• Korean Journal of Mineralogy and Petrology
• /
• v.34 no.4
• /
• pp.255-264
• /
• 2021

Asian dust (Hwangsa) deposited on the surface of the Korean Peninsula is difficult to recognize their existence in mountainous terrain undergoing active erosion and weathering. This study examined Asian dust sediments mixed in soils by analysing clay mineralogy, mineral composition, and microtextures of fine silt (< 20 ㎛) in the alkali feldspar granite area of Seoraksan. The fine silt was composed of detrital particles derived from bedrocks, Asian dust sediments, and their weathering products. Clay minerals of 2:1 structural type, chlorite, amphibole, epidote, and Ca-bearing plagioclase were identified as eolian mineral particles. During the weathering of the bedrock composed of quartz and alkali feldspars, albite was partially weathered to produce small amounts of gibbsite and kaolin minerals. Hydroxy-Al interlayered clay minerals were formed by the exchange and fixation of polynuclear Al cationic species into the interlayers of expandable 2:1 clay minerals dominated by illite-smectite series clay minerals. Contribution of Asian dust to the fine silt of soils was estimated around 70% on the basis of total contents of 2:1 phyllosilicates.

• Journal of The Geomorphological Association of Korea
• /
• v.21 no.4
• /
• pp.1-17
• /
• 2014

This study analyzed characteristics of landform relieves on 12 bedrock whole(W) areas and 24 mountain(M) and valley(V) areas. Based on this result, characteristics and relations between bedrocks and landform relief were classified as follows. 1) gneiss-height M and granite-height W, M, V areas show active stream incision for uplift. However these areas have relatively low relief and grade compared to high altitude, because effect of denudation don't pass on whole slope. 2) gneiss-height W, V, gneiss-mid M, schist M, granite-mid M, volcanic rock W, M, sedimentary rock-height(conglomerate) W, M, V, sedimentary rock-mid (sandstone and shale) M, limestone W, M areas have active stream erosion and mass movement, but landform relieves are on the high side, because these have resistant bedrock and geological structure against weathering and erosion. 3) gneiss-mid W, V, schist W, V, granite-mid W, V, volcanic rock V, sedimentary rock-mid W, V, sedimentary rock-low(shale) M, limestone V areas landform relieves are on the low side, because these have weak resistance and active weathering, mass movement, erosion, transportation and deposit. 4) gneiss-low W, M, V, granite-low W, M, V, sedimentary rock-low W, V areas landform relieves are very low, because these don't have active erosion and mass movement as costal area with low altitude.

• Journal of the Korean Geographical Society
• /
• v.44 no.3
• /
• pp.224-239
• /
• 2009

This study analyzes the properties of fluvial landforms in the upper and lower reaches and investigates the evolutions of stream and fluvial terrace in the Odae river basin. The lower basin of the river that consist of sedimentary rocks resistant to weathering and erosion processes shows higher altitude, relief and slope than the upper basin that consist of granite less resistant to weathering and erosion processes. The average width of river valley at the lower reaches is one-third to the upper reaches and the average width of river channel at the lower reaches is narrower than at the upper reaches. Based on the OSL age dating, the fluvial terrace T1 formed at the temperature-rising period during the late MIS 2 and T2 formed at the middle MIS 3, interstadial period during the last glacial period. Based on the these results, the average incision rates of Odae river are calculated as 0.205m/ka and 0.269m/ka at the upper granite area and lower sedimentary rocks area, respectively.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.527-534
• /
• 2000

136 cut slopes which extends from Namyangju to Chunchon city along the 46th national highway were investigated to analyze the influence factors affecting slope instability. Geologic and geotechnical conditions were examined and the detailed investigation were carried out for fifty five failed slopes. failure mode (wedge failure, planar failure, circular failure, sheet eroison and rock falls) are examined with respect to slope inclination, rock type, weathering grade and discontinuity patterns. It is suggested that the failure modes and their dimensions have relations to the morphology and geologic conditions of the slopes. Wedge failure has highest is the most frequent failure mode and falls, sheet erosions, planar failures and circular in descending order of failure percentage. Wedge failure is most dominant failure type over all lithology except quartzite formation. In slopes of well foliated and banded gneiss, failure ratio of wedge is up to 50% ca. Failure ratio(number of rock fall/number of total failure) of rock fall increases with increase fo slope inclinations and decrease of weathering grade. Dimension analyses of failed slopes shows wedge and circular failure has higher value of D/L and D/H than planar failure and sheet erosion.

• Journal of The Geomorphological Association of Korea
• /
• v.17 no.4
• /
• pp.71-83
• /
• 2010

In this study, the volume of shoreline retreat at sea-cliffs in the Taean peninsula(West Coast of Korea) was estimated and their erosion and seasonal landforms characteristics changes were investigated through multi-temporal aerial photographs and field survey. Based on the analysis of aerial photographs through ortho-correction, the results show that the length of shoreline and erosion area increase as erosion at sea-cliffs occurs in Pado-li and Dundu-li. To obtain the seasonal quantitative landforms changes and retreat of sea-cliffs, we marked top, middle, and bottom datum-points, from which the distance to the nearest bedrock was repeatedly measured. In these regions, the retreat of sea-cliffs gradually increases in spring to summer, but gradually decreases in autumn. In particular, the typhoon that has a great influence on the Korean peninsula in July to September in summer would drastically increase the retreat of sea-cliffs in comparison with other seasons. As the outcrop of sea-cliffs repeats freezing and thawing in winter, the retreat of sea-cliffs increases a little due to active mechanical weathering. To know the erosion and seasonal landforms changes of sea-cliffs, we took pictures of them in every month and then analyze their condition. The retreat of sea-cliffs was repeatedly occurred by the circulation of the erosion of sea-cliff base, landslides, the formation of slope sediment debris and their erosion, in that order.

