• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2010년도 추계 학술발표회
• /
• pp.1156-1167
• /
• 2010

The constant rate of strain (CRS) consolidation test has been widely used to evaluate consolidation characteristics of soils instead of the standard Incremental Loading Test. In practical problems, after the ground improvement, the condition of the soil is over-consolidated. Therefore, it is important to determine the recompression indices and the coefficient of consolidation(or the coefficient of swelling) of unloading-reloading cycle to predict the settlement behavior. However, since standard testing procedures or studies related with strain rate are insufficient especially in unloading-reloading cycle, it is difficult to predict the settlement field behavior accurately from the CRS consolidation test results in spite of its lots of strengths. The several CRS consolidation tests were performed changing the unloading strain rate from 0.2%/hr to 20%/hr with vertical drainage condition using the reconstituted kaolinite sample. For the reconstituted kaolinite sample in CRS consolidation test, the recompression indices are insensitive to the strain rate. It is revealed that the coefficient of consolidation of reloading is affected by the developed pore pressure during unloading. Additionally, the test should be conducted in the positive pore pressure ratio range (3~15%) to obtain the reasonable coefficient of consolidation in the whole range(loading, unloading and reloading).

• Structural Engineering and Mechanics
• /
• 제9권4호
• /
• pp.375-382
• /
• 2000

Experimental investigation into the cyclic behaviour of sand plast brick masonry was performed on forty two square panels. The panels were subjected to cyclic uniaxial compression for two cases of loading: normal to bed joint and parallel to bed joint. Experimental data were used to plot the unloading-reloading curves for the entire range of the stress-strain curve. Mathematical expressions to predict the reloading and unloading stress-strain curves at various values of residual strain are proposed. A simple parabola and an exponential type formula are found adequate to model the unloading and reloading curves respectively. The models account for the potential effects of residual strain on these curves. Comparison of test results with the proposed mathematical expression shows good correspondence.

• Structural Engineering and Mechanics
• /
• 제11권5호
• /
• pp.565-574
• /
• 2001

Experimental investigation into the behaviour of half-scale brick masonry panels were conducted under cyclic loading normal to the bed joint and parallel to the bed joint. For each cycle, full reloading was performed with the cycle peaks coinciding approximately with the envelope curve. Unloading, however, was carried out fully to zero stress level and partially to two different stress levels of 25 percent and 50 percent of peak stress. Stability point limit exhibits a unique stress-strain curve for full unloading but it could not be established for partial unloading. Common point limit was established for all unloading-reloading patterns considered, but its location depends on the stress level at which unloading is carried to. Common point curves were found to follow an exponential formula, while residual strains versus envelope strains can be expressed by a polynomial function of a single term. The relation between residual strain and envelope strain can be used to determine the stress level at which deterioration due to cyclic loading began.

• 전산구조공학
• /
• 제8권4호
• /
• pp.159-171
• /
• 1995

한 cycle의 이력곡선 loop을 완전히 표현하기 위해서는 pinch force, drift offset, effective stiffness, unloading, reloading, tangential stiffness 등의 변수가 필요하게 된다. 각 이력 loop에 대해 이들 변수들은 에너지 소산정도에 따라 변위와 축력의 함수로 표현될 수 있다. 본 논문에서는 먼저 16개의 전단벽 실험에서 얻어진 이력곡선 데이타를 분석하여 앞에 기술된 모든 변수를 표준화된 변위(.DELTA/.DELTA.y)의 함수로 표현했으며 이를 바탕으로 이력곡선의 포락선으로 표현되는 힘-변위관계를 예측할 수 있는 6개의 step을 제시하였다. 제시된 기법으로 구해진 비탄성 힘-변위관계는 실험곡선과 비교되었으며 내진설계에 있어서 가장 중요한 요소중 하나인 구조물의 비탄성 힘-변위관계를 예측하는 편리한 기법으로 이용될 수 있음을 보였다.

• Computers and Concrete
• /
• 제2권4호
• /
• pp.309-324
• /
• 2005

The moment-curvature relationship of reinforced concrete beams made of normal- and high-strength concrete experiencing complex load history is studied using a numerical method that employs the actual stress-strain curves of the constitutive materials and takes into account the stress-path dependence of the concrete and steel reinforcement. The load history considered includes loading, unloading and reloading. From the results obtained, it is found that the complete moment-curvature relationship, which is also path-dependent, is similar to the material stress-strain relationship with stress-path dependence. However, the unloading part of the moment-curvature relationship of the beam section is elastic but not perfectly linear, although the unloading of both concrete and steel is assumed to be linearly elastic. It is also observed that when unloading happens, the variation of neutral axis depth has different trends for under- and over-reinforced sections. Moreover, even when the section is fully unloaded, there are still residual curvature and stress in the section in some circumstances. Various issues related to the post-peak behavior of reinforced concrete beams are also discussed.

