• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.8
• /
• pp.626-631
• /
• 2012

$SnO_2$ nanoparticles were synthesized by flame spray pyrolysis, which were directly deposited on Pt interdigitated substrates. Gas sensing performance was evaluated for various gases such as $H_2$, CO, $H_2S$, and $NH_3$, and it was compared with that of commercial $SnO_2$ nanopowder. The synthesis of $SnO_2$ nanoparticles was also conducted in various solvents. As a result, the primary particle size was changed with the solvent of precursor solution, and their $H_2$ sensing properties were significantly affected.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.11
• /
• pp.3280-3288
• /
• 2014

Alkoxyalcohols are used as solvents or preservatives in various consumer products such as wet wipes. The metabolites of alkoxyalcohols are known to be chronically toxic and carcinogenic to animals. Thus, an analytical method is needed to monitor alkoxyalcohols in wet wipes. The aim of this study was to develop a simultaneous analytical method for 14 alkoxyalcohols using headspace gas chromatography coupled with mass spectrometry to analyze the wet wipes. This method was developed by comparing with various headspace extraction parameters. The linear calibration curves were obtained for the method ($r^2$ > 0.995). The limit of detection of alkoxyalcohols ranged from 2 to $200ng\;mL^{-1}$. The precision of the determinative method was less than 18.20% coefficient of variation both intra and inter days. The accuracy of the method ranged from 82.86% to 119.83%. (2-Methoxymethylethoxy)propanol, 2-phenoxyethanol, and 1-phenoxy-2-propanol were mainly detected in wet wipes.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.29 no.6
• /
• pp.843-848
• /
• 1996

As the first step of studies related to production of chitooligosaccharides by physical methods, chitosan solution were sonicated with 20 kHz and various treatment effects were examined to present fundamental data of sonicated chitosan solution. Intrinsic viscosity of chitosan solution sharply decreased from 3.76 dl/g to 2.90 dl/g until 5 minutes of sonication and then slowly decreased. With low volume of chitosan solution, sonication was very effective and temperature of chitosan solution slightly affected the efficiency of sonication. In case of changing the solvent, no significant differences were observed on the effect of sonication, however, acetate buffer had highest sonication effect among various solvents. The sonication effect was increased as the increasement of the value of pH, on the contrary, ionic strength and type of counterions showed no effect on sonication. With these results, we assumed that optimal sonication treatment would be as follows, solution volume was $10\~20\;ml$, temperature range was $20\~30^{\circ}C$, pH value of solution was 4.5 and type of solvent was acetate buffer.

• Journal of the Korean Chemical Society
• /
• v.32 no.2
• /
• pp.113-121
• /
• 1988

The retention mechanism and separation of various aromatic sulfonic and carboxylic acids on reversed-phase liquid chromatographic column were studied in the mobile phase containing dodecyltrimethylammonium bromide (DTAB). The retention mechanism was found to be followed the ion-interaction model where the DTAB occupies a primary layer at the stationary phase while the sample anions and other co-anions in the system compete for forming the secondary layer. The capacity factors of samples were influenced by the several factors such as pH, concentration of various organic solvents, co-anions in the mobile phase and functional groups in sample molecules. Some mixtures of organic samples were attempted to separate under optimum condition.

• Korean Membrane Journal
• /
• v.4 no.1
• /
• pp.25-35
• /
• 2002

The gas permeation properties have been studied on carbon molecular sieve (CMS) membranes prepared by pyrolysis of P84 polyimide under various conditions. P84 polyimide shows high permselectivities (O$_2$/N$_2$= 9.17 and CO$_2$/N$_2$= 35) for various gas pairs and has a good processibility because it is easily soluble in high polar solvents such as N-methylpyrrolidinone (NMP), dimethylformamide (DMF), and N,N-dimethylacetamide (DMAc). After pyrolysis under Ar flow, the change in the heating rate was found to affect the gas permeation properties to some extent. The permeabilities of the selected gases were shown to be in the order He ＞ CO$_2$＞ O$_2$＞ N$_2$for all the CMS membranes, whose order was in accordance with the order of kinetic gas diameters. It also revealed that the pyrolysis temperature considerably influenced the gas permeation properties of the CMS membranes derived from P84 polyimide. The CMS membranes pyrolized at 700$\^{C}$ temperature exhibited the highest permeability with relatively targe loss in permselectivity. This means that the pyrolysis temperature should be varied in accordance with target gases to be separated.

