• Journal of Power Electronics
• /
• 제17권3호
• /
• pp.641-652
• /
• 2017

This paper proposes a cost-effective topology to drive a three-phase open-end load based on a five-leg indirect matrix converter (IMC) and a space vector modulation (SVM) method. By sharing an inverter leg with two load terminals, the proposed topology can reduce the number of power switches when compared to topologies based on a direct matrix converter or a six-leg IMC. The new SVM method uses only the active vectors that do not produce common-mode voltage (CMV), which results in zero CMV across the load phase and significantly reduces the peak value of the CMV at the load terminal. Furthermore, the proposed drive system can increase the voltage transfer ratio up to 1.5 and provide a superior performance in terms of an output line-to-line voltage with a three-level pulse-width modulation waveform. Simulation and experimental results are given to verify the effectiveness of the proposed topology and the new SVM method.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2005년도 추계종합학술대회
• /
• pp.655-658
• /
• 2005

Due to reduced device sizes and threshold voltages, leakage current becomes an important issue in CMOS design. In a CMOS combinational logic circuit, the leakage current in the standby state depends on the state of the inputs and thus can be minimized by applying an optimal input when the circuit is idling. In this paper, we present a New Input Vector Control algorithm, called Leakage Minimization by Input vector Control (LMIC) for minimal leakage power. This algorithm finds the minimal leakage vector and reduces leakage current up to 22.% on the average, for TSMC 0.18um process parameters. Minimal leakage vectors are very useful in reducing leakage currents in standby mode of operation.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(2)
• /
• pp.625-629
• /
• 2004

This paper presents a systematical approach to study carrier based PWM techniques (CPWM) in diode-clamped and cascade multilevel inverters by using a proposed named multi-modulating pattern method. This method is based on the vector correlation between CPWM and the space vector PWM (SVPWM) and applicable to both multilevel inverter topologies. A CPWM technique can be described in a general mathematical equation, and obtain the same outputs similarly as of the corresponding SVPWM. Control of the fundamental voltage, vector redundancies and phase redundancies in multilevel inverter can be formulated separately in the CPWM equation. The deduced CPWM can obtain the full vector redundancy control, and fully utilize phase redundancy in a cascade inverter In this continued part, it will be deduced correlation between CPWM equations in multi-carrier system and single carrier system, present the mathematical model of voltage source inverter related to the common mode voltage and propose a general algorithm for multi-modulating modulator. The obtained theory will be demonstrated by simulation results.

• 한국광학회지
• /
• 제13권6호
• /
• pp.479-485
• /
• 2002

다중모드간섭을 이용한 임의 분배 비율의 광전력 분배기에 대한 벡터 해석법을 제시한다 광전력 분배는 집적 광학의 기초가 되는 부분이며 특히 광전력 비율을 임의로 조절할 수 있다면 많은 응용분야에 유용할 것이다. 본 벡터 해석법은 기존의 다중모드간섭 현상에 대한 해석적 결과를 도식화함으로써 임의 분배 비율의 다중모드간섭 광전력 분배기 설계를 보다 쉽게 할 수 있다는 장점을 가지고 있다.

• Structural Engineering and Mechanics
• /
• 제25권5호
• /
• pp.631-636
• /
• 2007

• Journal of Power Electronics
• /
• 제14권1호
• /
• pp.105-114
• /
• 2014

The sliding mode control (SMC) strategy is applied to a permanent magnet synchronous machine vector control system in this study to improve system robustness amid parameter changes and disturbances. In view of the intrinsic chattering of SMC, a current sliding mode control method with a load sliding mode observer is proposed. In this method, a current sliding mode control law based on variable exponent reaching law is deduced to overcome the disadvantage of the regular exponent reaching law being incapable of approaching the origin. A load torque-sliding mode observer with an adaptive switching gain is introduced to observe load disturbance and increase the minimum switching gain with the increase in the range of load disturbance, which intensifies system chattering. The load disturbance observed value is then applied to the output side of the current sliding mode controller as feed-forward compensation. Simulation and experimental results show that the designed method enhances system robustness amid load disturbance and effectively alleviates system chattering.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2006년도 전력전자학술대회 논문집
• /
• pp.292-294
• /
• 2006

This paper presents a study on the use of improved space-vector modulation of VSI employing only four switches, four body diodes. Different switching sequence strategy for vector control for inverter fault mode are described. The influence of different switching patterns at same modulation index and improved PWM method is proposed. The proposed PWM is compared with conventional PWM. Simulation and experimental results are presented.

• Journal of the Optical Society of Korea
• /
• 제1권1호
• /
• pp.41-43
• /
• 1997

We report the operation of a self-adaptive vector phase conjugate laser (VPCL) oscillator which compensates intracavity polarization distortion and wavefront aberration simultaneously. The VPCL in Nd:YAG gain media produce an output with energy of 125mJ in a 20ns single-longitudinal-mode pulse at 10Hz, which is unaffected by intracavity polarization distortion.

• Journal of Power Electronics
• /
• 제5권1호
• /
• pp.20-28
• /
• 2005

This paper presents a fuzzy predictive sliding mode control for high performance induction motor position drives. A new simplified inner-loop sliding-mode current control scheme based on a nonlinear mathematical model of an induction motor is introduced. Novel predictive fuzzy logic PI and PID controllers are used in speed and position loops, respectively. Sliding-mode current controllers and fuzzy predictive logic controllers are designed based on indirect vector control. The overall system performance is examined under different dynamic operating conditions. The performance of the drive system is robust and stable, and insensitive to parameters and operating condition variations even though non-exact system parameters are used in the implementation of the proposed controllers.

• Journal of Astronomy and Space Sciences
• /
• 제20권4호
• /
• pp.365-374
• /
• 2003

Satellite formation flying is currently an active area of research in the aerospace engineering. So it has been researched by various authors. In this study, a tracking controller using sliding mode techniques was designed to control a satellite for the satellite formation flying. In general, Hill's equations are used to describe the relative motion of the follower satellite with respect to the leader satellite. However the modified Hill's equations considering the $J_2$ perturbation were used for the design of sliding mode controller. The extended Kalman filter was applied to estimate the state vector based on the measurements of relative distance and velocity between two satellites. The simulation results show that the follower satellite tracks the desired trajectory well by thruster operations based on the sliding mode control law.