• Computers and Concrete
• /
• 제5권4호
• /
• pp.359-373
• /
• 2008

The present parametric study deals with the meso-scale modelling of concrete subjected to cyclic compression, which exhibits hysteresis loops during unloading and reloading. Concrete is idealised as a two-dimensional three-phase composite made of aggregates, mortar and interfacial transition zones (ITZs). The meso-scale modelling approach relies on the hypothesis that the hysteresis loops are caused by localised permanent displacements, which result in nonlinear fracture processes during unloading and reloading. A parametric study is carried out to investigate how aggregate density and size, amount of permanent displacements in the ITZ and the mortar, and the ITZ strength influence the hysteresis loops obtained with the meso-scale modelling approach.

• 한국해양공학회지
• /
• 제15권4호
• /
• pp.92-100
• /
• 2001

It is very important to determine the coefficient of earth pressure at rest accurately in order to estimate the behavior of soil structure. For estimation of K/sub 0/-value depending upon the stress history of dry sand, a new type of K/sub 0/-oedeometer apparatus is devised, and the horizontal earth pressure is accurately measured. For this study, 2 types of one-cyclic K/sub 0/-Loading/unloading models have been studied experimentally using four relative densities of the sand. The results obtained in this test are as follows : K/sub on'/ the coefficient of earth pressure at - rest for virgin loading is a function of the angle of internal friction Φ' of the sand and is determined as K/sub on/=1 - 0.914 sin Φ', K/sub ou'/ the coefficient of earth pressure at rest for virgin unloading is a function of K/sub on/ and over consolidation ratio(OCR), and is determined as K/sub ou/=K/sub on/(OCR)K/sup a/. The exponent α, increases as the relative density increases. K/sub or'/ the coefficient of earth pressure at rest for virgin reloading decreases in hyperbola type as the vertical stress, σ/sub v/’, increases. And, the stress path at virgin reloading leads to the maximum prestress point, independent upon the value of the minimum unloading stress. The gradient of this curve, m/sub r/ increases as OCR increases.

• 대한토목학회논문집
• /
• 제8권2호
• /
• pp.33-40
• /
• 1988

본 연구에서는 밀도와 구속압력이 노상토의 탄성계수에 미치는 영향을 살펴보기 위하여 전국 고속도로로 노상토를 채취분석하여 얻은 전형적인 5가지 노상토 재료에 대하여 함수비, 밀도 및 구속압력을 달리하면서 비압밀 비배수 삼축압축시험을 실시하였다. 삼축압축시험시 unloading-reloading 실험을 수행하여 얻은 응력-변형을 관계로부터 최대탄성계수를 측정하였다. 실험결과 노상토의 탄성거동은 Janbu의 제안식에 잘 부합하였으며, 구속압력으로 표준화된 탄성계수는 건조단위체적중량과 지수함수의 상관관계가 있음을 알 수 있었다. 또한 포화도가 70%이하에서는 함수비가 탄성계수에 영향을 거의 미치지 않음이 밝혀졌다.

• 한국지반공학회논문집
• /
• 제21권8호
• /
• pp.85-93
• /
• 2005

벽체 변위가 제한되는 옹벽 구조물에 작용하는 토압은 시공 중 뒷채움토에 작용하는 다짐응력의 영향에 따라 변화한다. 정지토압을 보다 적절하게 추정하기 위해서는 이러한 영향을 고려하여 정지토압계수를 산정하여야 할 필요가 있다. 본 연구에서는 다짐 화강풍화토에 대해서 정지토압상태에서 흙이 받는 응력의 재하, 제하, 재 재하 단계를 모사하는 응력이력모델을 단주기 $K_o$-삼축시험으로 재현하였다. 실험결과로부터 각 하중단계의 응력이력조건에 대한 정지상태토압을 결정하였다. 이들 값을 경험식으로부터 얻은 값과 비교하여 다짐 화강풍화토에 대한 정지토압계수 결정을 위한 경험식의 적용성을 평가하였다. 결과적으로 다짐 화강풍화토에 대한 경험식의 적용성은 재 재하 경로에 대해서 오차 감안이 가능한 경우에 대체적으로 적절한 것으로 평가되었다.

• 한국지반공학회지:지반
• /
• 제10권4호
• /
• pp.83-102
• /
• 1994

건조모래의 응력이력에 따른 Ko 값을 관찰하기 위하여 압밀링 형태의 Ko시험기를 새로이 고안하였으며, 이 시험기를 사용하여 수평응력을 측정하였다. 본 실험을 위하여 총 2형태의 단주기 Ko 재하/제하시험이 4종류의 상대밀도에 대하여 수행하였다. 실험결과, 처녀재하 시의 정지토압계수 K.은 모래의 내부마촹각 U'의 함수로서 K.. : 1-0.914sin0'와 같은 관계식을 얻을 수 있었다. 처녀제하 시의 정지토압계수 Kou는 Ko.과 과압밀비(OCR)의 함수로서 Ko.=Ko. (OCR)a으로 표시할 수 있으며, 지수 a는 대체로 상대밀도가 클수록 증가하는 경향을 보인다. 처녀재재하 시의 정지토압계수 Kor은 연직응력 Qv'가 증가함에 따라 쌍곡선 형태로 감소한다. 그리고 처녀재재하 시의 응력경로는 최소제하응력의 크기에 무관하게 최대선행점으로 복귀하며, 이곡선의 기울기 mr은 OCR이 클수로 증가한다.