• Journal of Korean Society of Water and Wastewater
• /
• v.31 no.6
• /
• pp.501-510
• /
• 2017

In this study, it is estimated that ceramic membrane process which can operate stably in harsh conditions replacing existing organic membrane connected with coagulation, sedimentation etc.. Jar-test was conducted by using artificial raw water containing kaolin and humic acid. It was observed that coagulant (A-PAC, 10.6%) 4mg/l is the optimal dose. As a results of evaluation of membrane single filtration process (A), coagulation-membrane filtration process (B) and coagulation-sedimentation-membrane filtration process (C), TMP variation is stable regardless of in Flux $2m^3/m^2{\cdot}day$. But in Flux $5m^3/m^2{\cdot}day$, it show change of 1-89.3 kpa by process. TMP of process (B) and (C) is increased 11.8, 0.6 kpa each. But, the (A) showed the greatest change of TMP. When evaluate (A) and (C) in Flux $10m^3/m^2{\cdot}day$, TMP of (A) stopped operation being exceeded 120 kpa in 20 minutes. On the other hand, TMP of (C) is increased only 3 kpa in 120 minutes. Through this, membrane filtration process can be operated stably by using the linkage between the pretreatment process and the ceramic membrane filtration process. Turbidity of treated water remained under 0.1 NTU regardless of flux condition and DOC and $UV_{254}$ showed a removal rate of 65-85%, 95% more each at process connected with pretreatment. Physical cleaning was carried out using water and air of 500kpa to show the recovery of pollutants formed on membrane surface by filtration. In (A) process, TMP has increased rapidly and decreased the recovery by physical cleaning as the flux rises. This means that contamination on membrane surface is irreversible fouling difficult to recover by using physical cleaning. Process (B) and (C) are observed high recovery rate of 60% more in high flux and especially recovery rate of process (B) is the highest at 95.8%. This can be judged that the coagulation flocs in the raw water formed cake layer with irreversible fouling and are favorable to physical cleaning. As a result of estimation, observe that ceramic membrane filtration connected with pretreatment improves efficiency of filtration and recovery rate of physical cleaning. And ceramic membrane which is possible to operate in the higher flux than organic membrane can be reduce the area of water purification facilities and secure a stable quantity of water by connecting the ceramic membrane with pretreatment process.

• Korean Journal of Materials Research
• /
• v.19 no.3
• /
• pp.163-168
• /
• 2009

$Eu^{3+}$-doped $Y_2O_3$ red phosphor was synthesized in a flux method using the chemicals $Y_2O_3,\;Eu_2O_3,\;H_3BO_3$ and $BaCl_2{\cdot}2H_2O$. The effect of a flux addition on the preparation of $Y_2O_3:Eu_{3+}$ red phosphor used as a cold cathode fluorescence lamp was investigated. $H_3BO_3$ and $BaCl_2{\cdot}2H_2O$ fluxes were used due to their different melting points. The crystallinity, thermal properties, morphology, and emission characteristics were measured using XRD, TG-DTA, SEM, and a photo-excited spectrometer. Under UV excitation of 254 nm, $Eu_2O_3$ 3.7 mol% doped $Y_2O_3$ exhibited a strong narrow-band red emission, peaking at 612 nm. From this result, the phosphor synthesized by firing $Y_2O_3$ with 3.7 mol% of $Eu_2O_3$, 0.25 mol% of $H_3BO_3$ and 0.5 mol% of $BaCl_2{\cdot}2H_2O$ fluxes at $1400^{\circ}C$ for 2 hours had a larger particle size of $4{\mu}m$ on average compared to the phosphor of the $H_3BO_3$ flux alone. In addition, a phosphor synthesized by the two fluxes together had a rounder corner shape, which led to the maximum emission intensity.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.36 no.2
• /
• pp.149-154
• /
• 2007