• Journal of The Geomorphological Association of Korea
• /
• v.19 no.4
• /
• pp.27-37
• /
• 2012

This study investigated granite landforms formed by Hantan-gang fluvial erosion and deposition, or by weathering in the area neighboring the Seungil-gyo bridge in Cheorwon-gun Gangwon-do Korea, in which the contact zone of Myeongseongsan granite and Cheorwon lava plateau creates a unique landform. Major granite landforms are deeply weathered hill, sheet erosional landform, paleo-landform surface and paleosoil, micro-fluvial landforms such as pothole and groove, granite rampart, sand bar and boulder bar, former riverbed. And river cliffs on a weakly weathered dome act as a barrier to lateral shifting of the river.

• Journal of The Geomorphological Association of Korea
• /
• v.26 no.3
• /
• pp.1-17
• /
• 2019

Naeseongcheon is Korea's representative sand stream, and it is one of the regions where the dynamic changes of various river topography developed in the sand bed can be observed. Most of drainage area near of the river channel are formed with Daebo granite, and the granite weathering zone is developed at the surface of hill. Due to the massive input of sediment flux, braided channel reaches are found some of the area. However, the results of the study shows that the alluvial layer is very thin in some reaches. In addition, bedrock or weathered materials, including the Tors are exposed at the channel beds. On the other hand, during the flood, a considerable amount of sediment was introduced, causing the massive sediment to be close to 1m thick. In addition, despite the short distance, large changes in the particle size and sorting of the sediment were observed. Vegetation, on the other hand, has been shown to have a significant effect on the development of the overall channel bed topography, as reported in previous studies. In small floods or low water levels, vegetation's protection role of the surface is predominates, but in large flood conditions, herbaceous loss at the surface of the point bars, accelerating the erosion of surface.

• Proceedings of the KIEE Conference
• /
• 2002.11a
• /
• pp.102-105
• /
• 2002

ADSS(All Dielectirc Self-Supporting) cable installed under high voltage power cable line suffers a variety of environmental influence, rain, wind, snow fall, chemical pollution, salt fog and electrical stress. Its lifetime is required to be at least 20 years with this harsh weathering condition. The electrical stress under high voltage power line gives rise to dry band arcing and tracking, the severest damage, on the outer sheath of cable. Finally tracking might penetrate sheath and cause the break-down of ADSS cable. Tracking resistant sheath material, therefore, should be used to protect the core of ADSS from dry band arcing and to be sure long lifetime. In this work, we discuss various commercial tracking resistant material to investigate the way of track resistance and compare their mechanical, electrical, weathering and tracking properties through serial experiments. We found track resistant material is categorized into two main type : polyethylene with metal hydroxide and polyethylene with reduced carbon black. The Liquid contaminant, Inclined plane Tracking and Erosion test says the time to track of tracking resistant material with metal hydroxide has a little longer time to track in the high applied voltage than that with carbon black, but mechanical and weathering properties were inferior to.

• Journal of the Korean Geographical Society
• /
• v.38 no.6
• /
• pp.922-934
• /
• 2003

On top of several peaks of Seoraksan National Park. many extensive blockfields are found. After initial report was made in year 2000, further field work and analysis of satellite image have been made. Blockfields on top of mountain peaks exhibit evidence of chemical weathering including gnammas and grooves. Also, several lichen colonies larger than 80 cm in diameter have been found on the surface of many blocks. High resolution IKONOS image has been used to delineate the boundary of blockfields which are hard to access during the field trip. Blockfields of Mt. Seoraksan lack fine material necessary for age dating and clay mineral analysis because they experienced long period of wash and erosion during the Holocene. The ages of blockfields seem to be pre-Holocene on the basis of size of lichen colony and weathering pits.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.18 no.4
• /
• pp.4218-4225
• /
• 1976

To insure the safety of the drainage sluice, topogrophical change due to erosion as well as capability of discharging the design flow in a very important factor. In consideration of the fact that the drainage sluice is built in the sea, its construction has many topographically restricted problems and naturally requires a completeness of research and experiment. This thesis is a comparative and analytic study of discharging flow acting on the erosion at the bottom of the structure on the basis of the measured velocity on the downstream channel of the drainage sluice. (1) The measured velocity shows a little higher values than the computed velocity, because the measured velocity was observed at the surface of the stream. There fore, it is reasonable that the compated velocity should be taken in this study. (2) The field observation was conducted to have the measurement of the flow velocity without surveying the area of flow. Therefore, the coefficient of discharge could not be computed. The survey of the area of flow is planned to be conducted along with the measurement of the flow velocity. (3) The apron of the drainage sluice is free discharging type and it was designed to be about 80m in length less than it should be. (4) The apron of free flow discharging type should have a solid foundation to protect the structure by preventing erosion damage to upstream and downstream channels against weathering of rock and strong torrent. Whether free flow discharging type or energy-dissipating type is best chosen depends on the topographical condition of the forage site, therefore, there would be a comparative study before the final decision was made about the protrection for the structure. (5) It is considered to be appropriate that the design and construction of the drainage sluice should have a complete study which is based on hydraulie model test before the type of protection is decided. (6) It is much requested that a variety of experiment equipments be installed and observed to study the protection for the drainage sluice.