• The Journal of the Acoustical Society of Korea
• /
• v.41 no.6
• /
• pp.610-620
• /
• 2022

An acoustic vector sensor can simultaneously receive vector quantities, such as particle velocity and acceleration, as well as acoustic pressure at one location, and thus it can be used as a single input multiple output receiver in underwater acoustic communication systems. On the other hand, vector signals received by a single vector sensor have different channel characteristics due to the azimuth angle between the source and receiver and the difference in propagation angle of multipath in each component, producing different communication performances. In this paper, we propose a channel parameter-based weighting method to improve the performance of an acoustic communication system using a single vector sensor. To verify the proposed method, we used communication data collected from the experiment conducted during the KOREX-17 (Korea Reverberation Experiment). For communication demodulation, block-based time reversal technique which is robust against time-varying channels were utilized. Finally, the communication results showed that the effectiveness of the channel parameter-based weighting method for the underwater communication system using a single vector sensor was verified.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.4
• /
• pp.255-261
• /
• 2014

This paper presents an underwater acoustic communication with nonlinear chirp modulation. The information is carried by the carrier amplitude, frequency or phase in the most common underwater acoustic communications. However, the proposed method includes the information within frequency variation of carrier wave for a symbol. Especially, as carrier wave the hyperbolic frequency modulated signal, one of the nonlinear chirp signal, is used and it is robust in the Doppler channel. The proposed method was analyzed and compared to conventional method by simulation. When the doppler shift existed, the error probability of the proposed method is reduced by 5~12 % than conventional method with linear frequency modulated signal. Sea trial was performed to analyze the performance of the proposed method.

• Journal of Navigation and Port Research
• /
• v.37 no.3
• /
• pp.269-273
• /
• 2013

Underwater acoustic channels are generally recognized as one of the most difficult communication media because of the multipath propagation, dispersion, and so on. MIMO (Multiple-input multiple-output) techniques have been actively pursued in underwater acoustic communications recently to increase the data rate over the bandwidth-limited channels. The transmit diversity techniques can be applied in this case, and one of them is Alamouti's scheme. In this paper the performances of the transmit diversity technique are evaluated via experiment. Two transmitters and two receivers were used in experiment, and the experiment was performed in indoor water tank. The error rate 5~8% was confirmed in experimental results, and these are the improved values than the error rate 14.8% for SISO(Single-input single-output) channel under same data rate condition.

• The Journal of the Acoustical Society of Korea
• /
• v.31 no.1
• /
• pp.1-10
• /
• 2012

The linear and decision-feedback equalization can mitigate time-varying intersymbol interference (ISI) caused by time-varying multipath propagation for underwater acoustic channels. The perfect elimination of interference components, however, is difficult using the linear equalization and the decision feedback equalizer has an error propagation problem. To overcome these shortcomings, this paper proposes an equalizer mode selection method using training sequences. The proposed method selects an equalization mode corresponding to the signal-to-noise ratio (SNR). If the SNR is low, the proposed system operates the linear equalizer for preventing the error propagation and if the SNR is high, the decision feedback equalizer for eliminating the residual ISI. Therefore, the proposed method can improve the error performance compared to the conventional equalizers. The computer simulation shows the proposed method improves the bit error performance using practical underwater channels responses acquired from the sea experiment.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.9
• /
• pp.2094-2100
• /
• 2014

The performance of underwater acoustic communication system is sensitive to the inter-symbol interference due to delay spread develop of multipath signal propagation. Thus, it is necessary technique of equalizer and channel code to eliminate inter-symbol interference. In this paper, underwater acoustic communication system were analyzed by experiment using these techniques on the Kyeong-chun lake, Munkyeong City. Based on the results of experiment, we confirmed that the performance of the proposed iterative BCJR equalization method is improved by increasing the number of iterations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.12
• /
• pp.1023-1030
• /
• 2012

The diversity techniques can benefit underwater acoustic communications when the distance between sensors is sufficiently apart, and this leads to the increases in the physical size of the communication system: thus it is very hard to practically use such systems in real-environments. Therefore, in this paper, we have collected data from real underwater cannel environments in order to analyze the usability of diversity combined with beamforming techniques. And we have estimated the fading characteristics from the measurement data, and analyzed the correlation coefficients using the estimated fading characteristics. After analyzing the estimated fading characteristics from the measurements data, we found out that by applying diversity techniques on the output signals from beamformers that perform beamforming from different multipath directions, we can reduce the distance between sensors and at the same time benefit from the diversity gain.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.6
• /
• pp.455-471
• /
• 2013

Active sonar has been commonly used to detect targets existing in the shallow water. When a signal is transmitted and returned back from a target, it has been distorted by various properties of acoustic channel such as multipath arrivals, scattering from rough sea surface and ocean bottom, and refraction by sound speed structure, which makes target detection difficult. It is therefore necessary to consider these channel properties in the target signal simulation in operational performance system of active sonar. In this paper, a monostatic active sonar system is considered, and the target echo, reverberation, and ambient noise are individually simulated as a function of time, and finally summed to simulate a total received signal. A 3-dimensional highlight model, which can reflect the target features including the shape, position, and azimuthal and elevation angles, has been applied to each multipath pair between source and target to simulate the target echo signal. The results are finally compared to those obtained by the algorithm in which only direct path is considered in target signal simulation.

• The Journal of the Acoustical Society of Korea
• /
• v.34 no.4
• /
• pp.295-302
• /
• 2015

Acoustic channels are characterized by long multipath spreads that cause inter-symbol interference. The way in which this fact influences the design of the receiver structure is considered. To satisfy performance and throughput, we presented consecutive iterative BCJR (Bahl, Cocke, Jelinek, Raviv) equalization to improve the performance and throughput. To achieve low error performance, we resort to powerful BCJR equalization algorithms that iteratively update probabilistic information between inner decoder and outer decoder. Also, to achieve high throughput, we divide long packet into consecutive small packets, and the estimate channel information of previous packets are compensated to next packets. Based on experimental channel response, we confirmed that the performance is improved for long length packet size.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1818-1826
• /
• 2014

Time-variant sea surface causes a forward scattering and Doppler spreading in received signal on underwater acoustic communication system. This results in time-varying amplitude, frequency and phase variation of the received signal. In such a way the channel coherence bandwidth and fading feature also change with time. Consequently, the system performance is degraded and high-speed coherent digital communication is disrupted. In this paper, quadrature phase shift keying (QPSK) performance is examined in two different sea surface conditions. The impact of sea surface scattering on performance is analyzed on basis of the channel impulse response and temporal coherence using linear frequency modulation (LFM) signal. The impulse response and the temporal coherence of the rough sea surface condition were more unstable and less than that of the calm sea surface condition, respectively. By relating these with time variant envelope, amplitude and phase of received signal, it was found that the bit error rate (BER) of QPSK are closely related to time variation of sea surface state.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.5
• /
• pp.1042-1050
• /
• 2014

The performance of underwater acoustic(UWA) communication system is sensitive to the Inter-Symbol Interference(ISI) due to delay spread develop of multipath signal propagation. And due to limited frequency using acoustic wave, UWA is a low transmission rate. Thus, it is necessary technique of Space-time code, equalizer and channel code to improve transmission speed and eliminate ISI. In this paper, UWA communication system were analyzed by simulation using these techniques. In the result of simulation, the proposed Turbo Equalization method based on layered Space Time Codes has improved performance compared to conventional UWA communication.