An antibacterial substance to the Streptococcus mutans, a causative bacterium for decayed teeth, was isolated from the dried sea mustard, Undaria pinnatifida, and identified by GC and GC/MS. Acetone extract from the sea mustard (10.4 kg), was evaporated and partitioned to 4 fractions such as hexane, chloroform, butanol and water. The most active chloroform fraction were further purified through basic alumina, silicic acid and ODS column, successively, and finally, 3 antibacterial substances were isolated on the HPLC attached ODS column by using 95% MeOH and guided with UV detector (254 nm). Antibacterial substances (total 160mg, yield $1.5\times10^{-3}$%) had the same Rf value (0.42) on the TLC developed hexane diethyl ether acetic acid (80:30:1) and those methyl esters moved to 0.95. They were identified as the same unsaturated fatty acid, $C_{18:4,\;n-3}$ (3,6,9,12-octadecatetraenoic acid, stearidonic acid) compared relative retention times (15.5 min) with authentic fatty acid on the GC chromatogram. It was further confirmed unambiguously on the GC/MS giving molecular ion peak at m/z 290 which coincided with its methyl ester.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.19 no.1
• /
• pp.20-30
• /
• 1993

Liquid Chromatographic behavior of Pd(II) in Isonitosoethylacetoacetate imine IEAA-NR: R=H, CH3, C2H5, n-C3H7, n-C4H9, C6H5-CH2) Chelates were investigated by reversed phase high performance 1iquid chromatography on Micropak MCH-5 Column using Methanol /water as mobile phase. The optimum condition for the separation of Pd-Isonitrosoethylacetoacetate imine chelates were examined with respect to the flow rate, mobile phase strength. It was found that Pd(IEAA-NR)2 chelates were eluted in an acceptable range of the capacity factor value (0 $\leq$ log k' $\leq$ 1), The dependence of the logarithm of capacity factor(k') on the volume fraction of water in mixture with in the binary mobile phase was examined. Also, the dependence of k'on the liquid-liquid extraction distribution constant in methanol-water / n-alkane extraction system was on system was invert tigated for Pd(IEAA-NR)2. Both kinds of dependence are linear, which suggests that the retention of the electroneutral metal chelates be largely due to the solvophobic effect.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.9
• /
• pp.637-643
• /
• 2012

This study was carried out to investigate how reversible and irreversible fouling were distributed in the filtration using ceramic membrane of 300 kDa pore size for secondary effluent of wastewater. It was performed by calculating fouling as numerical method for diverse TMPs and measured F-EEM and SEC for raw water, treated water and backwashed water. Water quality was also checked to know whether treated water quality was stable or not. The results showed that reversible fouling formation was increased when lower TMP was applied and it is caused by protein like organic matters having higher molecular weights. The secondary wastewater effluent had diverse molecular weight materials, especially contaminants lower than 0.5 kDa and bigger than 12 kDa. Decreasing TMP induced contaminants above 12 kDa and below 1 kDa to become reversible fouling.

• Analytical Science and Technology
• /
• v.16 no.1
• /
• pp.32-38
• /
• 2003

The rapid and sensitive determination method of sildenafil and its related compounds (Vardenafil, Homosildenafil, Tadanafil.) has been investigated using high performance thin layer choromatography (HPTLC). Optimizing separation conditions and simultaneous determination method of these compounds were studied. The calibration curves of those compounds at 254 nm was found to be linear in the range of $1.0{\sim}56.5{\mu}g/mL$, respectively. The detection limts (LOD) and quantification limits (LOQ) of these were found to be $0.8{\sim}1.8{\mu}g/mL$ and $1.0{\sim}2.3{\mu}g/mL$. The coefficient of variation (C.V.) were less than 2.5%. Finally, the present method was applied to determine sildenafil and its related substances in dietary supplement.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.45 no.3
• /
• pp.342-351
• /
• 2016

