• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.3A
• /
• pp.345-355
• /
• 2006

The RF Module which can be adjusted for a digital terrestrial and multi standard(DVB-C, ISDB-T, DVB-H) reception is developed. The Module by single conversion does divide a broadband($45MHz{\sim}860MHz$) broadcasting channels into three-bands(UHF, VHF_HIGH, VHF_LOW) to satisfy some electrical performances such as image signal rejection, phase noise, IF flatness etc and digital reception specifications such as analog and digital adjacent channel protection, co-channel protection which is important in environment with co-existence both analog and digital broadcasting systems.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.9
• /
• pp.414-420
• /
• 2005

A method for partial discharge diagnosis based on UHF narrow band type for GIS has been developed and calibrated. In generally, PD cannot be directly measured under on-line condition, but we can indirectly measure the electromagnetic wave made by PD using the high-frequency antenna. Compared with VHF band, electromagnetic waves of UHF band have a low influence for external noise in high-voltage substation. Therefore, we can detect the real abnormality with several pC in GIS using UHF narrow-band type method. For the case of no internal VHF sensor for GIS of the domestic substation, it has applied to use the external UHF sensor attached in spacer in GIS of existing substation. In this paper, we firstly described the technique of partial discharge measurement using frequency analysis and phase analysis in UHF band. Secondly, we presented the results of sensitivity test, the relationship of dBm-pC and diagnosis result of the cause of PD source by phase analysis. And then, we report the diagnosis result of partial discharge on the real GIS in domestic substation. These results make above method applicable for measurement of quantity and cause of PD for real operation GIS in high-voltage substation.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.5
• /
• pp.813-818
• /
• 2020

This study is a study on the characteristics and analysis of the reflected signals about the target in the VHF band. In advance, the RCS(Radar Cross Section) characteristics of the target were analyzed by using the CST electromagnetic analysis tool, and the target was detected by using the Bi-Static method, and the change in the signal-to-noise ratio was tested. The test results show similar results with no significant fluctuations in the signal-to-noise ratio characteristics for the detection of signals reflected on the target, such as the results for RCS analysis according to the pre-incidence angle. In the future, this study will be used for RCS analysis of the targets and target detection of Radar in VHF/UHF band with relatively large wavelength compared to the X band.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.6
• /
• pp.522-528
• /
• 2014

A UHF/VHF full-duplex communication using monopole and dipole antenna has been widely used for cube satellite applications. This kind of communication system requires a dedicated structure panel for antenna integration, which is the one of the disadvantages of the conventional communication system from the accommodation point of view considering the extremely limited volume of the cube satellite. In this study, to maximize the accommodation efficiency of the cube satellite, the commercial UHF half-duplex antenna combined with buck converter for communication modes transition has been considered in the communication system design. Its effectiveness has been verified through link budget analysis based on the antenna specifications and satellite's operation conditions. In addition, the antenna deployment mechanism for the synchronous release of multi-antennas has also been introduced.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.11
• /
• pp.527-531
• /
• 2006

Since 1996, KEPCO has been operating a wide range lightning detection system, LPATS, and been accumulating relative application techniques and statistical analysis skills. So, KEPRI already has its own basis to develope more accurate advanced detection technology and references to do comparative study. For three-dimensional imaging of lightning channels, UHF/VHF antenna systems were installed at 2 sites. The distance between two sites is about 30 km. These systems were used the AOA(Angle of Arrival) methods for lightning detection. In this paper, we would like to introduce about our system and its results.

• Journal of Broadcast Engineering
• /
• v.16 no.5
• /
• pp.824-833
• /
• 2011

In this paper, using the Rec. ITU-R P.1546 explaining a propagation prediction model in the VHF and UHF bands, we propose the analytical methodology for calculating the service distance and field strength for analogue and digital TV receivers. From the derived formulation of the receiver field strength, some computation results are presented and discussed in terms of the equivalent level of service caused by analogue to digital TV conversion. The suggested method is also applicable to the analysis of frequency coordination or compatibility from unwanted signal in VHF and UHF bands.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.17 no.2
• /
• pp.1-9
• /
• 1980

A voltage synthesizing channel selection circuit was designed to improve on the conventional vol tape synthesizer which has been memorized each charnel's tuning vol cage itself. In the course of this study, tuning voltage was calculated by channel number entered from 10 keys. Then this circuit has tie function of direct access channel selection and rear display of channel number for the whole range of UHF and VHF, Attention was also given to realize the fine tuning by searching each commended channel, and the sequential selection by using 2keys, and the flash of channel indicator in case of inactive station.

• Proceedings of the KIEE Conference
• /
• 2002.11a
• /
• pp.28-30
• /
• 2002

The PD in GIS leads to a charge transfer and a voltage drop across the discharge area. They cannot be measure directly but we can measure electromagnetic wave made by PD. In generally, compared with VHF band, electromagnetic waves of UHF band have a low noise therefore, we can detect the real defect with several pC in GIS using UHF method. In this paper, the U-slot microstrip patch antenna for measuring PD signal in GIS is presented. the proposed UHF sensor are designed to have large band characteristics and unaffected structure for GIS operation.

• Journal of Broadcast Engineering
• /
• v.15 no.6
• /
• pp.731-741
• /
• 2010

In this paper, we propose the methodology of prediction of field strength for a digital television (DTV) receiver by virtue of Recommendation ITU-R P.1546. The curves shown in this recommendation represent the point-to area field strength for 1.0 kW effective radiated power in the 30 MHz ~ 3000 MHz. Based upon the procedures described in this Recommendation, computation results are presented here from the derived formulation of field strength for DTV receiver. To show the validity of this method, some results are compared with the analysis by Okumura-Hata model and it was shown that the error of field strength is in the range of 6.9 ~ 11.5 %. The presented method provides not only the predicted values of field strength for DTV receiving area to check the quality of transmitted signal, but also an appropriate site selection for obtaining good propagation environment. In addition, it can be directly used for analyzing the protection ratio or separated distance for frequency sharing in the same band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.10
• /
• pp.951-957
• /
• 2013

In this paper, we propose a performance evaluation process of aircraft blade antennas. The process consists of various sub-processes that should be considered for a stable communication link with the base station. The process begins with the settlement of the ground shape and size to evaluate the impedance matching characteristics of a stand-alone antenna. Next, the main communications area of the antenna is determined by considering a flight scenario, and then the minimum gain requirements of the antenna are derived in the operating frequency band. Finally, the proposed evaluation process is applied for a commercial aircraft blade antenna. The results demonstrate that the proposed process is suitable to be adopted for the evaluation of aircraft blade antennas.