupling wireless power transfer (CCWPT). The CCWPT uses electric field in the coupling capacitor between the transmitter and receiver electrodes with a dielectric layer. Given that capacitance is very small and the impedance is large, transferring power with a simple series resonance is difficult. Therefore, the high frequency (MHz) and high Q factor LLC converter is proposed to reduce the impedance of the coupling capacitance and to obtain a high output voltage. This paper deals with the operation analysis of the proposed LLC converter and a theoretical capacitance estimation. The operation and features of the proposed CCWPT LLC converter is verified with a 4.2 W prototype for charging mobile devices.

• Journal of Communications and Networks
• /
• v.18 no.2
• /
• pp.173-181
• /
• 2016

In this paper, we address a new robust optimization problem in a multiuser multiple-input single-output broadcasting system with simultaneous wireless information and power transmission, where a multi-antenna base station (BS) sends energy and information simultaneously to multiple users equipped with a single antenna. Assuming that perfect channel-state information (CSI) for all channels is not available at the BS, the uncertainty of the CSI is modeled by an Euclidean ball-shaped uncertainty set. To optimally design transmit beamforming weights and receive power splitting, an average total transmit power minimization problem is investigated subject to the individual harvested power constraint and the received signal-to-interference-plus-noise ratio constraint at each user. Due to the channel uncertainty, the original problem becomes a homogeneous quadratically constrained quadratic problem, which is NP-hard. The original design problem is reformulated to a relaxed semidefinite program, and then two different approaches based on convex programming are proposed, which can be solved efficiently by the interior point algorithm. Numerical results are provided to validate the robustness of the proposed algorithms.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.25 no.1
• /
• pp.44-53
• /
• 2020

A bridgeless single-stage AC-DC converter for wireless power charging systems is proposed. This converter is composed of a PFC stage and a three-level hybrid DC-DC stage. The proposed converter can control the wide output voltage (200-450 V_DC) by the variable link voltage and the pulse-width voltage applied to the primary resonant circuit due to the phase-shifted modulation at a fixed switching frequency. Moreover, the input power factor and the total harmonic distortion can be improved by using the proposed converter. A 1 kW prototype was fabricated and validated through experimental results and analysis.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.6
• /
• pp.43-48
• /
• 2006

In this paper, the rectenna converting 2.45[GHz] microwave into DC power is designed and fabricated for wireless power transmission using microwave and the methode for impedance matching and tuning are proposed in order to maximize RF-DC conversion efficiency. The fabricated rectenna can be easily tuned by using a broad open stub and has the RF-DC conversion efficiency up to 59[%] when the 5[dBm] input power is applied. The 2.2[V], 1.5[mW] DC level, in the 1[m] distance between the transmitter and the receiver can be obtained and this value is avaliable in the small power digital system.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.26 no.2
• /
• pp.141-149
• /
• 2021

In the field of electric vehicles and AGVs, wireless power transfer (WPT) charging systems have been developed recently because of its convenience, reliability, and positive environmental impact due to cable and cord elimination. In this study, we propose a WPT charging system using a single stage AC-DC converter that can be reduced in size and weight and thus can ensure convenience. The proposed single-stage AC-DC converter can control a wide output voltage (36-54 VDC) within coupling ranges by using the variable link voltage applied to the WPT resonant circuit through phase-shifted modulation at a fixed switching frequency. Moreover, the input power factor and total harmonic distortion can be improved by using the proposed converter. A 1 kW prototype that can operate with an air gap range of 40-50 mm is fabricated and validated through experimental results and analysis.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.2
• /
• pp.483-503
• /
• 2015

This paper analyzes the optimal user density and power allocation for Device-to-Device (D2D) communication underlaying cellular networks on multiple bands with the target of maximizing the D2D transmission capacity. The entire network is modeled by Poisson point process (PPP) which based on stochastic geometry. Then in order to ensure the outage probabilities of both cellular and D2D communication, a sum capacity optimization problem for D2D system on multiple bands is proposed. Using convex optimization, the optimal D2D density is obtained in closed-form when the D2D transmission power is determined. Next the optimal D2D transmission power is obtained in closed-form when the D2D density is fixed. Based on the former two conclusions, an iterative algorithm for the optimal D2D density and power allocation on multiple bands is proposed. Finally, the simulation results not only demonstrate the D2D performance, density and power on each band are constrained by cellular communication as well as the interference of the entire system, but also verifies the superiority of the proposed algorithm over sorting-based and removal algorithms.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.3
• /
• pp.107-112
• /
• 2015

A smart phone and the number of wireless terminals are mobile-to the nature of the AP mobility are many call transfer between wireless terminals and AP (Access Point). Each wireless terminal that is the call processing process for each is relatively large to cause the wireless traffic, and a factor that inhibits the efficient use of the radio band on the AP. In this paper, we use the power intensity threshold and threshold timer of the AP received by the mobile station to reduce the amount of switching traffic between the AP's cause and traffic generation factors between the wireless device and the AP that can effectively utilize the radio traffic from the AP the measures proposed. The proposed method and the conventional method is improved by simulation to handle the amount of radio traffic from the AP it was confirmed that it is possible to effectively utilize the whole of the radio band.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.13 no.4
• /
• pp.85-98
• /
• 2003

Computational power of IC chip is improved day after day producing IC chips holding co-processor continuously. Also a lot of wireless terminals which IC chip embedded in are produced in order to provide simple and various services in the wireless terminal market. However it is difficult to apply the key distribution protocol under wired communication environment to wireless communication environment. Because the computational power of co-processor embedded in IC chip under wireless communication environment is less than that under wired communication environment. In this paper, we propose the hey distribution protocol appropriate for wireless communication environment which diminishes the computational burden of server and client by using co-processor that performs cryptographic operations and makes up for the restrictive computational power of terminal. And our proposal is satisfied with the security requirements that are not provided in existing key distribution protocol.

• Journal of Advanced Information Technology and Convergence
• /
• v.9 no.1
• /
• pp.25-37
• /
• 2019

Power-line communication (PLC) has influenced smart grid development. In addition, PLC has also been instrumental in current research on internet-of-things (IoT). Due to the implementation of PLC in smart grid and IoT environments, strides have been made in PLC and its combination with the wireless system to form a hybrid communication system. Also, PLC has evolved from a single-input-single-output (SISO) configuration to multiple-input-multiple-output (MIMO) configuration system, and from a point-to-point communication system to cooperative communication systems. In this work, we extend a MIMO wireless two-way amplify-and-forward (AF) cooperative communication system to a hybrid PLC and wireless (PLC/W) system configuration. We then maximize the weighted sum-rate for the hybrid PLC/W by optimizing the precoders at each node within the hybrid PLC/W system. The sum-rate problem was found to be non-convex, therefore, an iterative algorithm is used to find the optimal precoders that locally maximize the system sum-rate. For our simulation results, we compare our proposed hybrid PLC/W configuration to a PLC only and wireless only configuration at each node. Due to an improvement in system diversity, the hybrid PLC/W configuration outperformed the PLC only and wireless only system configurations in all simulation results presented in this paper.