• 한국정밀공학회지
• /
• 제16권11호
• /
• pp.68-73
• /
• 1999

In this paper, the residual stresses for the wide-band laser heat treatment using a polygon mirror have been analyzed. The results of FE analysis are compared with the experimental results. ANSYS Version 5.3, a commercial FE-code, is used for the FE stress analysis. The structural analysis was performed on after thermal analysis. The residual stress distribution across the hardened area was measured by the X-ray diffraction technique. The laser hardening conditions, 2kW laser power and 2mm/s travel speed, were used for the experiment and the FE analysis. Analysis results, which is maximum tensile residual stress is about 143MPa and maximum compressive residual stress is about -380MPa. Under same parameters with the analysis, experimental results indicate that MTRS is about 152MPa and MCRS is about -312MPa. The experimental results is about 6% higher than the FE analysis. As a result, residual stress data from the experiment close well with that of the FE analysis.

• 한국정보통신학회논문지
• /
• 제12권12호
• /
• pp.2136-2139
• /
• 2008

카오스 발진기는 광대역의 신호를 발생시킬 수 있으며, 발진기의 출력 신호는 스위치를 사용해서 on/off 하더라도 스펙트럼 특성이 변하지 않는다. 통신시스템에서 카오스 발진기를 이용하면, 송수신기에서 국부발진기, 믹서 등의 사용이 필요없기 때문에 전력 소모도 적고 시스템이 간단해지는 장점이 있다. 본 논문에는 UWB 시스템용 카오스 발진기의 설계, 구현 및 시험 결과가 기술되어 있다. 본 논문에서 제작된 카오스 발진기의 출력은 3.4GHz의 중심주파수에서 500MHz의 채널대역폭에 -8.11dBm의 출력전력을 가지며, -10dB 대역폭은 약 470MHz 이었다.

• 대한조선학회논문집
• /
• 제53권6호
• /
• pp.514-520
• /
• 2016

Oil and gas production riser systems need to be designed considering a wide band quarter-modal analysis which contains low-, wave-, VIV(Vortex induced vibration) frequencies. The VIV can be separated into cross-flow(CF) and in-line(IL) components. In this study, the various idealized tri- and quarter-modal spectra are suggested to analyze fatigue damage on the production riser system. In order to evaluate the fatigue damage increment caused by the IL's motion, tri- and quarter-modal spectral fatigue damages are calculated in time domain. And the fatigue damage calculated from two different modal spectra are compared quantitatively. Then the suitability of existent wide band fatigue damage models for quarter modal spectrum was evaluated by comparison of frequency domain calculation and time domain calculation. The result show that although spectral density of IL motion is not remarkable in quantity, the effect on the fatigue damage is significant and existent fatigue damage models are not adequately estimating damage by quarter-modal spectra.

• 전기전자학회논문지
• /
• 제22권4호
• /
• pp.1202-1205
• /
• 2018

본 논문에서는 4H-SiC물질 기반으로 제작된 ggNMOS를 제안하고 전기적 특성을 분석하였다. 4H-SiC는 Wide Band-gap 물질로 Si 물질 보다 면적대비 특성과 고전압 특성이 뛰어나 전력반도체 분야에 주목받고 있다. 제안된 소자는 높은 감내 특성과 Strong snapback 특성을 가진다. 공정은 SiC 공정으로 이루어 졌으며 TLP 측정 장비를 통해 전기적 특성을 분석하였다.

• Journal of electromagnetic engineering and science
• /
• 제7권1호
• /
• pp.42-46
• /
• 2007

This paper presents a linear amplitude equalizer developed to secure the linearity of the slope of the amplitude over the frequency band ranging $2\sim18\;GHz$. The circuit model is featured by the resistor placed between each pair of a transmission-line and a stub. The design includes finding the values of resistors and stubs to have the optimal linear slope and return loss performances. The measured data show the acceptable performances of the slope variation and return loss over $2\sim18\;GHz$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 춘계학술대회 논문집
• /
• pp.26-26
• /
• 2010

Line to ground faults or lightning strikes in electrical power systems produce high frequency overvoltages. With this reason, a wide band analysis of the ground impedance is necessary. In the paper, design of a wideband ground impedance meter which can measure the ground impedance in ranges from 65 Hz to 1.5 MHz is described. Also, a noise elimination method by a digital band-pass filter during measurement is proposed. The maximum measurement error of the meter is estimated 3 % in full ranges.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2001년도 종합학술발표회 논문집 Vol.11 No.1
• /
• pp.257-261
• /
• 2001

This paper presents the implementation of wide-band RFIC amplifier operating from near 50MHz to 3GHz using Tachyonics SiGe HBT foundry. Voltage shunt feedback is used for the flat gain and the broad band impedance matching. Initial design parameters are calculated using the low frequency small signal analysis. Since the HBT model was not available at the design time, discrete tuning board was made for fine tuning in the low frequency range. Fabricated amplifier shows 12dB gain with 1dB fluctuation and PldB reaches 15dBm at 850MHz.

• 한국정보통신학회논문지
• /
• 제9권4호
• /
• pp.839-843
• /
• 2005

본 논문에서는 VHF 송수신기 셋트에 쉽게 장착할 수 있는 해상용 광대역 수신증폭기를 소형 경량, 저비용으로 제작하여 전반적인 수신기의 수신성능을 개선하고자 한다. 제작된 수신 증폭기는 140MHz $\~$ 170MHz 주파수 대역에서 3dBm 정도의 수신감도를 개선하는 특성을 나타내었다. 따라서 VHF대역을 이용하는 통신장비를 더욱 효율적으로 사용가능하며, 양질의 원거리통신이 가능하기 때문에 활용도가 매우 높을 것으로 사료된다.

• Journal of Communications and Networks
• /
• 제14권6호
• /
• pp.710-718
• /
• 2012

The implementation of a common control channel is one of the most challenging issues in cognitive radio networks, since a fully reliable control channel cannot be created without reserving bandwidth specifically for this purpose. In this paper, we investigate a promising solution that exploits the ultra wide band (UWB) technology to let cognitive radio nodes discover each other and exchange control information for establishing a communication link. The contribution of this paper is threefold: (i) We define the communication protocol needed to let cognitive radio nodes discover each other and exchange control information for link set up, (ii) we overcome the gap in coverage, which typically exists between UWB and long-medium range technologies, by using multi-hop communication, (iii) we evaluate the performance of our approach by adopting an accurate channel model and show its benefits with respect to an in-band signaling solution.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 ITC-CSCC -1
• /
• pp.163-166
• /
• 2000

The design, numerical simulation, and an experimental implementation of two-element cross-shaped microstrip line-fed printed slot array antenna for IMT-2000 at the 2.0 GHz band is presented in this paper. The proposed antenna with relative permittivity 4.3 and thickness 1.0mm is analyzed by the Finite-Difference Time-Domain (FDTD) method. It was shown that the measured 2.0 VSWR bandwidth of one-element microstrip slot antenna is from 1.42 GHz to 2.69 GHz, which is approximately 61.8% and that of two-element microstrip slot array antenna is from 1.42 GHz to 2.56 GHz, which is approximately 57.3% And it was shown that the measured gain of one-element microstrip slot antenna is 2.75 dBi and that of two-element microstrip slot antenna is 4.75 dEi. The antennas were fabricated and tested. The measured results are in good agreements with the FDTD results.