• Preventive Nutrition and Food Science
• /
• v.12 no.4
• /
• pp.267-272
• /
• 2007

The objective of this study was to investigate antioxidant activities of Panax ginseng extracted with various solvents including n-hexane, chloroform, EtOAC, n-butanol and water. Among the various ginseng extracts, ethyl acetate (EtOAC) extracts showed the most powerful scavenging activities against DPPH radicals. Among the other solvent extracts, the butanol extract seemed relatively more effective in scavenging activity, followed by chloroform, water and hexane extracts. Moreover, the highest reducing power and ferrous ion chelating activity were found in the EtOAC extract followed by other extracts of ginseng. EtOAC extracts, which exhibited the best antioxidant activities of all solvent extracts of ginseng, possessed higher concentrations of total phenolics (777.61 mg/100 g) than other extracts. These results suggest that EtOAC extracts of ginseng (P. ginseng C.A. Meyer) have the most effective antioxidant capacity compared to n-hexane, chloroform, n-butanol and water tested in this study, and has important applications for the pharmaceutical and food industries.

• Korean Journal of Plant Resources
• /
• v.33 no.6
• /
• pp.597-603
• /
• 2020

Red ginseng marc (RGM) has been used on primary industries using fertilizer or forage, and it mostly has been dumped. To improve utilization of RGM, the biological activities of RGM were examined. RGM was extracted and fractionated using various solvents and their biological activities were compared. The hexane fraction from the methanol extract of RGM (RGMMH) showed strong anti-cancer activity (58.56 ± 6.04% at 100 ㎍/mL) and anti-inflammatory effect (65.72 ± 1.33% at 100 ㎍/mL). But, oil extract of RGM extracted with hexane (RGMH) showed low activities (anti-cancer: 16.42 ± 3.33%, at 100 ㎍/mL, anti-inflammatory activity: 29.46 ± 2.10%, at 100 ㎍/mL). Their metabolites were analyzed using HPLC. Panaxydol known as anti-cancer compound of RGM was one of major compounds in RGMMH. Meanwhile, panaxydol was detected in trace amount in red ginseng marc oil (RGMH). In addition, RGMMH and RGMH showed big differences in HPLC profiling. This research suggests optimal extraction method of RGM oil.

• Korean Membrane Journal
• /
• v.3 no.1
• /
• pp.9-16
• /
• 2001

The diamide-diamine having carboxylic acid was prepared by direct condensation of 1,2,4-benzenetricarboxylic acid with bits[4- (3-aminophenoxy ) phenyl] sulfone and bits(4-aminouhenyl)-1,4- diisopropylbenzene in medium consisting of triphenylphosphite, LiCl, and N-methyl-2-pyrrolidone. Copoly (amide-imide) derivatives with high molecular weight could be synthesized by one-step polycondensation of prepared diamide-diamine having carboxylic acid and various dianhydride compounds. Depending on the chemical structure and composition of polymer backbones, the viscosities of polymers were found to range between 0.87∼ 1.57 dL/B. All the polymers showed good thermal stability up to 320$\^{C}$ and the 10% weight loss temperature was observed in the range of 450∼540$\^{C}$ in a thermogravimetric traces. The glass transition was recorded in the temperature range of 200 ∼ 270$\^{C}$. All the polymers showed an amorphous nature on a differential scanning calorimetric thermograms. These polymers generally had good mechanical properties and readily soluble in various polar solvents. Further, it was proved that their properties could be determined from the composition.

• Textile Coloration and Finishing
• /
• v.33 no.3
• /
• pp.141-146
• /
• 2021

Supercritical fluid has excellent dissolving power for various materials based on low viscosity and high diffusion coefficient and is used as solvents in various chemical processes. However, its industrial application can be very tricky because the design, especially the size of the supercritical apparatus, should be carefully chosen to optimize the cost and the production of supercritical fluidic state. And the first step of the supercritical fluid apparatus design is to choose the appropriate size of the reactor vessel to produce supercritical fluid above its critical pressure and temperature. Therefore, this study aims to analyze thermodynamic behaviors of dichloromethane based on ideal gas, van der Waals, Redlich-Kwong, Soave-Redlich-Kwong, and Peng-Robinson equations of state. The correlation between the volume and pressure of dichloromethane at 200℃ was revealed and it can be used to design the optimized size of the supercritical apparatus for industrial production.

• Food Science of Animal Resources
• /
• v.43 no.4
• /
• pp.625-638
• /
• 2023

Among various biological agents, bacteriocins are important candidates to control Listeria monocytogenes which is a foodborne pathogen. In this study, a novel bacteriocin, named agilicin C7, was isolated from Ligilactobacillus agilis C7 showing inhibitory activity against L. monocytogenes. Agilicin C7 biosynthesis gene was characterized by bioinformatics analyses and heterologously expressed in Escherichia coli for further study. The anti-listeria activity of recombinant agilicin C7 (r-agilicin C7) was lost by proteases and α-amylase, suggesting that agilicin C7 is a glycoprotein. r-Agilicin C7 has wide pH and thermal stability and is also stable in various organic solvents. It destroyed L. monocytogenes by damaging the integrity of the cell envelope. These properties of r-agilicin C7 indicate that agilicin C7 is a novel amylase-sensitive anti-listerial Class IId bacteriocin. Physicochemical stability and inhibitory activity against L. monocytogenes of r-agilicin C7 suggest that it can be applied to control L. monocytogenes in the food industry, including dairy and meat products.