• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 하계학술대회 논문집 A
• /
• pp.415-419
• /
• 1996

This paper presents motor speed and phase angle detection method using a sinusoidal AC tachogenerator. The 2-phase or 3-phase output tacho-generator can be adopted, and its' output voltages must have sinusoidal waveforms. Because the detection algorithm is simple, the proposed method can be implemented with analog devices of microprocessor conveniently. And the proposed method has a very short detection delay time. Especially in the analog implementation, there is no delay time without the settling time of analog devices. With the Experimental results, it is verified that the proposed method can accurately detect the instantaneous motor speed and phase over the wide ranges.

• 동력기계공학회지
• /
• 제5권3호
• /
• pp.17-24
• /
• 2001

In order to investigate a characteristic of the behavior of spray pattern in accordance with running conditions for a DI diesel engine, the PLN Injection system with changeable revolution speed of fuel injection cam was set up, and through this, history curves of injection pressure for a similar real DI diesel engine were able to be displayed. Authors visualized and analyzed the sprays at various revolution speed of fuel injection cam, and found out that fuel distributions of the sprays in the low speed condition were bad, fuel with air was injected from the hole of nozzle at the beginning of injection, and wide spray angle at the early stage of injection became narrower with elapsed time, but wider again at the end of injection.

• International Journal of Automotive Technology
• /
• 제6권3호
• /
• pp.215-219
• /
• 2005

Liquefied petroleum gas (LPG) has been used as motor fuel due to its low emissions and low cost. A liquid direct injection system into a cylinder was suggested as a next generation system to maximize a fuel economy as well as a power. This study addresses the analysis of the LPG spray injecting from single hole injector. Two different test conditions are given, which are a fully developed spray case with various injection pressures and a developing spray case with ambient pressure variation. The LPG spray photographs are compared with the sprays of gasoline and diesel fuel at the same conditions, and the spray angles and penetration lengths are also compared, and then the spray behavior is analyzed. The LPG spray photos show that the dispersion characteristic depends very sensitively on the ambient pressure soon after injection. The spray angle is very wide in a low ambient pressure condition until the saturated pressure, but the angle is quickly reduced at the condition over the pressure. However, the down stream of the LPG spray shows much wider dispersion and less penetration than those of gasoline and diesel sprays regardless ambient pressure condition.

• 한국정밀공학회지
• /
• 제31권4호
• /
• pp.353-358
• /
• 2014

This paper reports a simple, yet effective 1-step surface modification method for stainless steel. Electrochemical etching in dilute Aqua Regia forms hierarchical micro and nanoscale structure on the surface. The surface becomes highly hydrophobic (${\sim}150^{\circ}$) as a result of the etching in terms of static contact angle (CA). However the liquid drops easily pinned on the surface because of high contact angle hysteresis (CAH), which is called a "petal effect": The petal effect occur because of gap between surface microstructures, despite of intrinsic hydrophobicity of the base material. The pore size and period of surface structure can be controlled by applied voltage during the etching. This method can be applied to wide variety of industrial demand for surface modification, while maintaining the advantageous anti-corrosion property of stainless steel.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.144-146
• /
• 2007

Interior Permanent Magnet Synchronous Motors(IPMSM) are expanding the application extent for industrial applications. Because that High efficiency and wide speed range are required in applications of electric vehicles, spindle drives and compressors and so on. The performance of IPMSM are deeply affected by the current phase control. Therefore, this paper deals with the analysis of the torque performance according to the variation of the current phase angle.

• Journal of Biosystems Engineering
• /
• 제23권3호
• /
• pp.291-304
• /
• 1998

A control algorithm fir the unmanned vehicles was developed using image information received through a CCD camera that acquires more powerful information over the wide range of wave-length comparing with other sensors and was applied to a speed-sprayer. The algorithm consisted of straight mode for passing along with middle of two tree-rows and turning mode for changing from a row to another row. In case of turning mode, two marks of colored papers were employed to indicate turning point and to decide turning direction for various orchard situations. The method of analysis and image would be differed according to camera's tilt-angle and position that is set on the speed-sprayer. Hence, it analyzed the point of difference by making camera's up and downward tilt-angle.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 하계학술대회 논문집
• /
• pp.376-378
• /
• 2008

A new family of single-phase Z-source ac-ac converter(SZAC) based on single-phase matrix converter (SPMC) is proposed in this paper. Compared to conventional Z-source ac-ac converter, the proposed SZAC has unique feature: providing a wide range of output ac voltage with buck/boost in-phase (maintaining phase angle) and buck/boost out-of-phase (reversing phase angle) operation. A new commutation strategy is used to eliminate voltage spikes on switches. The operating principle of the proposed SZAC is presented. Analysis and experimental results are also presented.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• 제30권5호
• /
• pp.473-479
• /
• 2008

Asians tend to have prominent mandibular angle. The causes of wide lower third of the facial contour are obtuse mandibular angle and hypertrophy of masseter muscles. In cases of hypertrophy of masseter muscles, conventional treatment intends to the contraction of masseter muscle. Recently, volumetric reduction of masseter muscles using botulinum toxin type A injection and radiofrequency (RF) reduction have been introduced. The use of RF energy for masseter muscle reduction is known as a safe, simple, and effective method for aesthetic lower facial contouring. The purpose of this study is to present the effects of RF reduction applied to hypertrophy of masseter muscles, to review and to encourage RF practices in oral and maxillofacial region.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2008년도 International Meeting on Information Display
• /
• pp.306-309
• /
• 2008

We proposed azimuthally continuous nematic domain mode characterized by a cone field induced from patterned electrode structure with a circular slit. This mode has good optical performances such as higher transmittance and wider viewing angle through decreasing the demerits caused by domain walls. We could confirm to these optical characteristics by the manufactured sample.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2015년도 춘계학술대회
• /
• pp.852-854
• /
• 2015

본 논문에서는 건물 통신환경 개선을 위한 건물 내벽의 실제적인 적용을 위해 제작과정이 단순하고 생산 단가가 저렴한 잉크젯 프린팅 방식을 이용하여 종이를 기반의 링 구조 주파수 선택 표면구조를 설계하고 제작하였다. 설계된 종이 기반 주파수 선택 표면구조는 X-대역에서 대역차단 특성과 우수한 입사각 안정성, 광대역 특성을 갖는다. 측정결과로부터 시뮬레이션 결과와 비교적 잘 일치하는 것을 확인하였다.