This study was carried out to develop an optimized analytical method using high-performance liquid chromatography (HPLC) applied to canthaxanthin, which is not yet designated as a food colorant in Korea, as well as to perform validation and uncertainty evaluation of this method. Official methods of AOAC, UK, and Japan with HPLC-UV detection were evaluated for the analysis of canthaxanthin by comparison of linearity, resolution, selectivity, limit of detection (LOD), limit of quantitation (LOQ), accuracy, precision, recovery, inter-laboratory tests, and uncertainty measurement. The calibration curves showed high linearity with an $R_2$ value of over 0.999 for canthaxanthin standard solutions in all three official methods. The official method of Japan exhibited the best results in terms of resolution and selectivity, including the lowest LOD and LOQ. The average coefficients of variation were calculated as less than five of three institutes with a precision value less than 1, accuracy near 100%, and recovery ratio between $100{\pm}10%$. The expanded uncertainty for canthaxanthin was estimated to be $39.5{\pm}5.29mg/kg$ (95% confidence level, k=2), and the uncertainty of measurement was 13.4%. In this study, official methods of canthaxanthin were compared and the validities verified. The results will be further applied to establish an authorized analytical method for canthaxanthin in Korea.

• Journal of Sericultural and Entomological Science
• /
• v.47 no.2
• /
• pp.51-55
• /
• 2005

Resveratrol is naturally occurring phytoalexin compounds produced by grape berries, peanuts, and their products in response to stress such as fungal infection, heavy metal ions or UV irradiation. The objective of this study was to develope a reliable high performance liquid chromatographic (HPLC) method for the quantitative determination of trans-resveratrol in mulberry fruit. Samples were extracted in 80% MeOH and filtered with $0.45{\mu}m$ syringe filter. The transresveratrol was separated Waters $C_{18}$ column, using a mobile phase containing 0.025% trifluroacetic acid in 5% acetonitril and 0.035% trifluroacetic acid in 50% acetonitril, detected by photodiode array detector (PDA) at 254 nm and the flow rate was 1ml/min. Under this analytical condition, the mean content of mulberry fruits (fifty varieties) was $777.3{\pm}585.9ppm$. Among the tested samples, 'Mansaengbaekpinosang (II)' was the highest level in 3450.6 ppm. However four accessions including 'Gukbu', 'Sabangso (I)', 'Simseol' and yield mulberry fruit were not able to detected. Eight suitable varieties selected for the production of fruit were 'Jeolgokchosaeng (Chungbuk)' 777.8 ppm, 'Dangsang 7' 771.1 ppm, 'Jangsosang' 133.9 ppm, 'Susungppong' 31.1 ppm, 'Suwonnosang' 639.7 ppm, 'Palcheongsipyung' 1475.9 ppm, 'Kangsun' 864.0 ppm, and 'Jukcheonchosaeng' 1458.5 ppm. 'Daesungppong' which was the first authorized variety for the production of mulberry fruit was 1236.7 ppm. In conclusion, these results suggest that mulberry including fruit and leaf may a good new resource for resveratrol production.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.4
• /
• pp.402-408
• /
• 2005

This investigation aimed at selecting the optimum catalyst and reaction conditions used in Fenton oxidation for landfill leachate treatment and was carried out at ambient temperature using a lab-scale experiment. The investigation led to the following results: 1) The optimum pH and dose for each iron catalyst were as follows: $Fe^{2+}\;=\;1,200\;mg/L$, $H_2O_2\;=\;1,200\;mg/L$, initial pH=3.0; $Fe^{3+}\;=\;1,200\;mg/L$, $H_2O_2\;=\;1,500\;mg/L$, initial pH=4.5; $Fe^0\;=\;1,200\;mg/L$, $H_2O_2\;=\;900\;mg/L$, initial pH=4.0, respectively. 2) The progress of Fenton oxidation could be instrumentally monitored by measuring redox potential evolution during leachate oxidation, thus, indicating the possibility of an on-line process monitoring. 3) A simple acid-base titration of Fenton-treated leachate proved that a relevant fraction of by- products formed during the treatment was made of acidic compounds in the optimum reaction condition for each catalyst used, thus demonstrating that the higher the extent of Fenton oxidation the greater was the amount of acids formed. 4) With the aim of selecting the optimum catalyst among $Fe^0$, $Fe^{2+}$ and $Fe^{3+}$, removal efficiency of each parameter in the optimum reaction conditions was considered. Although $Fe^{3+}$ was higher than other catalysts($Fe^0$, $Fe^{2+}$) in removal efficiency, $Fe^0$ was a optimum catalyst with a view of cost effectiveness.